Mahmoud Miri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Mahmoud Miri has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
Mohsen Rashki
Department of Architectural Engineering, University of Sistan and Baluchestan, Zahedan, Iran
8 shared publications- Mehdi Azhdary Moghaddam
University of Sistan and Baluchestan
3 shared publications - Naser Safaeian Hamzehkolaei
Department of Civil Engineering, Bozorgmehr University of Qaenat, Qaen, Iran
3 shared publications - Behrooz Keshtegar
University of Zabol Department of Civil Engineering
2 shared publications Hossein Beheshti Nezhad
Dept of Civil Eng. Islamic Azad University, Birjand Branch
2 shared publicationsM. Rashki
Department of Civil Engineering, Faculty of Engineering, University of Sistan and Baluchestan, Zahedan, Iran
2 shared publications
Latest Publications
- Open Access
- 28 July 2026
- Published by Springer Nature in Multiscale and Multidisciplinary Modeling, Experiments and Design
- Vol. 9 (1) , 168
Assessment of mechanical properties with ANN modeling and fresh, and microstructural characteristics of eco-friendly concrete containing zeolite and crumb rubber waste
- 28 July 2026
- Published by Springer Nature in Multiscale and Multidisciplinary Modeling, Experiments and Design
- Vol. 9 (1) , 168
Open AccessAssessment of mechanical properties with ANN modeling and fresh, and microstructural characteristics of eco-friendly concrete containing zeolite and crumb rubber waste
- 8 January 2025
- Published by Springer Nature in Life Cycle Reliability and Safety Engineering
- Vol. 14 (2) , 151-165
Seismic performance assessment of steel structures equipped with uncertain torsional-yielding dampers
- 8 January 2025
- Published by Springer Nature in Life Cycle Reliability and Safety Engineering
- Vol. 14 (2) , 151-165
Seismic performance assessment of steel structures equipped with uncertain torsional-yielding dampers
- Open Access
- 1 January 2022
- Published by Wiley in Advances in Civil Engineering
- Vol. 2022 (1)
Multiobjective Reliability‐Based Design Optimization of Recycled Aggregates Used in Corrosive Environment Based on Response Surface Modelling
In this study, durability properties of concrete samples including rapid chloride migration and electrical resistance as corrosion evaluation indicators were tested. The effects of some environmental parameters including humidity percentage, temperature, and chloride concentration were also examined on concrete electrical resistance. The prediction models for mechanical and durability parameters of concrete were obtained using the response surface method. These models were then evaluated using a metaheuristic optimization algorithm coupled with a simple and fast usability new method of reliability evaluation. Eventually, the probabilistic optimal values of using recycled aggregates were calculated for achieving environmentally friendly concrete. Probabilistic multiobjective optimization results revealed that, in an environment with humidity of 70%, temperature of 23°C, and chloride ion concentrations of 3%, 5%, and 8%, use of recycled aggregates for above different chloride ion concentrations was limited to (33.56%, 13.23%), (32.14%, 5.56%), and (13.23%, 2.86%), recycled coarse and fine aggregates, respectively. Furthermore, optimization procedures were performed for the environment or precontaminant recycled aggregate with the chloride concentration of 10%, but the analysis procedure did not converge to an optimum design point.
- 1 January 2022
- Published by Wiley in Advances in Civil Engineering
- Vol. 2022 (1)
Open AccessMultiobjective Reliability‐Based Design Optimization of Recycled Aggregates Used in Corrosive Environment Based on Response Surface Modelling
In this study, durability properties of concrete samples including rapid chloride migration and electrical resistance as corrosion evaluation indicators were tested. The effects of some environmental parameters including humidity percentage, temperature, and chloride concentration were also examined on concrete electrical resistance. The prediction models for mechanical and durability parameters of concrete were obtained using the response surface method. These models were then evaluated using a metaheuristic optimization algorithm coupled with a simple and fast usability new method of reliability evaluation. Eventually, the probabilistic optimal values of using recycled aggregates were calculated for achieving environmentally friendly concrete. Probabilistic multiobjective optimization results revealed that, in an environment with humidity of 70%, temperature of 23°C, and chloride ion concentrations of 3%, 5%, and 8%, use of recycled aggregates for above different chloride ion concentrations was limited to (33.56%, 13.23%), (32.14%, 5.56%), and (13.23%, 2.86%), recycled coarse and fine aggregates, respectively. Furthermore, optimization procedures were performed for the environment or precontaminant recycled aggregate with the chloride concentration of 10%, but the analysis procedure did not converge to an optimum design point.
