Fan Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Fan Liu has a total of 42 co-authors. Here are the top co-authors by number of shared publications:
- Jia Cheng
Tsinghua University
5 shared publications Linhong Ji
State Key Laboratory of Tribology, Department of Mechanical Engineering, Tsinghua University, Beijing 100084, China
4 shared publications- Yijia Lu
State Key Laboratory of Tribology, Department of Mechanical Engineering, Tsinghua University, Beijing, China
3 shared publications - Ze Yang
Institution Lab of State Forestry Administration on Forestry Equipment and Automation, School of Technology
3 shared publications - Zhaozheng Wang
CAS Center for Excellence in Nanoscience, Beijing Key Laboratory of Micro-Nano Energy and Sensor, Beijing Institute of Nanoenergy and Nanosystems, Chinese Academy of Sciences, Beijing 101400, China
3 shared publications - Zhong Lin Wang
Beijing Institute of Nanoenergy and Nanosystems, Chinese Academy of Sciences, Beijing, China
3 shared publications
Latest Publications
- 20 June 2025
- Published by Springer Nature in Nature Physics
- Vol. 21 (8) , 1311-1318
Intercellular flow dominates the poroelasticity of multicellular tissues
- 20 June 2025
- Published by Springer Nature in Nature Physics
- Vol. 21 (8) , 1311-1318
Intercellular flow dominates the poroelasticity of multicellular tissues
- 9 November 2022
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 16 (11) , 19363-19372
Bulk Electroporation for Intracellular Delivery Directly Driven by Mechanical Stimulus
Electroporation (EP) is an effective and widely accepted intracellular delivery method for fundamental research and medical applications. Existing electroporation methods usually require a commercially available EP system or tailormade high-voltage (HV, up to kV) power source and are complicated, expensive, harmful to the cells, and even dangerous to the operators. A triboelectric nanogenerator (TENG) is a highly studied device that can generate HV output with limited charges and ultrahigh internal impedance. Here, we developed a Bulk Electroporation System based on TENG (BEST). To maximize the load voltage of the TENG, a flowing EP unit with a capillary was designed as a resistive load to realize impedance matching. A low conductivity buffer was used to further match and assist cell electroporation. Besides, the electrical model and experiments on cells transfected with the BEST showed that the bulk electric field of the cell medium could reach up to 1 kV/cm, therefore resulting in a nearly 30 times increase of trans-membrane potential, thus largely improving transfection efficiency. Finally, using 40 kDa FITC-dextran, we showed that a delivery efficiency above 50% with a cell viability maintained over 90% can be achieved in HeLa cells. This work demonstrated the potential of TENG in the biomedical field as a naturally safe HV power source. It also provided a simple, alternative, and low-cost solution for EP research and related biomedicine applications.
- 9 November 2022
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 16 (11) , 19363-19372
Bulk Electroporation for Intracellular Delivery Directly Driven by Mechanical Stimulus
Electroporation (EP) is an effective and widely accepted intracellular delivery method for fundamental research and medical applications. Existing electroporation methods usually require a commercially available EP system or tailormade high-voltage (HV, up to kV) power source and are complicated, expensive, harmful to the cells, and even dangerous to the operators. A triboelectric nanogenerator (TENG) is a highly studied device that can generate HV output with limited charges and ultrahigh internal impedance. Here, we developed a Bulk Electroporation System based on TENG (BEST). To maximize the load voltage of the TENG, a flowing EP unit with a capillary was designed as a resistive load to realize impedance matching. A low conductivity buffer was used to further match and assist cell electroporation. Besides, the electrical model and experiments on cells transfected with the BEST showed that the bulk electric field of the cell medium could reach up to 1 kV/cm, therefore resulting in a nearly 30 times increase of trans-membrane potential, thus largely improving transfection efficiency. Finally, using 40 kDa FITC-dextran, we showed that a delivery efficiency above 50% with a cell viability maintained over 90% can be achieved in HeLa cells. This work demonstrated the potential of TENG in the biomedical field as a naturally safe HV power source. It also provided a simple, alternative, and low-cost solution for EP research and related biomedicine applications.
