George Tsiambaos
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
George Tsiambaos has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
H. Saroglou
7 shared publicationsN. Sabatakakis
Patras University
7 shared publications- Pavlos Asteriou
Department of Civil Engineering, Democritus University of Thrace, 67100 Xanthi, Greece
7 shared publications G. Koukis
3 shared publications- Charalampos Saroglou
National Technical University of Athens
2 shared publications - Dimitrios Zekkos
Department of Civil and Environmental Engineering University of California at Berkeley Berkeley CA USA
2 shared publications
Latest Publications
- 1 June 2018
- Published by Elsevier in International Journal of Rock Mechanics and Mining Sciences
- Vol. 106, 41-50
Effect of impact velocity, block mass and hardness on the coefficients of restitution for rockfall analysis
- 1 June 2018
- Published by Elsevier in International Journal of Rock Mechanics and Mining Sciences
- Vol. 106, 41-50
Effect of impact velocity, block mass and hardness on the coefficients of restitution for rockfall analysis
- Open Access
- 22 January 2018
- Published by Copernicus GmbH in Natural Hazards and Earth System Sciences
- Vol. 18 (1) , 321-333
UAV-based mapping, back analysis and trajectory modeling of a coseismic rockfall in Lefkada island, Greece
We present field evidence and a kinematic study of a rock block mobilized in the Ponti area by a M w = 6.5 earthquake near the island of Lefkada on 17 November 2015. A detailed survey was conducted using an unmanned aerial vehicle (UAV) with an ultrahigh definition (UHD) camera, which produced a high-resolution orthophoto and a digital terrain model (DTM). The sequence of impact marks from the rock trajectory on the ground surface was identified from the orthophoto and field verified. Earthquake characteristics were used to estimate the acceleration of the rock slope and the initial condition of the detached block. Using the impact points from the measured rockfall trajectory, an analytical reconstruction of the trajectory was undertaken, which led to insights on the coefficients of restitution (CORs). The measured trajectory was compared with modeled rockfall trajectories using recommended parameters. However, the actual trajectory could not be accurately predicted, revealing limitations of existing rockfall analysis software used in engineering practice.
- 22 January 2018
- Published by Copernicus GmbH in Natural Hazards and Earth System Sciences
- Vol. 18 (1) , 321-333
Open AccessUAV-based mapping, back analysis and trajectory modeling of a coseismic rockfall in Lefkada island, Greece
We present field evidence and a kinematic study of a rock block mobilized in the Ponti area by a M w = 6.5 earthquake near the island of Lefkada on 17 November 2015. A detailed survey was conducted using an unmanned aerial vehicle (UAV) with an ultrahigh definition (UHD) camera, which produced a high-resolution orthophoto and a digital terrain model (DTM). The sequence of impact marks from the rock trajectory on the ground surface was identified from the orthophoto and field verified. Earthquake characteristics were used to estimate the acceleration of the rock slope and the initial condition of the detached block. Using the impact points from the measured rockfall trajectory, an analytical reconstruction of the trajectory was undertaken, which led to insights on the coefficients of restitution (CORs). The measured trajectory was compared with modeled rockfall trajectories using recommended parameters. However, the actual trajectory could not be accurately predicted, revealing limitations of existing rockfall analysis software used in engineering practice.
