Junliang Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Junliang Zhang has a total of 96 co-authors. Here are the top co-authors by number of shared publications:
- Changqing Jin
Beijing National Laboratory for Condensed Matter Physics, Institute of Physics, Chinese Academy of Sciences, Beijing, PR China
6 shared publications Jiancheng Yu
4 shared publicationsChenlu Wang
Zhejiang Engineering Research Center of Advanced Mass spectrometry and Clinical Application
3 shared publications- Hongming Weng
Institute of Physics, Chinese Academy of Sciences
3 shared publications J. Zhu
Institute of Physics, Chinese Academy of Sciences, Beijing, China
3 shared publications- Keqi Tang
Zhejiang Engineering Research Center of Advanced Mass Spectrometry and Clinical Application. Institute of Mass Spectrometry, School of Materials Science & Chemical Engineering, Ningbo University, Ningbo, Zhejiang 315211, China
3 shared publications
Latest Publications
- 8 July 2025
- Published by Elsevier in International Journal of Mass Spectrometry
- Vol. 516
Experimental studies on low-pressure air dielectric barrier discharge plasma for ionization source
- 8 July 2025
- Published by Elsevier in International Journal of Mass Spectrometry
- Vol. 516
Experimental studies on low-pressure air dielectric barrier discharge plasma for ionization source
- 26 July 2024
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 7 (15) , 17329-17338
Methylamine Gas Sensor Based on Fluorescent Perovskite Nanocrystal Nanofibers Incorporating Aggregation-Induced Emission Materials
- 26 July 2024
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 7 (15) , 17329-17338
Methylamine Gas Sensor Based on Fluorescent Perovskite Nanocrystal Nanofibers Incorporating Aggregation-Induced Emission Materials
- 4 March 2024
- Published by Taylor & Francis in Analytical Letters
- Vol. 58 (4) , 543-554
Characterization of the Conversion of Benzene to Nitrosobenzene in a Helium Low-Temperature Plasma
Benzene, recognized as a highly volatile organic compound (VOC) and the simplest aromatic (Patros, Mann, and Jarrold 2016), is acknowledged by the International Health Organization as a potent carc...
- 4 March 2024
- Published by Taylor & Francis in Analytical Letters
- Vol. 58 (4) , 543-554
Characterization of the Conversion of Benzene to Nitrosobenzene in a Helium Low-Temperature Plasma
Benzene, recognized as a highly volatile organic compound (VOC) and the simplest aromatic (Patros, Mann, and Jarrold 2016), is acknowledged by the International Health Organization as a potent carc...
- 9 April 2021
- Published by Wiley in Rapid Communications in Mass Spectrometry
- Vol. 35 (12) , e9099
Hollow electrode capillary plasma ionization source for rapid online detection of gaseous samples
RATIONALE: Gas chromatography mass spectrometry (GC‐MS) with electron ionization (EI) is the most widely used analysis technique of gaseous samples, but it may be time‐consuming for online monitoring of mixtures whose concentrations relatively change rapidly. On the contrary, current ionization methods, such as chemical ionization (CI) and proton transfer reaction (PTR), also have some disadvantages such as selectivity. Therefore, appropriate soft ionization sources are searched for rapid online detection. METHODS: Hollow electrode capillary plasma ionization (HECPI) is based on single electrode plasma. A hollow capillary was placed as both the electrode and the inlet of the gaseous samples. The ionization source is coupled with a mass spectrometer for performance evaluation. RESULTS: Several typical compounds have been tested with HECPI‐mass spectrometer. In this process, the dominant ion peaks of all compounds can be indexed as molecular ion peaks, and the product ions of HECPI are less than that of dielectric barrier discharge ionization (DBDI). Three gaseous samples (linalool, triethylamine, and styrene) with various concentrations have been used to further confirm the performance of this source, and the detection limit of linalool is as low as 10 ppb. CONCLUSIONS: HECPI is simple in structure and shows good performance. The results also show that HECPI has the potential to be an effective tool for detecting online gaseous samples rapidly.
- 9 April 2021
- Published by Wiley in Rapid Communications in Mass Spectrometry
- Vol. 35 (12) , e9099
Hollow electrode capillary plasma ionization source for rapid online detection of gaseous samples
RATIONALE: Gas chromatography mass spectrometry (GC‐MS) with electron ionization (EI) is the most widely used analysis technique of gaseous samples, but it may be time‐consuming for online monitoring of mixtures whose concentrations relatively change rapidly. On the contrary, current ionization methods, such as chemical ionization (CI) and proton transfer reaction (PTR), also have some disadvantages such as selectivity. Therefore, appropriate soft ionization sources are searched for rapid online detection. METHODS: Hollow electrode capillary plasma ionization (HECPI) is based on single electrode plasma. A hollow capillary was placed as both the electrode and the inlet of the gaseous samples. The ionization source is coupled with a mass spectrometer for performance evaluation. RESULTS: Several typical compounds have been tested with HECPI‐mass spectrometer. In this process, the dominant ion peaks of all compounds can be indexed as molecular ion peaks, and the product ions of HECPI are less than that of dielectric barrier discharge ionization (DBDI). Three gaseous samples (linalool, triethylamine, and styrene) with various concentrations have been used to further confirm the performance of this source, and the detection limit of linalool is as low as 10 ppb. CONCLUSIONS: HECPI is simple in structure and shows good performance. The results also show that HECPI has the potential to be an effective tool for detecting online gaseous samples rapidly.
