MWMarcus Thomas Wilson

Marcus Thomas Wilson

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Marcus Thomas Wilson has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effect of Pauses in Cycling on Millihertz Battery Impedance

    by Marcus T. Wilson, Logan I. Cowie, Michael J. Cree

    Li-ion batteries show history-dependent behavior; their voltage response to a current stimulus depends upon the history of current. Such non-local time responses can be described with fractional calculus and circuit elements. We demonstrate that existing results show time-scale-free rather than exponential behavior, consistent with fractional circuit elements. We have measured impedance of a NCA (LiNixCoyAl1-x-yO2) battery following breaks in cycling. Change in impedance is consistent with a time-scale-free power law, as measured following both (i) 1-day and (ii) 56 day breaks in cycling. In our experiments, the impedance change decays slowly back to baseline, conforming approximately to a power law. However, an exponential relationship cannot be ruled-out. Small relative changes of around 2% are still evident up to 32 days after a 56 day break in cycling. The magnitude of the history-dependent change in impedance is smaller than that due to changes in stimulating waveform, and thus history-dependent effects may be masked in many practical applications. In conclusion, long-term effects of history can be exemplified by a careful choice of experiment, implying that measurements such as electrochemical impedance spectroscopy should be carried out after relaxation periods longer than previously used (greater than two days). However, in practical applications such as electric vehicles the effect may well be masked by the variability in applied waveforms and temperature fluctuations, and be of limited practical consequence.


  • Open Access

    Incremental Capacity and Voltammetry of Batteries, and Implications for Electrochemical Impedance Spectroscopy

    by Christopher Dunn, Jonathan Scott, Marcus Wilson, Michael Mucalo, Michael Cree

    Incremental capacity analysis (ICA), where incremental charge (Q) movements associated with changes in potential are tracked, and cyclic voltammetry (CV), where current response to a linear voltage sweep is recorded, are used to investigate the properties of electrochemical systems. Electrochemical impedance spectroscopy (EIS), on the other hand, is a powerful, non-destructive technique that can be used to determine small-signal AC impedance over a wide frequency range. It is frequently used to design battery equivalent-circuit models. This manuscript explores the relationships between ICA, CV and EIS and demonstrates how sweep rate in CV is related to charging (C) rate in ICA. In addition, it shows the connection between observations linked to rate of charge movement in CV and ICA and intermittent, irregular behavior seen in EIS when performed on a battery. It also explains the use of an additional DC stimulus during EIS to ensure reliability of battery impedance data and to facilitate equivalent-circuit modeling, and suggests a method for obtaining data analogous to CV from a whole battery without risking its destruction.


  • Dynamic Nonlinear Resistance Model for a Power MOSFET in an Oscillatory RLC Circuit

    by Soniya Raju, D. Alistair Steyn-Ross, Marcus Wilson, Nihal Kularatna

    This paper presents the development of a new Matlab mosfet model specifically designed for RLC circuits. The key contribution is the formulation of a novel equation that accurately captures the device behavior across subthreshold, above-threshold regions and at threshold point, addressing limitations in existing models. The developed model treats the mosfet as a variable resistance element, with the resistance changing dynamically at each instant, enabling the solution of differential equations governing the RLC circuit. Curve fitting and refinement were conducted based on experimental results, leading to a close match between the simulations and experimental data. The model was tested with triangle, sinusoidal and quadrilateral gate voltages, and the simulation results show good match with the experimental data, demonstrating the model’s accuracy. It provides a straightforward way to predict performance, making it easier to refine and optimize the design gate voltage before physical implementation. This work provides a solid foundation for mosfet modeling in oscillatory RLC circuits, which can be applied to a wide range of power electronics applications.


  • Open Access

    Early prediction of Li-ion cell failure from EIS derived from current–voltage time series

    by M T Wilson, V Farrow, C J Dunn, L Cowie, M J Cree, J Bjerkan, A Stefanovska, J B Scott

    The ability to reliably detect the forthcoming failure of a rechargeable cell without removing it from its normal operating environment remains a significant goal in battery research. In this work we have cycled in the laboratory a previously-aged 3.2 A h, 3.6 V 18650 INR LiNi x Mn y Co 1 − x − y O2 cell for 300 d until failure was apparent, using a current waveform representative of use in an electric vehicle application. Electrochemical impedance spectroscopy (EIS) down to 5 µHz was also performed on the cell as a ‘gold-standard’ measure, at the beginning, end and part way through the cycling. Analysis of voltage and current time series data using both parametric (equivalent circuit model) and non-parametric (wavelet-based analysis) approaches allowed us to successfully reconstruct the EIS data. As the battery aged, impedance gradually increased at frequencies between 10−4 Hz—10−1 Hz. The increase accelerated around 50 d before the battery ultimately failed. The acceleration in rate of change of impedance was detectable while the cycle efficiency remained high, indicating that a user of the cell would be unlikely to detect any change in the cell based on its performance or by common measures of state-of-health. The results imply upcoming failure may be detectable from time series analysis weeks before any noticeable drop in cell performance.


