Jianning Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jianning Liu has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Shi-Qing Wang
School of Polymer Science and Polymer Engineering, University of Akron, Akron, Ohio 44325, USA
7 shared publications Panpan Lin
5 shared publicationsShi-Qing Wang
5 shared publicationsZhichen Zhao
Department of Polymer Science, University of Akron, Akron, Ohio 44325, USA
4 shared publicationsJimmy Mays
Department of Chemistry, University of Tennessee, Knoxville, Tennessee 37996, USA
3 shared publications- Xiaoxiao Li
Department of Polymer Science, University of Akron, Akron, Ohio 44325, United States
3 shared publications
Latest Publications
- 31 March 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 16 (15) , 3705-3716
Uncommon nonlinear rheological phenomenology in uniaxial extension of polystyrene solutions and melts
This study examines nonlinear rheological responses to uniaxial extension of two entangled polystyrene (PS) solutions and two PS melts. Several unusual characteristics are revealed. The pair of the PS solutions have the same number of entanglements per chain (because of the same concentration) but well separated effective glass transition temperatures Tg. When examined at a common effective rate of extension (e.g., the same Rouse–Weissenberg number WiR) and at a comparable distance from their respective Tg, the solution A with lower Tg, examined at a lower temperature, shows stronger stress responses when WiR > 1. At the same test temperature and a common WiR, the solution A is still found to display a stronger stress response than the solution B that is made of the same fraction of parent PS in a second solvent also made of oligomeric PS of higher molecular weight. Finally, there are two features intrinsic to each of the four PS samples. First, at the same WiR they show reduced stress level at a lower temperature. Second, at sufficiently high applied Hencky rates, they show limiting rate behavior, i.e., undergoing the same melt rupture independent of the applied rate. These remarkable rheological responses indicate major theoretical difficulties facing the subject of nonlinear extensional rheology of entangled polymers.
- 31 March 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 16 (15) , 3705-3716
Uncommon nonlinear rheological phenomenology in uniaxial extension of polystyrene solutions and melts
This study examines nonlinear rheological responses to uniaxial extension of two entangled polystyrene (PS) solutions and two PS melts. Several unusual characteristics are revealed. The pair of the PS solutions have the same number of entanglements per chain (because of the same concentration) but well separated effective glass transition temperatures Tg. When examined at a common effective rate of extension (e.g., the same Rouse–Weissenberg number WiR) and at a comparable distance from their respective Tg, the solution A with lower Tg, examined at a lower temperature, shows stronger stress responses when WiR > 1. At the same test temperature and a common WiR, the solution A is still found to display a stronger stress response than the solution B that is made of the same fraction of parent PS in a second solvent also made of oligomeric PS of higher molecular weight. Finally, there are two features intrinsic to each of the four PS samples. First, at the same WiR they show reduced stress level at a lower temperature. Second, at sufficiently high applied Hencky rates, they show limiting rate behavior, i.e., undergoing the same melt rupture independent of the applied rate. These remarkable rheological responses indicate major theoretical difficulties facing the subject of nonlinear extensional rheology of entangled polymers.
- 26 September 2019
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 151 (12) , 124906
Characterizing effects of fast melt deformation on entangled polymers in their glassy state
Fast deformation of entangled melts is known to cause chain stretching due to affinelike straining of the entanglement network. Since the chain deformation may also result in perturbations of covalent bond angles and bond length, there are always possible enthalpic effects. In this study, we first subject polystyrene and PMMA of different molecular weights to either uniaxial melt extension or planar extension and subsequently impose rapid thermal quenching to preserve the chain deformation. Then, such pre-melt-deformed samples are annealed at various temperatures below the glass transition temperature Tg. During annealing, these samples can undergo appreciable contraction on a time scale much shorter than the alpha relaxation time. Significant retractive stress is observed when such contracting samples are held fixed during the annealing. The stress level can be nearly as high as the Cauchy stress produced during melt stretching. These observations not only allowed us to investigate glassy chain dynamics as well as the molecular nature of mechanical stress but may also suggest that pre-melt-stretched polymers can cause segmental mobilization in the glassy state. The available evidence indicates that the retractive stress is enthalpic in origin, associated with the conformational distortion at the bond level produced by melt stretching.
