Pengfei Lu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Pengfei Lu has a total of 42 co-authors. Here are the top co-authors by number of shared publications:
- Liyuan Wu
CAS Key Laboratory for Biomedical Effects of Nanomaterials and Nanosafety, Institute of High Energy Physics, Chinese Academy of Sciences, Beijing 100049, China
6 shared publications - Ruge Quhe
State Key Laboratory of Information Photonics and Optical Communications
4 shared publications Pengfei Guan
Beijing Computational Science Research Center, Beijing 100193, China
3 shared publicationsQian Wang
State Key Laboratory of Information Photonics and Optical Communications, Beijing University of Posts and Telecommunications, Beijing 100876, China
3 shared publications- Dan Liang
State key laboratory of Information photonics and optical communications, School of Electronic Engineering, Beijing University of Posts and Telecommunications, Beijing 100876, China
2 shared publications - Kesong Yang
University of California San Diego 9500 Gilman Drive
2 shared publications
Latest Publications
- 13 July 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 125 (28) , 15742-15750
Impact of Halogen Substitution on the Electronic and Optical Properties of 2D Lead-Free Hybrid Perovskites
- 13 July 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 125 (28) , 15742-15750
Impact of Halogen Substitution on the Electronic and Optical Properties of 2D Lead-Free Hybrid Perovskites
- 21 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (22) , 6334-6344
Ionizing Radiation Effect upon Er/Yb Co-Doped Fibre Made by In-Situ Nano Solution Doping
In order to assess the possible use in terrestrial and space applications, radiation effects by different ionizing radiation (gamma ray, electron beam, and mixed neutron / γ radiation) upon erbium and ytterbium co-doped fibre (EYDF) made by in-situ nano solution doping have been investigated. The spectral attenuation, unsaturable loss at 830 nm, emission and lifetime of irradiated (max dose is up to 140 kGy) and non-irradiated EYDF samples are measured, and the outcomes were analysed and compared. The results indicate that both the spectral attenuation and unsaturable loss at 830 nm are increased significantly and that the emission is reduced by radiation induced attenuation (RIA) and the decrease of the lifetime. The radiation effects produced by electron beam and gamma ray are almost comparable. The comparison between the radiation effects induced by pure gamma radiation and mix gamma and neutron radiation indicates that the neutron irradiation may have, to some degree, opposite effects as compared with pure γ ray.
- 21 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (22) , 6334-6344
Ionizing Radiation Effect upon Er/Yb Co-Doped Fibre Made by In-Situ Nano Solution Doping
In order to assess the possible use in terrestrial and space applications, radiation effects by different ionizing radiation (gamma ray, electron beam, and mixed neutron / γ radiation) upon erbium and ytterbium co-doped fibre (EYDF) made by in-situ nano solution doping have been investigated. The spectral attenuation, unsaturable loss at 830 nm, emission and lifetime of irradiated (max dose is up to 140 kGy) and non-irradiated EYDF samples are measured, and the outcomes were analysed and compared. The results indicate that both the spectral attenuation and unsaturable loss at 830 nm are increased significantly and that the emission is reduced by radiation induced attenuation (RIA) and the decrease of the lifetime. The radiation effects produced by electron beam and gamma ray are almost comparable. The comparison between the radiation effects induced by pure gamma radiation and mix gamma and neutron radiation indicates that the neutron irradiation may have, to some degree, opposite effects as compared with pure γ ray.
- 23 September 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (39) , 18329-18337
Strain and defect engineered monolayer Ni-MoS2for pH-universal hydrogen evolution catalysis
The demonstrated monolayer Ni-MoS2possesses a high HER performance in both acidic and alkaline solutions.
- 23 September 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (39) , 18329-18337
Strain and defect engineered monolayer Ni-MoS2for pH-universal hydrogen evolution catalysis
The demonstrated monolayer Ni-MoS2possesses a high HER performance in both acidic and alkaline solutions.