- 18 May 2021
- Published by Wiley in Advanced Energy Materials
- Vol. 11 (28) , 2101147
Charge Pumping for Sliding‐mode Triboelectric Nanogenerator with Voltage Stabilization and Boosted Current
As an emerging harvester for mechanical energy, the ultrahigh and unstable voltage and low surface charge density have limited the practical applications of triboelectric nanogenerators (TENGs). Herein, a charge pumping technology is demonstrated for sliding‐mode TENG with voltage stabilization and enhanced current by utilizing unfixed shuttling charges to generate electricity. A voltage booster circuit and a switch circuit are incorporated to elevate charge density and reduce high output voltage, respectively. With this technology, output electricity can be doubled owing to its two conduction domains and the voltage is outputted in an approximately direct‐current form. Moreover, a reduction of 63.9% in voltage fluctuation and an elevation of 43.4% in current are achieved, and an ultrahigh charge density is obtained up to 1328 µC m−2. This sliding charge pump technology is fundamentally different from traditional ones, providing insight into enhancing the output of TENG and offering a new high‐output energy harvesting strategy.
- 18 May 2021
- Published by Wiley in Advanced Energy Materials
- Vol. 11 (28) , 2101147
Charge Pumping for Sliding‐mode Triboelectric Nanogenerator with Voltage Stabilization and Boosted Current
As an emerging harvester for mechanical energy, the ultrahigh and unstable voltage and low surface charge density have limited the practical applications of triboelectric nanogenerators (TENGs). Herein, a charge pumping technology is demonstrated for sliding‐mode TENG with voltage stabilization and enhanced current by utilizing unfixed shuttling charges to generate electricity. A voltage booster circuit and a switch circuit are incorporated to elevate charge density and reduce high output voltage, respectively. With this technology, output electricity can be doubled owing to its two conduction domains and the voltage is outputted in an approximately direct‐current form. Moreover, a reduction of 63.9% in voltage fluctuation and an elevation of 43.4% in current are achieved, and an ultrahigh charge density is obtained up to 1328 µC m−2. This sliding charge pump technology is fundamentally different from traditional ones, providing insight into enhancing the output of TENG and offering a new high‐output energy harvesting strategy.
- 3 February 2021
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 15 (2) , 2611-2623
Power Backpack for Energy Harvesting and Reduced Load Impact
Long-distance walking with heavy loads is often needed when going hiking or for field rescue, which is prone to cumulative fatigue. There is also a great need for labor-saving and biomechanical energy harvesting in daily life for extended security and communication needs. Here, we report a load-suspended backpack for harvesting the wasted energy of human motion based on a triboelectric nanogenerator (TENG). Two elastomers are incorporated into the backpack to decouple the synchronous movement of the load and the human body, which results in little or no extra accelerative force. With such a design, through theoretical analysis and field experiments, the backpack can realize a reduction of 28.75 % in the vertical oscillation of the load and 21.08 % in the vertical force on the wearer, respectively. Meanwhile, the mechanical-to-electric energy conversion efficiency is modeled and calculated to be 14.02 % under normal walking conditions. The designed backpack has the merits of labor-saving and shock absorption as well as electricity generation, which has the promising potential to be a power source for small-scale wearable and portable electronics, GPS systems, and other self-powered health care sensors.
- 3 February 2021
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 15 (2) , 2611-2623
Power Backpack for Energy Harvesting and Reduced Load Impact
Long-distance walking with heavy loads is often needed when going hiking or for field rescue, which is prone to cumulative fatigue. There is also a great need for labor-saving and biomechanical energy harvesting in daily life for extended security and communication needs. Here, we report a load-suspended backpack for harvesting the wasted energy of human motion based on a triboelectric nanogenerator (TENG). Two elastomers are incorporated into the backpack to decouple the synchronous movement of the load and the human body, which results in little or no extra accelerative force. With such a design, through theoretical analysis and field experiments, the backpack can realize a reduction of 28.75 % in the vertical oscillation of the load and 21.08 % in the vertical force on the wearer, respectively. Meanwhile, the mechanical-to-electric energy conversion efficiency is modeled and calculated to be 14.02 % under normal walking conditions. The designed backpack has the merits of labor-saving and shock absorption as well as electricity generation, which has the promising potential to be a power source for small-scale wearable and portable electronics, GPS systems, and other self-powered health care sensors.
