LCLars Nielausen Cleemann

Lars Nielausen Cleemann

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Lars Nielausen Cleemann has a total of 124 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Systematic Investigation of Carbon Pretreatment for the Synthesis of Platinum Nano-Catalysts for Oxygen Reduction Reaction

    by Fabian Luca Buchauer, Lars Cleemann, Jens Oluf Jensen, Qingfeng Li, Benedikt Axel Brandes

    The synthesis of electrocatalysts for low- and high temperature fuel cells is dependent on many different factors that determine the activity of the produced catalysts. One important and highly underrepresented factor in literature are carbon pretreatments, which have a strong impact on the electrochemical activity of the produced catalyst. A web of science search showed that less than 1% of the articles working with the synthesis of Pt-based catalysts for the Oxygen reduction reaction (ORR) contain information on carbon pretreatments. In recent years no articles on the topic of carbon pretreatment for the synthesis of Pt-based ORR catalyst have been published. However, different forms (as powder, nano tubes, etc.) of carbon are commonly used as support material for Pt-based catalysts. Previous work has shown the importance of pretreatment of carbon supports to change the surface-active groups, enhancing the dispersion and reducing agglomeration of Pt-nanoparticles [1]. Oxidizing treatments are known to change the surface groups and decreasing the BET surface area [2]. Furthermore, carbon pretreatments can effectively reduce impurities present in as-purchased carbon [3]. A systematic study of pretreatments of Vulcan XC72-R and Ketjen 300 have been carried out followed by the synthesis of supported Pt-nanoparticles using XPS, XRD, TEM, BET and RDE techniques. We found that the presence of sulfur in the surface strongly correlates with the ECSA of the supported Pt catalyst. This talk will elaborate on the effect of pretreatments on the carbon support, the synthesis of Pt nanoparticles and its impact on the resulting electrochemical performance: Compared to as received carbon, the Pt mass activity could be increased by a factor 4, exceeding the mass activity of comparable commercial Pt/C electrocatalysts. [1] Bimetallic Pt–Sn catalysts supported on activated carbon I. The effects of support modification and impregnation strategy - A. Erhan Aksoylu; M. Madalena A. Freitas; Jose L. Figueiredo [2] The effect of pretreatment of Vulcan XC-72R carbon on morphology and electrochemical oxygen reduction kinetics of supported Pd nano-particle in acidic electrolyte - Senthil Kumar, S. M.; Soler Herrero, Jaime; Irusta, Silvia; Scott, Keith [3] Effect of the carbon pre-treatment on the properties and performance for nitrobenzene hydrogenation of Pt/C catalysts - Torres, G. C.; Jablonski, E. L.; Baronetti, G. T.; Castro, A. A.; De Miguel, S. R.; Scelza, O. A.; Blanco, M. D.; Peña Jiménez, M. A.; Fierro, J. L.G. Figure 1

  • Synthesis of Platinum-Rare Earth Metal Alloy Catalysts for Proton Exchange Membrane Fuel Cells

    by Quan Zhou, Yang Hu, Benedikt Axel Brandes, Lars Cleemann, Jens Oluf Jensen, Qingfeng Li

    Electrocatalysts for low temperature fuel cells are based on noble metals and can be promoted by development of alloys of platinum with e.g. late transition metals such as Ni and Co.[1,2] It has been reported that Pt alloys with rare earth (RE) metals exhibit remarkable activity and high stability towards the oxygen reduction reaction.[3] Due to the very low standard reduction potentials and high oxophilicity of rare earth metals, preparation platinum alloys in form of nanoparticles meets great challenges for chemical routes of co-reduction. A one-step method is recently developed to prepare Pt−RE nanoalloys from a mixture of solid state precursors consisting of metal halides in their hydrate forms, a suitable nitrogen-rich compound and a carbon support.[4,5] The synthesis involves in situ formation of a carbon-nitrogen network, onto which the two metals are atomically dispersed. The coordination with nitrogen sites stabilizes the metals, which, upon thermal decomposition under a mild reducing atmosphere, leads to the formation of Pt-RE nanoalloys. The carbon support is introduced either as carbon blacks or carbon supported platinum powder. The pre-formed, either in or ex situ, platinum nanoparticles, facilitates the reduction of rare earth metals thermodynamically driven by the negative alloying free energy. A series of pure crystal phases such as Pt5RE (e.g. La, Ce, Nd), and Pt3RE (e.g. Y, Gd, Tb) have been synthesized in form of carbon supported nanoparticles with tunable metal loadings and alloy particle sizes. One of the typical catalysts is the Pt5Ce/C in a metal to carbon ratio of 30 wt% and an average alloy particle size of ca. 5.5 nm which exhibits an area specific activity of 3.7 times and a mass activity of 1.9 times higher than those of the Pt/C analogue. Further understanding and improvement of the process are in progress and the updated results will be presented in this talk. [1]. J. K. Norskov et al., Nature Chemistry 1, 37-46 (2009) [2]. X. Q. Huang et al., Science 348, 1230-1234 (2015) [3]. M. Escudero-Escribano et al., Science 352, 73-76 (2016) [4]. Y. Hu et al., J. Am. Chem. Soc. 142, 953–961 (2020) [5]. Y. Hu et al., Chem. Mater. 33, 2, 535–546 (2021)

