Karen D. Vernon-Parry
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Karen D. Vernon-Parry has a total of 62 co-authors. Here are the top co-authors by number of shared publications:
J.H. Evans-Freeman
7 shared publications- Anthony R. Peaker
Photon Science Institute and Department of Electrical and Electronic Engineering, The University of Manchester 1 , Manchester M13 9PL
6 shared publications J H Evans-Freeman
University of Canterbury
3 shared publicationsP. Dawson
School of Physics and Astronomy, The University of Manchester, Manchester M13 9PL, United Kingdom
3 shared publicationsC.J. Humphreys
2 shared publicationsC.R.M. Grovenor
Department of Materials, University of Oxford, Parks Road, OX1 3PH, United Kingdom
2 shared publications
Latest Publications
- 23 October 2015
- Published by Trans Tech Publications, Ltd. in Solid State Phenomena
- Vol. 242, 41-47
Potential Synthesis of Solar-Grade Silicon from Rice Husk Ash
Rice husk, an agricultural waste product obtained in large quantities in many countries including Nigeria, is very rich in siliceous materials. It has been known for several decades that, with careful processing, rice husk can be a source of metallurgical grade silicon [1]. The question remains as to whether rice husk ash (RHA) can be purified by a cost-effective, low technology route to produce solar-grade silicon suitable for use in photovoltaic devices. In Nigeria this would have the benefit of transforming large volumes (> 600,000 tonnes per annum) of agricultural waste into a partial solution to that country's issue with energy distribution.In this work, high purity silica has been prepared from RHA (ashed at 700°C for 5 and 12 hours) using a hydrometallurgical process. We report on the effect of natural variations in the rice husk composition on the effectiveness of the hydrometallurgical purification; the effectiveness of each stage of the hydrometallurgical process in removing impurity elements. While the hydrometallurgical purification of RHA is effective in removing impurities such as Ti and Fe to levels below the limits of detection of X-ray fluorescence (XRF), B and P levels need to be reduced to < 1017cm-3 well below the detection limits of XRF. The resultant silica has been subsequently reduced to metallurgical-grade silicon (MG-Si) by direct reduction using Mg powder.
- 23 October 2015
- Published by Trans Tech Publications, Ltd. in Solid State Phenomena
- Vol. 242, 41-47
Potential Synthesis of Solar-Grade Silicon from Rice Husk Ash
Rice husk, an agricultural waste product obtained in large quantities in many countries including Nigeria, is very rich in siliceous materials. It has been known for several decades that, with careful processing, rice husk can be a source of metallurgical grade silicon [1]. The question remains as to whether rice husk ash (RHA) can be purified by a cost-effective, low technology route to produce solar-grade silicon suitable for use in photovoltaic devices. In Nigeria this would have the benefit of transforming large volumes (> 600,000 tonnes per annum) of agricultural waste into a partial solution to that country's issue with energy distribution.In this work, high purity silica has been prepared from RHA (ashed at 700°C for 5 and 12 hours) using a hydrometallurgical process. We report on the effect of natural variations in the rice husk composition on the effectiveness of the hydrometallurgical purification; the effectiveness of each stage of the hydrometallurgical process in removing impurity elements. While the hydrometallurgical purification of RHA is effective in removing impurities such as Ti and Fe to levels below the limits of detection of X-ray fluorescence (XRF), B and P levels need to be reduced to < 1017cm-3 well below the detection limits of XRF. The resultant silica has been subsequently reduced to metallurgical-grade silicon (MG-Si) by direct reduction using Mg powder.
- 1 August 2012
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 407 (15) , 2960-2963
Characterisation of defects in p-GaN by admittance spectroscopy
- 1 August 2012
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 407 (15) , 2960-2963
Characterisation of defects in p-GaN by admittance spectroscopy
- 1 August 2012
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 407 (15)
Preface
- 21 May 2012
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 27 (6) , 65019
Effect of doping on electronic states in B-doped polycrystalline CVD diamond films
- 21 May 2012
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 27 (6) , 65019
Effect of doping on electronic states in B-doped polycrystalline CVD diamond films
- 14 May 2012
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 717-720, 1315-1318
Electrical Characterisation of Defects in Polycrystalline B-Doped Diamond Films
Admittance spectroscopy (AS) and deep level transient spectroscopy (DLTS) have been applied to B-doped thin polycrystalline diamond films deposited on p+-silicon by hot filament chemical vapour deposition. Films with two boron concentrations (1.5×10^19 cm-3 and 4×10^19 cm-3) were selected to study the effect of B concentration on the electronic states in CVD-diamond. We have investigated whether these deep states arise from point or extended defects. DLTS and AS find two hole traps, E1 (0.29±0.03 eV) and E2 (0.53±0.07 eV), in both films. A third level, E3 (0.36±0.02 eV) was also detected in the more highly doped film. The defect levels E1 and E2 exhibited behaviour typical of extended defects, which we suggest may be due to B segregated to the grain boundaries. In contrast, the defect level E3 exhibited behaviour characteristic of an isolated point defect, which we attribute to B-related centres in bulk diamond.
