PLPeter van der Linden

Peter van der Linden

*This is an algorithmically generated author record based on publicly available information.

Peter van der Linden has a total of 124 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Structures of variants of Escherichia coli flavodiiron-type nitric oxide reductase reveal changes in the di-iron site

    by Patrícia T. Borges, Filipe Folgosa, Maria C. Martins, Guillaume Gotthard, Peter van der Linden, Philippe Carpentier, Miguel Teixeira, Carlos Frazão, Célia V. Romão

    Flavodiiron proteins (FDPs) are NO and/or O 2 reductases which contain a di-iron catalytic center. Interestingly, they exhibit different selectivities towards each one of these substrates, despite having the same ligands of the iron ions. Escherichia coli FDP is a selective NO reductase that protects this bacterium against nitric oxide by catalyzing two-electron reduction to the nontoxic N 2 O. Previously, based on kinetic studies, we explored the possible role of two amino acids located in the di-iron second coordination sphere, Lys53 and Tyr271, in modulation of the substrate selectivity of Entamoeba histolytica FDP, a selective O 2 reductase. In this work, we replaced the structurally equivalent residues in E. coli FDP, Asp52 and Ser262, by those present in the O 2 -selective FDP and determined their crystal structures in both oxidized and reduced states. Furthermore, the molecular-substrate tunnels were experimentally identified using krypton pressurization of the crystals. The data obtained corroborated previous molecular-dynamics calculations on this FDP. The side chains of residues in both positions 52 and 262 of E. coli FDP variants and wild type are in the vicinity of the shorter intramolecular tunnel, which is suggested to be the exit route for the reaction products N 2 O and H 2 O. The E. coli FDP S262Y variant shows photoreduction of the di-iron center and partial loss of electron density in some of its coordinating ligands after X-ray exposure, and these effects are consistent with increased radiation sensitivity. The kinetic properties of the variants towards NO and O 2 were not significantly different from the wild type, contrary to what was observed previously for E. histolytica FDP.

  • Open Access

    The High-Pressure Freezing Laboratory for Macromolecular Crystallography (HPMX), an ancillary tool for the macromolecular crystallography beamlines at the ESRF

    by Philippe Carpentier, Peter van der Linden, Christoph Mueller-Dieckmann

    This article describes the High-Pressure Freezing Laboratory for Macromolecular Crystallography (HPMX) at the ESRF, and highlights new and complementary research opportunities that can be explored using this facility. The laboratory is dedicated to investigating interactions between macromolecules and gases in crystallo, and finds applications in many fields of research, including fundamental biology, biochemistry, and environmental and medical science. At present, the HPMX laboratory offers the use of different high-pressure cells adapted for helium, argon, krypton, xenon, nitrogen, oxygen, carbon dioxide and methane. Important scientific applications of high pressure to macromolecules at the HPMX include noble-gas derivatization of crystals to detect and map the internal architecture of proteins (pockets, tunnels and channels) that allows the storage and diffusion of ligands or substrates/products, the investigation of the catalytic mechanisms of gas-employing enzymes (using oxygen, carbon dioxide or methane as substrates) to possibly decipher intermediates, and studies of the conformational fluctuations or structure modifications that are necessary for proteins to function. Additionally, cryo-cooling protein crystals under high pressure (helium or argon at 2000 bar) enables the addition of cryo-protectant to be avoided and noble gases can be employed to produce derivatives for structure resolution. The high-pressure systems are designed to process crystals along a well defined pathway in the phase diagram (pressure–temperature) of the gas to cryo-cool the samples according to the three-step `soak-and-freeze method'. Firstly, crystals are soaked in a pressurized pure gas atmosphere (at 294 K) to introduce the gas and facilitate its interactions within the macromolecules. Samples are then flash-cooled (at 100 K) while still under pressure to cryo-trap macromolecule–gas complexation states or pressure-induced protein modifications. Finally, the samples are recovered after depressurization at cryo-temperatures. The final section of this publication presents a selection of different typical high-pressure experiments carried out at the HPMX, showing that this technique has already answered a wide range of scientific questions. It is shown that the use of different gases and pressure conditions can be used to probe various effects, such as mapping the functional internal architectures of enzymes (tunnels in the haloalkane dehalogenase DhaA) and allosteric sites on membrane-protein surfaces, the interaction of non-inert gases with proteins (oxygen in the hydrogenase ReMBH) and pressure-induced structural changes of proteins (tetramer dissociation in urate oxidase). The technique is versatile and the provision of pressure cells and their application at the HPMX is gradually being extended to address new scientific questions.


  • Open Access

    The TR-icOS setup at the ESRF: time-resolved microsecond UV–Vis absorption spectroscopy on protein crystals

    by Sylvain Engilberge, Nicolas Caramello, Sergei Bukhdruker, Martin Byrdin, Thierry Giraud, Philippe Jacquet, Damien Scortani, Rattana Biv, Hervé Gonzalez, Antonin Broquet, et al.