- 3 July 2019
- Published by Springer Nature
- p. 1-9
Electronic Properties of Dilute Bismides
- 15 November 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (47) , 24389-24396
First-principles characterization of two-dimensional (CH3(CH2)3NH3)2(CH3NH3)n−1GenI3n+1 perovskite
Two-dimensional (2D) organic–inorganic hybrid perovskites have drawn significant interest due to their great tunability of optoelectronic properties via a control of layer dimensionality and high stability compared to their 3D counterparts. Here, we report structural, electronic, excitonic, and optical properties of lead-free 2D Ruddlesden–Popper hybrid perovskites (CH3(CH2)3NH3)2(CH3NH3)n−1GenI3n+1 (n = 1, 2, and 3) from first-principles calculations. Our results show that the 2D perovskites have a higher stability than their 3D analogous (CH3NH3)GeI3 (n = ∞), and their band gaps decrease with increasing n values, from 1.88 eV (n = 1), to 1.83 eV (n = 2), to 1.69 eV (n = 3), and to 1.57 eV (n = ∞). The 2D perovskites exhibit a strong anisotropic feature, i.e., a low charge carrier effective mass and strong absorption in their 2D planes as compared to that in their third direction. These 2D perovskites also show a high exciton binding energy, allowing for an enhanced photoluminescence quantum efficiency with respect to their 3D compounds. These results suggest a great potential of these germanium-based 2D hybrid perovskites in the optoelectronic applications.
- 15 November 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (47) , 24389-24396
First-principles characterization of two-dimensional (CH3(CH2)3NH3)2(CH3NH3)n−1GenI3n+1 perovskite
Two-dimensional (2D) organic–inorganic hybrid perovskites have drawn significant interest due to their great tunability of optoelectronic properties via a control of layer dimensionality and high stability compared to their 3D counterparts. Here, we report structural, electronic, excitonic, and optical properties of lead-free 2D Ruddlesden–Popper hybrid perovskites (CH3(CH2)3NH3)2(CH3NH3)n−1GenI3n+1 (n = 1, 2, and 3) from first-principles calculations. Our results show that the 2D perovskites have a higher stability than their 3D analogous (CH3NH3)GeI3 (n = ∞), and their band gaps decrease with increasing n values, from 1.88 eV (n = 1), to 1.83 eV (n = 2), to 1.69 eV (n = 3), and to 1.57 eV (n = ∞). The 2D perovskites exhibit a strong anisotropic feature, i.e., a low charge carrier effective mass and strong absorption in their 2D planes as compared to that in their third direction. These 2D perovskites also show a high exciton binding energy, allowing for an enhanced photoluminescence quantum efficiency with respect to their 3D compounds. These results suggest a great potential of these germanium-based 2D hybrid perovskites in the optoelectronic applications.
- Open Access
- 11 June 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (38) , 21280-21287
High n-type and p-type thermoelectric performance of two-dimensional SiTe at high temperature
From a device perspective, achieving great merits for both n- and p-type thermoelectric systems is particularly desirable. By first-principles calculations, electronic, phonon, and thermoelectric transport properties of 2D SiTe with three different structural phases are investigated, which are quadruple layer (QL), black-phosphorene-like (α-SiTe) and blue-phosphorene-like (β-SiTe), respectively. Of these three structure phases, β-SiTe possesses the best thermoelectric properties. This is because the DOS peak near the valence band results in a high Seebeck coefficient, further leading to a high power factor. We also demonstrate that strong phonon scattering heavily influences the lattice thermal conductivity Kl of β-SiTe. With the combination of high power factor and low Kl, the ZTmax value of β-SiTe reaches 0.95 at T = 1300 K for both n- and p-type doped systems. Therefore, 2D β-SiTe is a promising candidate for future high-temperature solid-state thermoelectric generators with a balanced performance of the n- and p-legs.