- 1 October 2020
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 146 (1) , 124-131
On a separation voltage polarity switching transient capillary isotachophoresis method for higher sample loading capacity and better separation performance
Mechanism of a PS-tCITP method with higher sample loading capacity and better separation performance.
- 1 October 2020
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 146 (1) , 124-131
On a separation voltage polarity switching transient capillary isotachophoresis method for higher sample loading capacity and better separation performance
Mechanism of a PS-tCITP method with higher sample loading capacity and better separation performance.
- 27 March 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 123 (12)
Pressure induced electronic phase transitions and superconductivity in n-type Bi2Te3
Temperature dependent-electrical resistance of n-type Bi2Te3 was investigated under high pressure. Superconductivity was detected at 4.9 GPa with Tconset = 2.8 K. Resistance and Tc suggest that there are two electronic phase transitions below 10 GPa. We conjecture that the bulk insulating phase first changes to semimetal and then to metal. The evolution of the Hall coefficient is qualitatively consistent with the proposed electronic phase transition. The origin of superconductivity and topological properties are also discussed.
- 27 March 2018
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 123 (12)
Pressure induced electronic phase transitions and superconductivity in n-type Bi2Te3
Temperature dependent-electrical resistance of n-type Bi2Te3 was investigated under high pressure. Superconductivity was detected at 4.9 GPa with Tconset = 2.8 K. Resistance and Tc suggest that there are two electronic phase transitions below 10 GPa. We conjecture that the bulk insulating phase first changes to semimetal and then to metal. The evolution of the Hall coefficient is qualitatively consistent with the proposed electronic phase transition. The origin of superconductivity and topological properties are also discussed.
- 15 October 2013
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 493, 75-76
Superconductivity in copper intercalated topological compound CuxBi2Te3 induced via high pressure
- 15 October 2013
- Published by Elsevier in Physica C: Superconductivity and its Applications
- Vol. 493, 75-76
Superconductivity in copper intercalated topological compound CuxBi2Te3 induced via high pressure
- Open Access
- 14 August 2013
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 25 (36) , 362204
Superconductivity of the topological insulator Bi2Se3at high pressure
The pressure-induced superconductivity and structural evolution of Bi2Se3 single crystals are studied. The emergence of superconductivity at an onset transition temperature (Tc) of about 4.4 K is observed at around 12 GPa. Tc increases rapidly to a maximum of 8.2 K at 17.2 GPa, decreases to around 6.5 K at 23 GPa, and then remains almost constant with further increases in pressure. Variations in Tc with respect to pressure are closely related to the carrier density, which increases by over two orders of magnitude from 2 to 23 GPa. High-pressure synchrotron radiation measurements reveal structural transitions at around 12, 20, and above 29 GPa. A phase diagram of superconductivity versus pressure is also constructed.
- 14 August 2013
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 25 (36) , 362204
Open AccessSuperconductivity of the topological insulator Bi2Se3at high pressure
The pressure-induced superconductivity and structural evolution of Bi2Se3 single crystals are studied. The emergence of superconductivity at an onset transition temperature (Tc) of about 4.4 K is observed at around 12 GPa. Tc increases rapidly to a maximum of 8.2 K at 17.2 GPa, decreases to around 6.5 K at 23 GPa, and then remains almost constant with further increases in pressure. Variations in Tc with respect to pressure are closely related to the carrier density, which increases by over two orders of magnitude from 2 to 23 GPa. High-pressure synchrotron radiation measurements reveal structural transitions at around 12, 20, and above 29 GPa. A phase diagram of superconductivity versus pressure is also constructed.
- Open Access
- 20 June 2013
- Published by Springer Nature in Scientific Reports
- Vol. 3 (1) , 2016
Superconductivity in Topological Insulator Sb2Te3 Induced by Pressure
Topological superconductivity is one of most fascinating properties of topological quantum matters that was theoretically proposed and can support Majorana Fermions at the edge state. Superconductivity was previously realized in a Cu-intercalated Bi2Se3 topological compound or a Bi2Te3 topological compound at high pressure. Here we report the discovery of superconductivity in the topological compound Sb2Te3 when pressure was applied. The crystal structure analysis results reveal that superconductivity at a low-pressure range occurs at the ambient phase. The Hall coefficient measurements indicate the change of p-type carriers at a low-pressure range within the ambient phase, into n-type at higher pressures, showing intimate relation to superconducting transition temperature. The first principle calculations based on experimental measurements of the crystal lattice show that Sb2Te3 retains its Dirac surface states within the low-pressure ambient phase where superconductivity was observed, which indicates a strong relationship between superconductivity and topology nature.
- 20 June 2013
- Published by Springer Nature in Scientific Reports
- Vol. 3 (1) , 2016
Open AccessSuperconductivity in Topological Insulator Sb2Te3 Induced by Pressure
Topological superconductivity is one of most fascinating properties of topological quantum matters that was theoretically proposed and can support Majorana Fermions at the edge state. Superconductivity was previously realized in a Cu-intercalated Bi2Se3 topological compound or a Bi2Te3 topological compound at high pressure. Here we report the discovery of superconductivity in the topological compound Sb2Te3 when pressure was applied. The crystal structure analysis results reveal that superconductivity at a low-pressure range occurs at the ambient phase. The Hall coefficient measurements indicate the change of p-type carriers at a low-pressure range within the ambient phase, into n-type at higher pressures, showing intimate relation to superconducting transition temperature. The first principle calculations based on experimental measurements of the crystal lattice show that Sb2Te3 retains its Dirac surface states within the low-pressure ambient phase where superconductivity was observed, which indicates a strong relationship between superconductivity and topology nature.