Krzysztof P. Kowalski
Krzysztof P. Kowalski has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Erik Gydesen Soegaard
Department of Chemistry and Bioscience, Aalborg University, 6700 Esbjerg, Denmark
4 shared publications - David Kofi Essumang
Department of Chemistry, Faculty of Science, University of Cape Coast, Cape Coast, Ghana
1 shared publication E. G. Søgaard
Colloid and Interface Chemistry Group, Aalborg University Esbjerg, Niels Bohrs Vej 8, 6700 Esbjerg, Denmark
1 shared publication- Henrik Tækker Madsen
Department of Biotechnology, Chemistry and Environmental Engineering, Aalborg University, Niels Bohrs Vej 8, 6700 Esbjerg, Denmark
1 shared publication - Jens Muff
Department of Chemistry and Bioscience, Aalborg University, Niels Bohrs Vej 8A, 6700 Esbjerg, Denmark
1 shared publication - Katarzyna Ratajczyk Arturi
Department of Environmental Chemistry
1 shared publication
Latest Publications
- 1 December 2014
- Published by Elsevier in Chemosphere
- Vol. 117, 108-114
Implementation of zero-valent iron (ZVI) into drinking water supply – Role of the ZVI and biological processes
- 1 December 2014
- Published by Elsevier in Chemosphere
- Vol. 117, 108-114
Implementation of zero-valent iron (ZVI) into drinking water supply – Role of the ZVI and biological processes
- 31 January 2014
- Published by IWA Publishing in Water Supply
- Vol. 14 (4) , 532-539
Comparison of sand and membrane filtration as non-chemical pre-treatment strategies for pesticide removal with nanofiltration/low pressure reverse osmosis membranes
Pilot plant investigations of sand and membrane filtration (microfiltration (MF)/ultrafiltration (UF)/nanofiltration (NF)/low pressure reverse osmosis (LPRO)) have been performed to treat groundwater polluted with pesticides. The results show that simple treatment, with use of aeration and sand filtration or MF/UF membranes, does not remove pesticides. However, by reducing the content of key foulants, the techniques can be used as a pre-treatment for nanofiltration and low pressure reverse osmosis that has proved to be capable of removing pesticides. It was found that a lower fouling potential could be obtained by using the membranes, but that sand filter was better at removing manganese and dissolved organic matter. The results indicate that combining aeration, sand filtration and membrane techniques might be a good option for pesticide removal without any addition of chemicals and minimized membrane maintenance.
- 31 January 2014
- Published by IWA Publishing in Water Supply
- Vol. 14 (4) , 532-539
Comparison of sand and membrane filtration as non-chemical pre-treatment strategies for pesticide removal with nanofiltration/low pressure reverse osmosis membranes
Pilot plant investigations of sand and membrane filtration (microfiltration (MF)/ultrafiltration (UF)/nanofiltration (NF)/low pressure reverse osmosis (LPRO)) have been performed to treat groundwater polluted with pesticides. The results show that simple treatment, with use of aeration and sand filtration or MF/UF membranes, does not remove pesticides. However, by reducing the content of key foulants, the techniques can be used as a pre-treatment for nanofiltration and low pressure reverse osmosis that has proved to be capable of removing pesticides. It was found that a lower fouling potential could be obtained by using the membranes, but that sand filter was better at removing manganese and dissolved organic matter. The results indicate that combining aeration, sand filtration and membrane techniques might be a good option for pesticide removal without any addition of chemicals and minimized membrane maintenance.
- Open Access
- 30 September 2013
- Published by IWA Publishing in Water Supply
- Vol. 14 (3) , 347-357
Removal of arsenic from contaminated groundwater with application of iron electrodissolution, aeration and sand filtration
The results from a new water treatment system for arsenic removal are presented. The technology is based on the employment of an electrolytic iron dissolution and efficient aeration procedure prior to sand filtration. The treatment was introduced and investigated in a pilot scale plant and full scale waterworks. The pilot scale results showed the potential for efficient arsenic removal from spiked solutions (with As in the range of 50–85 μg/L) depending on the process conditions (flow and applied current). In the waterworks where the system was implemented for a period of 14 months, there was a relationship where the higher applied current from the iron generator resulted in a better quality of water produced. The long period of use also helped to determine a proper iron dosage (the Fe/As ratio 68 mg/mg) and identify carbonate scale formation in the electrochemical process. The electrolytic dissolution of the Fe was found to be a practical method for iron dosing; however more work has to be done on process improvement and optimization that will focus on the Fe anode geometry.