- 11 May 2017
- Published by Springer Nature in Bulletin of Engineering Geology and the Environment
- Vol. 77 (4) , 1673-1688
The effect of microstructure on mi strength parameter variation of common rock types
- 11 May 2017
- Published by Springer Nature in Bulletin of Engineering Geology and the Environment
- Vol. 77 (4) , 1673-1688
The effect of microstructure on mi strength parameter variation of common rock types
- Open Access
- 16 February 2017
- Published by Copernicus GmbH in EGUsphere
- Vol. 2017, 1-30
UAV-enabled reconnaissance and trajectory modeling of a co-seismic rockfall in Lefkada
The paper presents the field evidence and the kinematical study of the motion of a rock block mobilised by an earthquake-induced rockfall in Ponti area in the island of Lefkada during a Mw 6.5 earthquake on 17th November 2015. A detailed field survey was deployed using an Unmanned Aerial Vehicle (UAV) with an ultra-high definition (UHD) camera, which produced a high-resolution orthophoto and a Digital Surface Model (DSM) of the terrain. The sequence of impact marks from the rock trajectory on the ground surface was identified using the orthophoto and verified through a detailed field survey. Additionally, the earthquake characteristics were determined in order to define the acceleration on the rock slope and the initial conditions of the detached block. Using the impact points from the actual rockfall trajectory, an analytical approach to reconstruct the trajectory was implemented, which led to some insights on the coefficients of restitution. In order to match the actual trajectory, 2D and 3D rockfall analyses were performed using the recommended set of parameters. However, the actual trajectory could not be accurately predicted, revealing limitations of existing models.
- 16 February 2017
- Published by Copernicus GmbH in EGUsphere
- Vol. 2017, 1-30
Open AccessUAV-enabled reconnaissance and trajectory modeling of a co-seismic rockfall in Lefkada
The paper presents the field evidence and the kinematical study of the motion of a rock block mobilised by an earthquake-induced rockfall in Ponti area in the island of Lefkada during a Mw 6.5 earthquake on 17th November 2015. A detailed field survey was deployed using an Unmanned Aerial Vehicle (UAV) with an ultra-high definition (UHD) camera, which produced a high-resolution orthophoto and a Digital Surface Model (DSM) of the terrain. The sequence of impact marks from the rock trajectory on the ground surface was identified using the orthophoto and verified through a detailed field survey. Additionally, the earthquake characteristics were determined in order to define the acceleration on the rock slope and the initial conditions of the detached block. Using the impact points from the actual rockfall trajectory, an analytical approach to reconstruct the trajectory was implemented, which led to some insights on the coefficients of restitution. In order to match the actual trajectory, 2D and 3D rockfall analyses were performed using the recommended set of parameters. However, the actual trajectory could not be accurately predicted, revealing limitations of existing models.
- Open Access
- 19 January 2017
- Published by National Documentation Centre (EKT) in Bulletin of the Geological Society of Greece
- Vol. 43 (1) , 183-195
ENGINEERING GEOLOGICAL BEHAVIOUR OF HETEROGENEOUS AND CHAOTIC ROCK MASSES
The engineering characterization of heterogeneous and complex geological formations for estimating their rock mass strength and deformability characteristics constitutes a challenge to geo-scientists and engineers dealing with the design and construction of slopes and tunnels. Mélanges and similar heterogeneous mixtures of hard blocks in weaker matrix, known as “bimrocks”, present an overall strength significantly greater than the matrix strength, because the presence of rock blocks, above a threshold volumetric proportion, influences the mechanical characteristics and the behaviour of these rock masses. Moreover, recent studies have shown that the strength and mechanical behaviour of heterogeneous and composite rock masses such as flysch and molasses consisting of alternating layers of competent and incompetent rocks are governed by the presence and volumetric percentage of the interlayers of the weaker rocks.
- 19 January 2017
- Published by National Documentation Centre (EKT) in Bulletin of the Geological Society of Greece
- Vol. 43 (1) , 183-195
Open AccessENGINEERING GEOLOGICAL BEHAVIOUR OF HETEROGENEOUS AND CHAOTIC ROCK MASSES
The engineering characterization of heterogeneous and complex geological formations for estimating their rock mass strength and deformability characteristics constitutes a challenge to geo-scientists and engineers dealing with the design and construction of slopes and tunnels. Mélanges and similar heterogeneous mixtures of hard blocks in weaker matrix, known as “bimrocks”, present an overall strength significantly greater than the matrix strength, because the presence of rock blocks, above a threshold volumetric proportion, influences the mechanical characteristics and the behaviour of these rock masses. Moreover, recent studies have shown that the strength and mechanical behaviour of heterogeneous and composite rock masses such as flysch and molasses consisting of alternating layers of competent and incompetent rocks are governed by the presence and volumetric percentage of the interlayers of the weaker rocks.
