ESElizabeth H. Steenbergen

Elizabeth H. Steenbergen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Elizabeth H. Steenbergen has a total of 59 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Recombination rate analysis in long minority carrier lifetime mid-wave infrared InGaAs/InAsSb superlattices

    by Rigo A. Carrasco, Christian P. Morath, Perry C. Grant, Gamini Ariyawansa, Chad A. Stephenson, Clark N. Kadlec, Samuel D. Hawkins, John F. Klem, Eric A. Shaner, Elizabeth H. Steenbergen, et al.

    Gallium is incorporated into the strain-balanced In(Ga)As/InAsSb superlattice system to achieve the same mid-wave infrared cutoff tunability as conventional Ga-free InAs/InAsSb type-II superlattices, but with an additional degree of design freedom to enable optimization of absorption and transport properties. Time-resolved photoluminescence measurements of InGaAs/InAsSb superlattice characterization- and doped device structures are reported from 77 to 300 K and compared to InAs/InAsSb. The low-injection photoluminescence decay yields the minority carrier lifetime, which is analyzed with a recombination rate model, enabling the determination of the temperature-dependent Shockley–Read–Hall, radiative, and Auger recombination lifetimes and extraction of defect energy levels and capture cross section defect concentration products. The Shockley–Read–Hall-limited lifetime of undoped InGaAs/InAsSb is marginally reduced from 2.3 to 1.4 μs due to the inclusion of Ga; however, given that Ga improves the vertical hole mobility by a factor of >10×, a diffusion-limited InGaAs/InAsSb superlattice nBn could expect a lower bound of 2.5× improvement in diffusion length with significant impact on photodetector quantum efficiency and radiation hardness. At temperatures below 120 K, the doped device structures are Shockley–Read–Hall limited at 0.5 μs, which shows promise for detector applications.


  • Minority carrier lifetime and photoluminescence of mid-wave infrared InAsSbBi

    by Priyanka Petluru, Perry C. Grant, Aaron J. Muhowski, Isabella M. Obermeier, Marko S. Milosavljevic, Shane R. Johnson, Daniel Wasserman, Elizabeth H. Steenbergen, Preston T. Webster

    Time-resolved photoluminescence measurements are reported for InAsSbBi alloys grown by molecular beam epitaxy with Bi mole fractions ranging from 0 to 0.8%, yielding minority carrier lifetimes on the order of hundreds of nanoseconds. The minority carrier lifetimes extracted from the time-resolved photoluminescence measurements are comparable to those of lattice-matched InAsSb grown at the same respective temperatures. Nomarski imaging shows that smooth, droplet-free surface morphologies are obtained in 1 μm thick InAsSbBi epilayers grown at temperatures between 360 and 380 °C. The alloy composition-dependent bandgap energies for the InAsSbBi samples are determined from temperature-dependent steady-state photoluminescence measurements and compared with the tetragonal distortion measured by x-ray diffraction to determine the Sb and Bi mole fractions of each sample. The minority carrier lifetime and the achievable extension of the InAsSb(Bi) cut-off wavelength are analyzed as functions of alloy composition and compared with the performance of InAsSb layers with similar growth parameters.


  • Vertical carrier transport in strain-balanced InAs/InAsSb type-II superlattice material

    by Lilian K. Casias, Christian P. Morath, Elizabeth H. Steenbergen, Gilberto A. Umana-Membreno, Preston T. Webster, Julie V. Logan, Jin K. Kim, Ganesh Balakrishnan, Lorenzo Faraone, Sanjay Krishna

    Anisotropic carrier transport properties of unintentionally doped InAs/InAs0.65Sb0.35 type-II strain-balanced superlattice material are evaluated using temperature- and field-dependent magnetotransport measurements performed in the vertical direction on a substrate-removed metal-semiconductor-metal device structure. To best isolate the measured transport to the superlattice, device fabrication entails flip-chip bonding and backside device processing to remove the substrate material and deposit contact metal directly to the bottom of an etched mesa. High-resolution mobility spectrum analysis is used to calculate the conductance contribution and corrected mixed vertical-lateral mobility of the two carrier species present. Combining the latter with lateral mobility results from in-plane magnetotransport measurements on identical superlattice material allows for the calculation of the true vertical majority electron and minority hole mobilities; amplitudes of 4.7 × 10 3 cm2/V s and 1.60 cm2/V s are determined at 77 K, respectively. The temperature-dependent results show that vertical hole mobility rapidly decreases with decreasing temperature due to trap-induced localization and then hopping transport, whereas vertical electron mobility appears phonon scattering-limited at high temperature, giving way to interface roughness scattering at low temperatures, analogous to the lateral electron mobility but with a lower overall magnitude.


