Kryštof Pilnáček
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kryštof Pilnáček has a total of 55 co-authors. Here are the top co-authors by number of shared publications:
- Karel Friess
University of Chemistry and Technology, Prague
9 shared publications - Marek Lanč
Department of Physical Chemistry, University of Chemistry and Technology, Technická 5, 166 28 Prague, Czech Republic
5 shared publications Ondřej Vopička
5 shared publications- Johannes Carolus Jansen
Institute on Membrane Technology, Italy
4 shared publications - Mariolino Carta
Department of Chemistry, Swansea University, College of Science, Grove Building, Singleton Park, Swansea SA2 8PP, UK
3 shared publications - Neil Bruce McKeown
University of Edinburgh
3 shared publications
Latest Publications
- Open Access
A Novel Time Lag Method for the Analysis of Mixed Gas Diffusion in Polymeric Membranes by On-Line Mass Spectrometry: Pressure Dependence of Transport Parameters
This paper presents a novel method for transient and steady state mixed gas permeation measurements, using a quadrupole residual gas analyser for the on-line determination of the permeate composition. The on-line analysis provides sufficiently quick response times to follow even fast transient phenomena, enabling the unique determination of the diffusion coefficient of the individual gases in a gas mixture. Following earlier work, the method is further optimised for higher gas pressures, using a thin film composite and a thick dense styrene-butadiene-styrene (SBS) block copolymer membrane. Finally, the method is used to calculate the CO2/CH4 mixed gas diffusion coefficients of the spirobisfluorene-based polymer of intrinsic microporosity, PIM-SBF-1. It is shown that the modest pressure dependence of the PIM-SBF-1 permeability can be ascribed to a much stronger pressure dependence of the diffusion coefficient, which partially compensates the decreasing solubility of CO2 with increasing pressure, typical for the strong sorption behaviour in PIMs. The characteristics of the instrument are discussed and suggestions are given for even more versatile measurements under stepwise increasing pressure conditions. This is the first report on mixed gas diffusion coefficients at different pressures in a polymer of intrinsic microporosity.
Open AccessA Novel Time Lag Method for the Analysis of Mixed Gas Diffusion in Polymeric Membranes by On-Line Mass Spectrometry: Pressure Dependence of Transport Parameters
This paper presents a novel method for transient and steady state mixed gas permeation measurements, using a quadrupole residual gas analyser for the on-line determination of the permeate composition. The on-line analysis provides sufficiently quick response times to follow even fast transient phenomena, enabling the unique determination of the diffusion coefficient of the individual gases in a gas mixture. Following earlier work, the method is further optimised for higher gas pressures, using a thin film composite and a thick dense styrene-butadiene-styrene (SBS) block copolymer membrane. Finally, the method is used to calculate the CO2/CH4 mixed gas diffusion coefficients of the spirobisfluorene-based polymer of intrinsic microporosity, PIM-SBF-1. It is shown that the modest pressure dependence of the PIM-SBF-1 permeability can be ascribed to a much stronger pressure dependence of the diffusion coefficient, which partially compensates the decreasing solubility of CO2 with increasing pressure, typical for the strong sorption behaviour in PIMs. The characteristics of the instrument are discussed and suggestions are given for even more versatile measurements under stepwise increasing pressure conditions. This is the first report on mixed gas diffusion coefficients at different pressures in a polymer of intrinsic microporosity.
- 1 April 2017
- Published by Elsevier in Polymer Testing
- Vol. 58, 199-207
Sorption of organic liquids in poly(ethylene chlorotrifluoroethylene) Halar®901: Experimental and theoretical analysis
- 1 April 2017
- Published by Elsevier in Polymer Testing
- Vol. 58, 199-207
Sorption of organic liquids in poly(ethylene chlorotrifluoroethylene) Halar®901: Experimental and theoretical analysis
- 1 March 2017
- Published by Elsevier in Separation and Purification Technology
- Vol. 174, 1-11
Separation of methanol-dimethyl carbonate vapour mixtures with PDMS and PTMSP membranes
- 1 March 2017
- Published by Elsevier in Separation and Purification Technology
- Vol. 174, 1-11
Separation of methanol-dimethyl carbonate vapour mixtures with PDMS and PTMSP membranes
- Open Access
- 1 December 2016
- Published by Elsevier in Journal of Membrane Science
- Vol. 520, 895-906
Aging of polymers of intrinsic microporosity tracked by methanol vapour permeation
- 1 December 2016
- Published by Elsevier in Journal of Membrane Science
- Vol. 520, 895-906
Open AccessAging of polymers of intrinsic microporosity tracked by methanol vapour permeation
- 27 October 2015
- Published by Wiley in Journal of Polymer Science Part B: Polymer Physics
- Vol. 54 (5) , 561-569