- 14 May 2012
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 717-720, 1315-1318
Electrical Characterisation of Defects in Polycrystalline B-Doped Diamond Films
Admittance spectroscopy (AS) and deep level transient spectroscopy (DLTS) have been applied to B-doped thin polycrystalline diamond films deposited on p+-silicon by hot filament chemical vapour deposition. Films with two boron concentrations (1.5×10^19 cm-3 and 4×10^19 cm-3) were selected to study the effect of B concentration on the electronic states in CVD-diamond. We have investigated whether these deep states arise from point or extended defects. DLTS and AS find two hole traps, E1 (0.29±0.03 eV) and E2 (0.53±0.07 eV), in both films. A third level, E3 (0.36±0.02 eV) was also detected in the more highly doped film. The defect levels E1 and E2 exhibited behaviour typical of extended defects, which we suggest may be due to B segregated to the grain boundaries. In contrast, the defect level E3 exhibited behaviour characteristic of an isolated point defect, which we attribute to B-related centres in bulk diamond.
- 1 January 2012
- Published by Elsevier in Thin Solid Films
- Vol. 520 (7) , 3064-3070
Characterization of defects in Mg doped GaN epitaxial layers using conductance measurements
- 1 January 2012
- Published by Elsevier in Thin Solid Films
- Vol. 520 (7) , 3064-3070
Characterization of defects in Mg doped GaN epitaxial layers using conductance measurements
- 8 June 2010
- Published by Springer Nature in Journal of Electroceramics
- Vol. 25 (2-4) , 188-197
Deep level transient spectroscopy study of the effect of Mn and Bi doping on trap formation in ZnO
- 8 June 2010
- Published by Springer Nature in Journal of Electroceramics
- Vol. 25 (2-4) , 188-197
Deep level transient spectroscopy study of the effect of Mn and Bi doping on trap formation in ZnO
- 1 July 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10972137,p. 16-19
High resolution Deep Level Transient Spectroscopy of p-n diodes formed from p-type polycrystalline diamond on n-type silicon.
High resolution Laplace deep level transient spectroscopy (LDLTS) at temperatures up to 450 K has been applied to thin polycrystalline semiconducting diamond films deposited on n-type silicon. Such structures form p-n diodes and can be characterised by capacitance DLTS. The boron doped diamond films were grown by hot filament chemical vapour deposition and the diamond film thickness was 3-4 microns. The boron concentration in the diamond films ranged from 7times1018 cm-3 to 1times1019 cm-3. In the LDLTS an isothermal measurement of thousands of capacitance transients was made and then averaged, and the result was inverse transformed to find the trap emission rate. The temperature was chosen as the maximum of the conventional DLTS emission peak. Conventional DLTS showed a combination of majority and minority carrier emission from deep levels. Multiple peaks in the LDLTS spectra suggest that some of the defects are located in a strain field. Capture cross section measurements also show that these peaks exhibit a time dependent capture cross section, which is indicative of carriers being trapped at a large electrically active defect. It is shown in the paper that a combination of LDLTS and direct capture cross section measurements can be applied to semiconducting diamond and can be used to understand whether defects possess single or multiple energy levels, and whether the trapping is at an isolated point defect or in defects in the strain field of an extended defect.
- 1 July 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10972137,p. 16-19
High resolution Deep Level Transient Spectroscopy of p-n diodes formed from p-type polycrystalline diamond on n-type silicon.
High resolution Laplace deep level transient spectroscopy (LDLTS) at temperatures up to 450 K has been applied to thin polycrystalline semiconducting diamond films deposited on n-type silicon. Such structures form p-n diodes and can be characterised by capacitance DLTS. The boron doped diamond films were grown by hot filament chemical vapour deposition and the diamond film thickness was 3-4 microns. The boron concentration in the diamond films ranged from 7times1018 cm-3 to 1times1019 cm-3. In the LDLTS an isothermal measurement of thousands of capacitance transients was made and then averaged, and the result was inverse transformed to find the trap emission rate. The temperature was chosen as the maximum of the conventional DLTS emission peak. Conventional DLTS showed a combination of majority and minority carrier emission from deep levels. Multiple peaks in the LDLTS spectra suggest that some of the defects are located in a strain field. Capture cross section measurements also show that these peaks exhibit a time dependent capture cross section, which is indicative of carriers being trapped at a large electrically active defect. It is shown in the paper that a combination of LDLTS and direct capture cross section measurements can be applied to semiconducting diamond and can be used to understand whether defects possess single or multiple energy levels, and whether the trapping is at an isolated point defect or in defects in the strain field of an extended defect.
- 15 January 2008
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 146 (1) , 231-235
The effect of hole confinement on photoluminescence from Er in SiGe/Si quantum wells
- 15 January 2008
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 146 (1) , 231-235
The effect of hole confinement on photoluminescence from Er in SiGe/Si quantum wells
- 1 May 2006
- Published by Elsevier in Optical Materials
- Vol. 28 (6-7) , 802-809
Optical and electrical activity of defects in rare earth implanted Si
- 1 May 2006
- Published by Elsevier in Optical Materials
- Vol. 28 (6-7) , 802-809
Optical and electrical activity of defects in rare earth implanted Si