    The technique of time-resolved macromolecular crystallography (TR-MX) has recently been rejuvenated at synchrotrons, resulting in the design of dedicated beamlines. Using pump–probe schemes, this should make the mechanistic study of photoactive proteins and other suitable systems possible with time resolutions down to microseconds. In order to identify relevant time delays, time-resolved spectroscopic experiments directly performed on protein crystals are often desirable. To this end, an instrument has been built at the icOS Lab (in crystallo Optical Spectroscopy Laboratory) at the European Synchrotron Radiation Facility using reflective focusing objectives with a tuneable nanosecond laser as a pump and a microsecond xenon flash lamp as a probe, called the TR-icOS (time-resolved icOS) setup. Using this instrument, pump–probe spectra can rapidly be recorded from single crystals with time delays ranging from a few microseconds to seconds and beyond. This can be repeated at various laser pulse energies to track the potential presence of artefacts arising from two-photon absorption, which amounts to a power titration of a photoreaction. This approach has been applied to monitor the rise and decay of the M state in the photocycle of crystallized bacteriorhodopsin and showed that the photocycle is increasingly altered with laser pulses of peak fluence greater than 100 mJ cm−2, providing experimental laser and delay parameters for a successful TR-MX experiment.


  • Open Access

    Evolutionary adaptation from hydrolytic to oxygenolytic catalysis at the α/β-hydrolase fold

    by Soi Bui, Sara Gil-Guerrero, Peter van der Linden, Philippe Carpentier, Matteo Ceccarelli, Pablo G. Jambrina, Roberto A. Steiner

    Protein fold adaptation to novel enzymatic reactions is a fundamental evolutionary process. Cofactor-independent oxygenases degrading N-heteroaromatic substrates belong to the α/β-hydrolase (ABH) fold superfamily that typically does not catalyze oxygenation reactions. Here, we have integrated crystallographic analyses under normoxic and hyperoxic conditions with molecular dynamics and quantum mechanical calculations to investigate its prototypic 1-H-3-hydroxy-4-oxoquinaldine 2,4-dioxygenase (HOD) member. O2 localization to the “oxyanion hole”, where catalysis occurs, is an unfavorable event and the direct competition between dioxygen and water for this site is modulated by the “nucleophilic elbow” residue. A hydrophobic pocket that overlaps with the organic substrate binding site can act as a proximal dioxygen reservoir. Freeze-trap pressurization allowed the structure of the ternary complex with a substrate analogue and O2 bound at the oxyanion hole to be determined. Theoretical calculations reveal that O2 orientation is coupled to the charge of the bound organic ligand. When 1-H-3-hydroxy-4-oxoquinaldine is uncharged, O2 binds with its molecular axis along the ligand's C2–C4 direction in full agreement with the crystal structure. Substrate activation triggered by deprotonation of its 3-OH group by the His-Asp dyad, rotates O2 by approximately 60°. This geometry maximizes the charge transfer between the substrate and O2, thus weakening the double bond of the latter. Electron density transfer to the O2(π*) orbital promotes the formation of the peroxide intermediate via intersystem crossing that is rate-determining. Our work provides a detailed picture of how evolution has repurposed the ABH-fold architecture and its simple catalytic machinery to accomplish metal-independent oxygenation.


  • Peltier-Based Experimental Device for Studying the Effect of Temperature on Protein Crystallization Kinetics

    by Anton M. Popov, Peter J. E. M. van der Linden, Diego Pontoni, Christoph Mueller-Dieckmann, Mark D. Tully

  • A miniature airlock system to aid the cryo-cooling of protein crystals grown under anoxic conditions

    by Peter van der Linden, Sylvain Engilberge, Mohamed Atta, Philippe Carpentier

    Crystallographic studies of structures and mechanisms of dioxygen-employing enzymes or oxygen-sensitive proteins usually require these molecules to be prepared and crystallized under anoxic conditions in gloveboxes. Handling, cryo-cooling and extraction of these crystals from gloveboxes for X-ray data collection can be a tricky operation, during which samples might be ruined if they are accidentally exposed to atmospheric oxygen. This work reports the design of a new miniature airlock system and describes the associated method in order to simplify these tasks. The system allows flash-cooling of crystals harvested in a glovebox directly into an external liquid nitrogen container via a miniature airlock while maintaining strict anoxic conditions. The method was assessed using hen egg-white lysozyme crystals soaked in dihydroresorufin (an O2 indicator) and with the reduced tRNA-hydroxylase enzyme MiaE.


