MEMartin Engler

Martin Engler

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Martin Engler has a total of 49 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Intermediate morphology in the patterning of the crystalline Ge(001) surface induced by ion irradiation

    by Denise J. Erb, Daniel A. Pearson, Tomáš Škereň, Martin Engler, R. Mark Bradley, Stefan Facsko

    We investigate the morphologies of the Ge(001) surface that are produced by bombardment with a normally incident, broad argon ion beam at sample temperatures above the recrystallization temperature. Two previously observed kinds of topographies are seen, i.e., patterns consisting of upright and inverted rectangular pyramids, as well as patterns composed of shallow, isotropic basins. In addition, we observe the formation of an unexpected third type of pattern for intermediate values of the temperature, ion energy, and ion flux. In this type of intermediate morphology, isolated peaks with rectangular cross-sections stand above a landscape of shallow, rounded basins. We also extend past theoretical work to include a second-order correction term that comes from the curvature dependence of the sputter yield. For a range of parameter values, the resulting continuum model of the surface dynamics produces patterns that are remarkably similar to the intermediate morphologies we observe in our experiments. The formation of the isolated peaks is the result of a term that is not ordinarily included in the equation of motion, a second-order correction to the curvature dependence of the sputter yield. Published by the American Physical Society 2024


  • Open Access

    On the insulator-to-metal transition in titanium-implanted silicon

    by Fang Liu, Mao Wang, Yonder Berencén, Slawomir Prucnal, Martin Engler, René Hübner, Ye Yuan, René Heller, Roman Böttger, Lars Rebohle, et al.

    Hyperdoped silicon with deep level impurities has attracted much research interest due to its promising optical and electrical properties. In this work, single crystalline silicon supersaturated with titanium is fabricated by ion implantation followed by both pulsed laser melting and flash lamp annealing. The decrease of sheet resistance with increasing Ti concentration is attributed to a surface morphology effect due to the formation of cellular breakdown at the surface and the percolation conduction at high Ti concentration is responsible for the metallic-like conductivity. The insulator-to-metal transition does not happen. However, the doping effect of Ti incorporation at low concentration is not excluded, which might be responsible for the sub-bandgap optical absorption reported in literature.


  • Decoupling the Two Roles of Ga Droplets in the Self-Catalyzed Growth of GaAs Nanowires on SiOx/Si(111) Substrates

    by Tina Tauchnitz, Timur Nurmamytov, René Hübner, Martin Engler, Stefan Facsko, Harald Schneider, Manfred Helm, Emmanouil Dimakis


  • Amorphous to crystalline phase transition: Onset of pattern formation during ion erosion of Si(001)

    by Martin Engler, Thomas Michely

    The morphological evolution of Si(001) is investigated for normal incidence 2 keV Kr+ ion irradiation under ultra-high vacuum conditions as a function of temperature and ion fluence through scanning tunneling microscopy and low energy electron diffraction. Under the conditions chosen, the selvage of Si(001) amorphizes below the critical temperature Tc of 670 K, while above it remains crystalline. Below Tc the sample remains flat, irrespective of the ion fluence. Above Tc, the crystalline sample displays for fixed ion fluence and as a function of sample temperature a pronounced roughness maximum at 700 K. Around this temperature, with increasing ion fluence a strong increase of roughness as well as coarsening are observed. Pyramidal pits and mounds develop, with facets formed by Si steps and narrow reconstructed terraces. Most exciting, with increasing ion fluence the pattern reorients from pits and mounds with edges along the 〈110〉 directions to ridges and valleys rotated ≈45∘ to the 〈110〉 directions.


