Juan Felipe Franco-Gonzalez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Juan Felipe Franco-Gonzalez has a total of 72 co-authors. Here are the top co-authors by number of shared publications:
- Igor Zozoulenko
Wallenberg Wood Science Center
14 shared publications - Javier Ramos
BIOPHYM, Department of Macromolecular Physics, Instituto de Estructura de la Materia, IEM-CSIC, C/Serrano 113 bis, 28006 Madrid, Spain
4 shared publications Sandeep Kumar Singh
Department of Science and Technology, Organic Electronics Linkoping University Norrkoping SE‐601 74 Sweden
4 shared publications- Alejandra Matamoros-Recio
Department of Structural and Chemical Biology, Centro de Investigaciones Biológicas Margarita Salas (CSIC) 28040 Madrid Spain
3 shared publications - Eleni Stavrinidou
Laboratory of Organic Electronics, Department of Science and Technology, Linköping University, SE-60174, Norrköping, Sweden
3 shared publications - Javier Martínez-Salazar
Biophym, Departamento de Física Macromolecular, Instituto de Estructura de la Materia, CSIC, C/Serrano 113 bis, 28006 Madrid, Spain
3 shared publications
Latest Publications
- Open Access
- 25 October 2021
- Published by Wiley in Chemistry – A European Journal
- Vol. 27 (62) , 15274
Cover Feature: Full‐Atom Model of the Agonist LPS‐Bound Toll‐like Receptor 4 Dimer in a Membrane Environment (Chem. Eur. J. 62/2021)
- 25 October 2021
- Published by Wiley in Chemistry – A European Journal
- Vol. 27 (62) , 15274
Open AccessCover Feature: Full‐Atom Model of the Agonist LPS‐Bound Toll‐like Receptor 4 Dimer in a Membrane Environment (Chem. Eur. J. 62/2021)
- Open Access
- 26 September 2021
- Published by Wiley in Chemistry – A European Journal
- Vol. 27 (62) , 15406-15425
Full‐Atom Model of the Agonist LPS‐Bound Toll‐like Receptor 4 Dimer in a Membrane Environment
The Toll‐like receptor 4 (TLR4)/myeloid differentiation factor 2 (MD‐2) innate immunity system is a membrane receptor of paramount importance as therapeutic target. Its assembly, upon binding of Gram‐negative bacteria lipopolysaccharide (LPS), and also dependent on the membrane composition, finally triggers the immune response cascade. We have combined ab‐initio calculations, molecular docking, all‐atom molecular dynamics simulations, and thermodynamics calculations to provide the most realistic and complete 3D models of the active full TLR4 complex embedded into a realistic membrane to date. Our studies give functional and structural insights into the transmembrane domain behavior in different membrane environments, the ectodomain bouncing movement, and the dimerization patterns of the intracellular Toll/Interleukin‐1 receptor domain. Our work provides TLR4 models as reasonable 3D structures for the (TLR4/MD‐2/LPS)2 architecture accounting for the active (agonist) state of the TLR4, and pointing to a signal transduction mechanism across cell membrane. These observations unveil relevant molecular aspects involved in the TLR4 innate immune pathways and will promote the discovery of new TLR4 modulators.
- 26 September 2021
- Published by Wiley in Chemistry – A European Journal
- Vol. 27 (62) , 15406-15425
Open AccessFull‐Atom Model of the Agonist LPS‐Bound Toll‐like Receptor 4 Dimer in a Membrane Environment
The Toll‐like receptor 4 (TLR4)/myeloid differentiation factor 2 (MD‐2) innate immunity system is a membrane receptor of paramount importance as therapeutic target. Its assembly, upon binding of Gram‐negative bacteria lipopolysaccharide (LPS), and also dependent on the membrane composition, finally triggers the immune response cascade. We have combined ab‐initio calculations, molecular docking, all‐atom molecular dynamics simulations, and thermodynamics calculations to provide the most realistic and complete 3D models of the active full TLR4 complex embedded into a realistic membrane to date. Our studies give functional and structural insights into the transmembrane domain behavior in different membrane environments, the ectodomain bouncing movement, and the dimerization patterns of the intracellular Toll/Interleukin‐1 receptor domain. Our work provides TLR4 models as reasonable 3D structures for the (TLR4/MD‐2/LPS)2 architecture accounting for the active (agonist) state of the TLR4, and pointing to a signal transduction mechanism across cell membrane. These observations unveil relevant molecular aspects involved in the TLR4 innate immune pathways and will promote the discovery of new TLR4 modulators.
- 2 September 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 125 (36) , 10324-10334
How Long are Polymer Chains in Poly(3,4-ethylenedioxythiophene):Tosylate Films? An Insight from Molecular Dynamics Simulations
Poly(3,4-ethylenedioxythiophene) (PEDOT) is one of the most important conductive polymers utilized in a variety of applications in organic electronics and bioelectronics and energy storage. PEDOT chains are believed to be rather short, but detailed knowledge of their length is missing because of the challenges in its experimental determination due to insolubility of PEDOT films. Here, we report a molecular dynamics (MD) study of in situ oxidative chemical polymerization and simultaneous crystallization of molecularly doped PEDOT focusing on the determination of its chain lengths at different polymerization temperatures. We find the average chain length to be 6, 7, and 11 monomers for 298, 323 and 373 K, respectively. At the same time, the length distribution is rather broad, for example, between 2 and 16 monomer units for T = 323 K. We demonstrate that the limiting factor determining the chain length is the diffusivity of the reactants (PEDOT monomers and oligomers). We also study the polymer film formation during solvent evaporation, and we find that although crystallization starts and proceeds already during the polymerization and doping phases, it mostly occurs during the evaporation phase. Finally, we believe that our results providing the oligomer chain length and polymerization and crystallization mechanisms obtained by means of MD “computational microscopy” provide an important insight into the morphology of PEDOT that cannot be obtained by other means.