- 27 June 2021
- Published by SAGE Publications in Journal of Intelligent Material Systems and Structures
- Vol. 33 (5) , 669-686
Reliability and reliability-based sensitivity analysis of self-centering buckling restrained braces using meta-models
This paper aims to carry out sensitivity analyses to study how the effect of each design variable on the performance of self-centering buckling restrained brace (SC-BRB) and the corresponding buckling restrained brace (BRB) without shape memory alloy (SMA) rods. Furthermore, the reliability analyses of BRB and SC-BRB are performed in this study. Considering the high computational cost of the simulation methods, three Meta-models including the Kriging, radial basis function (RBF), and polynomial response surface (PRSM) are utilized to construct the surrogate models. For this aim, the nonlinear dynamic analyses are conducted on both BRB and SC-BRB by using OpenSees software. The results showed that the SMA area, SMA length ratio, and BRB core area have the most effect on the failure probability of SC-BRB. It is concluded that Kriging-based Monte Carlo Simulation (MCS) gives the best performance to estimate the limit state function (LSF) of BRB and SC-BRB in the reliability analysis procedures. Considering the effects of changing the maximum cyclic loading on the failure probability computation and comparison of the failure probability for different LSFs, it is also found that the reliability indices of SC-BRB were always higher than the corresponding reliability indices determined for BRB which confirms the performance superiority of SC-BRB than BRB.
- 27 June 2021
- Published by SAGE Publications in Journal of Intelligent Material Systems and Structures
- Vol. 33 (5) , 669-686
Reliability and reliability-based sensitivity analysis of self-centering buckling restrained braces using meta-models
This paper aims to carry out sensitivity analyses to study how the effect of each design variable on the performance of self-centering buckling restrained brace (SC-BRB) and the corresponding buckling restrained brace (BRB) without shape memory alloy (SMA) rods. Furthermore, the reliability analyses of BRB and SC-BRB are performed in this study. Considering the high computational cost of the simulation methods, three Meta-models including the Kriging, radial basis function (RBF), and polynomial response surface (PRSM) are utilized to construct the surrogate models. For this aim, the nonlinear dynamic analyses are conducted on both BRB and SC-BRB by using OpenSees software. The results showed that the SMA area, SMA length ratio, and BRB core area have the most effect on the failure probability of SC-BRB. It is concluded that Kriging-based Monte Carlo Simulation (MCS) gives the best performance to estimate the limit state function (LSF) of BRB and SC-BRB in the reliability analysis procedures. Considering the effects of changing the maximum cyclic loading on the failure probability computation and comparison of the failure probability for different LSFs, it is also found that the reliability indices of SC-BRB were always higher than the corresponding reliability indices determined for BRB which confirms the performance superiority of SC-BRB than BRB.
- 5 February 2021
- Published by Periodica Polytechnica Budapest University of Technology and Economics in Periodica Polytechnica Civil Engineering
- Vol. 65 (2) , 577-587
Influence of Nano-silica and Crack Width on Corrosion Parameters of Pre-cracked Reinforced Concrete Beams
This paper presents an experimental study on the durability of both sound and cracked reinforced concrete (RC) beam specimens. Using nano-silica (NS) can improve the durability properties of reinforced concrete. So, RC beams with three nano-silica percentages of 0 %, 1.5 %, and 3 % were prepared. In addition, to consider the effect of cracking on corrosion, crack widths between 0.1 mm and 0.5 mm, and cover depths of 30 mm and 45 mm were considered. All beam specimens were subjected to 5 % NaCl solution and monitored weekly for half-cell potentials (HCP). The presented results include the HCP evaluation and diffusion factor values in sound and cracked concrete beams exposed to chloride attack. The experimental results indicated that the chloride diffusion coefficient increases with extending crack width. Nano-silica improved the permeability characteristics of concrete, HCP and also diffusion factor values. Regressive models of the chloride diffusion factor and HCP values were proposed for influencing parameters, i.e., nano-silica and crack width with two different cover depths.
- 5 February 2021
- Published by Periodica Polytechnica Budapest University of Technology and Economics in Periodica Polytechnica Civil Engineering
- Vol. 65 (2) , 577-587
Influence of Nano-silica and Crack Width on Corrosion Parameters of Pre-cracked Reinforced Concrete Beams
This paper presents an experimental study on the durability of both sound and cracked reinforced concrete (RC) beam specimens. Using nano-silica (NS) can improve the durability properties of reinforced concrete. So, RC beams with three nano-silica percentages of 0 %, 1.5 %, and 3 % were prepared. In addition, to consider the effect of cracking on corrosion, crack widths between 0.1 mm and 0.5 mm, and cover depths of 30 mm and 45 mm were considered. All beam specimens were subjected to 5 % NaCl solution and monitored weekly for half-cell potentials (HCP). The presented results include the HCP evaluation and diffusion factor values in sound and cracked concrete beams exposed to chloride attack. The experimental results indicated that the chloride diffusion coefficient increases with extending crack width. Nano-silica improved the permeability characteristics of concrete, HCP and also diffusion factor values. Regressive models of the chloride diffusion factor and HCP values were proposed for influencing parameters, i.e., nano-silica and crack width with two different cover depths.
