Hafiz H. Salih
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hafiz H. Salih has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Seyed Abolfazl Dastgheib
Illinois State Geological Survey, Prairie Research Institute, University of Illinois, Champaign, Illinois 61820, United States
8 shared publications - Bajio Varghese Kaleeckal
Univ. of Illinois at Urbana-Champaign, IL (United States)
4 shared publications - Craig. L. Patterson
USEPA
4 shared publications Daryl-Lynn Roberts
Visage Energy, Culver City, CA (United States)
4 shared publicationsDerick Dreyer
Holcim Cement, Ste. Genevieve, MO (United States)
4 shared publications- Kevin Obrien
Univ. of Illinois at Urbana-Champaign, IL (United States)
4 shared publications
Latest Publications
- 3 February 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 58 (8) , 3370-3376
Treatment of Highly Saline Brines by Supercritical Precipitation Followed by Supercritical Membrane Separation
- 3 February 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 58 (8) , 3370-3376
Treatment of Highly Saline Brines by Supercritical Precipitation Followed by Supercritical Membrane Separation
- 21 June 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (6) , 6627-6633
Utilization of Water Utility Lime Sludge for Flue Gas Desulfurization in Coal-Fired Power Plants: Part I. Supply–Demand Evaluation and Life Cycle Assessment
The feasibility of lime-softening sludge utilization for flue gas desulfurization in coal-fired power plants was evaluated through a supply–demand analysis and a life cycle assessment (LCA). To evaluate the demand and supply of lime sludge to replace limestone on a national scale, the annual amount of lime sludge generated by water treatment utilities in the United States was estimated and compared with the annual amount of limestone used by coal-fired power utilities. To evaluate the environmental sustainability of reusing lime sludge in power plants, an LCA study was performed in which the environmental impact and water footprint of the proposed approach were quantified and these results were compared with the conventional approaches for limestone mining, grinding, and transportation to power plants and lime sludge disposal in landfills. Water utilities across the United States are currently generating approximately 3.2 million tons of lime sludge per year at an estimated disposal cost of approximately US$90 million, whereas power utilities are using approximately 6.3 million tons of limestone per year. The potential savings that would result from partial replacement of limestone with lime sludge was estimated to be approximately US$97 million per year. The LCA study showed that the environmental impact of lime sludge utilization in power plants under different scenarios was 2 orders of magnitude lower than that of the landfill disposal option. Furthermore, the water footprint for lime sludge reuse in power plants was almost negligible compared with that of the conventional approaches of disposing of lime sludge at water utilities or using limestone at power utilities.
- 21 June 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (6) , 6627-6633
Utilization of Water Utility Lime Sludge for Flue Gas Desulfurization in Coal-Fired Power Plants: Part I. Supply–Demand Evaluation and Life Cycle Assessment
The feasibility of lime-softening sludge utilization for flue gas desulfurization in coal-fired power plants was evaluated through a supply–demand analysis and a life cycle assessment (LCA). To evaluate the demand and supply of lime sludge to replace limestone on a national scale, the annual amount of lime sludge generated by water treatment utilities in the United States was estimated and compared with the annual amount of limestone used by coal-fired power utilities. To evaluate the environmental sustainability of reusing lime sludge in power plants, an LCA study was performed in which the environmental impact and water footprint of the proposed approach were quantified and these results were compared with the conventional approaches for limestone mining, grinding, and transportation to power plants and lime sludge disposal in landfills. Water utilities across the United States are currently generating approximately 3.2 million tons of lime sludge per year at an estimated disposal cost of approximately US$90 million, whereas power utilities are using approximately 6.3 million tons of limestone per year. The potential savings that would result from partial replacement of limestone with lime sludge was estimated to be approximately US$97 million per year. The LCA study showed that the environmental impact of lime sludge utilization in power plants under different scenarios was 2 orders of magnitude lower than that of the landfill disposal option. Furthermore, the water footprint for lime sludge reuse in power plants was almost negligible compared with that of the conventional approaches of disposing of lime sludge at water utilities or using limestone at power utilities.
