Deb Dulal Tripura
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Deb Dulal Tripura has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Konjengbam Darunkumar Singh
Indian Institute of Technology Guwahati
4 shared publications - Satya Sai Deep Raavi
Department of Civil Engineering, National Institute of Technology Agartala, Tripura, India
2 shared publications - Shashank Chandra
Department of Civil Engineering, National Institute of Technology Agartala, Agartala, India
2 shared publications - Jagdish Lohar
Malaviya National Institute of Technology
1 shared publication Pardhasaradhi Kasinikota
1 shared publication- Richi Prasad Sharma
Department of Civil Engineering, National Institute of Technology Agartala, Agartala, India
1 shared publication
Latest Publications
- 12 May 2023
- Published by Elsevier in Structures
- Vol. 53, 1389-1401
Compressive and shear behavior of cement stabilized rammed earth wallettes reinforced with coir, bamboo splints and steel bars
- 12 May 2023
- Published by Elsevier in Structures
- Vol. 53, 1389-1401
Compressive and shear behavior of cement stabilized rammed earth wallettes reinforced with coir, bamboo splints and steel bars
- 11 February 2022
- Published by Springer Nature in Materials and Structures
- Vol. 55 (2) , 1-18
Evaluating the flexural strength and failure patterns of cement stabilized rammed earth wallettes reinforced with coir, bamboo and steel
- 11 February 2022
- Published by Springer Nature in Materials and Structures
- Vol. 55 (2) , 1-18
Evaluating the flexural strength and failure patterns of cement stabilized rammed earth wallettes reinforced with coir, bamboo and steel
- Open Access
- 30 December 2018
- Published by Editorial CSIC in Materiales de Construcción
- Vol. 68 (332) , e174
Mechanical behaviour of rammed earth column: A comparison between unreinforced, steel and bamboo reinforced columns
This paper presents an experimental study on the behavior of cement stabilized rammed earth (CSRE) column reinforced with steel under axial loading and its comparison with unreinforced and bamboo reinforced columns. Effects of structural parameters such as tie / stirrup spacing on the failure pattern, lateral and axial deformation of columns are studied. Test results show that the load-capacity of columns increases with increase in lateral / tie reinforcement ratio. Maximum axial and lateral deformations occur in columns with least tie spacing. Behavior of CSRE columns reinforced with close tie spacing is characterized by gradual spalling of cover at the failure zone. Steel reinforced columns perform better than other column types in terms of load-capacity; hence it may be used as structural member adjacent to walls for low-rise rammed earth houses. Proposed reinforcement technique can be adopted in the field for enhancement of greater strength and performance of columns.
- 30 December 2018
- Published by Editorial CSIC in Materiales de Construcción
- Vol. 68 (332) , e174
Open AccessMechanical behaviour of rammed earth column: A comparison between unreinforced, steel and bamboo reinforced columns
This paper presents an experimental study on the behavior of cement stabilized rammed earth (CSRE) column reinforced with steel under axial loading and its comparison with unreinforced and bamboo reinforced columns. Effects of structural parameters such as tie / stirrup spacing on the failure pattern, lateral and axial deformation of columns are studied. Test results show that the load-capacity of columns increases with increase in lateral / tie reinforcement ratio. Maximum axial and lateral deformations occur in columns with least tie spacing. Behavior of CSRE columns reinforced with close tie spacing is characterized by gradual spalling of cover at the failure zone. Steel reinforced columns perform better than other column types in terms of load-capacity; hence it may be used as structural member adjacent to walls for low-rise rammed earth houses. Proposed reinforcement technique can be adopted in the field for enhancement of greater strength and performance of columns.
- 3 December 2018
- Published by Taylor & Francis in Structural Engineering International
- Vol. 29 (1) , 133-143
Axial Load-Capacity of Bamboo-Steel Reinforced Cement Stabilised Rammed Earth Columns
This paper presents a novel experimental study of the capacity of cement stabilised rammed earth (CSRE) columns reinforced with bamboo and steel under concentric axial loading. Effects of percent lateral reinforcement on the failure pattern, load-axial deformation and load-lateral deformation of columns are studied. Results show that the reinforcement significantly increases the load-capacity of columns, i.e. the higher the reinforcement ratio, the higher the load-capacity. The behaviour of columns reinforced with close tie spacing is characterised by gradual spalling of cover at the failure zone leading to a loss of axial capacity before the lateral confinement becomes effective. Unlike high-strength concrete columns confined by rectangular ties, the load-capacity of columns at ultimate peak load (second peak) did not fall below the value of first peak. On the other hand, specimens with low confinement did not d the second peak. In the end, bamboo can be a substitute for steel to some extent in the construction of low-rise reinforced rammed earth structures.
