Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Nagib Qarah has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    SIMPLE AND SENSITIVE SPECTROPHOTOMETRIC ASSAYS FOR THE DETERMINATION OF TERBINAFINE HCL ANTIFUNGAL DRUG IN PHARMACEUTICALS

    by Nagib Qarah, Ezzouhra El-Maaıden, Kanakapura Basavaiah

    Objective: Two highly sensitive, accurate, inexpensive, and simple spectrophotometric assays were developed and validated for the determination of an anti-fungal drug, Terbinafine HCl (TBH), in pure drug and tablets using potassium permanganate (PP) and disodium 2-(1,3-dioxo-2,3-dihydro-1H-inden-2-yl)quinoline-6,8-disulfonate (DSOQ). Material and Method: In the present study, Sebifin and Terbiforce 250 mg tablets were used as pharmaceuticals, potassium permanganate KMnO4 and disodium 2-(1,3-dioxo-2,3-dihydro-1H-inden-2-yl)quinoline-6,8-disulfonate in water were used as reagents, and DR 3900 spectrophotometer equipped with 1cm matched quartz cells was used for absorbance measurements. Result and Discussion: The amount of terbinafine hydrochloride reacting with permanganate and disodium 2-(1,3-dioxo-2,3-dihydro-1H-inden-2-yl)quinoline-6,8-disulfonate in an acidic medium has been determined. The colored reaction products in both cases were measured at the maximum absorptions of 540 nm and 440 nm, respectively. The absorbance measured in each assay as a function of TBH concentration was related to TBH concentrations. Different experimental and variable conditions of assays were done carefully, accurately studied, and optimized. The validation of two assays also was done by following the current guidelines of the International Conference on Harmonization (ICH). Beer’s law for the two methods is obeyed over the concentration ranges 1-15 µg/ml (Correlation coefficient = 0.9983) and 1-18 µg/ml (Correlation coefficient = 0.9989) for methods PP and DSOQ, respectively. Molar absorptivity, limits of detection, and quantification (LOD & LOQ) values were (1.38×104 l/ mol cm, 0.92 & 2.78 µg/ml) for PP assay, and (1.73×104 l/ mol cm, 0.09 & 0.27 µg/ml) for DSOQ assay, respectively. The two assays were successfully applied for the determination of TBH in commercial tablets with reliable and satisfactory results, and hence the proposed assays can be applied in pharmaceutical laboratories of quality control.


  • Open Access

    Spectrophotometric/Titrimetric Drug Analysis

    by Nagib Qarah, Ezzouhra El-Maaiden

    The importance of pharmaceuticals comes from their direct connection to human life. Therefore, many analysis techniques such as chromatography, spectroscopic methods, and others have been developed for one goal, which is to ensure that the drug reaches humans with high quality. Spectrophotometric and titrimetric methods have been in general use for the last 40 years and over this period have become the most important analytical instrument in the modern-day laboratory. In many applications, other techniques could be employed in pharmaceutical analysis, but none rival UV–visible spectrometry as well as titrimetry, for their simplicity, versatility, speed, accuracy, and cost-effectiveness. This chapter highlights the spectroscopic methods in the ultraviolet and visible regions, as well as the titration methods that are still widely used in the field of pharmaceutical analysis. The types of titrations, as well as the most important reactions used in spectrophotometric methods, are presented. Examples of the most important applications in the field of pharmaceutical analysis are also presented.


  • Open Access

    Ultrasound-Assisted Extraction of Isoquercetin from Ephedra alata (Decne): Optimization Using Response Surface Methodology and In Vitro Bioactivities

    by Ezzouhra El Maaiden, Nagib Qarah, Amine Ezzariai, Adil Mazar, Boubker Nasser, Khadija Moustaid, Hassan Boukcim, Abdelaziz Hirich, Lamfeddal Kouisni, Youssef El Kharrassi

