Aji. A. Anappara
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Aji. A. Anappara has a total of 92 co-authors. Here are the top co-authors by number of shared publications:
- Alessandro Tredicucci
Università di Pisa
16 shared publications - Giorgio Biasiol
Laboratorio TASC, Istituto Officina dei Materiali (IOM CNR), Trieste, Italy
14 shared publications - Lucia Sorba
NEST Istituto Nanoscienze-CNR and Scuola Normale Superiore, Piazza S. Silvestro 12, 56127 Pisa, Italy
13 shared publications - Simone De Liberato
University of Southampton
7 shared publications A. Sell
University of Konstanz 1 Department of Physics and Center for Applied Photonics 78457 Konstanz, Germany
6 shared publications- Alfred Leitenstorfer
University of Konstanz
6 shared publications
Latest Publications
- 19 November 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (48) , 65781-65792
Cellulose Fiber Tortuosity as a Bioinspired Design Strategy for Light-Driven, Self-Powered Ionotronic Synapses
The drive toward energy-efficient, brain-inspired computing has spurred interest in ionotronic synapses that mimic ionic signaling in neurons. However, most light-driven synaptic devices overlook the influence of ion transport architecture, an essential aspect of biological learning and memory, which is shaped by the structural complexity of neural tissue. Here, we present a two-terminal ionotronic synaptic device constructed on cellulose fiber substrates, such as thread, cloth, and paper, offering tunable tortuosity to mimic complex ion pathways. Carbon electrodes patterned on these fibers are separated by a gap (∼1 mm) filled with the ionic liquid 1-ethyl-3-methylimidazolium acetate (EMIM: OAc), while lanthanum hexaboride (LaB6) nanoparticles are selectively coated near the gap on one electrode. The device operates in a self-powered mode, utilizing LaB6-induced light-to-heat conversion and thermodiffusion in EMIM: OAc, and enables light-modulated synaptic responses. Our findings reveal that upon illumination (λlaser = 638 nm, ∼500 mW), increasing substrate tortuosity reduces the excitatory post-synaptic potential (EPSP) amplitude (∼127 mV, ∼109 mV, and ∼26 mV) when illuminated for 1 s and enhances the retention time (∼245 s, ∼270 s, and ∼4224 s) under a 2.5 Hz light frequency with 10 s on and 20 s off cycles, corresponding to thread, cloth, and paper, respectively. In addition to EPSP, the device emulates paired-pulse facilitation (PPF) and spike-dependent plasticity by modulating optical parameters such as frequency, intensity, duration, and pulse number with operation spanning 450-808 nm. Demonstrations of optically driven Morse code and binary-to-hexadecimal data encryption further showcase the potential for secure communication. This work highlights fiber tortuosity as a previously underexplored yet powerful design variable for developing light-responsive, flexible ionotronic systems for neuromorphic vision and communication technologies.
- 19 November 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (48) , 65781-65792
Cellulose Fiber Tortuosity as a Bioinspired Design Strategy for Light-Driven, Self-Powered Ionotronic Synapses
The drive toward energy-efficient, brain-inspired computing has spurred interest in ionotronic synapses that mimic ionic signaling in neurons. However, most light-driven synaptic devices overlook the influence of ion transport architecture, an essential aspect of biological learning and memory, which is shaped by the structural complexity of neural tissue. Here, we present a two-terminal ionotronic synaptic device constructed on cellulose fiber substrates, such as thread, cloth, and paper, offering tunable tortuosity to mimic complex ion pathways. Carbon electrodes patterned on these fibers are separated by a gap (∼1 mm) filled with the ionic liquid 1-ethyl-3-methylimidazolium acetate (EMIM: OAc), while lanthanum hexaboride (LaB6) nanoparticles are selectively coated near the gap on one electrode. The device operates in a self-powered mode, utilizing LaB6-induced light-to-heat conversion and thermodiffusion in EMIM: OAc, and enables light-modulated synaptic responses. Our findings reveal that upon illumination (λlaser = 638 nm, ∼500 mW), increasing substrate tortuosity reduces the excitatory post-synaptic potential (EPSP) amplitude (∼127 mV, ∼109 mV, and ∼26 mV) when illuminated for 1 s and enhances the retention time (∼245 s, ∼270 s, and ∼4224 s) under a 2.5 Hz light frequency with 10 s on and 20 s off cycles, corresponding to thread, cloth, and paper, respectively. In addition to EPSP, the device emulates paired-pulse facilitation (PPF) and spike-dependent plasticity by modulating optical parameters such as frequency, intensity, duration, and pulse number with operation spanning 450-808 nm. Demonstrations of optically driven Morse code and binary-to-hexadecimal data encryption further showcase the potential for secure communication. This work highlights fiber tortuosity as a previously underexplored yet powerful design variable for developing light-responsive, flexible ionotronic systems for neuromorphic vision and communication technologies.
