Ting Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ting Sun has a total of 120 co-authors. Here are the top co-authors by number of shared publications:
- Huey Hoon Hng
Emerging Nanoscience Research Institute (EnRI) Nanyang Technological University Singapore Singapore
23 shared publications Jan Ma
School of Material Science and Engineering, Nanyang Technological University, Nanyang Avenue, 639798, Singapore
12 shared publicationsQingyu Yan
School of Materials Science and Engineering, Nanyang Technological University, 50 Nanyang Ave, Singapore 637819, Singapore
11 shared publicationsJ. Ma
5 shared publications- Jixin Zhu
State Key Laboratory of Fire Science University of Science and Technology of China Hefei P. R. China
5 shared publications - Qingyu Yan
School of Materials Science and Engineering Nanyang Technological University Singapore Singapore
5 shared publications
Latest Publications
- 1 September 2014
- Published by Elsevier in Nano Energy
- Vol. 8, 223-230
Enhanced thermoelectric properties of n-type Bi2Te2.7Se0.3 thin films through the introduction of Pt nanoinclusions by pulsed laser deposition
- 1 September 2014
- Published by Elsevier in Nano Energy
- Vol. 8, 223-230
Enhanced thermoelectric properties of n-type Bi2Te2.7Se0.3 thin films through the introduction of Pt nanoinclusions by pulsed laser deposition
- 1 February 2014
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 587, 420-427
Facile precipitation of two phase alloys in SnTe0.75Se0.25 with improved power factor
- 1 February 2014
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 587, 420-427
Facile precipitation of two phase alloys in SnTe0.75Se0.25 with improved power factor
- 28 October 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (47) , 24964-24970
m-BiVO4@γ-Bi2O3 core–shell p–n heterogeneous nanostructure for enhanced visible-light photocatalytic performance
In this paper, γ-Bi2O3, considered as the best photocatalyst among all Bi2O3 polymorphs, was successfully prepared on the surface of m-BiVO4 octahedral crystals through an alkaline “etching” process. Extensive XRD, SEM and TEM characterization revealed the formation of a p–n junction in the form of m-BiVO4@γ-Bi2O3 core–shell heterostructure. In addition, the alkaline concentration and reaction time during the etching process were studied and found to be critical parameters in the formation and yield of the Bi2O3 phase. The visible-light photocatalytic activities of these heterogeneous samples with different γ-Bi2O3/m-BiVO4 phase ratios were evaluated for the degradation of Rhodamine B (RhB). The results indicated that with an optimum amount of γ-Bi2O3 on the m-BiVO4 surface, the powders showed superior photocatalytic performance over pure m-BiVO4 octahedral crystals. The enhancement mechanisms were discussed based on the specific surface area and γ-Bi2O3 shell thickness, as well as the influences of improved charge carrier transfer on the p–n heterostructure.
- 28 October 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (47) , 24964-24970
m-BiVO4@γ-Bi2O3 core–shell p–n heterogeneous nanostructure for enhanced visible-light photocatalytic performance
In this paper, γ-Bi2O3, considered as the best photocatalyst among all Bi2O3 polymorphs, was successfully prepared on the surface of m-BiVO4 octahedral crystals through an alkaline “etching” process. Extensive XRD, SEM and TEM characterization revealed the formation of a p–n junction in the form of m-BiVO4@γ-Bi2O3 core–shell heterostructure. In addition, the alkaline concentration and reaction time during the etching process were studied and found to be critical parameters in the formation and yield of the Bi2O3 phase. The visible-light photocatalytic activities of these heterogeneous samples with different γ-Bi2O3/m-BiVO4 phase ratios were evaluated for the degradation of Rhodamine B (RhB). The results indicated that with an optimum amount of γ-Bi2O3 on the m-BiVO4 surface, the powders showed superior photocatalytic performance over pure m-BiVO4 octahedral crystals. The enhancement mechanisms were discussed based on the specific surface area and γ-Bi2O3 shell thickness, as well as the influences of improved charge carrier transfer on the p–n heterostructure.
