Reyad El-Khazali
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Reyad El-Khazali has a total of 72 co-authors. Here are the top co-authors by number of shared publications:
Pyotr Arkhipovich Ushakov
Kalashnikov State Technical University
5 shared publicationsAnis Kharisovich Gil’mutdinov
Kazan National Research Technical University-KAI (KNRTU-KAI)
4 shared publicationsNabeel Tawalbeh
EE Department, Jordan University, Amman-Jordan
4 shared publications- Wajdi Ahmad
Electrical and Computer Engineering Department, University of Sharjah, Sharjah, United Arab Emirates
3 shared publications Ayman Abulail
Department of Physics, Khalifa University, Abu Dhabi, UAE
2 shared publications- Braden Goddard
Department of Mechanical and Nuclear Engineering, Virginia Commonwealth University, 401 West Main Street, Richmond, VA, 23284-3068, USA
2 shared publications
Latest Publications
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 75 (11) , 28755-28759
GNSS Signal Resiliency Metric: A Stochastic Approach
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 75 (11) , 28755-28759
GNSS Signal Resiliency Metric: A Stochastic Approach
- Open Access
- 22 February 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
AI-enabled drones for date palm pollination
Pollination is a critical determinant of date palm productivity across tropical and subtropical regions. However, manual pollination remains labor-intensive, costly, and challenging to scale during staggered flowering periods that require multiple interventions. This study introduces a prototype and simulation-based framework for AI-enabled, drone-assisted pollination of date palms, developed to improve precision, scalability, and sustainability in agricultural operations. The system integrates YOLOv5 and YOLOv8 models for automated inflorescence detection and supports both semi-autonomous and fully autonomous flight modes that link perception to pollen-spraying actuation. A carefully prepared and manually labeled dataset was used to train and evaluate these models across varied illumination and canopy conditions. Model performance, expressed in mean Average Precision (mAP), along with operational metrics such as labor, time, and pollen efficiency, demonstrated substantial improvements over traditional methods. The proposed design achieved an estimated 80% reduction in labor and 97% reduction in pollen usage compared to manual pollination, highlighting its potential as a scalable and cost-effective alternative. While agronomic parameters such as fruit set percentage (FSP), yield, and quality were not directly measured, this work establishes a decision-support and prototype baseline for future large-scale field trials under diverse environmental conditions, including. wind, humidity, and canopy density.
- 22 February 2026
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Open AccessAI-enabled drones for date palm pollination
Pollination is a critical determinant of date palm productivity across tropical and subtropical regions. However, manual pollination remains labor-intensive, costly, and challenging to scale during staggered flowering periods that require multiple interventions. This study introduces a prototype and simulation-based framework for AI-enabled, drone-assisted pollination of date palms, developed to improve precision, scalability, and sustainability in agricultural operations. The system integrates YOLOv5 and YOLOv8 models for automated inflorescence detection and supports both semi-autonomous and fully autonomous flight modes that link perception to pollen-spraying actuation. A carefully prepared and manually labeled dataset was used to train and evaluate these models across varied illumination and canopy conditions. Model performance, expressed in mean Average Precision (mAP), along with operational metrics such as labor, time, and pollen efficiency, demonstrated substantial improvements over traditional methods. The proposed design achieved an estimated 80% reduction in labor and 97% reduction in pollen usage compared to manual pollination, highlighting its potential as a scalable and cost-effective alternative. While agronomic parameters such as fruit set percentage (FSP), yield, and quality were not directly measured, this work establishes a decision-support and prototype baseline for future large-scale field trials under diverse environmental conditions, including. wind, humidity, and canopy density.
- 1 January 2026
- Published by Engineered Science Publisher in Engineered Science
Modeling and Design of Fractional-Order LCαL Filters in Grid-Connected Networks
Simulation and experimental results show fractional-order inductor–fractional order capacitor–inductor filtering eliminates real-valued resonance, reduces total harmonic distortion by 45.45%, and accelerates phase-locked loop locking by 84.29%.
- 1 January 2026
- Published by Engineered Science Publisher in Engineered Science
Modeling and Design of Fractional-Order LCαL Filters in Grid-Connected Networks
Simulation and experimental results show fractional-order inductor–fractional order capacitor–inductor filtering eliminates real-valued resonance, reduces total harmonic distortion by 45.45%, and accelerates phase-locked loop locking by 84.29%.
