Hüseyin Kaan Kaplan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hüseyin Kaan Kaplan has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
M. Ahmetoglu
2 shared publicationsS.K. Akay
2 shared publicationsSertan Kemal Akay
Department of Physics, Faculty of Arts and Sciences, Bursa Uludağ University, Görükle, Bursa, Turkey
2 shared publications- Sertan Kemal Akay
Physics Department, Faculty of Arts and Sciences, Bursa Uludag University, Bursa, Türkiye
2 shared publications A. Kara
1 shared publicationAbdul Jalil
Department of Physics, Allama Iqbal Open University, Islamabad 44000, Pakistan
1 shared publication
Latest Publications
- 13 January 2025
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 58 (10) , 105111
High-performance, self-powered ZnO NWs-ZnSe heterojunction photodetectors for superior visible and near-infrared detection
We present the development of a type-II heterojunction photodetector (PD) comprising Ag/ZnO nanowires (NWs)/ZnSe/In, fabricated on a commercially available Si substrate. ZnO NWs were hydrothermally synthesized on thermally evaporated ZnSe thin films, with scanning electron microscopy (SEM) analysis revealing uniform, vertically aligned ZnO NWs on the ZnSe layer. Cross-sectional SEM imaging determined the thickness of the In/ZnSe thin film to be approximately 460 nm, with ZnO NWs exhibiting an average diameter of ∼161 nm. Structural analysis of the ZnSe thin film, annealed at 370 °C in an ambient environment, identified a prominent ZnSe peak at 27.48° alongside peaks at 30.98° and 33.21° corresponding to In2O3 and ZnSeO3, respectively. The ZnO NWs, under similar annealing conditions, displayed a strong (002) peak, confirming vertical growth. Hall effect measurements revealed a transition from p-type carriers in as-deposited ZnSe thin films to n-type in the annealed ZnSe and ZnO NWs, attributed to the formation of In2O3 as evidenced by XRD. The PD exhibited the highest photoresponse under IR illumination (950 nm), surpassing responses to green (515 nm) and blue (456 nm) LEDs, with a short-circuit current (I sc) of −26 μA and an open-circuit voltage (V oc) of +80 mV, characteristic of a self-powered device. In contrast, minimal photoresponse was observed in a Schottky-type Ag/ZnSe/In junction on the Si substrate. The photoresponse mechanism was elucidated using an energy band diagram, while density functional theory simulations using Vienna ab initio simulation package provided a strong correlation with the experimental data, validating the structural and electronic properties of the heterojunction.
- 13 January 2025
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 58 (10) , 105111
High-performance, self-powered ZnO NWs-ZnSe heterojunction photodetectors for superior visible and near-infrared detection
We present the development of a type-II heterojunction photodetector (PD) comprising Ag/ZnO nanowires (NWs)/ZnSe/In, fabricated on a commercially available Si substrate. ZnO NWs were hydrothermally synthesized on thermally evaporated ZnSe thin films, with scanning electron microscopy (SEM) analysis revealing uniform, vertically aligned ZnO NWs on the ZnSe layer. Cross-sectional SEM imaging determined the thickness of the In/ZnSe thin film to be approximately 460 nm, with ZnO NWs exhibiting an average diameter of ∼161 nm. Structural analysis of the ZnSe thin film, annealed at 370 °C in an ambient environment, identified a prominent ZnSe peak at 27.48° alongside peaks at 30.98° and 33.21° corresponding to In2O3 and ZnSeO3, respectively. The ZnO NWs, under similar annealing conditions, displayed a strong (002) peak, confirming vertical growth. Hall effect measurements revealed a transition from p-type carriers in as-deposited ZnSe thin films to n-type in the annealed ZnSe and ZnO NWs, attributed to the formation of In2O3 as evidenced by XRD. The PD exhibited the highest photoresponse under IR illumination (950 nm), surpassing responses to green (515 nm) and blue (456 nm) LEDs, with a short-circuit current (I sc) of −26 μA and an open-circuit voltage (V oc) of +80 mV, characteristic of a self-powered device. In contrast, minimal photoresponse was observed in a Schottky-type Ag/ZnSe/In junction on the Si substrate. The photoresponse mechanism was elucidated using an energy band diagram, while density functional theory simulations using Vienna ab initio simulation package provided a strong correlation with the experimental data, validating the structural and electronic properties of the heterojunction.
