Ahmed Hichem Hamzaoui
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ahmed Hichem Hamzaoui has a total of 51 co-authors. Here are the top co-authors by number of shared publications:
- Hajer Said
Useful Materials Valorization Laboratory, National Centre for Research in Materials Science, Technological Park of Borj Cedria, B.P.73, Soliman 8027, Tunisia
2 shared publications - A. Messaâdi
Laboratoire de Chimie Analytique et Electrochimie, Département de Chimie, Faculté des Sciences de Tunis , Campus Universitaire , El Manar , 2092
1 shared publication - Abdeldjebar Touahri
Earth Sciences Department, Hydrocarbons and Renewable Energy College, Kasdi Merbah University, Ouargla, Algeria
1 shared publication - Abdelmoneim Mars
Water Researches and Technologies Center (CERTE)
1 shared publication Adel M'Nif
1 shared publication- Adel Mnif
Useful Materials Valorization Laboratory, National Centre for Research in Materials Science, Technological Park of Borj Cedria, B.P.73, Soliman 8027, Tunisia
1 shared publication
Latest Publications
- Open Access
- 30 September 2026
- Published by Union of Iraqi Geologists (UIG) in Iraqi Geological Journal
- p. 101-111
Carnallite Crystallization During Isothermal Evaporation of Chott Melghir Brine, Algeria
The characterization of the inland brine of the chott of Melghir, the largest chott in Algeria, was approached using isothermal evaporation experiments at 35°C. The ionic composition, density, and pH were monitored during evaporation. Five filtrations were performed for each increase of 2 g.cm–3 hundredths in density. The recovered solids were identified using X-ray Diffraction. The Jänecke solubility diagram of the quinary system Na+, K+, Mg2+, Cl–, SO42–/ H2O was used to first predict the foreseeable crystallization pathway and then to plot the experimental pathway based on the experimental results. To better understand the behavior of the brine under isothermal evaporation, the calculated pathway using the PHREEQC software with the Pitzer thermodynamic database was plotted. The crystallization sequences obtained are gypsum (traces) + halite, halite, halite + kainite (traces) + hexahedrite (traces), and finally halite + carnallite. This result agrees well with those of the Jänecke’s foreseeable, experimental, and calculated diagrams. The deviation is the absence of bloedite and the crystallization of hexahydrite instead of kieserite. It is well known that bloedite does not precipitate directly because it is a secondary mineral, and the relatively high relative humidity (50 to 60%) of the experiment explains the occurrence of hexahydrite rather than kieserite. Kieserite crystallizes at lower relative humidity.
- 30 September 2026
- Published by Union of Iraqi Geologists (UIG) in Iraqi Geological Journal
- p. 101-111
Open AccessCarnallite Crystallization During Isothermal Evaporation of Chott Melghir Brine, Algeria
The characterization of the inland brine of the chott of Melghir, the largest chott in Algeria, was approached using isothermal evaporation experiments at 35°C. The ionic composition, density, and pH were monitored during evaporation. Five filtrations were performed for each increase of 2 g.cm–3 hundredths in density. The recovered solids were identified using X-ray Diffraction. The Jänecke solubility diagram of the quinary system Na+, K+, Mg2+, Cl–, SO42–/ H2O was used to first predict the foreseeable crystallization pathway and then to plot the experimental pathway based on the experimental results. To better understand the behavior of the brine under isothermal evaporation, the calculated pathway using the PHREEQC software with the Pitzer thermodynamic database was plotted. The crystallization sequences obtained are gypsum (traces) + halite, halite, halite + kainite (traces) + hexahedrite (traces), and finally halite + carnallite. This result agrees well with those of the Jänecke’s foreseeable, experimental, and calculated diagrams. The deviation is the absence of bloedite and the crystallization of hexahydrite instead of kieserite. It is well known that bloedite does not precipitate directly because it is a secondary mineral, and the relatively high relative humidity (50 to 60%) of the experiment explains the occurrence of hexahydrite rather than kieserite. Kieserite crystallizes at lower relative humidity.