  • Mid-wavelength infrared unipolar nBp superlattice photodetector

    by Alireza Kazemi, Stephen Myers, Zahra Taghipour, Sen Mathews, Ted Schuler-Sandy, Seunghyun Lee, Vincent M. Cowan, Eli Garduno, Elizabeth Steenbergen, Christian Morath, et al.


  • Comparison of MWIR unipolar barrier structures based on strained layer superlattices (Conference Presentation)

    by David A. Ramirez, Stephen A. Myers, Yuliya Kuznetsova, Sen Mathews, Theodore Schuler-Sandy, Elizabeth H. Steenbergen, Christian P. Morath, Vicent M. Cowan, Sanjay Krishna

    In this work, we compare the performance of three MWIR unipolar barrier structures based on the InAs/GaSb Type-2 strained layer superlattice material system. We have designed, fabricated, and characterized pBiBn, pBn, and pBp detector structures. All the structures have been designed so that the cut off wavelength is around 5 microns at 100 K. We fabricated single-pixel devices and characterize their radiometric performance. In addition, we have characterized the degradation of the performance of the devices after exposing the devices to 63 MeV proton radiation to total ionizing dose of 100 kRad (Si). In this report, we compare the performance of the different structures with the objective of determining the advantages and disadvantages of the different designs. This work was supported by the Small Business Innovation Research (SBIR) program under the contract FA9453-14-C-0032, sponsored by the Air Force Research Laboratory (AFRL).

  • Unipolar infrared detectors based on InGaAs/InAsSb ternary superlattices

    by Gamini Ariyawansa, Charles J. Reyner, Joshua M. Duran, Joshua D. Reding, John E. Scheihing, Elizabeth H. Steenbergen

    Growth and characteristics of mid-wave infrared (MWIR) InGaAs/InAsSb strained layer superlattice (SLS) detectors are reported. InGaAs/InAsSb SLSs, identified as ternary SLSs, not only provide an extra degree of freedom for superlattice strain compensation but also show enhanced absorption properties compared to InAs/InAsSb SLSs. Utilizing In1-yGayAs/InAs0.65Sb0.35 ternary SLSs (y = 0, 5, 10, and 20%) designed to have the same bandgap, a set of four unipolar detectors are investigated. These demonstrate an enhancement in the detector quantum efficiency due to the increased absorption coefficient. The detectors exhibit dark current performance within a factor of 10 of Rule 07 at temperatures above 120 K, and external quantum efficiencies in the 15%–25% range. This work demonstrates ternary SLSs are a potential absorber material for future high performance MWIR detectors.


  • Open Access

    Evaluation of antimony segregation in InAs/InAs1−xSbx type-II superlattices grown by molecular beam epitaxy

    by Jing Lu, Esperanza Luna, Toshihiro Aoki, Elizabeth H. Steenbergen, Yong-Hang Zhang, David J. Smith

    InAs/InAs1−xSbx type II superlattices designed for mid-wavelength infrared photo-detection have been studied using several electron microscopy methods, with specific attention directed towards interface chemical diffusion caused by Sb segregation. Reciprocal-space image analysis using the geometric phase method showed asymmetric interfacial strain profiles at the InAs-on-InAsSb interface. Measurement of local Sb compositional profiles across the superlattices using electron energy-loss spectroscopy and 002 dark-field imaging confirmed asymmetric Sb distribution, with the InAs-on-InAsSb interface being chemically graded. In contrast, the InAsSb-on-InAs interface showed a small intrinsic interface width. Careful evaluation of the experimental Sb composition profiles using a combined segregation and sigmoidal model reached quantitative agreement. Segregation dominated over the sigmoidal growth at the InAs-on-InAsSb interface, and the segregation probability of 0.81 ± 0.01 obtained from the two microscopy techniques agreed well within experimental error. Thus, 81% of Sb atoms from the topmost layers segregated into the next layer during growth causing the interfaces to be broadened over a length of ∼3 nm. This strong Sb segregation occurred throughout the whole superlattice stack, and would likely induce undesirable effects on band-gap engineering, such as blue-shift or broadening of the optical response, as well as weakened absorption.


