Aiat Hegazy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Aiat Hegazy has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Eric Prouzet
Chemistry, ChemEng & Waterloo Institute of Nanotechnology, University of Waterloo, 200 University Avenue West, Waterloo (ON) N2L 3G1, Canada
3 shared publications - Nageh K. Allam
Energy Materials Laboratory, School of Sciences and Engineering, The American University in Cairo, New Cairo 11835, Egypt
3 shared publications - Heba Ali
Physical Chemistry Department, National Research Centre, Giza, Egypt
2 shared publications - Mohamed Mekewi
Chemistry Department, Faculty of Science, Ain Shams University, Cairo, Egypt
2 shared publications - Nahla Ismail
National Research Centre
2 shared publications Abdub G. Ali
1 shared publication
Latest Publications
- 1 March 2017
- Published by Elsevier in Solar Energy
- Vol. 144, 445-452
Defect states determined the performance of dopant-free anatase nanocrystals in solar fuel cells
- 1 March 2017
- Published by Elsevier in Solar Energy
- Vol. 144, 445-452
Defect states determined the performance of dopant-free anatase nanocrystals in solar fuel cells
- 1 December 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 687, 920-926
Wide visible emission and narrowing band gap in Cd-doped ZnO nanopowders synthesized via sol-gel route
- 1 December 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 687, 920-926
Wide visible emission and narrowing band gap in Cd-doped ZnO nanopowders synthesized via sol-gel route
- 1 August 2016
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 153, 108-116
TiO2 nanoparticles optimized for photoanodes tested in large area Dye-sensitized solar cells (DSSC)
- 1 August 2016
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 153, 108-116
TiO2 nanoparticles optimized for photoanodes tested in large area Dye-sensitized solar cells (DSSC)
- 14 October 2015
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 20 (1) , 309
Erratum to: Facile one-step process for synthesis of vertically aligned cobalt oxide doped TiO2 nanotube arrays for solar energy conversion
- 14 October 2015
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 20 (1) , 309
Erratum to: Facile one-step process for synthesis of vertically aligned cobalt oxide doped TiO2 nanotube arrays for solar energy conversion
- 1 December 2014
- Published by Elsevier in Electrochimica Acta
- Vol. 150, 314-319
A novel photoelectrode from TiO2-WO3 nanoarrays grown on FTO for solar water splitting
- 1 December 2014
- Published by Elsevier in Electrochimica Acta
- Vol. 150, 314-319
A novel photoelectrode from TiO2-WO3 nanoarrays grown on FTO for solar water splitting
- 28 May 2013
- Published by MathDoc/Centre Mersenne in Comptes Rendus. Chimie
- Vol. 16 (7) , 651-659
Effect of physical chemistry parameters in photocatalytic properties of TiO2 nanocrystals
We used a new synthesis of TiO 2 anatase 6 nm nanocrystals prepared at room temperature (Hegazy and Prouzet, 2012 [10]) to explore the influence of different physical-chemical parameters on photocatalysis, and bench-tested the material against two commercial powders made of either pure anatase (Sigma™), or composite anatase–rutile particles (P25 Degussa™). The initial as-synthesised material demonstrates a low photocatalytic activity, which is greatly improved after thermal activation as a result of improved crystallinity without any drastic change in crystal size. The influence of several other parameters was studied, the resulting tests being compared with commercial products. The cumulative improvement provided by these different parameters led finally to a material that exhibits a higher photocatalysis compared to commercial anatase, and similar to the commercial material usually used for reference (P25). This study, which can apply to other titania materials, illustrates how the post-treatment and process adaptation can help to optimise an initial material.
- 28 May 2013
- Published by MathDoc/Centre Mersenne in Comptes Rendus. Chimie
- Vol. 16 (7) , 651-659
Effect of physical chemistry parameters in photocatalytic properties of TiO2 nanocrystals
We used a new synthesis of TiO 2 anatase 6 nm nanocrystals prepared at room temperature (Hegazy and Prouzet, 2012 [10]) to explore the influence of different physical-chemical parameters on photocatalysis, and bench-tested the material against two commercial powders made of either pure anatase (Sigma™), or composite anatase–rutile particles (P25 Degussa™). The initial as-synthesised material demonstrates a low photocatalytic activity, which is greatly improved after thermal activation as a result of improved crystallinity without any drastic change in crystal size. The influence of several other parameters was studied, the resulting tests being compared with commercial products. The cumulative improvement provided by these different parameters led finally to a material that exhibits a higher photocatalysis compared to commercial anatase, and similar to the commercial material usually used for reference (P25). This study, which can apply to other titania materials, illustrates how the post-treatment and process adaptation can help to optimise an initial material.
- 4 January 2012
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 24 (2) , 245-254
Room Temperature Synthesis and Thermal Evolution of Porous Nanocrystalline TiO2 Anatase
- 4 January 2012
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 24 (2) , 245-254
Room Temperature Synthesis and Thermal Evolution of Porous Nanocrystalline TiO2 Anatase