Suk Woo Nam
Research Subjects
Suk Woo Nam has a total of 180 co-authors. Here are the top co-authors by number of shared publications:
Chang Won Yoon
12 shared publicationsSeong-Ahn Hong
12 shared publicationsTae-Hoon Lim
Fuel Cell Research Center, Korea Institute of Science and Technology, Hwarangno 14-gil 5, Seongbuk-gu, Seoul 136-791, Republic of Korea
10 shared publicationsYongmin Kim
10 shared publicationsJonghee Han
Korea Inst Sci & Technol, Fuel Cell Res Ctr, Seoul 02792, South Korea
8 shared publications- Chang Won Yoon
Pohang University of Science and Technology (POSTECH)
7 shared publications
Latest Publications
- 4 June 2024
- Published by Springer Nature in Nature Energy
- Vol. 9 (7) , 849-861
Self-assembled network polymer electrolyte membranes for application in fuel cells at 250 °C
- 4 June 2024
- Published by Springer Nature in Nature Energy
- Vol. 9 (7) , 849-861
Self-assembled network polymer electrolyte membranes for application in fuel cells at 250 °C
- Open Access
- 22 December 2020
- Published by Wiley in Advanced Materials
- Vol. 32 (51) , e2005655
Interactive Cooperation in Education and Research at Korea University and KIST
- 22 December 2020
- Published by Wiley in Advanced Materials
- Vol. 32 (51) , e2005655
Open AccessInteractive Cooperation in Education and Research at Korea University and KIST
- 10 April 2019
- Published by American Scientific Publishers in Science of Advanced Materials
- Vol. 11 (5) , 629-641
Preparation of Porous Ni–Al Alloys and Methane Steam Reforming Application for Hydrogen Generation
A new alloying method has been proposed to synthesize Ni50Al alloy powder using AlCl3 at 500–600 °C under vacuum. AlCl3 served as an activator, promoting the reaction between Ni and Al powders and lowering the fabrication temperature compared with that of conventional synthesis processes. The properties of Ni50Al alloys prepared by varying the synthesis parameters were investigated, and the alloys were alkali leached using NaOH solution for surface modification to increase the specific surface area. Methane steam reforming experiments were performed in the temperature range of 550–850 °C investigate the possibility of using the alloys as a catalyst for hydrogen generation. The results confirmed that the leached Ni50Al alloy exhibited good methane conversion, long-term stability without decrease in catalytic activity, and good hydrogen production rate.
- 10 April 2019
- Published by American Scientific Publishers in Science of Advanced Materials
- Vol. 11 (5) , 629-641
Preparation of Porous Ni–Al Alloys and Methane Steam Reforming Application for Hydrogen Generation
A new alloying method has been proposed to synthesize Ni50Al alloy powder using AlCl3 at 500–600 °C under vacuum. AlCl3 served as an activator, promoting the reaction between Ni and Al powders and lowering the fabrication temperature compared with that of conventional synthesis processes. The properties of Ni50Al alloys prepared by varying the synthesis parameters were investigated, and the alloys were alkali leached using NaOH solution for surface modification to increase the specific surface area. Methane steam reforming experiments were performed in the temperature range of 550–850 °C investigate the possibility of using the alloys as a catalyst for hydrogen generation. The results confirmed that the leached Ni50Al alloy exhibited good methane conversion, long-term stability without decrease in catalytic activity, and good hydrogen production rate.
- 30 July 2018
- Published by Wiley in Energy Technology
- Vol. 7 (1) , 113-121
A Novel Eutectic Mixture of Biphenyl and Diphenylmethane as a Potential Liquid Organic Hydrogen Carrier: Catalytic Hydrogenation
A novel, liquid‐phase hydrogen storage material was produced by mixing biphenyl (C12H10, solid) and diphenylmethane (C13H12, liquid) with a mass ratio (wt %) of 35:65. The eutectic mixture was proved to be liquid at ambient temperature with a viscosity of 3.0 cP at 25 °C and a vapor pressure of 1.4 Pa at 25 °C, which potentially meets the requirements for an efficient hydrogen storage system. A theoretical study using COSMO‐RS method further confirms that an optimum composition of biphenyl and diphenylmethane for the formation of eutectic mixture is 37:63 by mass, which is very close to the composition found experimentally. The eutectic mixture exhibited a superior activity for hydrogenation reactions conducted at 120 °C under 50 bar of H2 pressure in the presence of a Ru (5 wt %)/Al2O3 catalyst. Hydrogen uptake of the eutectic mixture tested was close to full conversion, which corresponds to 6.9 wt % and 60.1 g L−1 of gravimetric and volumetric hydrogen storage capacities, respectively.
