JTJuan José Trujillo

Juan José Trujillo

*This is an algorithmically generated author record based on publicly available information.

Juan José Trujillo has a total of 27 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Top Cited Papers
    Open Access

    Offshore wind farm cluster wakes as observed by long-range-scanning wind lidar measurements and mesoscale modeling

    by Beatriz Cañadillas, Maximilian Beckenbauer, Juan J. Trujillo, Martin Dörenkämper, Richard Foreman, Thomas Neumann, Astrid Lampert

    As part of the ongoing X-Wakes research project, a 5-month wake-measurement campaign was conducted using a scanning lidar installed amongst a cluster of offshore wind farms in the German Bight. The main objectives of this study are (1) to demonstrate the performance of such a system and thus quantify cluster wake effects reliably and (2) to obtain experimental data to validate the cluster wake effect simulated by the flow models involved in the project. Due to the lack of free wind flow for the wake flow directions, wind speeds obtained from a mesoscale model (without any wind farm parameterization) for the same time period were used as a reference to estimate the wind speed deficit caused by the wind farm wakes under different wind directions and atmospheric stabilities. For wind farm waked wind directions, the lidar data show that the wind speed is reduced up to 30 % at a wind speed of about 10 m s−1, depending on atmospheric stability and distance to the wind farm. For illustrating the spatial extent of cluster wakes, an airborne dataset obtained during the scanning wind lidar campaign is used and compared with the mesoscale model with wind farm parameterization and the scanning lidar. A comparison with the results of the model with a wind farm parameterization and the scanning lidar data reveals a relatively good agreement in neutral and unstable conditions (within about 2 % for the wind speed), whereas in stable conditions the largest discrepancies between the model and measurements are found. The comparative multi-sensor and model approach proves to be an efficient way to analyze the complex flow situation in a modern offshore wind cluster, where phenomena at different length scales and timescales need to be addressed.


  • Open Access

    Alignment of scanning lidars in offshore wind farms

    by Andreas Rott, Jörge Schneemann, Frauke Theuer, Juan José Trujillo Quintero, Martin Kühn

    Long-range Doppler wind lidars are applied more and more for high-resolution areal measurements in and around wind farms. Proper alignment, or at least knowledge on how the systems are aligned, is of great relevance here. The paper describes in detail two methods that allow a very accurate alignment of a long-range scanning lidar without the use of extra equipment or sensors. The well-known so-called hard targeting allows a very precise positioning and north alignment of the lidar using the known positions of the surrounding obstacles, e.g. wind turbine towers. Considering multiple hard targets instead of only one with a given position in an optimization algorithm allows us to increase the position information of the lidar device and minimizes the consequences of using erroneous input data. The method, referred to as sea surface levelling, determines the levelling of the device during offshore campaigns in terms of roll and pitch angles based on distance measurements to the water surface. This is particularly well-suited during the installation of the systems to minimize alignment error from the start, but it can also be used remotely during the measurement campaign for verification purposes. We applied and validated these methods to data of an offshore measurement campaign, where a commercial long-range scanning lidar was installed on the transition piece platform of a wind turbine. In addition, we present a model that estimates the quasi-static inclination of the device due to the thrust loading of the wind turbine at different operating conditions. The results show reliable outcomes with a very high accuracy in the range of 0.02∘ in determining the levelling. The importance of the exact alignment and the possible applications are discussed in this paper. In conclusion, these methods are useful tools that can be applied without extra effort and contribute significantly to the quality of successful measurement campaigns.


  • Open Access

    Offshore wind farm cluster wakes as observed by a long-range scanning wind lidar

    by Beatriz Cañadillas, Maximilian Beckenbauer, Juan José Trujillo, Martin Dörenkämper, Richard Foreman, Thomas Neumann, Astrid Lampert

    To establish long-term flow measurements for the validation of wake models, a scanning Doppler wind lidar system was installed at the western edge of the wind farm Gode Wind 1 in the German Bight for a period of five months. The main goal was to detect the wakes from clusters for different wind directions and atmospheric stabilities. The lidar data are categorized into five sectors based on the different upstream conditions. The influence of wakes and atmospheric stability are initially investigated with respect to airborne measurements collected within the lidar measurement period. Mesoscale simulations are used as a reference for the free wind flow. The percent wind speed difference downstream of the wind farm clusters and at the location of the scanning lidar measurements (1.5 km downstream the closest wind farm) can reach a maximum of about 30 % for a mean wind speed of 10 m s−1 depending on the wind direction and under stable atmospheric conditions. A good agreement between mesoscale simulations (without any wind farm parameterization) and lidar measurements is found for undisturbed wind sectors and unstable and near-neutral atmospheric conditions. By taking into account the surrounding wind farms through a parameterization in the mesoscale simulations, the agreement of the model with the measurements is relatively good for unstable and near-neutral conditions, including sectors influenced by wind farm wakes. For stable conditions, however, the highest discrepancies between simulations and observations occur. Overall, the scanning lidar dataset can be used as a validation tool for wake model validations.

