Konstantinos Georgiadis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Konstantinos Georgiadis has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
L Zdravkovic
4 shared publications- Andrei V. Lyamin
University of Newcastle
3 shared publications D Potts
3 shared publications- Scott William Sloan
Laureate Professor, ARC Centre of Excellence for Geotechnical Science and Engineering, Faculty of Engineering and Built Environment, Univ. of Newcastle, Callaghan, NSW 2308, Australia
3 shared publications M. Georgiadis
2 shared publications- Anastasios Anastasiadis
Aristotle University of Thessaloniki
1 shared publication
Latest Publications
- Open Access
- 17 November 2026
- Published by Springer Nature
- p. 435-444
ERIES-HELIQUAKE: Dynamic soil structure interaction effects in helical steel pile foundations
- 17 November 2026
- Published by Springer Nature
- p. 435-444
Open AccessERIES-HELIQUAKE: Dynamic soil structure interaction effects in helical steel pile foundations
- 1 August 2020
- Published by Emerald Publishing in Géotechnique
- Vol. 70 (8) , 700-710
Effect of torsion on the undrained limiting lateral resistance of piles in clay
The behaviour of piles subjected to lateral loads has been explored by a number of investigators over the past five decades. However, the vast majority of the previous literature has ignored the potential influence of additional torsional effects due to horizontal eccentricities of the applied lateral loads. In this paper, an upper bound mechanism and a lower bound stress field are presented for the calculation of the ultimate combined torsional and lateral loads on single piles in clay. The corresponding analytical upper and lower bound plasticity solutions are shown to be in excellent agreement, bracketing the theoretically exact failure loads with an error of less than 0·5%. Two-dimensional finite-element analyses are also presented and the computed ultimate loads and observed failure mechanisms are shown to compare very well with the plasticity solutions. Based on the numerical results and analytical solutions, failure load interaction diagrams and a simple empirical equation are presented that allow the calculation of the lateral bearing capacity factor for any level of applied torsion and pile–soil adhesion factor. It is demonstrated that the effect of torsion can be very significant, causing reduction in lateral bearing capacity of up to 50% and therefore should be considered in design.
- 1 August 2020
- Published by Emerald Publishing in Géotechnique
- Vol. 70 (8) , 700-710
Effect of torsion on the undrained limiting lateral resistance of piles in clay
The behaviour of piles subjected to lateral loads has been explored by a number of investigators over the past five decades. However, the vast majority of the previous literature has ignored the potential influence of additional torsional effects due to horizontal eccentricities of the applied lateral loads. In this paper, an upper bound mechanism and a lower bound stress field are presented for the calculation of the ultimate combined torsional and lateral loads on single piles in clay. The corresponding analytical upper and lower bound plasticity solutions are shown to be in excellent agreement, bracketing the theoretically exact failure loads with an error of less than 0·5%. Two-dimensional finite-element analyses are also presented and the computed ultimate loads and observed failure mechanisms are shown to compare very well with the plasticity solutions. Based on the numerical results and analytical solutions, failure load interaction diagrams and a simple empirical equation are presented that allow the calculation of the lateral bearing capacity factor for any level of applied torsion and pile–soil adhesion factor. It is demonstrated that the effect of torsion can be very significant, causing reduction in lateral bearing capacity of up to 50% and therefore should be considered in design.
- 1 March 2020
- Published by Elsevier in Renewable Energy
- Vol. 147, 2599-2617
Heating and cooling induced stresses and displacements in heat exchanger piles in sand
- 1 March 2020
- Published by Elsevier in Renewable Energy
- Vol. 147, 2599-2617
Heating and cooling induced stresses and displacements in heat exchanger piles in sand
- 1 December 2018
- Published by Emerald Publishing in Géotechnique
- Vol. 68 (12) , 1071-1084
Lateral soil resistance on soldier piles or king posts in clay
The undrained ultimate lateral soil resistance pu on soldier piles (king posts) is investigated using three-dimensional finite-element analysis. Ultimate lateral resistance variations with depth are determined for different pile spacings, pile–soil adhesion factors and retained soil heights. Based on the numerical results, simple design equations are developed, which give the variation of the lateral bearing capacity factor Np with depth for soldier piles of different spacings and retained soil heights. The proposed equations are used in limit equilibrium calculations to determine the required pile length plotted against retained soil height curves for two typical soldier pile wall examples, a cantilever and a single-propped wall, examining different pile spacings, pile–soil adhesion factors and undrained soil shear strengths. These curves are compared to those produced using the six most commonly used methods, including two-dimensional finite-element analysis. Three-dimensional finite-element analysis results of the typical soldier pile wall examples are also presented in order to verify the proposed method.
