TCTat Sing Paul Chow

Tat Sing Paul Chow

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Tat Sing Paul Chow has a total of 74 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    An Improved Analytical Model for SiC P-I-N Diode Reverse Recovery

    by Giorgian Borca-Tasciuc, T. Paul Chow

    We generalize a recent Si P-i-N reverse-recovery (RR) model to more accurately capture 4H-SiC diode behavior by adding deep-acceptor-limited anode injection, strong recombination (due to >100x shorter optimized high-level lifetimes compared to Si), and improved modeling of the depletion layer dynamics. Closed-form expressions for the growth of the depletion layer are derived, enabling analytical estimates for Q RR , t RR , and J PR . The model is validated against Sentaurus RR simulations of optimized 4H-SiC P-i-N diodes spanning BV = 6–17kV and di/dt = 10 A/µs–10 kA/µs, achieving an average reduction in error of >90% for estimations of key switching performance parameters (Q RR , t RR , J PR ). By correctly capturing the dependence of Q RR on di/dt, the model enables better estimates for the high-level lifetime (τ HL ) directly from the RR waveforms. The differential form enables straightforward utilization of the model to analyze non-idealized RR waveforms. Overall, the generalized model reveals a more favorable Q RR –V F trade-off than implied by the unmodified Si model and improves first-order device optimization prior to full design.

  • Open Access

    Anomalous Reverse Recovery of Body Diode in 4H-SiC Superjunction DMOSFET

    by Giorgian Borca-Tasciuc, Reza Ghandi, Collin W. Hitchcock, Tat Sing Paul Chow

    We report an anomalous reverse-recovery (RR) of the body diode in a 3.3 kV 4H-SiC superjunction (SJ) DMOSFET: at 77 K, Q RR,sp increases by 1.4×–3.5× versus room temperature and 5× versus 195 K, and J PR increases by >2×, while t RR changes by only 77 K the switching for both devices is dominated by the depletion capacitance (weak Q RR,sp dependence on the ramp rate): the SJ device turns off faster (t RR = 0.3–0.8× CB), is snappier (t B /t A = 0.23–0.56× CB), and shows larger J PR (1.8–2.8× CB) while recovering less charge (Q RR,sp = 0.4–0.8× CB). The CB device shows the expected increase of Q RR,sp with temperature and only modest t RR temperature variation. Overall, the CB device provides softer, predictable RR without a cryogenic anomaly, whereas SJ delivers the shortest t RR above 77 K but exhibits the 77 K anomalous increase and is consistently snappier.

  • Open Access

    Demonstration of Integrated 3.3kV 4H-SiC Bidirectional Conventional DMOSFETs at Cryogenic Temperatures

    by Zhao Wen He, Giorgian Borca-Tasciuc, T. Paul Chow

    We have demonstrated an integrated 3.3 kV 4H-SiC vertical planar bidirectional (BD) conventional (Conv) power DMOSFET in common-drain (CD) configuration using two commercially available power DMOSFET dies and study its operation down to 77 K (-196 °C) to evaluate its cryogenic static and switching performance. The BD conduction and blocking are achieved down to 77 K. The measured specific on-resistance (R ON,sp ) of the BD MOSFET at room temperature (RT) is 26 mΩ-cm 2 , approximately twice that of the unidirectional device. It increases by 54% when cooled to 77 K due to a substantial increase in channel and possibly JFET on-resistance components. In addition, the extracted specific switching losses (E ON, sp and E OFF,sp ) increases by 33% (13%) at 195K (–77 °C) and by 83% (88%) at 77 K, relative to their RT values. These increases are primarily attributed to the substantial rise in R ON,sp at 77 K. As a result, the implemented BD Conv DMOSFET exhibits degradation in both on-state and switching performance under cryogenic operation, driven mainly by the significant increase in channel and JFET resistance components.

  • Open Access

    Single-Event-Burnout in 1.2kV 4H-SiC Lateral RESURF Power MOSFET

    by Zhao Wen He, Wei Ji, T. Paul Chow

    Extensive experiments and simulations indicate that Single-Event ion bombardment Effects (SEE) can trigger a Single-Event Burnout (SEB) in 4H-SiC vertical power devices at lower than half of the rated breakdown voltage. This paper investigates the SEB robustness of a 1.2kV 4H-SiC lateral RESURF MOSFET using a 3-D electrothermal device simulator (Sentaurus) with a reported heavy ion model based on high-fidelity radiation data. The maximum VSEB/BVrate ratio of 0.67 is 2.2 times higher than the reported VSEB/BVrate ratio of 0.3 for a 4H-SiC vertical DMOSFET with the same voltage rating. The reason is due to the reduced surface field at the drain terminal and the orthogonality of the heavy ion and impact ionization paths, resulting in less efficient excess carrier generation. This highlights the potential of lateral power devices for use in radiation-hardened environments.