- Open Access
- 1 January 2023
- Published by American Institute of Mathematical Sciences (AIMS) in AIMS Mathematics
- Vol. 8 (1) , 657-675
Optimal design of $ PI^\rho D^\mu $-controller for artificial ventilation systems for COVID-19 patients
In light of the COVID-19 pandemic, many patients have suffered from Acute Respiratory Distress Syndrome (ARDS) in Intensive Care Units (ICUs) around the world. In the medical field, it is known that the so-called artificial ventilation device, which has become the mainstay of treatment of such syndrome, decreases mortality in critically ill COVID-19 patients. Due to the high reliability of this device, there is an emergency need to follow up the progress made on designing a robust controller for improving its performance. From this perspective, this work introduces different control design schemes for obtaining an optimal Fractional-order PID controller (or simply $ PI^\rho D^\mu $-controller) of the Artificial Ventilation (AV) system through two optimization algorithms: the Bacteria Foraging Optimization (BFO) and the Particle Swarm Optimization (PSO) algorithms. The realization of the controller is accomplished using four approximations: Oustaloup's approximation, the Continued Fractional Expansion (CFE) approximation and the $ 1^{st} $- and $ 2^{nd} $-order El-Khazali approximations. The validation of the controller design and the AV system behavior are verified via numerical simulation in order to demonstrate the effectiveness and the potency of all proposed schemes.- 1 January 2023
- Published by American Institute of Mathematical Sciences (AIMS) in AIMS Mathematics
- Vol. 8 (1) , 657-675
Open AccessOptimal design of $ PI^\rho D^\mu $-controller for artificial ventilation systems for COVID-19 patients
In light of the COVID-19 pandemic, many patients have suffered from Acute Respiratory Distress Syndrome (ARDS) in Intensive Care Units (ICUs) around the world. In the medical field, it is known that the so-called artificial ventilation device, which has become the mainstay of treatment of such syndrome, decreases mortality in critically ill COVID-19 patients. Due to the high reliability of this device, there is an emergency need to follow up the progress made on designing a robust controller for improving its performance. From this perspective, this work introduces different control design schemes for obtaining an optimal Fractional-order PID controller (or simply $ PI^\rho D^\mu $-controller) of the Artificial Ventilation (AV) system through two optimization algorithms: the Bacteria Foraging Optimization (BFO) and the Particle Swarm Optimization (PSO) algorithms. The realization of the controller is accomplished using four approximations: Oustaloup's approximation, the Continued Fractional Expansion (CFE) approximation and the $ 1^{st} $- and $ 2^{nd} $-order El-Khazali approximations. The validation of the controller design and the AV system behavior are verified via numerical simulation in order to demonstrate the effectiveness and the potency of all proposed schemes. - Open Access
- 31 December 2022
- Published by MDPI AG in Atmosphere
- Vol. 14 (1) , 86
Study of the Possibility of Stimulating Cloud Convection by Solar Radiation Energy Absorbed in an Artificial Aerosol Layer
We consider the possibility of creating artificial clouds similar to Pyro clouds formed in nature over large forest and other fires. It is assumed that the creation of an artificial surface aerosol layer that absorbs solar radiation can lead to the heating of local air volumes and initiate thermal convection. The possibility of such convection was examined theoretically using the computational fluid dynamics software package suite FlowVision, in which the equations of motion, energy and mass transfer are solved in relative variables. Numerical experiments showed the principal possibility of initiating cloud convection only under some favorable atmospheric conditions (low wind speeds, temperature lapse rate greater than 8–9 °C/km), with an aerosol layer area of at least 5–10 km2 and a duration of its existence (heating) of at least 30 min. To assess the possibility of the practical implementation of this method, eight variants of highly efficient smoke compositions were developed and tested, and two batches of aerosol checkers weighing 25 kg, creating an aerosol of optimal size to absorb solar radiation, were produced. Calculations of the required dose based on the results of laboratory and field tests of the checkers showed that for one experiment to initiate cloud convection several thousand checkers need to be burned. The consumption of pyrotechnic aerosol composition (tens of tons) is about 1.5 times less than the burning of petroleum products in previously tested meteotrons. However, for environmental safety purposes, full-scale tests and the application of the aerosol layer method is advisable to conduct away from populated areas.