- Open Access
- 1 July 2020
- Published by Academic World Research in Journal of Computational Methods In Engineering
- Vol. 39 (1) , 45-66
Probabilistic Evaluation on the Free Vibration of Functionally Graded Material Plates Using 3D Solution and Meta-Model Methods
This paper presents a probabilistic assessment on the free vibration analysis of functionally graded material plates, including layers with magneto-electro-elastic properties, using the 3D solution and surrogate models. The plate is located on an elastic foundation and the intra-layer slipping effect is also considered in the analysis by employing the generalized ...
- 1 July 2020
- Published by Academic World Research in Journal of Computational Methods In Engineering
- Vol. 39 (1) , 45-66
Open AccessProbabilistic Evaluation on the Free Vibration of Functionally Graded Material Plates Using 3D Solution and Meta-Model Methods
This paper presents a probabilistic assessment on the free vibration analysis of functionally graded material plates, including layers with magneto-electro-elastic properties, using the 3D solution and surrogate models. The plate is located on an elastic foundation and the intra-layer slipping effect is also considered in the analysis by employing the generalized ...
- Open Access
- 6 May 2020
- Published by Periodica Polytechnica Budapest University of Technology and Economics in Periodica Polytechnica Civil Engineering
- Vol. 64 (3) , 647-657
Experimental Investigation on Chloride Diffusion Coefficient of Self-compacting Concrete in the Oman Sea
Chloride ion penetration is an important parameter influencing the service life of a concrete structure, especially in aggressive environments. Severe chloride-induced corrosion of reinforced concretes has been reported in the southern part of Iran in the region of Oman Sea. In this paper, the effect of different environmental conditions of the Oman Sea on chloride penetration and mechanical properties of self-compacting concrete (SCC) and normal concrete (NC) is investigated. For this purpose, a number of prismatic specimens were exposed to various environmental conditions such as tide, submersion and atmospheric conditions. Surface chloride concentration and diffusion coefficient of SCC in these zones were calculated based on Fick’s second law, at 28, 90 and 150 days and compared with NC. Based on the values obtained in this study, relationships are proposed for concrete permeability and surface chloride of self-compacting concrete (SCC) at different ages in different aggressive environments. By determining the corrosion time based on these relations, it is observed that for a given water-to-cement ratio, the self-compacting concrete (SCC) has higher durability compared to normal concrete (NC).
- 6 May 2020
- Published by Periodica Polytechnica Budapest University of Technology and Economics in Periodica Polytechnica Civil Engineering
- Vol. 64 (3) , 647-657
Open AccessExperimental Investigation on Chloride Diffusion Coefficient of Self-compacting Concrete in the Oman Sea
Chloride ion penetration is an important parameter influencing the service life of a concrete structure, especially in aggressive environments. Severe chloride-induced corrosion of reinforced concretes has been reported in the southern part of Iran in the region of Oman Sea. In this paper, the effect of different environmental conditions of the Oman Sea on chloride penetration and mechanical properties of self-compacting concrete (SCC) and normal concrete (NC) is investigated. For this purpose, a number of prismatic specimens were exposed to various environmental conditions such as tide, submersion and atmospheric conditions. Surface chloride concentration and diffusion coefficient of SCC in these zones were calculated based on Fick’s second law, at 28, 90 and 150 days and compared with NC. Based on the values obtained in this study, relationships are proposed for concrete permeability and surface chloride of self-compacting concrete (SCC) at different ages in different aggressive environments. By determining the corrosion time based on these relations, it is observed that for a given water-to-cement ratio, the self-compacting concrete (SCC) has higher durability compared to normal concrete (NC).
- 1 October 2018
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 62, 542-561
An adaptive divergence-based method for structural reliability analysis via multiple Kriging models
- 1 October 2018
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 62, 542-561
An adaptive divergence-based method for structural reliability analysis via multiple Kriging models
- 1 October 2018
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 62, 1-20
New simulation-based frameworks for multi-objective reliability-based design optimization of structures
- 1 October 2018
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 62, 1-20
New simulation-based frameworks for multi-objective reliability-based design optimization of structures
- Open Access
- 1 July 2018
- Vol. 7 (3) , 117-138
Experimental Investigation of Corrosion Cracking in Reinforced Concrete Beams Containing Nano Wollastonite
- 1 July 2018
- Vol. 7 (3) , 117-138
Open AccessExperimental Investigation of Corrosion Cracking in Reinforced Concrete Beams Containing Nano Wollastonite