- 9 October 2025
- Published by Springer Nature in Ionics
- Vol. 31 (12) , 12885-12899
Enhancement of lithium extraction process from oilfield brine by response surface methodology: modelling and optimization
- 9 October 2025
- Published by Springer Nature in Ionics
- Vol. 31 (12) , 12885-12899
Enhancement of lithium extraction process from oilfield brine by response surface methodology: modelling and optimization
- 19 May 2023
- Published by Springer Nature in Silicon
- Vol. 15 (14) , 6257-6268
Surface Modification of Magnetite Using Silica Coating: Spectroscopic, Structural, Morphological Characterization and Interaction with Crystal Violet Dye
- 19 May 2023
- Published by Springer Nature in Silicon
- Vol. 15 (14) , 6257-6268
Surface Modification of Magnetite Using Silica Coating: Spectroscopic, Structural, Morphological Characterization and Interaction with Crystal Violet Dye
- Open Access
Robust Magnetic γ-Fe2O3/Al–ZnO Adsorbent for Chlorpyriphos Removal in Water
In this research, the removal of the pesticide chlorpyriphos (CPE) from water by adsorption using a novel adsorbent made of γ-Fe2O3/Al-ZnO nanocomposite was studied. The adsorbent was characterized using Fourier-transformed infrared spectroscopy (FTIR), Scanning electron microscopy (SEM), Brunauer-Emmett-Teller (BET) surface area, and vibrating sample magnetometry (VSM). The main parameters affecting the adsorption process, including the initial pH (2–12), the concentration of pesticide (10–70 ppm), the %Fe2O3 of the adsorbent, and the adsorption time (≤60 min), were studied. The results demonstrated that the adsorption of CPE depended on the pH, with a maximum removal of 92.3% achieved at around neutral pH. The adsorption isotherm was modelled and the results showed that the Freundlich model fitted the experimental data better than the Langmuir and Temkin models. The kinetics of adsorption were also studied and modelled using the pseudo-first-order and pseudo-second-order models, with the former being found more suitable. Energy dispersive X-ray (EDX) analysis confirmed the adsorption of CPE on γ-Fe2O3/Al-ZnO, while FTIR analysis suggested that the hydroxyl, N-pyridine, and chloro functional groups governed the adsorption mechanism. Furthermore, VSM analysis revealed that the magnetization saturation of γ-Fe2O3/Al-ZnO nanocomposite, after CPE adsorption, was slightly lower than that of fresh γ-Fe2O3/Al-ZnO but remained adequate for the efficient separation of the adsorbent simply using a magnet. This study demonstrates that binary γ-Fe2O3/Al-ZnO magnetic nanocomposites are effective for the removal of chlorpyriphos and could be highly promising materials for the removal of emerging pollutants in wastewater.
Open AccessRobust Magnetic γ-Fe2O3/Al–ZnO Adsorbent for Chlorpyriphos Removal in Water
In this research, the removal of the pesticide chlorpyriphos (CPE) from water by adsorption using a novel adsorbent made of γ-Fe2O3/Al-ZnO nanocomposite was studied. The adsorbent was characterized using Fourier-transformed infrared spectroscopy (FTIR), Scanning electron microscopy (SEM), Brunauer-Emmett-Teller (BET) surface area, and vibrating sample magnetometry (VSM). The main parameters affecting the adsorption process, including the initial pH (2–12), the concentration of pesticide (10–70 ppm), the %Fe2O3 of the adsorbent, and the adsorption time (≤60 min), were studied. The results demonstrated that the adsorption of CPE depended on the pH, with a maximum removal of 92.3% achieved at around neutral pH. The adsorption isotherm was modelled and the results showed that the Freundlich model fitted the experimental data better than the Langmuir and Temkin models. The kinetics of adsorption were also studied and modelled using the pseudo-first-order and pseudo-second-order models, with the former being found more suitable. Energy dispersive X-ray (EDX) analysis confirmed the adsorption of CPE on γ-Fe2O3/Al-ZnO, while FTIR analysis suggested that the hydroxyl, N-pyridine, and chloro functional groups governed the adsorption mechanism. Furthermore, VSM analysis revealed that the magnetization saturation of γ-Fe2O3/Al-ZnO nanocomposite, after CPE adsorption, was slightly lower than that of fresh γ-Fe2O3/Al-ZnO but remained adequate for the efficient separation of the adsorbent simply using a magnet. This study demonstrates that binary γ-Fe2O3/Al-ZnO magnetic nanocomposites are effective for the removal of chlorpyriphos and could be highly promising materials for the removal of emerging pollutants in wastewater.