- 10 October 2025
- Published by Springer Nature in Applied Physics A
- Vol. 131 (11) , 1-10
Ultraviolet emission from 2D tellurium nanosheets synthesised using diverse exfoliation techniques
- 10 October 2025
- Published by Springer Nature in Applied Physics A
- Vol. 131 (11) , 1-10
Ultraviolet emission from 2D tellurium nanosheets synthesised using diverse exfoliation techniques
- Open Access
- 6 October 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (44) , 22278-22286
Deciphering the crystal structure evolution from 3D non-van der Waals solids to 2D nanosheets
Shear-assisted fracturing of bulk cyclo-S 8 yields 2D α- and β-sulfur nanosheets, unlocking distinct 2D allotropes.
- 6 October 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (44) , 22278-22286
Open AccessDeciphering the crystal structure evolution from 3D non-van der Waals solids to 2D nanosheets
Shear-assisted fracturing of bulk cyclo-S 8 yields 2D α- and β-sulfur nanosheets, unlocking distinct 2D allotropes.
- 9 July 2025
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 41 (28) , 18544-18553
Unveiling the Potential Photothermal Activity of Vanadium Carbide for Driving Chemical Reactions
Photothermally activated chemical reactions play a pivotal role in a wide range of applications, highlighting the need for efficient photothermal agents. The photothermal effect, which utilizes dominant nonradiative deexcitation mechanisms, has been extensively demonstrated in nanoscale systems, including plasmonic metals, inorganic semiconductors, organic materials, and polymers. However, the development of these photothermal materials often requires intricate fabrication and separation techniques, presenting significant challenges for practical implementation. Here we demonstrate that commercially available bulk vanadium monocarbide (VC) powder exhibits excellent light-to-heat conversion efficiency (∼70%), combined with remarkable chemical, thermal, and optical stability (against intense laser irradiation). These unique attributes of VC were harnessed to drive industrially relevant photothermally activated chemical reactions, specifically in the polymerization of acrylic monomers and the Diels-Alder (DA) reaction between anthracene and N-phenyl maleimide. Comprehensive analysis through FTIR and 1H NMR studies confirms the successful formation of products in both the reactions. Importantly, the photothermal reactions exhibit significantly reduced reaction times compared to the conventional thermal protocols. Furthermore, the recoverability of VC powder after the completion of the reactions enhances environmental sustainability. This study contributes valuable insights into the utilization of commercially available bulk VC powder as an off-the-shelf, cost-effective, efficient and sustainable photothermal agent for various chemical transformations.
- 9 July 2025
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 41 (28) , 18544-18553
Unveiling the Potential Photothermal Activity of Vanadium Carbide for Driving Chemical Reactions
Photothermally activated chemical reactions play a pivotal role in a wide range of applications, highlighting the need for efficient photothermal agents. The photothermal effect, which utilizes dominant nonradiative deexcitation mechanisms, has been extensively demonstrated in nanoscale systems, including plasmonic metals, inorganic semiconductors, organic materials, and polymers. However, the development of these photothermal materials often requires intricate fabrication and separation techniques, presenting significant challenges for practical implementation. Here we demonstrate that commercially available bulk vanadium monocarbide (VC) powder exhibits excellent light-to-heat conversion efficiency (∼70%), combined with remarkable chemical, thermal, and optical stability (against intense laser irradiation). These unique attributes of VC were harnessed to drive industrially relevant photothermally activated chemical reactions, specifically in the polymerization of acrylic monomers and the Diels-Alder (DA) reaction between anthracene and N-phenyl maleimide. Comprehensive analysis through FTIR and 1H NMR studies confirms the successful formation of products in both the reactions. Importantly, the photothermal reactions exhibit significantly reduced reaction times compared to the conventional thermal protocols. Furthermore, the recoverability of VC powder after the completion of the reactions enhances environmental sustainability. This study contributes valuable insights into the utilization of commercially available bulk VC powder as an off-the-shelf, cost-effective, efficient and sustainable photothermal agent for various chemical transformations.