- 21 June 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (6) , 6634-6640
Utilization of Water Utility Lime Sludge for Flue Gas Desulfurization in Coal-Fired Power Plants: Part II. Lime Sludge Characterization and Mercury Re-emission
The feasibility of utilizing lime sludge in the flue gas desulfurization process of coal-fired power plants was evaluated through laboratory-scale studies. Eight lime sludge samples, collected from various water treatment plants, and a high-purity limestone sample were extensively characterized and tested for their ability to capture SO2 from a simulated flue gas, while investigating the mercury reemission profiles during the scrubbing process. The reactivity of lime sludge samples for acid neutralization was considerably higher than the reactivity of the tested limestone sample. At doses less than that of the limestone sample, the lime sludge materials reduced the SO2 concentration from 2,000 to <0.5 ppm. The residual lime, higher surface area, and more accessible pores in lime sludge samples were the major factors contributing to their higher reactivity. Concentrations of several elements including B, Mg, Mn, Fe, Cu, Zn, As, Sr, and Ba in some of the tested lime sludge samples were considerably higher than those elements in the limestone. However, no significant leaching of these elements into the scrubber solutions was observed. To investigate mercury reemission during the scrubbing process, ionic mercury was introduced into the simulated slurry and mercury reemission was monitored continuously. Results showed that compared with the limestone sample, the lime sludge samples tested had lower or similar cumulative mercury reemissions. However, different lime sludge samples showed different emission profiles. No conclusive correlation between the composition or trace element content of lime sludge samples and their mercury reemission could be identified. This result was likely due to the oxidative condition of the scrubbing process, which prohibited the reducing species from transforming the ionic mercury into elemental mercury.
- 21 June 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (6) , 6634-6640
Utilization of Water Utility Lime Sludge for Flue Gas Desulfurization in Coal-Fired Power Plants: Part II. Lime Sludge Characterization and Mercury Re-emission
The feasibility of utilizing lime sludge in the flue gas desulfurization process of coal-fired power plants was evaluated through laboratory-scale studies. Eight lime sludge samples, collected from various water treatment plants, and a high-purity limestone sample were extensively characterized and tested for their ability to capture SO2 from a simulated flue gas, while investigating the mercury reemission profiles during the scrubbing process. The reactivity of lime sludge samples for acid neutralization was considerably higher than the reactivity of the tested limestone sample. At doses less than that of the limestone sample, the lime sludge materials reduced the SO2 concentration from 2,000 to <0.5 ppm. The residual lime, higher surface area, and more accessible pores in lime sludge samples were the major factors contributing to their higher reactivity. Concentrations of several elements including B, Mg, Mn, Fe, Cu, Zn, As, Sr, and Ba in some of the tested lime sludge samples were considerably higher than those elements in the limestone. However, no significant leaching of these elements into the scrubber solutions was observed. To investigate mercury reemission during the scrubbing process, ionic mercury was introduced into the simulated slurry and mercury reemission was monitored continuously. Results showed that compared with the limestone sample, the lime sludge samples tested had lower or similar cumulative mercury reemissions. However, different lime sludge samples showed different emission profiles. No conclusive correlation between the composition or trace element content of lime sludge samples and their mercury reemission could be identified. This result was likely due to the oxidative condition of the scrubbing process, which prohibited the reducing species from transforming the ionic mercury into elemental mercury.
- 1 October 2017
- Published by Elsevier in Water Research
- Vol. 122, 419-430
Life cycle assessment of treatment and handling options for a highly saline brine extracted from a potential CO2 storage site
- 1 October 2017
- Published by Elsevier in Water Research
- Vol. 122, 419-430
Life cycle assessment of treatment and handling options for a highly saline brine extracted from a potential CO2 storage site
- 1 October 2017
- Published by Elsevier in Chemical Engineering Journal
- Vol. 325, 415-423
Treatment of a hypersaline brine, extracted from a potential CO2 sequestration site, and an industrial wastewater by membrane distillation and forward osmosis
- 1 October 2017
- Published by Elsevier in Chemical Engineering Journal
- Vol. 325, 415-423
Treatment of a hypersaline brine, extracted from a potential CO2 sequestration site, and an industrial wastewater by membrane distillation and forward osmosis
- 1 February 2017
- Published by Elsevier in Desalination
- Vol. 404, 87-101
Assessment of desalination technologies for treatment of a highly saline brine from a potential CO2 storage site
- 1 February 2017
- Published by Elsevier in Desalination
- Vol. 404, 87-101
Assessment of desalination technologies for treatment of a highly saline brine from a potential CO2 storage site