- 30 September 2013
- Published by IWA Publishing in Water Supply
- Vol. 14 (3) , 347-357
Open AccessRemoval of arsenic from contaminated groundwater with application of iron electrodissolution, aeration and sand filtration
The results from a new water treatment system for arsenic removal are presented. The technology is based on the employment of an electrolytic iron dissolution and efficient aeration procedure prior to sand filtration. The treatment was introduced and investigated in a pilot scale plant and full scale waterworks. The pilot scale results showed the potential for efficient arsenic removal from spiked solutions (with As in the range of 50–85 μg/L) depending on the process conditions (flow and applied current). In the waterworks where the system was implemented for a period of 14 months, there was a relationship where the higher applied current from the iron generator resulted in a better quality of water produced. The long period of use also helped to determine a proper iron dosage (the Fe/As ratio 68 mg/mg) and identify carbonate scale formation in the electrochemical process. The electrolytic dissolution of the Fe was found to be a practical method for iron dosing; however more work has to be done on process improvement and optimization that will focus on the Fe anode geometry.
- 4 March 2011
- Published by Springer Nature in Bulletin of Environmental Contamination and Toxicology
- Vol. 86 (4) , 438-443
Levels, Distribution and Source Characterization of Polycyclic Aromatic Hydrocarbons (PAHs) in Topsoils and Roadside Soils in Esbjerg, Denmark
A soil survey was performed to determine the levels, distributions and sources of 6 polycyclic aromatic hydrocarbons (PAHs) in 9 selected soil environments in Esbjerg, Denmark. In all, 24 soil samples were collected and the PAHs present were extracted with dichloromethane and analysed using GC/MS/MS with ion trap detector (TCD). There were elevated levels of the individual as well as the total PAHs in the soil samples and also, all 6 PAHs were present in all the soil samples. The most abundant components were fluoranthene, benzo(b)fluoranthene and benzo(a)pyrene. The average sum of the 6 PAHs in all soil samples was 2.5 mg.kg−1, with range from 0.24 to 7.6 mg kg−1. The total mean PAH concentration obtained was 1.67 times higher than the total limit set by the Danish Environmental Protection Agency (DEPA) whiles the mean benzo(a)pyrene (BaP) concentration (0.6 mg kg−1) also 6 times the Soil Quality Criteria (Human Health) (0.1 mg kg−1) by DEPA and 2 times the Maximum Permissible Concentrations (0.26 mg kg−1) by the Netherlands for BaP. This shows that there are elevated levels of PAH deposition on the Esbjerg soil environment which needs an urgent attention. The diagnostic ratios and the correlation analysis identified mixed petrogenic and pyrogenic sources as the main contributors of PAHs on the Esbjerg environment.
- 4 March 2011
- Published by Springer Nature in Bulletin of Environmental Contamination and Toxicology
- Vol. 86 (4) , 438-443
Levels, Distribution and Source Characterization of Polycyclic Aromatic Hydrocarbons (PAHs) in Topsoils and Roadside Soils in Esbjerg, Denmark
A soil survey was performed to determine the levels, distributions and sources of 6 polycyclic aromatic hydrocarbons (PAHs) in 9 selected soil environments in Esbjerg, Denmark. In all, 24 soil samples were collected and the PAHs present were extracted with dichloromethane and analysed using GC/MS/MS with ion trap detector (TCD). There were elevated levels of the individual as well as the total PAHs in the soil samples and also, all 6 PAHs were present in all the soil samples. The most abundant components were fluoranthene, benzo(b)fluoranthene and benzo(a)pyrene. The average sum of the 6 PAHs in all soil samples was 2.5 mg.kg−1, with range from 0.24 to 7.6 mg kg−1. The total mean PAH concentration obtained was 1.67 times higher than the total limit set by the Danish Environmental Protection Agency (DEPA) whiles the mean benzo(a)pyrene (BaP) concentration (0.6 mg kg−1) also 6 times the Soil Quality Criteria (Human Health) (0.1 mg kg−1) by DEPA and 2 times the Maximum Permissible Concentrations (0.26 mg kg−1) by the Netherlands for BaP. This shows that there are elevated levels of PAH deposition on the Esbjerg soil environment which needs an urgent attention. The diagnostic ratios and the correlation analysis identified mixed petrogenic and pyrogenic sources as the main contributors of PAHs on the Esbjerg environment.
- 1 December 2010
- Published by Elsevier in Journal of Photochemistry and Photobiology A: Chemistry
- Vol. 216 (2-3) , 244-249
Photocatalytic bleaching of p-nitrosodimethylaniline and a comparison to the performance of other AOP technologies
- 1 December 2010
- Published by Elsevier in Journal of Photochemistry and Photobiology A: Chemistry
- Vol. 216 (2-3) , 244-249
Photocatalytic bleaching of p-nitrosodimethylaniline and a comparison to the performance of other AOP technologies