Saptarshi Mandal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Saptarshi Mandal has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Srabanti Chowdhury
Electrical and Computer Engineering Department, University of California at Davis, Davis, CA, USA
4 shared publicationsMatthew A. Laurent
Electrical and Computer Engineering Department, University of California at Davis, Davis, CA, USA
2 shared publicationsStacia Keller
Electrical and Computer Engineering Department, University of California at Santa Barbara, Santa Barbara, CA, USA
2 shared publications- Alec M. Fischer
Arizona State University 1 Department of Physics Tempe, Arizona 85287-1504, USA
1 shared publication Anchal Agarwal
Electrical and Computer Engineering Department, University of California at Santa Barbara, Santa Barbara, CA, USA
1 shared publication- Burcu Ercan
Bell Laboratories, Alcatel-Lucent, 791 Holmdel-Keyport Rd, Holmdel, NJ, 07733, USA
1 shared publication
Latest Publications
- 1 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 40 (6) , 885-888
A Demonstration of Nitrogen Polar Gallium Nitride Current Aperture Vertical Electron Transistor
We report the first demonstration of Nitrogen polar GaN current aperture vertical electron transistor with a blocking electric field over 2.9MV/cm. The devices were grown by metalorganic chemical vapor deposition on a cplane sapphire substrate. The fabrication involved a maskless planar regrowth of a very thin AlN layer above the current blocking layer which induced a two-dimensional electron gas in the channel, and also prevented the out-diffusion of activated Mg ions into the GaN channel layer. The alloyed source and drain ohmic contacts on the regrown n+-GaN layer offered low contact resistance of 0.18 mY.cm2 (0.22 Y.mm). The device displayed a maximum drain current of 1.68 kA/cm2, with a low RON,SP of 2.48 mY.cm2. With just about 200nm drift layer, a 3-terminal breakdown voltage of 58V was achieved. Output characteristics were free of dispersion under pulsed measurements with 80 ls and 500 ns pulse widths. Npolar current aperture vertical electron transistors show fundamentally significant advantages in favor of using Mg2+-implanted GaN as current blocking layers compared to Gapolar counterparts.
- 1 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 40 (6) , 885-888
A Demonstration of Nitrogen Polar Gallium Nitride Current Aperture Vertical Electron Transistor
We report the first demonstration of Nitrogen polar GaN current aperture vertical electron transistor with a blocking electric field over 2.9MV/cm. The devices were grown by metalorganic chemical vapor deposition on a cplane sapphire substrate. The fabrication involved a maskless planar regrowth of a very thin AlN layer above the current blocking layer which induced a two-dimensional electron gas in the channel, and also prevented the out-diffusion of activated Mg ions into the GaN channel layer. The alloyed source and drain ohmic contacts on the regrown n+-GaN layer offered low contact resistance of 0.18 mY.cm2 (0.22 Y.mm). The device displayed a maximum drain current of 1.68 kA/cm2, with a low RON,SP of 2.48 mY.cm2. With just about 200nm drift layer, a 3-terminal breakdown voltage of 58V was achieved. Output characteristics were free of dispersion under pulsed measurements with 80 ls and 500 ns pulse widths. Npolar current aperture vertical electron transistors show fundamentally significant advantages in favor of using Mg2+-implanted GaN as current blocking layers compared to Gapolar counterparts.
- 17 May 2018
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 33 (6) , 065013
Observation and discussion of avalanche electroluminescence in GaN p-n diodes offering a breakdown electric field of 3 MV cm −1
We report on the first observation of avalanche electroluminescence resulting from band-to-band recombination (BTBR) of electron hole pairs at the breakdown limit of Gallium Nitride p-n diodes grown homo-epitaxially on single crystalline GaN substrates. The diodes demonstrated a near ideal breakdown electric field of 3 MV cm −1 with electroluminescence (EL) demonstrating sharp peaks of emission energies near and at the band gap of GaN. The high critical electric field, near the material limit of GaN, was achieved by generating a smooth curved mesa edge with low plasma damage, using etch engineering without any use of field termination. The superior material quality was critical for such a near-ideal performance. An electric field of 3 MV cm −1 recorded at the breakdown resulted in impact ionization, confirmed by a positive temperature dependence of the breakdown voltage. The spectral data provided evidence of BTBR of electron hole pairs that were generated by avalanche carrier multiplication in the depletion region.