  • ORR Activity and Surface Strain Relations of Commercial Pt Alloy Catalysts

    by Benedikt Axel Brandes, Daniel Kelly, Pei Liu, Thomas Willum Hansen, Jens Oluf Oluf Jensen, Qingfeng Li, Lars Cleemann

    Understanding and improving the catalysts for the ORR (Oxygen Reduction Reaction) is of great importance for the development of low temperature fuel cells. Within the past two decades great effort has been taken into the development of platinum alloy nano-catalysts and brought to commercialization. While thorough studies on the activity and stability of the individual catalysts have received great attention in the scientific literature, consistent comparisons of different platinum alloy nano-catalysts are scare: Due to different preparation methods and experimental conditions, the reported specific activities of, e.g. Pt3Co/C, vary by one order of magnitude [1][2]. In the first part of this talk we will present consistent electrochemical measurements on 7 different commercially available platinum alloy nano-catalysts (20% Pt loading on Vulcan XC-72R). In the second part we will present our results in context of the scientific understanding the ORR on platinum-based catalysts. Therefore, we conducted an extensive TEM survey on the measured nano-catalysts and gained further insights into the platinum surface strain. We find that the platinum surface strain of nano-catalysts is not only a phenomenon of an over-layer formation on platinum alloys, but also an inherent property of its nano-particular form. Wang, C. et al. “Monodisperse Pt3Co nanoparticles as a catalyst for the oxygen reduction reaction: Size-dependent activity.” Journal of Physical Chemistry C, 113(45), 19365–19368. https://doi.org/10.1021/jp908203p Koh, S. et al. “Activity-stability relationships of ordered and disordered alloy phases of Pt3Co electrocatalysts for the oxygen reduction reaction (ORR).” Electrochimica Acta, 52(8 SPEC. ISS.), 2765–2774. https://doi.org/10.1016/j.electacta.2006.08.039 Figure 1

  • High-Temperature PEM Fuel Cells: Towards Decreasing the Pt Loadings

    by Hans Aage Hjuler, Kobra Azizi, Nedjeljko Seselj, Silvia Martinez Alfaro, Hector Rodrigo Garcia, Denys Gromadskyi, Larysa Hromadska, Søren Primdahl, Jens Oluf Jensen, Qingfeng Li, et al.


  • Durability Studies on PBI Based High Temperature PEMFC

    by Hans Aage Hjuler, Kobra Azizi, Nedjeljko Seselj, Silvia Martinez Alfaro, Hector Rodrigo Garcia, Denys Gromadskyi, Larysa Hromadska, Søren Primdahl, Jens Oluf Jensen, Qingfeng Li, et al.

  • Durability Studies on PBI Based High Temperature PEMFC

    by Hans Aage Hjuler, Kobra Azizi, Nedjeljko Seselj, Silvia Martinez Alfaro, Hector Rodrigo Garcia, Denys Gromadskyi, Larysa Hromadska, Søren Primdahl, Jens Oluf Jensen, Qingfeng Li, et al.


  • Open Access

    Revealing the genuine stability of the reference Pt/C electrocatalyst toward the ORR

    by Yang Hu, Jens Oluf Jensen, Patrick Bretzler, Lars Nilausen Cleemann, Jianan Yu, Qingfeng Li


  • Polybenzimidazole-Based High-Temperature Polymer Electrolyte Membrane Fuel Cells: New Insights and Recent Progress

    by David Aili, Dirk Henkensmeier, Santiago Martin, Bhupendra Singh, Yang Hu, Jens Oluf Jensen, Lars N. Cleemann, Qingfeng Li


  • Synthesis of Pt–Rare Earth Metal Nanoalloys

    by Yang Hu, Jens Oluf Jensen, Lars Nilausen Cleemann, Benedikt Axel Brandes, Qingfeng Li

    Chemical synthesis of platinum-rare earth metal (Pt-RE) nanoalloys, one of the most active catalysts for the oxygen re-duction reaction, has been a formidable challenge, mainly due to the vastly different standard reduction potentials of the two metals and high oxophilicity of the latter. Here we report a universal chemical process to prepare Pt-RE nanoalloys with tunable compositions and particle sizes. Pt and RE metal ions from the most common hydrated metal salts are first atomically embedded into an in-situ formed C-N network, yielding a stable compound insensitive to O2 and H2O. The Pt-RE nanoalloys are subsequently obtained by heating the compound under a mild reducing atmosphere (e.g. 3.3% H2/Ar). The key intermediate step of the process is the formation of RE carbodiimides (RE2(CN2)3) along with Pt particles. This synthesis mechanism suggests an efficient strategy to prepare nanoalloys with highly reactive metals.