- 30 July 2018
- Published by Wiley in Energy Technology
- Vol. 7 (1) , 113-121
A Novel Eutectic Mixture of Biphenyl and Diphenylmethane as a Potential Liquid Organic Hydrogen Carrier: Catalytic Hydrogenation
A novel, liquid‐phase hydrogen storage material was produced by mixing biphenyl (C12H10, solid) and diphenylmethane (C13H12, liquid) with a mass ratio (wt %) of 35:65. The eutectic mixture was proved to be liquid at ambient temperature with a viscosity of 3.0 cP at 25 °C and a vapor pressure of 1.4 Pa at 25 °C, which potentially meets the requirements for an efficient hydrogen storage system. A theoretical study using COSMO‐RS method further confirms that an optimum composition of biphenyl and diphenylmethane for the formation of eutectic mixture is 37:63 by mass, which is very close to the composition found experimentally. The eutectic mixture exhibited a superior activity for hydrogenation reactions conducted at 120 °C under 50 bar of H2 pressure in the presence of a Ru (5 wt %)/Al2O3 catalyst. Hydrogen uptake of the eutectic mixture tested was close to full conversion, which corresponds to 6.9 wt % and 60.1 g L−1 of gravimetric and volumetric hydrogen storage capacities, respectively.
- Open Access
Oxygen Reduction Electrocatalysts Based on Coupled Iron Nitride Nanoparticles with Nitrogen-Doped Carbon
Aimed at developing a highly active and stable non-precious metal electrocatalyst for oxygen reduction reaction (ORR), a novel FexNy/NC nanocomposite—that is composed of highly dispersed iron nitride nanoparticles supported on nitrogen-doped carbon (NC)—was prepared by pyrolyzing carbon black with an iron-containing precursor in an NH3 atmosphere. The influence of the various synthetic parameters such as the Fe precursor, Fe content, pyrolysis temperature and pyrolysis time on ORR performance of the prepared iron nitride nanoparticles was investigated. The formed phases were determined by experimental and simulated X-ray diffraction (XRD) of numerous iron nitride species. We found that Fe3N phase creates superactive non-metallic catalytic sites for ORR that are more active than those of the constituents. The optimized Fe3N/NC nanocomposite exhibited excellent ORR activity and a direct four-electron pathway in alkaline solution. Furthermore, the hybrid material showed outstanding catalytic durability in alkaline electrolyte, even after 4,000 potential cycles.
Open AccessOxygen Reduction Electrocatalysts Based on Coupled Iron Nitride Nanoparticles with Nitrogen-Doped Carbon
Aimed at developing a highly active and stable non-precious metal electrocatalyst for oxygen reduction reaction (ORR), a novel FexNy/NC nanocomposite—that is composed of highly dispersed iron nitride nanoparticles supported on nitrogen-doped carbon (NC)—was prepared by pyrolyzing carbon black with an iron-containing precursor in an NH3 atmosphere. The influence of the various synthetic parameters such as the Fe precursor, Fe content, pyrolysis temperature and pyrolysis time on ORR performance of the prepared iron nitride nanoparticles was investigated. The formed phases were determined by experimental and simulated X-ray diffraction (XRD) of numerous iron nitride species. We found that Fe3N phase creates superactive non-metallic catalytic sites for ORR that are more active than those of the constituents. The optimized Fe3N/NC nanocomposite exhibited excellent ORR activity and a direct four-electron pathway in alkaline solution. Furthermore, the hybrid material showed outstanding catalytic durability in alkaline electrolyte, even after 4,000 potential cycles.
- 1 May 2015
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 166-167, 335-344
Steam reforming of simulated biogas over plate Ni Cr catalysts: Influence of pre-oxidation on catalytic activity
- 1 May 2015
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 166-167, 335-344
Steam reforming of simulated biogas over plate Ni Cr catalysts: Influence of pre-oxidation on catalytic activity
- 1 March 2015
- Published by Elsevier in Applied Surface Science
- Vol. 332, 409-418
Role of different Pd/Pt ensembles in determining CO chemisorption on Au-based bimetallic alloys: A first-principles study
- 1 March 2015
- Published by Elsevier in Applied Surface Science
- Vol. 332, 409-418
Role of different Pd/Pt ensembles in determining CO chemisorption on Au-based bimetallic alloys: A first-principles study
- 28 February 2015
- Published by The Korean Hydrogen and New Energy Society in Transactions of the Korean hydrogen and new energy society
- Vol. 26 (1) , 21-27
Hydrodesulfurization of Diesel for Molten Carbonate Fuel Cell Applications
- 28 February 2015
- Published by The Korean Hydrogen and New Energy Society in Transactions of the Korean hydrogen and new energy society
- Vol. 26 (1) , 21-27
Hydrodesulfurization of Diesel for Molten Carbonate Fuel Cell Applications
- 1 December 2014
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 39 (36) , 21786-21795
Promotional effects of oxygen-containing additives on ammonia borane dehydrogenation for polymer electrolyte membrane fuel cell applications
- 1 December 2014
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 39 (36) , 21786-21795
Promotional effects of oxygen-containing additives on ammonia borane dehydrogenation for polymer electrolyte membrane fuel cell applications