- 5 August 2013
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 1 (39) , 6271-6277
Aqueous solution synthesis of (Sb, Bi)2(Te, Se)3 nanocrystals with controllable composition and morphology
The introduction of nanostructures has been considered as one of the promising strategies to enhance the thermoelectric performance of bulk materials. In this work, we report a low-cost and facile aqueous solution method to prepare (Sb, Bi)2(Te, Se)3 nanocrystals with controllable composition and morphology by using short ligands containing thiol, acid and amine groups. The control of the morphology of the nanostructures such as nanowires and nanosheets is studied, and both n-type and p-type nanoparticles have been prepared successfully. The results show that the thermal conductivities of these nanocrystals are effectively reduced due to phonon scattering and the thermoelectric performance is affected greatly by the morphology. TE measurements show that the electrical conductivity can be enhanced significantly by using Bi2Te3 nanosheets, and as a result, a maximum thermoelectric figure-of-merit (ZT) of 0.86 is obtained for Bi2Te3 nanosheets at 225 °C.
- 5 August 2013
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 1 (39) , 6271-6277
Aqueous solution synthesis of (Sb, Bi)2(Te, Se)3 nanocrystals with controllable composition and morphology
The introduction of nanostructures has been considered as one of the promising strategies to enhance the thermoelectric performance of bulk materials. In this work, we report a low-cost and facile aqueous solution method to prepare (Sb, Bi)2(Te, Se)3 nanocrystals with controllable composition and morphology by using short ligands containing thiol, acid and amine groups. The control of the morphology of the nanostructures such as nanowires and nanosheets is studied, and both n-type and p-type nanoparticles have been prepared successfully. The results show that the thermal conductivities of these nanocrystals are effectively reduced due to phonon scattering and the thermoelectric performance is affected greatly by the morphology. TE measurements show that the electrical conductivity can be enhanced significantly by using Bi2Te3 nanosheets, and as a result, a maximum thermoelectric figure-of-merit (ZT) of 0.86 is obtained for Bi2Te3 nanosheets at 225 °C.
- 8 January 2013
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 6 (3) , 987-993
Hierarchical hollow spheres composed of ultrathin Fe2O3 nanosheets for lithium storage and photocatalytic water oxidation
Hollow hierarchical spheres self-organized from the ultrathin nanosheets of α-Fe2O3 were prepared by a simple process. These ultrathin nanosheet subunits possess an average thickness of around 3.5 nm and show preferential exposure of (110) facets. Their Li ion storage and visible-light photocatalytic water oxidation performance are tested. Such hierarchical nanostructures show high Li storage properties with good cycling stability and excellent rate capabilities. The water oxidation catalytic activity is 70 μmol h−1 g−1 for O2 evolution under visible light irradiation and can be maintained for 15 hours. The structural features of these α-Fe2O3 nanocrystals are considered to be important to lead to the attractive properties in both Li storage and photocatalytic water oxidation, e.g. hollow interior, ultrathin thickness and largely exposed active facets.
- 8 January 2013
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 6 (3) , 987-993
Hierarchical hollow spheres composed of ultrathin Fe2O3 nanosheets for lithium storage and photocatalytic water oxidation
Hollow hierarchical spheres self-organized from the ultrathin nanosheets of α-Fe2O3 were prepared by a simple process. These ultrathin nanosheet subunits possess an average thickness of around 3.5 nm and show preferential exposure of (110) facets. Their Li ion storage and visible-light photocatalytic water oxidation performance are tested. Such hierarchical nanostructures show high Li storage properties with good cycling stability and excellent rate capabilities. The water oxidation catalytic activity is 70 μmol h−1 g−1 for O2 evolution under visible light irradiation and can be maintained for 15 hours. The structural features of these α-Fe2O3 nanocrystals are considered to be important to lead to the attractive properties in both Li storage and photocatalytic water oxidation, e.g. hollow interior, ultrathin thickness and largely exposed active facets.