  • Open Access

    Supercapacitor-based pulse generator with waveform adjustment capability for small animal transcranial magnetic stimulation

    by Soniya Raju, Nihal Kularatna, Marcus Wilson, D Alistair Steyn-Ross

    In transcranial magnetic stimulation (TMS), pulsed magnetic fields are applied to the brain, typically requiring high-power stimulators with high voltages and low series impedance. TMS pulse generators for small animal coils, are underexplored, with limited dedicated circuits and simulation models. Here, we present a new design for a high-power TMS pulse generator for small animals, utilizing a pre-charged supercapacitor that is sufficient to produce repeated pulses for TMS applications without the need for recharging. This approach eliminates the need for expensive high-voltage components and a high-voltage power supply. In this paper, we detail the design approach and basic block diagrams of a supercapacitor (SC) based TMS pulse generator, along with its experimental results. The findings indicate that the new circuit enables a complete test using just a single charge of an SC module. The proposed circuit functions as a versatile pulse-shaping device, where the MOSFET is treated as a dynamically varying resistor element rather than a traditional switch; allowing pulse parameter variations. We analyze a novel circuit for generating and controlling TMS pulses in small animal coils, and demonstrate its effectiveness through experimental results.


  • Open Access

    Incremental Capacity and Voltammetry of Batteries, and Implications for Electrochemical Impedance Spectroscopy

    by Christopher J. Dunn, Jonathan B. Scott, Marcus T. Wilson, Michael R. Mucalo, Michael J. Cree

    Incremental capacity analysis (ICA), where incremental charge (Q) movements associated with changes in potential are tracked, and cyclic voltammetry (CV), where current response to a linear voltage sweep is recorded, are used to investigate the properties of electrochemical systems. Electrochemical impedance spectroscopy (EIS), on the other hand, is a powerful, non-destructive technique that can be used to determine small-signal AC impedance over a wide frequency range. It is frequently used to design battery equivalent-circuit models. This manuscript explores the relationships between ICA, CV and EIS and demonstrates how sweep rate in CV is related to charging (C) rate in ICA. In addition, it shows the connection between observations linked to rate of charge movement in CV and ICA and intermittent, irregular behavior seen in EIS when performed on a battery. It also explains the use of an additional DC stimulus during EIS to ensure reliability of battery impedance data and to facilitate equivalent-circuit modeling, and suggests a method for obtaining CV-type data from a whole battery without risking its destruction.

  • Open Access

    Passive, Fractional, Battery Equivalent-Circuit Model in Time and Frequency Domains Part 1: Linear Model

    by Vance Farrow, Jonathan Scott, Michael J. Cree, Marcus Wilson

    Existing time-domain fractional model simulations of batteries are either limited to short time sequences, frequently less than 100 s, if truly fractional or use low order RC-ladder fractional approximations to reduce computational burden. Here we present an entirely-passive, truly fractional, equivalent-circuit model of a battery. We rely on a Reimann-Louiville fractional order differintegral to account for long time-scales out to 12 days. An analytical solution is provided for the differintegral, subject to the constraint of piecewise constant current. We validate our model fitting against a multi-day sequence of measured time domain data and EIS measured to 10 μHz. The spectral content of the current waveform is identified as a crucial factor. The full evaluation of fractional elements leads to residual error of voltage waveforms that is amongst the best in the literature despite the model having only five parameters. In the time-domain, a root-mean-square error (RMSE) as low as 2.8mV is achieved while maintaining a frequency-domain RMSE of 14% from measured impedance values over a span of 6 decades. The use of time-weighted regression is shown to be important to the time-domain fit.


  • Open Access

    Rapid time-domain simulation of fractional capacitors with SPICE

    by Marcus Wilson, Logan Cowie, Vance Farrow, Michael Cree, Jonathan Scott

    Fractional capacitors, commonly called constant-phase elements or CPEs, are used in modeling and control applications, for example, for rechargeable batteries. Unfortunately, they are not natively supported in the well-used circuit simulator SPICE. This manuscript presents and demonstrates a modeling approach that allows users to incorporate these elements in circuits and model the response in the time domain. The novelty is that we implement for the first time a particular configuration of RC elements in parallel in a Foster-type network with SPICE in order to simulate a constant-phase element across a defined frequency range. We demonstrate that the circuit produces the required impedance spectrum in the frequency domain, and shows a power-law voltage response to a step change in current in the time domain, consistent with theory, and is able to reproduce the experimental voltage response to a complicated current profile in the time domain. The error depends on the chosen frequency limits and the number of RC branches, in addition to very small SPICE numerical errors. We are able to define an optimum circuit description that minimizes error while maintaining a short computation time. The scientific value is that the work permits rapid and accurate evaluation of the response of CPEs in the time domain, faster than other methods, using open source tools.


  • Open Access

    Efficiency of Cycled Batteries Analyzed Through Voltage-Current Phase Differences

    by Marcus T. Wilson, Christopher J. Dunn, Vance Farrow, Michael J. Cree, Jonathan B. Scott

    Ageing of rechargeable batteries is routinely characterized in the frequency domain by electrochemical impedance spectroscopy, but the technique requires laboratory measurements to be made on a time scale of days. However, the normal cycling of a battery as it is used in situ provides equivalent information in the time domain, though extracting robust frequency information from a time series is challenging. In this work, we explore, in the time domain, the relationship between instantaneous voltage-current phase difference and cycle efficiency. Moreover, we demonstrate that phase measures can be used to identify battery ageing. We have cycled a 250 mA h Nickel-Cobalt cell several hundred times and used Hilbert Transforms to identify phase difference between voltage and current. This phase difference becomes closer to zero as the battery ages, commensurate with a drop in energy cycle efficiency. In another experiment, we applied a synthetic current profile mimicking behaviour of an electric car cell, to a 3.2 A h LiNiMnCoO 2 cell, for ~100 days. For this more complicated profile with a wide range of frequency content, we used wavelet analysis to identify changes in phase difference and impedance as the battery aged. For this cell, drop in cycle efficiency was associated with a rise in internal resistance. The results imply that time-series analysis of in situ measurements of voltage and current, when applied with equivalent circuit models and underlying theory, can identify markers of battery ageing.