  • Open Access

    High-pressure crystallography shows noble gas intervention into protein-lipid interaction and suggests a model for anaesthetic action

    by Igor Melnikov, Philipp Orekhov, Maksim Rulev, Kirill Kovalev, Roman Astashkin, Dmitriy Bratanov, Yury Ryzhykau, Taras Balandin, Sergei Bukhdruker, Ivan Okhrimenko, et al.

    In this work we examine how small hydrophobic molecules such as inert gases interact with membrane proteins (MPs) at a molecular level. High pressure atmospheres of argon and krypton were used to produce noble gas derivatives of crystals of three well studied MPs (two different proton pumps and a sodium light-driven ion pump). The structures obtained using X-ray crystallography showed that the vast majority of argon and krypton binding sites were located on the outer hydrophobic surface of the MPs – a surface usually accommodating hydrophobic chains of annular lipids (which are known structural and functional determinants for MPs). In conformity with these results, supplementary in silico molecular dynamics (MD) analysis predicted even greater numbers of argon and krypton binding positions on MP surface within the bilayer. These results indicate a potential importance of such interactions, particularly as related to the phenomenon of noble gas-induced anaesthesia.


  • Comparative study of the effects of high hydrostatic pressure per se and high argon pressure on urate oxidase ligand stabilization

    by Thierry Prangé, Philippe Carpentier, Anne-Claire Dhaussy, Peter van der Linden, Eric Girard, Nathalie Colloc'H

    The stability of the tetrameric enzyme urate oxidase in complex with excess of 8-azaxanthine was investigated either under high hydrostatic pressure per se or under a high pressure of argon. The active site is located at the interface of two subunits, and the catalytic activity is directly related to the integrity of the tetramer. This study demonstrates that applying pressure to a protein–ligand complex drives the thermodynamic equilibrium towards ligand saturation of the complex, revealing a new binding site. A transient dimeric intermediate that occurs during the pressure-induced dissociation process was characterized under argon pressure and excited substates of the enzyme that occur during the catalytic cycle can be trapped by pressure. Comparison of the different structures under pressure infers an allosteric role of the internal hydrophobic cavity in which argon is bound, since this cavity provides the necessary flexibility for the active site to function.


  • Accurate and rapid 3D printing of microfluidic devices using wavelength selection on a DLP printer

    by Peter J. E. M. van der Linden, Anton M. Popov, Diego Pontoni

    The use of microfluidics on synchrotron X-ray beamlines represents an advanced sample preparation and delivery platform for state-of-the-art X-ray characterization of micro-samples. The recent developments of 3D printing technologies have opened possibilities for rapid fabrication of complex microfluidic devices. One of the major challenges in 3D printing of microfluidic devices using a digital light processing (DLP) desktop printer is that the static liquid resin trapped in the channels, once the “ceiling” is printed, still receives small doses of light through the subsequently printed layers. This easily triggers partial polymerisation of the resin which impedes its flushing out of the channels after completion of the printing session. We show here that it is possible to gain better control over the resin polymerisation and improve the quality of the microfluidic devices by efficiently reducing the penetration depth of the UV LED light through wavelength selection combined with a careful choice of absorber and photo-initiator materials. We produced and tested several structures using a slightly modified desktop printer at 385 nm wavelength with 37 × 37 μm2 pixel resolution at a printed layer thickness of 25 μm. The structures include particle filters, mixers, droplet generators and droplet storage traps with features below 100 μm. We demonstrate crystallisation of model inorganic and organic compounds in trapped droplets and assess the feasibility of in-device X-ray diffraction experiments. This research opens the path for the use of 3D printed microfluidic devices on X-ray beamlines.


  • Open Access

    3D-MiXD: 3D-printed X-ray-compatible microfluidic devices for rapid, low-consumption serial synchrotron crystallography data collection in flow

    by Diana C. F. Monteiro, David von Stetten, Claudia Stohrer, Marta Sans, Arwen R. Pearson, Gianluca Santoni, Peter van der Linden, Martin Trebbin

    Serial crystallography has enabled the study of complex biological questions through the determination of biomolecular structures at room temperature using low X-ray doses. Furthermore, it has enabled the study of protein dynamics by the capture of atomically resolved and time-resolved molecular movies. However, the study of many biologically relevant targets is still severely hindered by high sample consumption and lengthy data-collection times. By combining serial synchrotron crystallography (SSX) with 3D printing, a new experimental platform has been created that tackles these challenges. An affordable 3D-printed, X-ray-compatible microfluidic device (3D-MiXD) is reported that allows data to be collected from protein microcrystals in a 3D flow with very high hit and indexing rates, while keeping the sample consumption low. The miniaturized 3D-MiXD can be rapidly installed into virtually any synchrotron beamline with only minimal adjustments. This efficient collection scheme in combination with its mixing geometry paves the way for recording molecular movies at synchrotrons by mixing-triggered millisecond time-resolved SSX.