Peng Hong Liem
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Peng Hong Liem has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Donny Hartanto
ORNL
9 shared publications - Surian Pinem
National Research and Innovation Agency
5 shared publications Donny Hartanto
4 shared publicationsHiroshi Sekimoto
4 shared publications- Hoai-Nam Tran
PHENIKAA Institute for Advanced Study, PHENIKAA University, Hanoi 12116, Viet Nam
4 shared publications - Tagor Malem Sembiring
Center for Nuclear Reactor Technology and Safety, National Nuclear Energy Agency of Indonesia (BATAN), Kawasan Puspiptek, Gd. No. 80, Serpong, Tangerang Selatan 15310, Indonesia
4 shared publications
Latest Publications
- Open Access
- 2 February 2026
- Published by MDPI AG in Quantum Beam Science
- Vol. 10 (1) , 5
Optimized Neutronics Designs of the Indonesian Experimental Power Reactor/RDE (Comprehensive Review and Future Challenges)
In this paper, several optimized design results of the HTGR-based 10 MWth Reaktor Daya Eksperimental (RDE) (Experimental Power Reactor), so far conducted, are reviewed and compared from the neutronics, reactor types, refueling schemes, and fuel cycle points of view. The review covers the multipass and once-through-then-out (OTTO) pebble-bed cores, as well as block/prismatic type cores with several fuel shuffling options. As for the fuel cycle, uranium and thorium fuels are considered. The fuel burnup performance and power distribution are evaluated and compared among other important design parameters. Reactor physics codes, nuclear data libraries, and calculation models and procedures used for the design and analysis are reviewed, and challenges for future improvements are discussed.
- 2 February 2026
- Published by MDPI AG in Quantum Beam Science
- Vol. 10 (1) , 5
Open AccessOptimized Neutronics Designs of the Indonesian Experimental Power Reactor/RDE (Comprehensive Review and Future Challenges)
In this paper, several optimized design results of the HTGR-based 10 MWth Reaktor Daya Eksperimental (RDE) (Experimental Power Reactor), so far conducted, are reviewed and compared from the neutronics, reactor types, refueling schemes, and fuel cycle points of view. The review covers the multipass and once-through-then-out (OTTO) pebble-bed cores, as well as block/prismatic type cores with several fuel shuffling options. As for the fuel cycle, uranium and thorium fuels are considered. The fuel burnup performance and power distribution are evaluated and compared among other important design parameters. Reactor physics codes, nuclear data libraries, and calculation models and procedures used for the design and analysis are reviewed, and challenges for future improvements are discussed.
- Open Access
- 23 April 2025
- Published by MDPI AG in Journal of Nuclear Engineering
- Vol. 6 (2) , 11
The Application of JENDL-5.0 Covariance Libraries to the Keff Uncertainty Analysis of the HTTR Criticality Benchmark
In this study, a 56-group covariance library was generated based on the recently released JENDL-5 covariance data, which cover 105 isotopes. The AMPX-6 code system facilitated the generation of this library. Subsequently, the TSUNAMI-IP code was employed to estimate the uncertainty in the effective neutron multiplication factor (keff) for the critical experiment conducted in the Japanese High-Temperature Test Reactor (HTTR). Our analysis involved comparing results obtained from three nuclear data libraries: JENDL-5, ENDF/B-VIII.0, and ENDF/B-VII.1. The keff uncertainty originated from the nuclear data of JENDL-5, ENDF/B-VIII.0, and ENDF/B-VII.1 and were estimated to be 0.387%, 0.581%, and 0.556%, respectively. Interestingly, when the JENDL-5 covariance library was combined with ENDF/B-VIII.0 for JENDL-5 nuclides lacking covariance data, the keff uncertainty increased to 0.464%. The primary contributors to the keff uncertainty, ranked in decreasing order, were U-235 (nubar), C-12 (n,gamma), U-235 (fission), C-12 (elastic), and U-238 (n,gamma). Notably, significant differences in the keff uncertainty were observed between JENDL-5 and ENDF/B-VIII.0, particularly for U-235 (nubar) and C-12 (elastic). Additionally, the sensitivity coefficients, similarity, and kinetics parameters were evaluated across the three libraries, leading to insightful inter-library comparison results.