- 26 September 2019
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 151 (12) , 124906
Characterizing effects of fast melt deformation on entangled polymers in their glassy state
Fast deformation of entangled melts is known to cause chain stretching due to affinelike straining of the entanglement network. Since the chain deformation may also result in perturbations of covalent bond angles and bond length, there are always possible enthalpic effects. In this study, we first subject polystyrene and PMMA of different molecular weights to either uniaxial melt extension or planar extension and subsequently impose rapid thermal quenching to preserve the chain deformation. Then, such pre-melt-deformed samples are annealed at various temperatures below the glass transition temperature Tg. During annealing, these samples can undergo appreciable contraction on a time scale much shorter than the alpha relaxation time. Significant retractive stress is observed when such contracting samples are held fixed during the annealing. The stress level can be nearly as high as the Cauchy stress produced during melt stretching. These observations not only allowed us to investigate glassy chain dynamics as well as the molecular nature of mechanical stress but may also suggest that pre-melt-stretched polymers can cause segmental mobilization in the glassy state. The available evidence indicates that the retractive stress is enthalpic in origin, associated with the conformational distortion at the bond level produced by melt stretching.
- 1 September 2019
- Published by Society of Rheology in Journal of Rheology
- Vol. 63 (5) , 763-771
Exploring rheological responses to uniaxial stretching of various entangled polyisoprene melts
- 1 September 2019
- Published by Society of Rheology in Journal of Rheology
- Vol. 63 (5) , 763-771
Exploring rheological responses to uniaxial stretching of various entangled polyisoprene melts
- 15 April 2019
- Published by Wiley in Journal of Polymer Science Part B: Polymer Physics
- Vol. 57 (12) , 758-770
Brittle‐ductile transition in uniaxial compression of polymer glasses
We carried out a large set of tests to establish a correlation between the molecular (network) structure (influenced by molecular weight, molecular weight distribution, and melt predeformation) and mechanical responses of several glassy polymers to uniaxial compression at different temperatures and different compression speeds. The experimental results show that to have ductile responses there must be an adequate chain network, afforded by the interchain uncrossability among sufficiently long chains. Specifically, polystyrene (PS) and poly(methyl methacrylate) of sufficiently low molar mass do not have chain network and are found to be very brittle. Binary PS mixtures are brittle at room temperature when the volume fraction of the high‐molecular‐weight component is sufficiently low (e.g., at and below 27.5%). Moreover, sufficiently melt‐stretched PS mixtures show brittle fracture when compressed along the same direction, along which melt stretching was made. All the experimental findings confirm that a robust chain network is also a prerequisite for yielding and ductile cold compression of polymer glasses, as is for extension. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019, 57, 758–770
- 15 April 2019
- Published by Wiley in Journal of Polymer Science Part B: Polymer Physics
- Vol. 57 (12) , 758-770
Brittle‐ductile transition in uniaxial compression of polymer glasses
We carried out a large set of tests to establish a correlation between the molecular (network) structure (influenced by molecular weight, molecular weight distribution, and melt predeformation) and mechanical responses of several glassy polymers to uniaxial compression at different temperatures and different compression speeds. The experimental results show that to have ductile responses there must be an adequate chain network, afforded by the interchain uncrossability among sufficiently long chains. Specifically, polystyrene (PS) and poly(methyl methacrylate) of sufficiently low molar mass do not have chain network and are found to be very brittle. Binary PS mixtures are brittle at room temperature when the volume fraction of the high‐molecular‐weight component is sufficiently low (e.g., at and below 27.5%). Moreover, sufficiently melt‐stretched PS mixtures show brittle fracture when compressed along the same direction, along which melt stretching was made. All the experimental findings confirm that a robust chain network is also a prerequisite for yielding and ductile cold compression of polymer glasses, as is for extension. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019, 57, 758–770
- Open Access
- 13 February 2018
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 120 (7) , 077801
Illustrating the Molecular Origin of Mechanical Stress in Ductile Deformation of Polymer Glasses
New experiments show that tensile stress vanishes shortly after preyield deformation of polymer glasses while tensile stress after postyield deformation stays high and relaxes on much longer time scales, thus hinting at a specific molecular origin of stress in ductile cold drawing: chain tension rather than intersegmental interactions. Molecular dynamics simulation based on a coarse-grained model for polystyrene confirms the conclusion that the chain network plays an essential role, causing the glassy state to yield and to respond with a high level of intrachain retractive stress. This identification sheds light on the future development regarding an improved theoretical account for molecular mechanics of polymer glasses and the molecular design of stronger polymeric materials to enhance their mechanical performance.