Sorption of methanol, dimethyl carbonate, methyl acetate, and acetone vapors in CTA and PTMSP: General findings from the GAB Analysis
- 27 October 2015
- Published by Wiley in Journal of Polymer Science Part B: Polymer Physics
- Vol. 54 (5) , 561-569
Sorption of methanol, dimethyl carbonate, methyl acetate, and acetone vapors in CTA and PTMSP: General findings from the GAB Analysis
- 1 September 2015
- Published by Elsevier in Polymer Testing
- Vol. 46, 108-115
Aroma scalping characteristics of polybutylene succinate based films
- 1 September 2015
- Published by Elsevier in Polymer Testing
- Vol. 46, 108-115
Aroma scalping characteristics of polybutylene succinate based films
- 3 November 2014
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 47 (22) , 7900-7916
Molecular Modeling and Gas Permeation Properties of a Polymer of Intrinsic Microporosity Composed of Ethanoanthracene and Tröger’s Base Units
- 3 November 2014
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 47 (22) , 7900-7916
Molecular Modeling and Gas Permeation Properties of a Polymer of Intrinsic Microporosity Composed of Ethanoanthracene and Tröger’s Base Units
- 1 May 2013
- Published by Elsevier in Journal of Membrane Science
- Vol. 434, 148-160
Equilibrium and transient sorption of vapours and gases in the polymer of intrinsic microporosity PIM-1
- 1 May 2013
- Published by Elsevier in Journal of Membrane Science
- Vol. 434, 148-160
Equilibrium and transient sorption of vapours and gases in the polymer of intrinsic microporosity PIM-1
- 3 August 2012
- Published by Taylor & Francis in Journal of Macromolecular Science, Part B
- Vol. 52 (4) , 632-649
Hyperbranched Polyimide-Silica Hybrid Materials: Synthesis, Structure, Dynamics, and Gas Transport Properties
A series of organic–inorganic hybrid materials were prepared from a hyperbranched polyimide precursor (hyperbranched polyamic acid), tetramethoxysilane, and/or 3-glycidyloxypropyl-trimethoxysilane via a sol-gel process. The hyperbranched polyimide-silica hybrids, whose polyimide moieties were based on commercially available monomers 4,4′,4″-triaminotriphenylmethane and 4,4′-oxydiphthalic anhydride taken in molar ratio 1:1, contained from 10 to 30 wt% silica. Their morphology and dynamics were characterized by using scanning electron microscopy, differential scanning calorimetry, dynamic mechanical analysis, laser-interferometric creep rate spectroscopy, and wide-angle X-ray diffraction. Attention was also focused on the relation between morphology/dynamics and gas transport properties of these materials.
- 3 August 2012
- Published by Taylor & Francis in Journal of Macromolecular Science, Part B
- Vol. 52 (4) , 632-649
Hyperbranched Polyimide-Silica Hybrid Materials: Synthesis, Structure, Dynamics, and Gas Transport Properties
A series of organic–inorganic hybrid materials were prepared from a hyperbranched polyimide precursor (hyperbranched polyamic acid), tetramethoxysilane, and/or 3-glycidyloxypropyl-trimethoxysilane via a sol-gel process. The hyperbranched polyimide-silica hybrids, whose polyimide moieties were based on commercially available monomers 4,4′,4″-triaminotriphenylmethane and 4,4′-oxydiphthalic anhydride taken in molar ratio 1:1, contained from 10 to 30 wt% silica. Their morphology and dynamics were characterized by using scanning electron microscopy, differential scanning calorimetry, dynamic mechanical analysis, laser-interferometric creep rate spectroscopy, and wide-angle X-ray diffraction. Attention was also focused on the relation between morphology/dynamics and gas transport properties of these materials.
- Open Access
- 1 October 2011
- Published by Elsevier in Desalination and Water Treatment
- Vol. 34 (1-3) , 211-215
Mixed matrix membranes based on hyperbranched polyimide and mesoporous silica for gas separation
The novel mixed matrix membranes were prepared from the hyperbranched polyimide based on 4,4´,4´´-triaminotriphenylmethane and mesoporous silica MCM-41 (up to 16 wt.%). The permeability coefficients of hydrogen, carbon dioxide, oxygen, nitrogen and methane in the membranes increased and oxygen/nitrogen or carbon dioxide/methane selectivities decreased slightly with the silica content. The absolute values of permeability coefficients were fairly influenced by the method of additive incorporation to the polymeric matrix.
- 1 October 2011
- Published by Elsevier in Desalination and Water Treatment
- Vol. 34 (1-3) , 211-215
Open AccessMixed matrix membranes based on hyperbranched polyimide and mesoporous silica for gas separation
The novel mixed matrix membranes were prepared from the hyperbranched polyimide based on 4,4´,4´´-triaminotriphenylmethane and mesoporous silica MCM-41 (up to 16 wt.%). The permeability coefficients of hydrogen, carbon dioxide, oxygen, nitrogen and methane in the membranes increased and oxygen/nitrogen or carbon dioxide/methane selectivities decreased slightly with the silica content. The absolute values of permeability coefficients were fairly influenced by the method of additive incorporation to the polymeric matrix.