- 31 December 2022
- Published by MDPI AG in Atmosphere
- Vol. 14 (1) , 86
Open AccessStudy of the Possibility of Stimulating Cloud Convection by Solar Radiation Energy Absorbed in an Artificial Aerosol Layer
We consider the possibility of creating artificial clouds similar to Pyro clouds formed in nature over large forest and other fires. It is assumed that the creation of an artificial surface aerosol layer that absorbs solar radiation can lead to the heating of local air volumes and initiate thermal convection. The possibility of such convection was examined theoretically using the computational fluid dynamics software package suite FlowVision, in which the equations of motion, energy and mass transfer are solved in relative variables. Numerical experiments showed the principal possibility of initiating cloud convection only under some favorable atmospheric conditions (low wind speeds, temperature lapse rate greater than 8–9 °C/km), with an aerosol layer area of at least 5–10 km2 and a duration of its existence (heating) of at least 30 min. To assess the possibility of the practical implementation of this method, eight variants of highly efficient smoke compositions were developed and tested, and two batches of aerosol checkers weighing 25 kg, creating an aerosol of optimal size to absorb solar radiation, were produced. Calculations of the required dose based on the results of laboratory and field tests of the checkers showed that for one experiment to initiate cloud convection several thousand checkers need to be burned. The consumption of pyrotechnic aerosol composition (tens of tons) is about 1.5 times less than the burning of petroleum products in previously tested meteotrons. However, for environmental safety purposes, full-scale tests and the application of the aerosol layer method is advisable to conduct away from populated areas.
- Open Access
- 1 August 2020
- Published by Elsevier in Data in Brief
- Vol. 31, 105828
Data from multi year and multi radiation detector measurements of different radiation sources with environmental data
- 1 August 2020
- Published by Elsevier in Data in Brief
- Vol. 31, 105828
Open AccessData from multi year and multi radiation detector measurements of different radiation sources with environmental data
- Open Access
- 1 May 2020
- Published by MDPI AG in Electronics
- Vol. 9 (5) , 748
A Quadratic Fractional Map without Equilibria: Bifurcation, 0–1 Test, Complexity, Entropy, and Control
Fractional calculus in discrete-time systems is a recent research topic. The fractional maps introduced in the literature often display chaotic attractors belonging to the class of “self-excited attractors”. The field of fractional map with “hidden attractors” is completely unexplored. Based on these considerations, this paper presents the first example of fractional map without equilibria showing a number of hidden attractors for different values of the fractional order. The presence of the chaotic hidden attractors is validated via the computation of bifurcation diagrams, maximum Lyapunov exponent, 0–1 test, phase diagrams, complexity, and entropy. Finally, an active controller with the aim for stabilizing the proposed fractional map is successfully designed.
- 1 May 2020
- Published by MDPI AG in Electronics
- Vol. 9 (5) , 748
Open AccessA Quadratic Fractional Map without Equilibria: Bifurcation, 0–1 Test, Complexity, Entropy, and Control
Fractional calculus in discrete-time systems is a recent research topic. The fractional maps introduced in the literature often display chaotic attractors belonging to the class of “self-excited attractors”. The field of fractional map with “hidden attractors” is completely unexplored. Based on these considerations, this paper presents the first example of fractional map without equilibria showing a number of hidden attractors for different values of the fractional order. The presence of the chaotic hidden attractors is validated via the computation of bifurcation diagrams, maximum Lyapunov exponent, 0–1 test, phase diagrams, complexity, and entropy. Finally, an active controller with the aim for stabilizing the proposed fractional map is successfully designed.
- 24 November 2019
- Published by Springer Nature in Springer Proceedings in Mathematics & Statistics
- p. 1-17
Closed-Form Discretization of Fractional-Order Differential and Integral Operators
- 24 November 2019
- Published by Springer Nature in Springer Proceedings in Mathematics & Statistics
- p. 1-17
Closed-Form Discretization of Fractional-Order Differential and Integral Operators
- Open Access
The General Solution of Singular Fractional-Order Linear Time-Invariant Continuous Systems with Regular Pencils
This paper introduces a general solution of singular fractional-order linear-time invariant (FoLTI) continuous systems using the Adomian Decomposition Method (ADM) based on the Caputo's definition of the fractional-order derivative. The complexity of their entropy lies in defining the complete solution of such systems, which depends on introducing a method of decomposing their dynamic states from their static states. The solution is formulated by converting the singular system of regular pencils into a recursive form using the sequence of transformations, which separates the dynamic variables from the algebraic variables. The main idea of this work is demonstrated via numerical examples.
Open AccessThe General Solution of Singular Fractional-Order Linear Time-Invariant Continuous Systems with Regular Pencils
This paper introduces a general solution of singular fractional-order linear-time invariant (FoLTI) continuous systems using the Adomian Decomposition Method (ADM) based on the Caputo's definition of the fractional-order derivative. The complexity of their entropy lies in defining the complete solution of such systems, which depends on introducing a method of decomposing their dynamic states from their static states. The solution is formulated by converting the singular system of regular pencils into a recursive form using the sequence of transformations, which separates the dynamic variables from the algebraic variables. The main idea of this work is demonstrated via numerical examples.