- 1 December 2018
- Published by Emerald Publishing in Géotechnique
- Vol. 68 (12) , 1071-1084
Lateral soil resistance on soldier piles or king posts in clay
The undrained ultimate lateral soil resistance pu on soldier piles (king posts) is investigated using three-dimensional finite-element analysis. Ultimate lateral resistance variations with depth are determined for different pile spacings, pile–soil adhesion factors and retained soil heights. Based on the numerical results, simple design equations are developed, which give the variation of the lateral bearing capacity factor Np with depth for soldier piles of different spacings and retained soil heights. The proposed equations are used in limit equilibrium calculations to determine the required pile length plotted against retained soil height curves for two typical soldier pile wall examples, a cantilever and a single-propped wall, examining different pile spacings, pile–soil adhesion factors and undrained soil shear strengths. These curves are compared to those produced using the six most commonly used methods, including two-dimensional finite-element analysis. Three-dimensional finite-element analysis results of the typical soldier pile wall examples are also presented in order to verify the proposed method.
- 1 August 2018
- Published by Elsevier in Computers and Geotechnics
- Vol. 100, 110-120
Design procedure for the modelling of jet-grout column slabs supporting deep excavations
- 1 August 2018
- Published by Elsevier in Computers and Geotechnics
- Vol. 100, 110-120
Design procedure for the modelling of jet-grout column slabs supporting deep excavations
- 1 July 2016
- Published by Elsevier in Engineering Structures
- Vol. 118, 41-54
Lower bound limit analysis of 2D steel frames with foundation–structure interaction
- 1 July 2016
- Published by Elsevier in Engineering Structures
- Vol. 118, 41-54
Lower bound limit analysis of 2D steel frames with foundation–structure interaction
- 2 March 2015
- Published by Wiley in geotechnik
- Vol. 38 (1) , 17-27
Undrained bearing capacity of tripod skirted foundations under eccentric loading
The undrained bearing capacity of a group of three rigidly connected skirted foundations (tripod) under vertical, moment or combined vertical‐moment loading is investigated. Three‐dimensional displacement finite element analyses of a single footing are first presented in order to validate the numerical modelling procedure. Various loading paths are considered and comparisons with known solutions are made. Subsequently, a series of analyses of undrained loading on a three‐footing group is presented. Different footing spacings and loading directions are considered. The predominant failure mechanisms for characteristic load combinations are determined and the calculated failure loads are presented in dimensionless and normalized form. Based on the numerical results, a unique normalized failure load surface is proposed which applies to all loading directions and footing spacings for a given skirt length to footing diameter ratio.Undränierte Grenztragfähigkeit von Tripod‐Gründungen mit Schürze unter außermittiger Belastung. Die undränierte Grenztragfähigkeit einer Gruppe von drei starr miteinander verbundenen Gründungselementen (Tripods) unter Vertikallast, Momentenbelastung oder unter einer kombinierten Vertikal‐ und Momentenbelastung wird untersucht. Zunächst werden dreidimensionale Finite‐Elemente‐Berechnungen von einem einzelnen Gründungskörper präsentiert, um die numerische Modellierung zu validieren. Unterschiedliche Belastungspfade werden untersucht und mit bekannten Lösungen verglichen. Anschließend wird eine Reihe von undränierten Analysen mit allen drei Gründungskörpern eines Tripods vorgestellt. Variiert werden die Fundamentabstände und die Lastrichtung. Die vorherrschenden Versagensmechanismen werden für charakteristische Lastkombinationen bestimmt und die berechneten Grenztraglasten in dimensionsloser und normierter Form dargestellt. Basierend auf den numerischen Ergebnissen wird eine einzige normierte Grenzzustandskurve vorgeschlagen, welche auf alle Lastrichtungen und Fundamentabstände für ein gegebenes Verhältnis von Schürzenlänge zu Durchmesser der Gründungskörper anwendbar ist.