  • InGaAs/InAsSb strained layer superlattices for mid-wave infrared detectors

    by Gamini Ariyawansa, Charles J. Reyner, Elizabeth H. Steenbergen, Joshua M. Duran, Joshua D. Reding, John E. Scheihing, Henry R. Bourassa, Baolai L. Liang, Diana L. Huffaker

    Investigation of growth and properties of InGaAs/InAsSb strained layer superlattices, identified as ternary strained layer superlattices (ternary SLSs), is reported. The material space for the antimony-based SLS detector development is expanded beyond InAs/InAsSb and InAs/(In)GaSb by incorporating Ga into InAs. It was found that this not only provides support for strain compensation but also enhances the infrared (IR) absorption properties. A unique InGaAs/InAsSb SLS exists when the conduction band of InGaAs aligns with that of InAsSb. The bandgap of this specific InGaAs/InAsSb SLS can then be tuned by adjusting the thickness of both constituents. Due to the enhanced electron-hole wavefunction overlap, a significant increase in the absorption coefficient was theoretically predicted for ternary SLS as compared to current state-of-the-art InAs/InAsSb SLS structures, and an approximately 30%–35% increase in the absorption coefficient was experimentally observed. All the samples examined in this work were designed to have the same bandgap of approximately 0.240 eV (5.6 μm) at 150 K.


  • Measurement of InAsSb bandgap energy and InAs/InAsSb band edge positions using spectroscopic ellipsometry and photoluminescence spectroscopy

    by P. T. Webster, N. A. Riordan, S. Liu, E. H. Steenbergen, R. A. Synowicki, Y.-H. Zhang, S. R. Johnson

    The structural and optical properties of lattice-matched InAs0.911Sb0.089 bulk layers and strain-balanced InAs/InAs1−xSbx (x ∼ 0.1–0.4) superlattices grown on (100)-oriented GaSb substrates by molecular beam epitaxy are examined using X-ray diffraction, spectroscopic ellipsometry, and temperature dependent photoluminescence spectroscopy. The photoluminescence and ellipsometry measurements determine the ground state bandgap energy and the X-ray diffraction measurements determine the layer thickness and mole fraction of the structures studied. Detailed modeling of the X-ray diffraction data is employed to quantify unintentional incorporation of approximately 1% Sb into the InAs layers of the superlattices. A Kronig-Penney model of the superlattice miniband structure is used to analyze the valence band offset between InAs and InAsSb, and hence the InAsSb band edge positions at each mole fraction. The resulting composition dependence of the bandgap energy and band edge positions of InAsSb are described using the bandgap bowing model; the respective low and room temperature bowing parameters for bulk InAsSb are 938 and 750 meV for the bandgap, 558 and 383 meV for the conduction band, and −380 and −367 meV for the valence band.


  • Influence of carrier localization on minority carrier lifetime in InAs/InAsSb type-II superlattices

    by Zhi-Yuan Lin, Shi Liu, Elizabeth H. Steenbergen, Yong-Hang Zhang

    A long minority carrier lifetime of 12.8 μs in a mid-wavelength infrared InAs/InAsSb type-II superlattice is observed at 15 K using time-resolved photoluminescence technique. The long carrier lifetime is due to carrier localization, which is confirmed by a 3 meV blue shift of the photoluminescence peak energy and the monotonic decrease of lifetime with increasing temperature from 15 K to 50 K, along with an increased photoluminescence linewidth below 40 K. In contrast, no carrier localization is observed in a long-wavelength infrared type-II superlattice at the same temperatures. Modeling results show that carrier localization is stronger in shorter period (9.9 nm) mid-wavelength infrared superlattices as compared to longer period (24.2 nm) long-wavelength infrared superlattices, indicating that the carrier localization originates mainly from InAs/InAsSb interface disorder. Although carrier localization enhances carrier lifetimes, it also adversely affects carrier transport, and thus should be carefully considered in the design and evaluation of InAs/InAsSb type-II superlattice photodetectors.