- 17 May 2018
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 33 (6) , 065013
Observation and discussion of avalanche electroluminescence in GaN p-n diodes offering a breakdown electric field of 3 MV cm −1
We report on the first observation of avalanche electroluminescence resulting from band-to-band recombination (BTBR) of electron hole pairs at the breakdown limit of Gallium Nitride p-n diodes grown homo-epitaxially on single crystalline GaN substrates. The diodes demonstrated a near ideal breakdown electric field of 3 MV cm −1 with electroluminescence (EL) demonstrating sharp peaks of emission energies near and at the band gap of GaN. The high critical electric field, near the material limit of GaN, was achieved by generating a smooth curved mesa edge with low plasma damage, using etch engineering without any use of field termination. The superior material quality was critical for such a near-ideal performance. An electric field of 3 MV cm −1 recorded at the breakdown resulted in impact ionization, confirmed by a positive temperature dependence of the breakdown voltage. The spectral data provided evidence of BTBR of electron hole pairs that were generated by avalanche carrier multiplication in the depletion region.
- 12 February 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 39 (4) , 552-555
Determination of Minority Carrier Lifetime of Holes in Diamond p-i-n Diodes Using Reverse Recovery Method
The extracted minority carrier lifetime in the n-layer of a diamond PIN diode on (111)- oriented diamond is presented here using the diode reverse recovery method. The storage time delay and the reverse current varied as a function of the ramp time for the applied signal. The storage time delay and reverse current was extracted for zero ramp time by considering a capacitive overshoot effect that can occur during the measurement. The minority carrier lifetime of holes was measured to be ~ 6ns. The results obtained were compared to PIN diodes on (100)- where the n-side is fully depleted. The storage time delay was found to be negligible in the (100)- case. Further, time resolved cathodoluminescence measurements support the lifetime results obtained from the reverse recovery method.
- 12 February 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 39 (4) , 552-555
Determination of Minority Carrier Lifetime of Holes in Diamond p-i-n Diodes Using Reverse Recovery Method
The extracted minority carrier lifetime in the n-layer of a diamond PIN diode on (111)- oriented diamond is presented here using the diode reverse recovery method. The storage time delay and the reverse current varied as a function of the ramp time for the applied signal. The storage time delay and reverse current was extracted for zero ramp time by considering a capacitive overshoot effect that can occur during the measurement. The minority carrier lifetime of holes was measured to be ~ 6ns. The results obtained were compared to PIN diodes on (100)- where the n-side is fully depleted. The storage time delay was found to be negligible in the (100)- case. Further, time resolved cathodoluminescence measurements support the lifetime results obtained from the reverse recovery method.
- 30 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 38 (7) , 933-936
Dispersion Free 450-V p GaN-Gated CAVETs With Mg-ion Implanted Blocking Layer
In this letter, a GaN-based current aperture vertical electron transistor (CAVET) with a p-type gate layer and an implantation-based current blocking structure is presented. The devices measured showed a breakdown voltage of 450 V and no dispersion. The factors limiting higher breakdown voltages in these devices were carefully studied and discussed. The devices were grown on sapphire and relied on a box-shaped Mg implanted current blocking scheme. This is the first demonstration of an implantation-based CAVET, grown on sapphire blocking of 450 V with respectable on-state characteristics.
- 30 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 38 (7) , 933-936
Dispersion Free 450-V p GaN-Gated CAVETs With Mg-ion Implanted Blocking Layer
In this letter, a GaN-based current aperture vertical electron transistor (CAVET) with a p-type gate layer and an implantation-based current blocking structure is presented. The devices measured showed a breakdown voltage of 450 V and no dispersion. The factors limiting higher breakdown voltages in these devices were carefully studied and discussed. The devices were grown on sapphire and relied on a box-shaped Mg implanted current blocking scheme. This is the first demonstration of an implantation-based CAVET, grown on sapphire blocking of 450 V with respectable on-state characteristics.