- 2 March 2015
- Published by Wiley in geotechnik
- Vol. 38 (1) , 17-27
Undrained bearing capacity of tripod skirted foundations under eccentric loading
The undrained bearing capacity of a group of three rigidly connected skirted foundations (tripod) under vertical, moment or combined vertical‐moment loading is investigated. Three‐dimensional displacement finite element analyses of a single footing are first presented in order to validate the numerical modelling procedure. Various loading paths are considered and comparisons with known solutions are made. Subsequently, a series of analyses of undrained loading on a three‐footing group is presented. Different footing spacings and loading directions are considered. The predominant failure mechanisms for characteristic load combinations are determined and the calculated failure loads are presented in dimensionless and normalized form. Based on the numerical results, a unique normalized failure load surface is proposed which applies to all loading directions and footing spacings for a given skirt length to footing diameter ratio.Undränierte Grenztragfähigkeit von Tripod‐Gründungen mit Schürze unter außermittiger Belastung. Die undränierte Grenztragfähigkeit einer Gruppe von drei starr miteinander verbundenen Gründungselementen (Tripods) unter Vertikallast, Momentenbelastung oder unter einer kombinierten Vertikal‐ und Momentenbelastung wird untersucht. Zunächst werden dreidimensionale Finite‐Elemente‐Berechnungen von einem einzelnen Gründungskörper präsentiert, um die numerische Modellierung zu validieren. Unterschiedliche Belastungspfade werden untersucht und mit bekannten Lösungen verglichen. Anschließend wird eine Reihe von undränierten Analysen mit allen drei Gründungskörpern eines Tripods vorgestellt. Variiert werden die Fundamentabstände und die Lastrichtung. Die vorherrschenden Versagensmechanismen werden für charakteristische Lastkombinationen bestimmt und die berechneten Grenztraglasten in dimensionsloser und normierter Form dargestellt. Basierend auf den numerischen Ergebnissen wird eine einzige normierte Grenzzustandskurve vorgeschlagen, welche auf alle Lastrichtungen und Fundamentabstände für ein gegebenes Verhältnis von Schürzenlänge zu Durchmesser der Gründungskörper anwendbar ist.
- 1 October 2014
- Published by Elsevier in Computers and Geotechnics
- Vol. 62, 164-174
Variation of limiting lateral soil pressure with depth for pile rows in clay
- 1 October 2014
- Published by Elsevier in Computers and Geotechnics
- Vol. 62, 164-174
Variation of limiting lateral soil pressure with depth for pile rows in clay
- 1 October 2013
- Published by Emerald Publishing in Géotechnique
- Vol. 63 (13) , 1170-1175
Effect of loading direction on the ultimate lateral soil pressure of two piles in clay
Design equations are presented for the calculation of the ultimate lateral resistance of two-pile groups in clay under a general loading direction. Analytical upper bound solutions, numerical upper and lower bound limit analyses and displacement finite-element analyses are first presented for the case of two piles loaded parallel to the pile-to-pile axis. Displacement finite-element analyses are subsequently used to calculate the ultimate lateral resistance for different directions of pile displacement. The design equations that are proposed, based on the numerical study, take account of the effect of the pile spacing, the pile–soil adhesion and the displacement or the loading direction on the ultimate lateral resistance.
- 1 October 2013
- Published by Emerald Publishing in Géotechnique
- Vol. 63 (13) , 1170-1175
Effect of loading direction on the ultimate lateral soil pressure of two piles in clay
Design equations are presented for the calculation of the ultimate lateral resistance of two-pile groups in clay under a general loading direction. Analytical upper bound solutions, numerical upper and lower bound limit analyses and displacement finite-element analyses are first presented for the case of two piles loaded parallel to the pile-to-pile axis. Displacement finite-element analyses are subsequently used to calculate the ultimate lateral resistance for different directions of pile displacement. The design equations that are proposed, based on the numerical study, take account of the effect of the pile spacing, the pile–soil adhesion and the displacement or the loading direction on the ultimate lateral resistance.
- 1 October 2013
- Published by Elsevier in Computers and Geotechnics
- Vol. 54, 175-184
Undrained limiting lateral soil pressure on a row of piles
- 1 October 2013
- Published by Elsevier in Computers and Geotechnics
- Vol. 54, 175-184
Undrained limiting lateral soil pressure on a row of piles