- Open Access
- 24 January 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (3) , 363
Study of Structural and Optical Properties of Electrodeposited Silicon Films on Graphite Substrates
Silicon (Si) films were deposited on low-cost graphite substrates by the electrochemical reduction of silicon dioxide nanoparticles (nano-SiO2) in calcium chloride (CaCl2), melted at 855 °C. Cyclic voltammetry (CV) was used to analyze the electrochemical reduction mechanism of SiO2 to form Si deposits on the graphite substrate. X-ray diffraction (XRD) along with Raman and photoluminescence (PL) results show that the crystallinity of the electrodeposited Si-films was improved with an increase of the applied reduction potential during the electrochemical process. Scanning electron microscopy (SEM) reveals that the size, shape, and morphology of the Si-layers can be controlled from Si nanowires to the microcrystalline Si particles by controlling the reduction potentials. In addition, the morphology of the obtained Si-layers seems to be correlated with both the substrate materials and particle size of the feed materials. Thus, the difference in the electron transfer rate at substrate/nano-SiO2 interface due to different applied reduction potentials along with the dissolution rate of SiO2 particles during the electrochemical reduction process were found to be crucial in determining the microstructural properties of the Si-films.
- 24 January 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (3) , 363
Open AccessStudy of Structural and Optical Properties of Electrodeposited Silicon Films on Graphite Substrates
Silicon (Si) films were deposited on low-cost graphite substrates by the electrochemical reduction of silicon dioxide nanoparticles (nano-SiO2) in calcium chloride (CaCl2), melted at 855 °C. Cyclic voltammetry (CV) was used to analyze the electrochemical reduction mechanism of SiO2 to form Si deposits on the graphite substrate. X-ray diffraction (XRD) along with Raman and photoluminescence (PL) results show that the crystallinity of the electrodeposited Si-films was improved with an increase of the applied reduction potential during the electrochemical process. Scanning electron microscopy (SEM) reveals that the size, shape, and morphology of the Si-layers can be controlled from Si nanowires to the microcrystalline Si particles by controlling the reduction potentials. In addition, the morphology of the obtained Si-layers seems to be correlated with both the substrate materials and particle size of the feed materials. Thus, the difference in the electron transfer rate at substrate/nano-SiO2 interface due to different applied reduction potentials along with the dissolution rate of SiO2 particles during the electrochemical reduction process were found to be crucial in determining the microstructural properties of the Si-films.
- Open Access
- 7 October 2020
- Published by IntechOpen
Synthesis Methods in Solid-State Chemistry
The synthesis of single crystal is an area of intense activity in the materials science. The obtaining of the single crystal with sufficient dimension for X-ray diffraction depends on several factors including the chemical composition, crystal structure of the reagents, and physical parameters (temperature and pressure). In this context, this chapter is dedicated to the description of the most common synthesis methods of single crystal in the solid-state chemistry: solid-state method, hydrothermal, and slow evaporation at room temperature. Same other materials can be obtained at high pressure. There are also some physical techniques to grow single crystal, each technique is specific for specific materials.
- 7 October 2020
- Published by IntechOpen
Open AccessSynthesis Methods in Solid-State Chemistry
The synthesis of single crystal is an area of intense activity in the materials science. The obtaining of the single crystal with sufficient dimension for X-ray diffraction depends on several factors including the chemical composition, crystal structure of the reagents, and physical parameters (temperature and pressure). In this context, this chapter is dedicated to the description of the most common synthesis methods of single crystal in the solid-state chemistry: solid-state method, hydrothermal, and slow evaporation at room temperature. Same other materials can be obtained at high pressure. There are also some physical techniques to grow single crystal, each technique is specific for specific materials.
- 1 September 2019
- Published by Elsevier in Journal of Molecular Structure
- Vol. 1192, 42-48
The effect of silica additive on the structural and luminescence properties of Eu3+/Tb3+ co-doped metaphosphate glasses
- 1 September 2019
- Published by Elsevier in Journal of Molecular Structure
- Vol. 1192, 42-48
The effect of silica additive on the structural and luminescence properties of Eu3+/Tb3+ co-doped metaphosphate glasses
- 6 December 2012
- Published by Springer Nature in Journal of Solution Chemistry
- Vol. 41 (12) , 2186-2208
Correspondence Between Grunberg–Nissan, Arrhenius and Jouyban–Acree Parameters for Viscosity of Isobutyric Acid + Water Binary Mixtures from 302.15 to 313.15 K
- 6 December 2012
- Published by Springer Nature in Journal of Solution Chemistry
- Vol. 41 (12) , 2186-2208
Correspondence Between Grunberg–Nissan, Arrhenius and Jouyban–Acree Parameters for Viscosity of Isobutyric Acid + Water Binary Mixtures from 302.15 to 313.15 K