- 2 September 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 125 (36) , 10324-10334
How Long are Polymer Chains in Poly(3,4-ethylenedioxythiophene):Tosylate Films? An Insight from Molecular Dynamics Simulations
Poly(3,4-ethylenedioxythiophene) (PEDOT) is one of the most important conductive polymers utilized in a variety of applications in organic electronics and bioelectronics and energy storage. PEDOT chains are believed to be rather short, but detailed knowledge of their length is missing because of the challenges in its experimental determination due to insolubility of PEDOT films. Here, we report a molecular dynamics (MD) study of in situ oxidative chemical polymerization and simultaneous crystallization of molecularly doped PEDOT focusing on the determination of its chain lengths at different polymerization temperatures. We find the average chain length to be 6, 7, and 11 monomers for 298, 323 and 373 K, respectively. At the same time, the length distribution is rather broad, for example, between 2 and 16 monomer units for T = 323 K. We demonstrate that the limiting factor determining the chain length is the diffusivity of the reactants (PEDOT monomers and oligomers). We also study the polymer film formation during solvent evaporation, and we find that although crystallization starts and proceeds already during the polymerization and doping phases, it mostly occurs during the evaporation phase. Finally, we believe that our results providing the oligomer chain length and polymerization and crystallization mechanisms obtained by means of MD “computational microscopy” provide an important insight into the morphology of PEDOT that cannot be obtained by other means.
- 24 June 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (13) , 5915-5934
Electronic, Optical, Morphological, Transport, and Electrochemical Properties of PEDOT: A Theoretical Perspective
- 24 June 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (13) , 5915-5934
Electronic, Optical, Morphological, Transport, and Electrochemical Properties of PEDOT: A Theoretical Perspective
- Open Access
- 26 February 2021
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 6 (9) , 6041-6054
Understanding the Antibacterial Resistance: Computational Explorations in Bacterial Membranes
- 26 February 2021
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 6 (9) , 6041-6054
Open AccessUnderstanding the Antibacterial Resistance: Computational Explorations in Bacterial Membranes
- Open Access
- 1 March 2020
- Published by Elsevier in European Journal of Medicinal Chemistry
- Vol. 190, 112090
Tuning melatonin receptor subtype selectivity in oxadiazolone-based analogues: Discovery of QR2 ligands and NRF2 activators with neurogenic properties
- 1 March 2020
- Published by Elsevier in European Journal of Medicinal Chemistry
- Vol. 190, 112090
Open AccessTuning melatonin receptor subtype selectivity in oxadiazolone-based analogues: Discovery of QR2 ligands and NRF2 activators with neurogenic properties
- 8 October 2019
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 1 (11) , 2833-2839
Can Mobility Negative Temperature Coefficient Be Reconciled with the Hopping Character of Transport in Conducting Polymers?
- 8 October 2019
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 1 (11) , 2833-2839
Can Mobility Negative Temperature Coefficient Be Reconciled with the Hopping Character of Transport in Conducting Polymers?
- Open Access
- 4 March 2019
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 21 (12) , 6699-6711
Computational microscopy study of the granular structure and pH dependence of PEDOT:PSS
A coarse grained molecular dynamics simulation for the morphology of PEDOT:PSS at different pH.
- 4 March 2019
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 21 (12) , 6699-6711
Open AccessComputational microscopy study of the granular structure and pH dependence of PEDOT:PSS
A coarse grained molecular dynamics simulation for the morphology of PEDOT:PSS at different pH.
- Open Access
- 22 August 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (43) , 21304-21312
Vapor phase synthesized poly(3,4-ethylenedioxythiophene)-trifluoromethanesulfonate as a transparent conductor material
Inorganic transparent conductive oxides have dominated the market as transparent electrodes due to their high conductivity and transparency. Here, we report the fabrication and optimization of the synthesis of poly(3,4-ethylenedioxythiophene) trifluoromethanesulfonate via vapor phase polymerization for the potential replacement of such inorganic materials. The parameters and conditions of the polymerization were investigated and an electrical conductivity of 3800 S cm−1 and 4500 S cm−1 after acid treatment were obtained while maintaining an absorbance similar to that of commercial indium tin oxide. This increase in electrical conductivity was rationalized experimentally and theoretically to an increase in the oxidation level and a higher order of crystallinity which does not disrupt the π–π stacking of PEDOT chains.
- 22 August 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (43) , 21304-21312
Open AccessVapor phase synthesized poly(3,4-ethylenedioxythiophene)-trifluoromethanesulfonate as a transparent conductor material
Inorganic transparent conductive oxides have dominated the market as transparent electrodes due to their high conductivity and transparency. Here, we report the fabrication and optimization of the synthesis of poly(3,4-ethylenedioxythiophene) trifluoromethanesulfonate via vapor phase polymerization for the potential replacement of such inorganic materials. The parameters and conditions of the polymerization were investigated and an electrical conductivity of 3800 S cm−1 and 4500 S cm−1 after acid treatment were obtained while maintaining an absorbance similar to that of commercial indium tin oxide. This increase in electrical conductivity was rationalized experimentally and theoretically to an increase in the oxidation level and a higher order of crystallinity which does not disrupt the π–π stacking of PEDOT chains.