- 11 June 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (38) , 21280-21287
Open AccessHigh n-type and p-type thermoelectric performance of two-dimensional SiTe at high temperature
From a device perspective, achieving great merits for both n- and p-type thermoelectric systems is particularly desirable. By first-principles calculations, electronic, phonon, and thermoelectric transport properties of 2D SiTe with three different structural phases are investigated, which are quadruple layer (QL), black-phosphorene-like (α-SiTe) and blue-phosphorene-like (β-SiTe), respectively. Of these three structure phases, β-SiTe possesses the best thermoelectric properties. This is because the DOS peak near the valence band results in a high Seebeck coefficient, further leading to a high power factor. We also demonstrate that strong phonon scattering heavily influences the lattice thermal conductivity Kl of β-SiTe. With the combination of high power factor and low Kl, the ZTmax value of β-SiTe reaches 0.95 at T = 1300 K for both n- and p-type doped systems. Therefore, 2D β-SiTe is a promising candidate for future high-temperature solid-state thermoelectric generators with a balanced performance of the n- and p-legs.
- 29 March 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (17) , 7933-7941
Stanene nanomeshes as anode materials for Na-ion batteries
A two-dimensional stanene nanomesh is proposed as a promising anode material for Na-ion batteries.
- 29 March 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (17) , 7933-7941
Stanene nanomeshes as anode materials for Na-ion batteries
A two-dimensional stanene nanomesh is proposed as a promising anode material for Na-ion batteries.
- Open Access
- 26 September 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (73) , 45896-45901
Robust quasi-ohmic contact against angle rotation in noble transition-metal-dichalcogenide/graphene heterobilayers
Small Schottky barriers appear in PtS2/graphene and PdS2/graphene against interlayer rotation angles.
- 26 September 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (73) , 45896-45901
Open AccessRobust quasi-ohmic contact against angle rotation in noble transition-metal-dichalcogenide/graphene heterobilayers
Small Schottky barriers appear in PtS2/graphene and PdS2/graphene against interlayer rotation angles.
- Open Access
- 1 September 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (67) , 42455-42461
Electronic and excitonic properties of two-dimensional and bulk InN crystals
Motivated by potential extensive applications in nanoelectronics devices of III–V materials, we calculate the structural and optoelectronic properties of two-dimensional (2D) InN as well as its three-dimensional (3D) counterparts by using density functional theory (DFT). Compared with the 3D form, the In–N bonding in the 2D InN layer is stronger in terms of the shorter bond length, and the formation of the 2D one is higher in terms of the lower cohesive energy. The bandgap of monolayer InN is 0.31 eV at PBE level and 2.02 eV at GW0 level. By many-body GW0 and BSE within RPA calculations, monolayer InN presents an exciton binding energy of 0.12 eV. The fundamental bandgap increases along with layer reduction and is converted from direct (0.7–0.9 eV) in bulk InN to indirect (2.02 eV) in monolayer InN. Under biaxial compressive strain, the bandgap of 2D-InN can be further tuned from indirect to direct.
- 1 September 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (67) , 42455-42461
Open AccessElectronic and excitonic properties of two-dimensional and bulk InN crystals
Motivated by potential extensive applications in nanoelectronics devices of III–V materials, we calculate the structural and optoelectronic properties of two-dimensional (2D) InN as well as its three-dimensional (3D) counterparts by using density functional theory (DFT). Compared with the 3D form, the In–N bonding in the 2D InN layer is stronger in terms of the shorter bond length, and the formation of the 2D one is higher in terms of the lower cohesive energy. The bandgap of monolayer InN is 0.31 eV at PBE level and 2.02 eV at GW0 level. By many-body GW0 and BSE within RPA calculations, monolayer InN presents an exciton binding energy of 0.12 eV. The fundamental bandgap increases along with layer reduction and is converted from direct (0.7–0.9 eV) in bulk InN to indirect (2.02 eV) in monolayer InN. Under biaxial compressive strain, the bandgap of 2D-InN can be further tuned from indirect to direct.