- 23 April 2025
- Published by MDPI AG in Journal of Nuclear Engineering
- Vol. 6 (2) , 11
Open AccessThe Application of JENDL-5.0 Covariance Libraries to the Keff Uncertainty Analysis of the HTTR Criticality Benchmark
In this study, a 56-group covariance library was generated based on the recently released JENDL-5 covariance data, which cover 105 isotopes. The AMPX-6 code system facilitated the generation of this library. Subsequently, the TSUNAMI-IP code was employed to estimate the uncertainty in the effective neutron multiplication factor (keff) for the critical experiment conducted in the Japanese High-Temperature Test Reactor (HTTR). Our analysis involved comparing results obtained from three nuclear data libraries: JENDL-5, ENDF/B-VIII.0, and ENDF/B-VII.1. The keff uncertainty originated from the nuclear data of JENDL-5, ENDF/B-VIII.0, and ENDF/B-VII.1 and were estimated to be 0.387%, 0.581%, and 0.556%, respectively. Interestingly, when the JENDL-5 covariance library was combined with ENDF/B-VIII.0 for JENDL-5 nuclides lacking covariance data, the keff uncertainty increased to 0.464%. The primary contributors to the keff uncertainty, ranked in decreasing order, were U-235 (nubar), C-12 (n,gamma), U-235 (fission), C-12 (elastic), and U-238 (n,gamma). Notably, significant differences in the keff uncertainty were observed between JENDL-5 and ENDF/B-VIII.0, particularly for U-235 (nubar) and C-12 (elastic). Additionally, the sensitivity coefficients, similarity, and kinetics parameters were evaluated across the three libraries, leading to insightful inter-library comparison results.
- 22 January 2024
- Published by Taylor & Francis in Nuclear Science and Engineering
- Vol. 198 (10) , 1935-1949
Evaluation of Kinetic Parameters RSG-GAS Reactor Equilibrium Silicide Core Using Continuous-Energy Monte Carlo Serpent 2 Code
- 22 January 2024
- Published by Taylor & Francis in Nuclear Science and Engineering
- Vol. 198 (10) , 1935-1949
Evaluation of Kinetic Parameters RSG-GAS Reactor Equilibrium Silicide Core Using Continuous-Energy Monte Carlo Serpent 2 Code
- 8 February 2023
- Published by ASME International in Journal of Nuclear Engineering and Radiation Science
- Vol. 9 (3) , 1-36
Improvement of Few-Group Homogenized Cross-Sections for RSG-GAS In-Core Fuel Management Code Batan-FUEL
This paper presents the generation and the verification of the few-group homogenized cross section for Batan-FUEL code. This code is routinely used for fuel management in the G. A. Siwabessy Multipurpose Reactor (RSG-GAS). The Monte Carlo code Serpent 2 code, in conjunction with the latest nuclear data library ENDF/B-VIII.0, was used. Calculations using the existing newly generated few-group cross section data were carried out for the 88th core. The calculated core parameters such as excess reactivity and control rod worth are compared to the available experimental data. On the other hand, the fuel burnup fraction and radial power peaking factor (PPF) are compared to the results of Serpent 2. It was shown that the new cross section data have more consistency and a better agreement excess reactivity and control rod worth compared to the experimental data. Similarly, the U-235 burnup fraction and radial power peaking factor by the new cross section data are also shown to concur well with Serpent 2. The newly generated few-group cross section is recommended to replace the existing ones for the fuel management of RSG-GAS.
- 8 February 2023
- Published by ASME International in Journal of Nuclear Engineering and Radiation Science
- Vol. 9 (3) , 1-36
Improvement of Few-Group Homogenized Cross-Sections for RSG-GAS In-Core Fuel Management Code Batan-FUEL
This paper presents the generation and the verification of the few-group homogenized cross section for Batan-FUEL code. This code is routinely used for fuel management in the G. A. Siwabessy Multipurpose Reactor (RSG-GAS). The Monte Carlo code Serpent 2 code, in conjunction with the latest nuclear data library ENDF/B-VIII.0, was used. Calculations using the existing newly generated few-group cross section data were carried out for the 88th core. The calculated core parameters such as excess reactivity and control rod worth are compared to the available experimental data. On the other hand, the fuel burnup fraction and radial power peaking factor (PPF) are compared to the results of Serpent 2. It was shown that the new cross section data have more consistency and a better agreement excess reactivity and control rod worth compared to the experimental data. Similarly, the U-235 burnup fraction and radial power peaking factor by the new cross section data are also shown to concur well with Serpent 2. The newly generated few-group cross section is recommended to replace the existing ones for the fuel management of RSG-GAS.