    Isoquercetin (ISQ) is reported to be a powerful antioxidant with extremely high bioavailability and structural stability compared to aglycone quercetin. Despite this, it is not well studied due to the limited methods for its extraction. With the growing interest in the research and analysis of ISQ-rich herbs, there is a need to optimize an efficient and rapid method for their extraction. In the present study, the ultrasound-assisted extraction of ISQ from Ephedra alata Decne was optimized by a response surface methodology (RSM) using high-performance liquid chromatography as a separation method. The best possible ranges for extraction time (10–30 min), temperature (50–70 °C), ultrasonic power (60–90 W), solvent-to-solid ratio (50–70 mL/g), and ethanol concentration (50–70%) were determined using a single factor analysis. Subsequently, an optimization of the extraction conditions was performed with RSM using the Box–Behnken design. An ultrasonication time of 10 min, a temperature of 60 °C, a power of 75 W, a solvent-to-solid ratio of 60 mL/g, and an ethanol concentration of 70% were determined to be the optimal conditions for the highest recovery of isoquercetin (1033.96 ± 3.28 µg/g). Furthermore, E. alata powder morphology (using a scanning electron microscope), antioxidant activities, and the inhibition potential of key enzymes involved in skin aging (elastase and collagenase), hyperpigmentation (tyrosinase), diabetes (α-amylase), inflammation (hyaluronidase), and neurodegenerative disorders (cholinesterase) were determined and compared with those using the Soxhlet method. This study established a highly efficient method for ISQ extraction and suggested several potential applications of ISQ in the pharmaceutical and cosmetics industries.


  • Open Access

    Application of redox reactions for the determination of valganciclovir hydrochloride in pharmaceuticals

    by Nagib Abdullah Salem Qarah, Kanakapura Basavaiah, Sameer Abdulaziz Mohammed Abdulrahman

    Two simple, selective and sensitive spectrophotometric methods were developed and validated for the determination of valganciclovir hydrochloride (VLGH) in pure drug and tablets. The first method was based on the reduction of iron(III) to iron(II) by VLGH and subsequent formation of iron(III)-ferricyanide complex (Prussian blue) in acid medium which was measured at 730 nm (method A). In the second method (method B), permanganate was reduced by VLGH to bluish green manganate in alkaline medium and the absorbance was measured at 610 nm. The absorbance measured in each case was related to VLGH concentration. The experimental conditions were carefully studied and optimized. Beer’s law was obeyed over the concentration ranges of 2.5-20.0 and 2.0-40.0 µg mL-1 for method A and method B, respectively, with corresponding molar absorptivity values of 1.28×104 and 6.88×103 L mol-1 cm-1. The limits of detection (LOD) and quantification (LOQ) were 0.11 and 0.33 µg mL-1 (method A) and 0.21 and 0.64 µg mL-1 (method B). Within-day and between-day relative standard deviations (%RSD) at three different concentrations levels were < 2.4%, and the respective relative errors (%RE) were ≤ 3%. The proposed methods were successfully applied to the determination of VLGH in tablets, and the results confirmed that the proposed methods were equally precise and accurate as the official method.


  • Open Access

    Application of Cerium (IV) as an Oxidimetric Agent for the Determination of Ethionamide in Pharmaceutical Formulations

    by Kanakapura Basavaiah, Nagib A. S. Qarah, Sameer A. M. Abdulrahman

    Two simple methods are described for the determination of ethionamide (ETM) in bulk drug and tablets using cerium (IV) sulphate as the oxidimetric agent. In both methods, the sample solution is treated with a measured excess of cerium (IV) solution in H2SO4 medium, and after a fixed standing time, the residual oxidant is determined either by back titration with standard iron (II) solution to a ferroin end point in titrimetry or by reacting with o-dianisidine followed by measurement of the absorbance of the orange-red coloured product at 470 nm in spectrophotometry. In titrimetry, the reaction proceeded with a stoichiometry of 1 : 2 (ETM : Ce (IV)) and the amount of cerium (IV) consumed by ETM was related to the latter’s amount, and the method was applicable over 1.0–8.0 mg of drug. In spectrophotometry, Beer’s law was obeyed over the concentration range of 0.5–5.0 μg/mL ETM with a molar absorptivity value of 2.66 × 104 L/(mol·cm). The limits of detection (LOD) and quantification (LOQ) calculated according to ICH guidelines were 0.013 and 0.043 μg/mL, respectively. The proposed titrimetric and spectrophotometric methods were found to yield reliable results when applied to bulk drug and tablets analysis, and hence they can be applied in quality control laboratories.