  • Open Access

    Determination of the effective critical breakdown field for Si, wide, and extreme bandgap semiconductor superjunction devices

    by Mohamed Torky, T. Paul Chow

    Designing high voltage superjunction (SJ) power devices with wide bandgap and extreme bandgap semiconductors, when compared to silicon, can enhance the trade-off between RON,sp and BV significantly, due to their >10× higher avalanche breakdown electric field. Nevertheless, because of the difference in the breakdown field profile and ionization path length, the effective breakdown field for these semiconductor SJ devices has not been determined theoretically. Consequently, we estimate and compare the effective critical breakdown electric field for SJ device structures in Si, 4H–SiC, 2H–GaN, β-Ga2O3, diamond, and AlN using Technology Computer Aided Design TCAD simulation. We also establish its dependence on the SJ devices’ structural parameters, such as the pillar thickness. Furthermore, we also quantitatively compare the on-state performance of these SJ devices, including their thermal capabilities, using a paramount figure-of-merit to underscore the potential improvement possible.


  • Ion-Induced Mesoplasma Formation and Thermal Destruction in 4H-SiC Power MOSFET Devices

    by Joseph A. McPherson, Collin W. Hitchcock, T. Paul Chow, Wei Ji, Andrew A. Woodworth

    Both experiments and simulations have shown that single-event burnout (SEB), a catastrophic event, occurs at less than half of the rated blocking voltage in commercial 4H-SiC power devices under a heavy-ion strike. The failure was shown to be due to significant impact ionization near the epi/substrate interface. Adding a buffer layer between the drift epi and substrate layers reduces the impact ionization effect and changes the thermal failure location. In this article, the SEB phenomenon in a 4H-SiC power MOSFET utilizing a buffer layer is investigated. Heavy-ion transport and 3-D electro-thermal transient simulations were performed to study the device response to a heavy-ion strike. In examining the time evolution of electric field profile, charge carrier dynamics, and thermal heat transfer, it is determined that the failure mode for this design is the location shift of the mesoplasma (or hot spot) to within the drift epi region, away from the high field area. A sensitivity analysis was conducted to identify the dominant electrical or thermal factors contributing to device failure due to second breakdown. From these simulations, it is found that the semiconductor thermal conductivity is the primary material parameter that influences the mesoplasma formation.


  • Monolithically Integrated GaN LED/Quasi-Vertical Power U-Shaped Trench-Gate MOSFET Pairs Using Selective Epi Removal

    by Zhibo Guo, Mayank Bulsara, T. Paul Chow, Collin Hitchcock, Christian Wetzel, Robert F. Karlicek, Guanxi Piao, Yoshiki Yano, Shuuichi Koseki, Toshiya Tabuchi, et al.

    We report on the demonstration of monolithically integrated light-emitting diode (LED) and quasi-vertical U-shaped trench-gate metal-oxidesemiconductor field-effect transistor (UMOSFET) in GaN. Selective epi removal (SER) approach was used on an LED-on-FET epi stack on sapphire substrates. Individual p-GaN layers were used for LED and FET in our design. LED light modulation by the supply voltage and the FET gate voltage was realized, and an integrated 350μm × 350μm LED/UMOSFET pair exhibits a light output power (LOP) of 4.9 W/cm 2 or 6.0 mW. An integrated device with a UMOSFET driving a 3-LED chain was also demonstrated. The normally-off power UMOSFET has a threshold voltage of 7 V, a breakdown voltage of 208 V, and a specific on-resistance of 23 mΩ-cm 2 , in which hexagonal cells were applied to obtain identical m-plane MOS gate interfaces. The effect of FET sizing on integrated pairs was also studied, and a trade-off model of FET/LED power ratio vs. FET/LED area ratio was created, which serves as universal criterion for FET/LED integration. The tested device with the best trade-off has FET/LED area ratio of 24% and FET/LED power ratio of 56%. This work creates a new building block for future GaN light-emitting integrated circuits (LEICs).


  • Heavy Ion Transport Modeling for Single-Event Burnout in SiC-Based Power Devices

    by Joseph A. McPherson, Peter J. Kowal, Gyanesh K. Pandey, T. Paul Chow, Wei Ji, Andrew A. Woodworth

    SiC power devices have been found experimentally to burn out from heavy ion strikes with Linear Energy Transfers (LETs) as low as 2.0 MeV·cm2/mg. In this paper, to better understand the failure mechanisms, we study the single-event burnout (SEB) phenomenon using a unified physics model between heavy ion radiation transport and device response. High-fidelity radiation data, generated from a general purpose Monte Carlo N-Particle transport code (MCNP6.2), was modeled using a double Gaussian function to take into account both the heavy ion and the delta ray contributions. SiC Junction Barrier Schottky (JBS) diodes underwent 3-D TCAD electro-thermal simulations using the double Gaussian model. This model was compared against other heavy ion models to determine the behavior of the thermal response from a heavy ion strike. The results reveal that there is a more rapid thermal response from models using high-fidelity heavy ion radiation data than approximated models provided by TCAD simulators. Peak temperature results from high-voltage SiC JBS diodes agree with experimental observation of SEBs in SiC power devices.


  • Top Cited Papers
    Open Access

    Smart Power Devices and ICs Using GaAs and Wide and Extreme Bandgap Semiconductors

    by T. Paul Chow, Ichiro Omura, Masataka Higashiwaki, Hiroshi Kawarada, Vipindas Pala

    We evaluate and compare the performance and potential of GaAs and of wide and extreme bandgap semiconductors (SiC, GaN, Ga2O3, and diamond), relative to silicon, for power electronics applications. We examine their device structures and associated materials/process technologies and selectively review the recent experimental demonstrations of high voltage power devices and IC structures of these semiconductors. We discuss the technical obstacles that still need to be addressed and overcome before large-scale commercialization commences.