- 1 January 2013
- Published by Elsevier in Nano Energy
- Vol. 2 (1) , 4-11
Facile synthesis of Cu7Te4 nanorods and the enhanced thermoelectric properties of Cu7Te4–Bi0.4Sb1.6Te3 nanocomposites
- 1 January 2013
- Published by Elsevier in Nano Energy
- Vol. 2 (1) , 4-11
Facile synthesis of Cu7Te4 nanorods and the enhanced thermoelectric properties of Cu7Te4–Bi0.4Sb1.6Te3 nanocomposites
- 1 January 2013
- Published by Elsevier in Journal of Crystal Growth
- Vol. 362, 52-57
Crystallization kinetics and characterization of nanosized Nd:YAG by a modified sol–gel combustion process
- 1 January 2013
- Published by Elsevier in Journal of Crystal Growth
- Vol. 362, 52-57
Crystallization kinetics and characterization of nanosized Nd:YAG by a modified sol–gel combustion process
- 4 October 2012
- Published by IOP Publishing in Nanotechnology
- Vol. 23 (42) , 425502
A carbon monoxide gas sensor using oxygen plasma modified carbon nanotubes
Carbon monoxide (CO) is a highly toxic gas that can be commonly found in many places. However, it is not easily detected by human olfaction due to its colorless and odorless nature. Therefore, highly sensitive sensors need to be developed for this purpose. Carbon nanotubes (CNTs) have an immense potential in gas sensing. However, CNT-based gas sensors for sensing CO are seldom reported due to the lack of reactivity between CO and CNTs. In this work, O(2) plasma modified CNT was used to fabricate a CNT gas sensor. The plasma treated CNTs showed selectively towards CO, with the capability of sensing low concentrations of CO (5 ppm) at room temperature, while the pristine CNTs showed no response. UV spectra and oxygen reduction reaction provided evidence that the difference in sensing property was due to the elimination of metallic CNTs and enhancement of the oxygen reduction property.
- 4 October 2012
- Published by IOP Publishing in Nanotechnology
- Vol. 23 (42) , 425502
A carbon monoxide gas sensor using oxygen plasma modified carbon nanotubes
Carbon monoxide (CO) is a highly toxic gas that can be commonly found in many places. However, it is not easily detected by human olfaction due to its colorless and odorless nature. Therefore, highly sensitive sensors need to be developed for this purpose. Carbon nanotubes (CNTs) have an immense potential in gas sensing. However, CNT-based gas sensors for sensing CO are seldom reported due to the lack of reactivity between CO and CNTs. In this work, O(2) plasma modified CNT was used to fabricate a CNT gas sensor. The plasma treated CNTs showed selectively towards CO, with the capability of sensing low concentrations of CO (5 ppm) at room temperature, while the pristine CNTs showed no response. UV spectra and oxygen reduction reaction provided evidence that the difference in sensing property was due to the elimination of metallic CNTs and enhancement of the oxygen reduction property.
- 9 August 2012
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 51 (36) , 9052-9056
An Effective Method for the Fabrication of Few‐Layer‐Thick Inorganic Nanosheets
Intercalation and exfoliation of lithium: Few-layer-thick inorganic nanosheets (BN, NbSe2, WSe2, Sb2Se3, and Bi2Te3) have been prepared from their layered bulk precursors by using a controllable electrochemical lithium intercalation process (see picture). The lithium intercalation conditions, such as cut-off voltage and discharge current, have been systematically studied and optimized to produce high-quality BN and NbSe2 nanosheets.
- 9 August 2012
- Published by Wiley in Angewandte Chemie International Edition
- Vol. 51 (36) , 9052-9056
An Effective Method for the Fabrication of Few‐Layer‐Thick Inorganic Nanosheets
Intercalation and exfoliation of lithium: Few-layer-thick inorganic nanosheets (BN, NbSe2, WSe2, Sb2Se3, and Bi2Te3) have been prepared from their layered bulk precursors by using a controllable electrochemical lithium intercalation process (see picture). The lithium intercalation conditions, such as cut-off voltage and discharge current, have been systematically studied and optimized to produce high-quality BN and NbSe2 nanosheets.
- 26 May 2012
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 41 (8) , 2305
Erratum to: Effects of Pulsed Laser Deposition Conditions on the Microstructure of Ca3Co4O9 Thin Films
- 26 May 2012
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 41 (8) , 2305
Erratum to: Effects of Pulsed Laser Deposition Conditions on the Microstructure of Ca3Co4O9 Thin Films