- Open Access
- 1 January 2020
- Published by Elsevier in Nano Energy
- Vol. 67
Triboelectric nanogenerators for electro-assisted cell printing
- 1 January 2020
- Published by Elsevier in Nano Energy
- Vol. 67
Open AccessTriboelectric nanogenerators for electro-assisted cell printing
- Open Access
- 1 February 2019
- Published by Elsevier in Nano Energy
- Vol. 56, 482-493
Electrical analysis of triboelectric nanogenerator for high voltage applications exampled by DBD microplasma
- 1 February 2019
- Published by Elsevier in Nano Energy
- Vol. 56, 482-493
Open AccessElectrical analysis of triboelectric nanogenerator for high voltage applications exampled by DBD microplasma
- Top Cited PapersOpen Access
- 13 September 2018
- Published by Springer Nature in Nature Communications
- Vol. 9 (1) , 1-11
Triboelectric microplasma powered by mechanical stimuli
Triboelectric nanogenerators (TENGs) naturally have the capability of high voltage output to breakdown gas easily. Here we present a concept of triboelectric microplasma by integrating TENGs with the plasma source so that atmospheric-pressure plasma can be powered only by mechanical stimuli. Four classical atmospheric-pressure microplasma sources are successfully demonstrated, including dielectric barrier discharge (DBD), atmospheric-pressure non-equilibrium plasma jets (APNP-J), corona discharge, and microspark discharge. For these types of microplasma, analysis of electric characteristics, optical emission spectra, COMSOL simulation and equivalent circuit model are carried out to explain transient process of different discharge. The triboelectric microplasma has been applied to patterned luminescence and surface treatment successfully as a first-step evaluation as well as to prove the system feasibility. This work offers a promising, facile, portable and safe supplement to traditional plasma sources, and will enrich the diversity of plasma applications based on the reach of existing technologies.
- 13 September 2018
- Published by Springer Nature in Nature Communications
- Vol. 9 (1) , 1-11
Top Cited PapersOpen AccessTriboelectric microplasma powered by mechanical stimuli
Triboelectric nanogenerators (TENGs) naturally have the capability of high voltage output to breakdown gas easily. Here we present a concept of triboelectric microplasma by integrating TENGs with the plasma source so that atmospheric-pressure plasma can be powered only by mechanical stimuli. Four classical atmospheric-pressure microplasma sources are successfully demonstrated, including dielectric barrier discharge (DBD), atmospheric-pressure non-equilibrium plasma jets (APNP-J), corona discharge, and microspark discharge. For these types of microplasma, analysis of electric characteristics, optical emission spectra, COMSOL simulation and equivalent circuit model are carried out to explain transient process of different discharge. The triboelectric microplasma has been applied to patterned luminescence and surface treatment successfully as a first-step evaluation as well as to prove the system feasibility. This work offers a promising, facile, portable and safe supplement to traditional plasma sources, and will enrich the diversity of plasma applications based on the reach of existing technologies.
- 14 April 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 55 (7) , 4047-4058
Superresolution for UAV Images via Adaptive Multiple Sparse Representation and Its Application to 3-D Reconstruction
We propose a superresolution (SR) algorithm based on adaptive sparse representation via multiple dictionaries for images taken by unmanned aerial vehicles (UAVs). The SR attainable through the proposed algorithm can increase the precision of 3-D reconstruction from UAV images, enabling the production of high-resolution images for constructing high-frequency time series and for high-precision digital mapping in agriculture. The basic idea of the proposed method is to use a field server or ground-based camera to take training images and then construct multiple pairs of dictionaries based on selective sparse representations to reduce instability during the sparse coding process. The dictionaries are classified on the basis of the edge orientation into five clusters: 0, 45, 90, 135, and nondirection. The proposed method is expected to reduce blurring, blocking, and ringing artifacts especially in edge areas. We evaluated the proposed and previous methods using peak signal-to-noise ratio, structural similarity, feature similarity, and computation time. Our experimental results indicate that the proposed method clearly outperforms other state-of-the-art algorithms based on qualitative and quantitative analysis. In the end, we demonstrate the effectiveness of our proposed method to increase the precision of 3-D reconstruction from UAV images.
- 14 April 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 55 (7) , 4047-4058
Superresolution for UAV Images via Adaptive Multiple Sparse Representation and Its Application to 3-D Reconstruction
We propose a superresolution (SR) algorithm based on adaptive sparse representation via multiple dictionaries for images taken by unmanned aerial vehicles (UAVs). The SR attainable through the proposed algorithm can increase the precision of 3-D reconstruction from UAV images, enabling the production of high-resolution images for constructing high-frequency time series and for high-precision digital mapping in agriculture. The basic idea of the proposed method is to use a field server or ground-based camera to take training images and then construct multiple pairs of dictionaries based on selective sparse representations to reduce instability during the sparse coding process. The dictionaries are classified on the basis of the edge orientation into five clusters: 0, 45, 90, 135, and nondirection. The proposed method is expected to reduce blurring, blocking, and ringing artifacts especially in edge areas. We evaluated the proposed and previous methods using peak signal-to-noise ratio, structural similarity, feature similarity, and computation time. Our experimental results indicate that the proposed method clearly outperforms other state-of-the-art algorithms based on qualitative and quantitative analysis. In the end, we demonstrate the effectiveness of our proposed method to increase the precision of 3-D reconstruction from UAV images.