  • Evolution of ion beam induced patterns on Si(001)

    by Martin Engler, Sven Macko, Frank Frost, Thomas Michely

    In the range of incidence angles between 58${}^{$\circ${}}$ and 79${}^{$\circ${}}$, Si develops erosion patterns through room-temperature exposure to 2 keV ${\text{Kr}}^{+}$, while for other incidence angles it remains flat. We investigate the formation of these patterns through all in situ sample preparation and investigation under ultrahigh vacuum conditions. The ion fluence is varied by a factor of 1000 for the incidence angles of 63${}^{$\circ${}}$ and 75${}^{$\circ${}}$. The resulting morphologies are imaged by scanning tunneling microscopy and quantitatively analyzed in view of roughness, wavelength, disorder, and surface slopes. We find it necessary to distinguish between low-fluence and high-fluence regimes of pattern formation. While in both low-fluence regimes a similar parallel mode ripple pattern evolves, the high-fluence regimes are distinctly different and evidence either the evolution of disordered perpendicular ripples or a roof-tile structure for 63${}^{$\circ${}}$ or 75${}^{$\circ${}}$, respectively. The data are compared to other experimental data for ion beam erosion of Si and Ge enabling us to assess the universality of our observations. Comparison to existing models for the surface evolution under ion exposure allows us to draw conclusions on the applicability of these models for pattern formation on Si(001).


  • Silicide induced ion beam patterning of Si(001)

    by Martin Engler, Frank Frost, Sven Müller, Sven Macko, Moritz Will, René Feder, Daniel Spemann, René Hübner, Stefan Facsko, Thomas Michely

    Low energy ion beam pattern formation on Si with simultaneous co-deposition of Ag, Pd, Pb, Ir, Fe or C impurities was investigated by in situ scanning tunneling microscopy as well as ex situ atomic force microscopy, scanning electron microscopy, transmission electron microscopy and Rutherford backscattering spectrometry. The impurities were supplied by sputter deposition. Additional insight into the mechanism of pattern formation was obtained by more controlled supply through e-beam evaporation. For the situations investigated, the ability of the impurity to react with Si, i.e. to form a silicide, appears to be a necessary, but not a sufficient condition for pattern formation. Comparing the effects of impurities with similar mass and nuclear charge, the collision kinetics is shown to be not of primary importance for pattern formation. To understand the observed phenomena, it is necessary to assume a bi-directional coupling of composition and height fluctuations. This coupling gives rise to a sensitive dependence of the final morphology on the conditions of impurity supply. Because of this history dependence, the final morphology cannot be uniquely characterized by a steady state impurity concentration.


  • Strong anisotropy in surface kinetic roughening: Analysis and experiments

    by Edoardo Vivo, Matteo Nicoli, Martin Engler, Thomas Michely, Luis Vázquez, Rodolfo Cuerno

    We report an experimental assessment of surface kinetic roughening properties that are anisotropic in space. Working for two specific instances of silicon surfaces irradiated by ion-beam sputtering under diverse conditions (with and without concurrent metallic impurity codeposition), we verify the predictions and consistency of a recently proposed scaling Ansatz for surface observables like the two-dimensional (2D) height power spectral density (PSD). In contrast with other formulations, this ansatz is naturally tailored to the study of two-dimensional surfaces, and allows us to readily explore the implications of anisotropic scaling for other observables, such as real-space correlation functions and PSD functions for 1D profiles of the surface. Our results confirm that there are indeed actual experimental systems whose kinetic roughening is strongly anisotropic, as consistently described by this scaling analysis. In the light of our work, some types of experimental measurements are seen to be more affected by issues like finite space resolution effects, etc. that may hinder a clear-cut assessment of strongly anisotropic scaling in the present and other practical contexts.


  • Open Access

    Iron-assisted ion beam patterning of Si(001) in the crystalline regime

    by Sven Macko, Jörg Grenzer, Frank Frost, Martin Engler, Dietmar Hirsch, Monika Fritzsche, Arndt Mücklich, Thomas Michely


  • Open Access

    Phenomenology of iron-assisted ion beam pattern formation on Si(001)

    by Sven Macko, Frank Frost, Martin Engler, Dietmar Hirsch, Thomas Höche, Jörg Grenzer, Thomas Michely


  • Open Access

    Growth of graphene on Ir(111)

    by Johann Coraux, Alpha T N'DIaye, Martin Engler, Carsten Busse, Dirk Wall, Niemma Buckanie, Frank-J Meyer zu Heringdorf, Raoul van Gastel, Bene Poelsema, Thomas Michely