- 3 December 2018
- Published by Taylor & Francis in Structural Engineering International
- Vol. 29 (1) , 133-143
Axial Load-Capacity of Bamboo-Steel Reinforced Cement Stabilised Rammed Earth Columns
This paper presents a novel experimental study of the capacity of cement stabilised rammed earth (CSRE) columns reinforced with bamboo and steel under concentric axial loading. Effects of percent lateral reinforcement on the failure pattern, load-axial deformation and load-lateral deformation of columns are studied. Results show that the reinforcement significantly increases the load-capacity of columns, i.e. the higher the reinforcement ratio, the higher the load-capacity. The behaviour of columns reinforced with close tie spacing is characterised by gradual spalling of cover at the failure zone leading to a loss of axial capacity before the lateral confinement becomes effective. Unlike high-strength concrete columns confined by rectangular ties, the load-capacity of columns at ultimate peak load (second peak) did not fall below the value of first peak. On the other hand, specimens with low confinement did not d the second peak. In the end, bamboo can be a substitute for steel to some extent in the construction of low-rise reinforced rammed earth structures.
- 1 January 2018
- Published by American Concrete Institute
- Vol. 326, 37.1-37.10
Suitability of Recycled Aggregate as a Replacement for Natural Aggregate in Construction
- 1 January 2018
- Published by American Concrete Institute
- Vol. 326, 37.1-37.10
Suitability of Recycled Aggregate as a Replacement for Natural Aggregate in Construction
- 6 April 2017
- Published by American Society of Civil Engineers (ASCE)
- p. 336-348
Shape and Size Effects on the Compressive Strength of Cement Stabilised Rammed Earth
This paper deals with the shape and size effects of cement stabilized rammed earth (CSRE) samples subjected to axial loading. In this study, cubes of sizes 100 mm and 150 mm, and cylinders of sizes 75 x 150 mm, 100 x 200 mm, 130 x 260 mm, and 150 x 300 mm were prepared and tested. The effect of size with varying cement content from 10 to 20% was also assessed. Result shows that the compressive strength of cube is more than that of cylinder. The strength of 100 x 200 mm cylinder is approximately 0.80 times that of 150 mm cube, whereas the strength of 150 x 300 mm cylinder of size is approximately 0.60 times. The crack pattern is sensitive to the shape of the sample. The shear/ columnar cracking are observed in case of cylinders, while hour-glass failure type crack is observed in cubes. The post-peak behaviour of the cubes is milder than that of the cylinders, which results in strong energy consumption after the peak. The pre-peak and post-peak behaviours in the stress-strain curves are dependent on the specimen size and shape. Large specimens resist less in terms of stress than the small ones. The size effect in the cubes is quite stronger than in cylinders, where the average strength obtained is roughly constant within the size interval planned for this research. The effect of moisture content on strength is prevalent as the strength decreases with the increase in moisture content of the specimen during testing.
- 6 April 2017
- Published by American Society of Civil Engineers (ASCE)
- p. 336-348
Shape and Size Effects on the Compressive Strength of Cement Stabilised Rammed Earth
This paper deals with the shape and size effects of cement stabilized rammed earth (CSRE) samples subjected to axial loading. In this study, cubes of sizes 100 mm and 150 mm, and cylinders of sizes 75 x 150 mm, 100 x 200 mm, 130 x 260 mm, and 150 x 300 mm were prepared and tested. The effect of size with varying cement content from 10 to 20% was also assessed. Result shows that the compressive strength of cube is more than that of cylinder. The strength of 100 x 200 mm cylinder is approximately 0.80 times that of 150 mm cube, whereas the strength of 150 x 300 mm cylinder of size is approximately 0.60 times. The crack pattern is sensitive to the shape of the sample. The shear/ columnar cracking are observed in case of cylinders, while hour-glass failure type crack is observed in cubes. The post-peak behaviour of the cubes is milder than that of the cylinders, which results in strong energy consumption after the peak. The pre-peak and post-peak behaviours in the stress-strain curves are dependent on the specimen size and shape. Large specimens resist less in terms of stress than the small ones. The size effect in the cubes is quite stronger than in cylinders, where the average strength obtained is roughly constant within the size interval planned for this research. The effect of moisture content on strength is prevalent as the strength decreases with the increase in moisture content of the specimen during testing.
- 1 January 2015
- Published by Springer Nature
- p. 2459-2469
Structural Behavior of Rectangular Cement-Stabilized Rammed Earth Column Under Compression
- 1 January 2015
- Published by Springer Nature
- p. 2459-2469
Structural Behavior of Rectangular Cement-Stabilized Rammed Earth Column Under Compression