- 13 February 2018
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 120 (7) , 077801
Open AccessIllustrating the Molecular Origin of Mechanical Stress in Ductile Deformation of Polymer Glasses
New experiments show that tensile stress vanishes shortly after preyield deformation of polymer glasses while tensile stress after postyield deformation stays high and relaxes on much longer time scales, thus hinting at a specific molecular origin of stress in ductile cold drawing: chain tension rather than intersegmental interactions. Molecular dynamics simulation based on a coarse-grained model for polystyrene confirms the conclusion that the chain network plays an essential role, causing the glassy state to yield and to respond with a high level of intrachain retractive stress. This identification sheds light on the future development regarding an improved theoretical account for molecular mechanics of polymer glasses and the molecular design of stronger polymeric materials to enhance their mechanical performance.
- Open Access
- 10 July 2017
- Published by American Physical Society (APS) in Physical Review X
- Vol. 7 (3) , 031003
Fingerprinting Molecular Relaxation in Deformed Polymers
The flow and deformation of macromolecules is ubiquitous in nature and industry, and an understanding of this phenomenon at both macroscopic and microscopic length scales is of fundamental and practical importance. Here, we present the formulation of a general mathematical framework, which could be used to extract, from scattering experiments, the molecular relaxation of deformed polymers. By combining and modestly extending several key conceptual ingredients in the literature, we show how the anisotropic single-chain structure factor can be decomposed by spherical harmonics and experimentally reconstructed from its cross sections on the scattering planes. The resulting wave-number-dependent expansion coefficients constitute a characteristic fingerprint of the macromolecular deformation, permitting detailed examinations of polymer dynamics at the microscopic level. We apply this approach to survey a long-standing problem in polymer physics regarding the molecular relaxation in entangled polymers after a large step deformation. The classical tube theory of Doi and Edwards predicts a fast chain retraction process immediately after the deformation, followed by a slow orientation relaxation through the reptation mechanism. This chain retraction hypothesis, which is the keystone of the tube theory for macromolecular flow and deformation, is critically examined by analyzing the fine features of the two-dimensional anisotropic spectra from small-angle neutron scattering by entangled polystyrenes. We show that the unique scattering patterns associated with the chain retraction mechanism are not experimentally observed. This result calls for a fundamental revision of the current theoretical picture for nonlinear rheological behavior of entangled polymeric liquids.
- 10 July 2017
- Published by American Physical Society (APS) in Physical Review X
- Vol. 7 (3) , 031003
Open AccessFingerprinting Molecular Relaxation in Deformed Polymers
The flow and deformation of macromolecules is ubiquitous in nature and industry, and an understanding of this phenomenon at both macroscopic and microscopic length scales is of fundamental and practical importance. Here, we present the formulation of a general mathematical framework, which could be used to extract, from scattering experiments, the molecular relaxation of deformed polymers. By combining and modestly extending several key conceptual ingredients in the literature, we show how the anisotropic single-chain structure factor can be decomposed by spherical harmonics and experimentally reconstructed from its cross sections on the scattering planes. The resulting wave-number-dependent expansion coefficients constitute a characteristic fingerprint of the macromolecular deformation, permitting detailed examinations of polymer dynamics at the microscopic level. We apply this approach to survey a long-standing problem in polymer physics regarding the molecular relaxation in entangled polymers after a large step deformation. The classical tube theory of Doi and Edwards predicts a fast chain retraction process immediately after the deformation, followed by a slow orientation relaxation through the reptation mechanism. This chain retraction hypothesis, which is the keystone of the tube theory for macromolecular flow and deformation, is critically examined by analyzing the fine features of the two-dimensional anisotropic spectra from small-angle neutron scattering by entangled polystyrenes. We show that the unique scattering patterns associated with the chain retraction mechanism are not experimentally observed. This result calls for a fundamental revision of the current theoretical picture for nonlinear rheological behavior of entangled polymeric liquids.
- 20 February 2017
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 50 (5) , 2024-2032
How and Why Polymer Glasses Lose Their Ductility Due to Plasticizers
- 20 February 2017
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 50 (5) , 2024-2032
How and Why Polymer Glasses Lose Their Ductility Due to Plasticizers