- Open Access
- 1 January 2017
- Published by Elsevier in Procedia Engineering
- Vol. 191, 1108-1116
Study of Cracking Process in Granite
- 1 January 2017
- Published by Elsevier in Procedia Engineering
- Vol. 191, 1108-1116
Open AccessStudy of Cracking Process in Granite
- 26 July 2015
- Published by Springer Nature in Rock Mechanics and Rock Engineering
- Vol. 49 (3) , 927-941
Empirical Model for Predicting Rockfall Trajectory Direction
- 26 July 2015
- Published by Springer Nature in Rock Mechanics and Rock Engineering
- Vol. 49 (3) , 927-941
Empirical Model for Predicting Rockfall Trajectory Direction
- 4 January 2015
- Published by Springer Nature
- p. 1899-1903
Effect of Forest Presence on Rockfall Trajectory. An Example from Greece
- 4 January 2015
- Published by Springer Nature
- p. 1899-1903
Effect of Forest Presence on Rockfall Trajectory. An Example from Greece
- 4 January 2015
- Published by Springer Nature
- p. 2041-2044
Rockfalls: Effect of Slope Surface Weathering on the Coefficients of Restitution
- 4 January 2015
- Published by Springer Nature
- p. 2041-2044
Rockfalls: Effect of Slope Surface Weathering on the Coefficients of Restitution
- 12 August 2014
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9229, 92290C
Subsurface geological modeling using GIS and remote sensing data: a case study from Platanos landslide, Western Greece
Landslide phenomena constitute a major geological hazard in Greece and especially in the western part of the country as a result of anthropogenic activities, growing urbanization and uncontrolled land – use. More frequent triggering events and increased susceptibility of the ground surface to instabilities as consequence of climate change impacts (continued deforestation mainly due to the devastating forest wildfires and extreme meteorological events) have also increased the landslide risk. The studied landslide occurrence named “Platanos” has been selected within the framework of “Landslide Vulnerability Model – LAVMO” project that aims at creating a persistently updated electronic platform assessing risks related with landslides. It is a coastal area situated between Korinthos and Patras at the northwestern part of the elongated graben of the Corinth Gulf. The paper presents the combined use of geological-geotechnical insitu data, remote sensing data and GIS techniques for the evaluation of a subsurface geological model. High accuracy Digital Surface Model (DSM), airphotos mosaic and satellite data, with a spatial resolution of 0.5m were used for an othophoto base map compilation of the study area. Geological – geotechnical data obtained from exploratory boreholes were digitized and implemented in a GIS platform with engineering geological maps for a three – dimensional subsurface model evaluation. This model is provided for being combined with inclinometer measurements for sliding surface location through the instability zone.
- 12 August 2014
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9229, 92290C
Subsurface geological modeling using GIS and remote sensing data: a case study from Platanos landslide, Western Greece
Landslide phenomena constitute a major geological hazard in Greece and especially in the western part of the country as a result of anthropogenic activities, growing urbanization and uncontrolled land – use. More frequent triggering events and increased susceptibility of the ground surface to instabilities as consequence of climate change impacts (continued deforestation mainly due to the devastating forest wildfires and extreme meteorological events) have also increased the landslide risk. The studied landslide occurrence named “Platanos” has been selected within the framework of “Landslide Vulnerability Model – LAVMO” project that aims at creating a persistently updated electronic platform assessing risks related with landslides. It is a coastal area situated between Korinthos and Patras at the northwestern part of the elongated graben of the Corinth Gulf. The paper presents the combined use of geological-geotechnical insitu data, remote sensing data and GIS techniques for the evaluation of a subsurface geological model. High accuracy Digital Surface Model (DSM), airphotos mosaic and satellite data, with a spatial resolution of 0.5m were used for an othophoto base map compilation of the study area. Geological – geotechnical data obtained from exploratory boreholes were digitized and implemented in a GIS platform with engineering geological maps for a three – dimensional subsurface model evaluation. This model is provided for being combined with inclinometer measurements for sliding surface location through the instability zone.