- 27 April 2021
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 53 (5) , 1-16
Si-based photodiode and material characterization of TiO2 thin film
- 27 April 2021
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 53 (5) , 1-16
Si-based photodiode and material characterization of TiO2 thin film
- 1 December 2019
- Published by Elsevier in Journal of Molecular Structure
- Vol. 1198
Electrical and optical properties of photodiode structures formed by surface polymerization of P(Egdma-Vpca)-Swcnt films on n-si
- 1 December 2019
- Published by Elsevier in Journal of Molecular Structure
- Vol. 1198
Electrical and optical properties of photodiode structures formed by surface polymerization of P(Egdma-Vpca)-Swcnt films on n-si
- Open Access
- 27 May 2019
- Published by Uludag University Journal of the Faculty of Engineering in Uludağ University Journal of The Faculty of Engineering
- Vol. 24 (1) , 265-276
ZnSe/Si HETEROEKLEM YAPININ FOTOELEKTRİK ÖZELLİKLERİNİN İNCELENMESİ
ZnSe/Si Hetero eklem yapı, n-tipi silisyum (Si) alttaş üzerine çinko selenit (ZnSe) ince filmin termal buharlaştırma tekniği kullanılarak kaplanmasıyla üretilmiştir. Üretilen filmin yapısal, elektriksel ve optik özellikleri, x-ışınları kırınımı (XRD), taramalı elektron mikroskobu (SEM) ve UV-vis spektrofotometre yardımıyla incelenmiştir. XRD ve SEM analizleri ZnSe ince filmin Si alttaş üzerini kaplayacak şekilde ve poli kristal yapıda olduğunu göstermektedir. ZnSe ince filmin yüzeyi üzerinde 5 farklı bölgede gerçekleştirilen EDX analizine göre yapının %51 Zn ve %49 Se elemental bileşim dağılımına sahip olduğu sonucuna varılmıştır. ZnSe ince film kalınlığı 200 nm olarak ölçüldü. Yasak enerji bant aralığı yaklaşıkça 2,86 eV olarak hesaplandı. Üretilen yapının elektriksel parametreleri hem standart yöntem hem de Cheung-Cheung yöntemiyle elde edildi. Bariyer yüksekliği 0,74 eV, idealite faktörü 1,26 ve seri direnç 5,1 kΩ olarak belirlendi. Ayrıca, hetero eklem yapının dalga boyuna bağlı foto tepki ölçümleri gerçekleştirildi.
- 27 May 2019
- Published by Uludag University Journal of the Faculty of Engineering in Uludağ University Journal of The Faculty of Engineering
- Vol. 24 (1) , 265-276
Open AccessZnSe/Si HETEROEKLEM YAPININ FOTOELEKTRİK ÖZELLİKLERİNİN İNCELENMESİ
ZnSe/Si Hetero eklem yapı, n-tipi silisyum (Si) alttaş üzerine çinko selenit (ZnSe) ince filmin termal buharlaştırma tekniği kullanılarak kaplanmasıyla üretilmiştir. Üretilen filmin yapısal, elektriksel ve optik özellikleri, x-ışınları kırınımı (XRD), taramalı elektron mikroskobu (SEM) ve UV-vis spektrofotometre yardımıyla incelenmiştir. XRD ve SEM analizleri ZnSe ince filmin Si alttaş üzerini kaplayacak şekilde ve poli kristal yapıda olduğunu göstermektedir. ZnSe ince filmin yüzeyi üzerinde 5 farklı bölgede gerçekleştirilen EDX analizine göre yapının %51 Zn ve %49 Se elemental bileşim dağılımına sahip olduğu sonucuna varılmıştır. ZnSe ince film kalınlığı 200 nm olarak ölçüldü. Yasak enerji bant aralığı yaklaşıkça 2,86 eV olarak hesaplandı. Üretilen yapının elektriksel parametreleri hem standart yöntem hem de Cheung-Cheung yöntemiyle elde edildi. Bariyer yüksekliği 0,74 eV, idealite faktörü 1,26 ve seri direnç 5,1 kΩ olarak belirlendi. Ayrıca, hetero eklem yapının dalga boyuna bağlı foto tepki ölçümleri gerçekleştirildi.
- 20 September 2018
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 50 (10) , 362
Determination of electrical parameters of ZnO/Si heterojunction device fabricated by RF magnetron sputtering
- 20 September 2018
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 50 (10) , 362
Determination of electrical parameters of ZnO/Si heterojunction device fabricated by RF magnetron sputtering
- 1 August 2018
- Published by Elsevier in Superlattices and Microstructures
- Vol. 120, 402-409
Photoelectrical properties of fabricated ZnS/Si heterojunction device using thermionic vacuum arc method
- 1 August 2018
- Published by Elsevier in Superlattices and Microstructures
- Vol. 120, 402-409
Photoelectrical properties of fabricated ZnS/Si heterojunction device using thermionic vacuum arc method
- 1 November 2017
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 724, 543-548
The characteristics of ZnS/Si heterojunction diode fabricated by thermionic vacuum arc
- 1 November 2017
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 724, 543-548
The characteristics of ZnS/Si heterojunction diode fabricated by thermionic vacuum arc