  • Open Access

    Alignment of scanning lidars in offshore wind farms

    by Andreas Rott, Jörge Schneemann, Frauke Theuer, Juan José Trujillo Quintero, Martin Kühn

    Long-range Doppler wind lidars are applied more and more for high resolution areal measurements in and around wind farms. Proper alignment, or at least knowledge on how the systems are aligned, is of great relevance here. The paper describes in detail two methods that allow a very accurate alignment of a long-range scanning lidar without the use of extra equipment or sensors. The well-known so-called Hard Targeting allows a very precise positioning and north alignment of the lidar using the known positions of the surrounding obstacles, e.g. wind turbine towers. Considering multiple hard targets instead of only one with a given position in an optimization algorithm allows to increase the position information of the lidar device and minimizes the consequences of using erroneous input data. The method, referred to as Sea Surface Leveling, determines the leveling of the device during offshore campaigns in terms of roll and pitch angle based on distance measurements to the water surface. This is particularly well suited during the installation of the systems to minimize alignment error from the start, but it can also be used remotely during the measurement campaign for verification purposes. We applied and validated these methods to data of an offshore measurement campaign, where a commercial long-range scanning lidar was installed on the transition piece platform of a wind turbine. In addition, we present a model that estimates the quasi-static inclination of the device due to the thrust loading of the wind turbine at different operating conditions. The results show reliable outcomes with a very high accuracy in the range of 0.02° in determining the leveling. The importance of the exact alignment as well as the possible applications are discussed in this paper. In conclusion, these methods are useful tools that can be applied without extra effort and contribute significantly to the quality of successful measurement campaigns.


  • Open Access

    Full-field assessment of wind turbine near-wake deviation in relation to yaw misalignment

    by Juan José Trujillo, Janna Kristina Seifert, Ines Würth, David Schlipf, Martin Kühn

    Presently there is a lack of data revealing the behaviour of the path followed by the near wake of full scale wind turbines and its dependence on yaw misalignment. Here we present an experimental analysis of the horizontal wake deviation of a 5 MW offshore wind turbine between 0.6 and 1.4 diameters downstream. The wake field has been scanned with a short-range lidar and the wake path has been reconstructed by means of two-dimensional Gaussian tracking. We analysed the measurements for rotor yaw misalignments arising in normal operation and during partial load, representing high thrust coefficient conditions. We classified distinctive wake paths with reference to yaw misalignment, based on the nacelle wind vane, in steps of 3° in a range of ±10.5°. All paths observed in the nacelle frame of reference showed a consistent convergence towards 0.9 rotor diameters downstream, suggesting a kind of wake deviation shift. This contrasts with published results from wind tunnels which in general report a convergence towards the rotor. The discrepancy is evidenced in particular in a comparison which we performed against published paths obtained by means of tip vortex tracking.


  • Open Access

    Full field assessment of wind turbine near wake deviation in relation to yaw misalignment

    by Juan-José Trujillo, Janna K. Seifert, Ines Würth, David Schlipf, Martin Kühn

    Presently there is a lack of data revealing the behaviour of the path followed by the near wake of full scale wind turbines and its dependence on yaw misalignment. Here we present an experimental analysis of the horizontal wake deviation of a 5 MW offshore wind turbine between 0.6 and 1.4 diameters downstream. The wake field has been scanned with a short range lidar and the wake path has been reconstructed by means of two-dimensional Gaussian tracking. We analysed the measurements for rotor yaw misalignments arising in normal operation and during partial load, representing high thrust coefficient conditions. We classified distinctive wake paths with reference to yaw misalignment, based on the nacelle wind vane, in steps of 3° in a range of ±10.5°. All paths observed in the nacelle frame of reference showed a consistent convergence towards 0.9 rotor diameters downstream suggesting a kind of wake deviation delay. This contrasts with published results from wind tunnels which in general report a convergence towards the rotor. The discrepancy is evidenced in particular in a comparison which we performed against published paths obtained by means of tip vortex tracking.

  • Lidar Simulations to Study Measurements of Turbulence in Different Atmospheric Conditions

    by Jörge Schneemann, Stephan Voss, Gerald Steinfeld, Davide Trabucchi, Juan José Trujillo, Björn Witha, Martin Kühn


  • Utilizing a vanadium redox flow battery to avoid wind power deviation penalties in an electricity market

    by Burak Turker, Sebastian Arroyo Klein, Lidiya Komsiyska, Juan José Trujillo, Lueder von Bremen, Martin Kühn, Matthias Busse


  • Top Cited Papers

    Light detection and ranging measurements of wake dynamics. Part II: two‐dimensional scanning

    by Juan‐José Trujillo, Ferhat Bingöl, Gunner C. Larsen, Jakob Mann, Martin Kühn

    A nacelle‐mounted lidar system pointing downstream has been used to measure wind turbine wake dynamics. The new measurement and data analysis techniques allow estimation of quasi‐instantaneous wind fields in planes perpendicular to the rotor axis. A newly developed wake tracking procedure delivers the instantaneous transversal wake position which is quantitatively compared with the prediction of the Dynamic Wake Meandering model. The results, shown for two 10‐min time series, suggest that the conjecture of the wake behaving as a passive tracer is a fair approximation; this corroborates and expands the results of one‐dimensional measurements already presented in the first part of this paper. Consequently, it is now possible to separate the deterministic and turbulent parts of the wake wind field, thus enabling capturing the wake in the meandering frame of reference. The results correspond, qualitatively and to some extent quantitatively, to the expectations from CFD simulations which are compared in the paper. Copyright © 2010 John Wiley & Sons, Ltd.