Shilei Han
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Shilei Han has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Olivier A. Bauchau
15 shared publications- Olivier A. Bauchau
University of Michigan-Shanghai Jiao Tong University Joint Institute
8 shared publications - Olivier A. Bauchau
University of Maryland, College Park, USA
6 shared publications Qiang Tian
4 shared publications- Aki Mikkola
Lappeenranta University of Technology
3 shared publications Marko K. Matikainen
Lappeenranta University of Technology
2 shared publications
Latest Publications
- 12 December 2025
- Published by Elsevier in Computer Methods in Applied Mechanics and Engineering
- Vol. 450
Invariant-manifold-based model reduction for geometrically exact beam dynamics
- 12 December 2025
- Published by Elsevier in Computer Methods in Applied Mechanics and Engineering
- Vol. 450
Invariant-manifold-based model reduction for geometrically exact beam dynamics
- 31 July 2025
- Published by Elsevier in Computer Methods in Applied Mechanics and Engineering
- Vol. 446
Center manifold reduction of geometrically nonlinear beams: From 3D to 1D models
- 31 July 2025
- Published by Elsevier in Computer Methods in Applied Mechanics and Engineering
- Vol. 446
Center manifold reduction of geometrically nonlinear beams: From 3D to 1D models
- 2 July 2025
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 113 (20) , 27459-27482
Identification of friction in joints for multibody dynamics: a Neural-DAE based approach
- 2 July 2025
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 113 (20) , 27459-27482
Identification of friction in joints for multibody dynamics: a Neural-DAE based approach
- Open Access
- 22 February 2024
- Published by Wiley in Journal of Applied Mechanics
- Vol. 91 (6) , 1-2
Erratum: “On the Analysis of Periodically Heterogenous Beams” [ASME J. Appl. Mech., 2016, 83(9), p. 091001; DOI: 10.1115/1.4033721]
- 22 February 2024
- Published by Wiley in Journal of Applied Mechanics
- Vol. 91 (6) , 1-2
Open AccessErratum: “On the Analysis of Periodically Heterogenous Beams” [ASME J. Appl. Mech., 2016, 83(9), p. 091001; DOI: 10.1115/1.4033721]
- 12 December 2022
- Published by Springer Nature in Multibody System Dynamics
- Vol. 58 (3-4) , 275-298
Configurational forces in variable-length beams for flexible multibody dynamics
- 12 December 2022
- Published by Springer Nature in Multibody System Dynamics
- Vol. 58 (3-4) , 275-298
Configurational forces in variable-length beams for flexible multibody dynamics
- Open Access
- 15 September 2022
- Published by Springer Nature in Research Square
Configurational Forces in Variable-Length Beams for Flexible Multibody Dynamics
This paper addresses the problem of sliding beams or beams with sliding appendages, with special emphasis on situations where the axial motion of the beam or appendage is not prescribed a priori. Hamilton’s varia-tional principle is used to derive the weak and strong forms of governing equations based on the systematic use of Reynolds’ transport theorem. The strong form of the governing equations involve the mechanical and configurational momentum equations, together with the proper boundary conditions. It is shown that the configurational momentum equations are linear combinations of their mechanical counterparts and hence, are redundant. A weak form of the same equations is also developed; the configurational and mechanical momentum equations become independent because they combine in an integral form the strong mechanical and configurational momentum equations with their respective natural boundary conditions. The domain-and boundary-based formulations, stemming from these two forms of the governing equations, are proposed and numerical examples are presented to contrast their relative performances. The predictions of both formulations are found to be in good agreement with those obtained from an ABAQUS model using contact pairs. The domain-based formulation presents a higher convergence rate than the boundary-based formulation. Clearly, the proper treatment of the configurational forces impacts the accuracy of the model significantly.
- 15 September 2022
- Published by Springer Nature in Research Square
Open AccessConfigurational Forces in Variable-Length Beams for Flexible Multibody Dynamics
This paper addresses the problem of sliding beams or beams with sliding appendages, with special emphasis on situations where the axial motion of the beam or appendage is not prescribed a priori. Hamilton’s varia-tional principle is used to derive the weak and strong forms of governing equations based on the systematic use of Reynolds’ transport theorem. The strong form of the governing equations involve the mechanical and configurational momentum equations, together with the proper boundary conditions. It is shown that the configurational momentum equations are linear combinations of their mechanical counterparts and hence, are redundant. A weak form of the same equations is also developed; the configurational and mechanical momentum equations become independent because they combine in an integral form the strong mechanical and configurational momentum equations with their respective natural boundary conditions. The domain-and boundary-based formulations, stemming from these two forms of the governing equations, are proposed and numerical examples are presented to contrast their relative performances. The predictions of both formulations are found to be in good agreement with those obtained from an ABAQUS model using contact pairs. The domain-based formulation presents a higher convergence rate than the boundary-based formulation. Clearly, the proper treatment of the configurational forces impacts the accuracy of the model significantly.