- 18 December 2024
- Published by Springer Nature in Applied Physics A
- Vol. 131 (1) , 1-11
Selective etching of Aluminium towards the synthesis of AlB2 derived aqueous dispersion of luminescent boron-based Nanosheets
- 18 December 2024
- Published by Springer Nature in Applied Physics A
- Vol. 131 (1) , 1-11
Selective etching of Aluminium towards the synthesis of AlB2 derived aqueous dispersion of luminescent boron-based Nanosheets
- Open Access
- 22 July 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (33) , 22112-22121
Multivalency-induced structural variations of 2D selenium nanosheets: facile solution-phase synthesis and optical properties
We report the experimental realization of 2D α-selenene (α-Se) and β-selenene (β-Se) from bulk selenium via a simple solution-phase synthesis method.
- 22 July 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (33) , 22112-22121
Open AccessMultivalency-induced structural variations of 2D selenium nanosheets: facile solution-phase synthesis and optical properties
We report the experimental realization of 2D α-selenene (α-Se) and β-selenene (β-Se) from bulk selenium via a simple solution-phase synthesis method.
- 18 July 2022
- Published by Wiley in Luminescence
- Vol. 37 (9) , 1475-1481
Comparative photoluminescence study of nitrogen‐doped carbon dots co‐doped with boron and sulphur
Although different studies in carbon dots (CDs) have been reported based on heteroatom doping, most of them have focussed on the enhancement of fluorescence properties. Here we report a comparative study of both fluorescence and room‐temperature phosphorescence (RTP) of nitrogen–sulphur‐doped CDs (N–S CDs) and nitrogen–boron‐doped CDs (N–B CDs) with N‐doped CDs (N CDs). The CDs used in the study were synthesized through microwave‐assisted pyrolysis. Among the doped CDs, sulphur‐doped CDs showed a high fluorescence quantum yield. Upon irradiation, the aqueous dispersion of the CDs demonstrated blue fluorescence. Furthermore, by incorporating the CDs in a potash alum matrix, blue fluorescence, as well as green phosphorescence was observed. The phosphorescence lifetime measurements indicated that the N–S CDs exhibited a longer emission lifetime and a red‐shifted emission in contrast with other samples, which might be attributed to the presence of a greater proportion of surface states on the N–S CDs.
- 18 July 2022
- Published by Wiley in Luminescence
- Vol. 37 (9) , 1475-1481
Comparative photoluminescence study of nitrogen‐doped carbon dots co‐doped with boron and sulphur
Although different studies in carbon dots (CDs) have been reported based on heteroatom doping, most of them have focussed on the enhancement of fluorescence properties. Here we report a comparative study of both fluorescence and room‐temperature phosphorescence (RTP) of nitrogen–sulphur‐doped CDs (N–S CDs) and nitrogen–boron‐doped CDs (N–B CDs) with N‐doped CDs (N CDs). The CDs used in the study were synthesized through microwave‐assisted pyrolysis. Among the doped CDs, sulphur‐doped CDs showed a high fluorescence quantum yield. Upon irradiation, the aqueous dispersion of the CDs demonstrated blue fluorescence. Furthermore, by incorporating the CDs in a potash alum matrix, blue fluorescence, as well as green phosphorescence was observed. The phosphorescence lifetime measurements indicated that the N–S CDs exhibited a longer emission lifetime and a red‐shifted emission in contrast with other samples, which might be attributed to the presence of a greater proportion of surface states on the N–S CDs.
- 1 June 2021
- Published by Elsevier in Materials Research Bulletin
- Vol. 138
Multi-functional carbon dots for visual detection of picric acid and white-light emission
- 1 June 2021
- Published by Elsevier in Materials Research Bulletin
- Vol. 138
Multi-functional carbon dots for visual detection of picric acid and white-light emission
- Open Access
- 27 August 2020
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 10 (53) , 31788-31793
Facile synthesis of aqueous-dispersed luminescent nanosheets from non-layered lanthanum hexaboride
Nanosheets were synthesised by incorporating probe sonication and grinding of an aqueous dispersion of non-layered lanthanam hexaboride.
- 27 August 2020
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 10 (53) , 31788-31793
Open AccessFacile synthesis of aqueous-dispersed luminescent nanosheets from non-layered lanthanum hexaboride
Nanosheets were synthesised by incorporating probe sonication and grinding of an aqueous dispersion of non-layered lanthanam hexaboride.