- Open Access
- 15 January 2023
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 55 (5) , 1775-1782
Evaluation of neutronics parameters during RSG-GAS commissioning by using Monte Carlo code
- 15 January 2023
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 55 (5) , 1775-1782
Open AccessEvaluation of neutronics parameters during RSG-GAS commissioning by using Monte Carlo code
- 27 December 2022
- Published by Elsevier in Progress in Nuclear Energy
- Vol. 156
Control rods’ position history effect on the Indonesian multipurpose research reactor RSG-GAS operation and safety parameters
- 27 December 2022
- Published by Elsevier in Progress in Nuclear Energy
- Vol. 156
Control rods’ position history effect on the Indonesian multipurpose research reactor RSG-GAS operation and safety parameters
- 6 September 2021
- Published by Hindawi Limited in International Journal of Energy Research
- Vol. 46 (2) , 1327-1338
Performance indices optimization of l ong‐lived fission products transmutation in fast reactors
An investigation on the nuclear transmutations of elemental long-lived fission products (LLFPs) in a fast reactor is being conducted in Japan, focusing on the Se-79, Zr-93, Tc-99, Pd-107, I-129, and Cs-135, to reduce the environmental burden. With their high neutron flux and adequate excessive neutrons, fast reactors are considered strong candidates for transmuting those LLFPs into stable isotopes or shorter effective half-lives under the partition and transmutation (P/T) strategy. In this investigation, the LLFP subassembly is assumed to be loaded into the radial blanket region of a Japanese MONJU class sodium-cooled fast reactor (710 MWth). This work focuses on two LLFPs, namely, I-129 and Tc-99. The LLFPs are mixed with YD2 or YH2 moderator material to enhance the LLFP transmutation rate. The results include the optimal position of the LLFP assembly in the radial blanket and the optimal moderator volume fraction to optimize the transmutation performance indices, that is, the transmutation rate (TR, %/year), the support factor (SF is defined as the ratio of transmuted to produced LLFP), and the effective half-life (T-half) of the LLFPs. A countermeasure is also devised to resolve the expected higher power peak at the fuel assembly adjacent to the LLFP assembly. The neutronics and burnup analyses are conducted using the continuous-energy Monte Carlo SERPENT2 code with the JENDL-4.0 nuclear data library.
- 6 September 2021
- Published by Hindawi Limited in International Journal of Energy Research
- Vol. 46 (2) , 1327-1338
Performance indices optimization of l ong‐lived fission products transmutation in fast reactors
An investigation on the nuclear transmutations of elemental long-lived fission products (LLFPs) in a fast reactor is being conducted in Japan, focusing on the Se-79, Zr-93, Tc-99, Pd-107, I-129, and Cs-135, to reduce the environmental burden. With their high neutron flux and adequate excessive neutrons, fast reactors are considered strong candidates for transmuting those LLFPs into stable isotopes or shorter effective half-lives under the partition and transmutation (P/T) strategy. In this investigation, the LLFP subassembly is assumed to be loaded into the radial blanket region of a Japanese MONJU class sodium-cooled fast reactor (710 MWth). This work focuses on two LLFPs, namely, I-129 and Tc-99. The LLFPs are mixed with YD2 or YH2 moderator material to enhance the LLFP transmutation rate. The results include the optimal position of the LLFP assembly in the radial blanket and the optimal moderator volume fraction to optimize the transmutation performance indices, that is, the transmutation rate (TR, %/year), the support factor (SF is defined as the ratio of transmuted to produced LLFP), and the effective half-life (T-half) of the LLFPs. A countermeasure is also devised to resolve the expected higher power peak at the fuel assembly adjacent to the LLFP assembly. The neutronics and burnup analyses are conducted using the continuous-energy Monte Carlo SERPENT2 code with the JENDL-4.0 nuclear data library.
- 1 September 2021
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 381
Neutron importance based lattice-to-core projection technique and its application for HTGR design using Monte Carlo method
- 1 September 2021
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 381
Neutron importance based lattice-to-core projection technique and its application for HTGR design using Monte Carlo method
- 4 December 2020
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 31 (12) , 1-11
Analysis of OECD/NEA medium 1000 MWth sodium-cooled fast reactor using the Monte Carlo serpent code and ENDF/B-VIII.0 nuclear data library
- 4 December 2020
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 31 (12) , 1-11
Analysis of OECD/NEA medium 1000 MWth sodium-cooled fast reactor using the Monte Carlo serpent code and ENDF/B-VIII.0 nuclear data library