Fetta Danane
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Fetta Danane has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Rahma Bessah
Centre de Développement des Energies Renouvelables, CDER
5 shared publications - Rhiad Alloune
Centre de Développement des Energies Renouvelables
5 shared publications - Sabah Abada
Centre de Développement des Energies Renouvelables
4 shared publications - Madina Kechkar
Centre de Développement des Energies Renouvelables, CDER
3 shared publications Rhiad Alloune
Centre de Développement des Energies Renouvelables, CDER, BP 62 Route de l’Observatoire, Bouzaréah, 16340 Algiers, Algeria
3 shared publications- Latifa Tebbouche
Centre de Développement des Energies Renouvelables, CDER
2 shared publications
Latest Publications
- 1 July 2026
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 16 (13)
Design and optimization of biodiesel production using agro-waste derived bioethanol
- 1 July 2026
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 16 (13)
Design and optimization of biodiesel production using agro-waste derived bioethanol
- 10 January 2025
- Published by Springer Nature
- p. 289-292
Unlocking the Potential of Used Cooking Oil for Biodiesel Production Beyond Lab Scale
- 10 January 2025
- Published by Springer Nature
- p. 289-292
Unlocking the Potential of Used Cooking Oil for Biodiesel Production Beyond Lab Scale
- 16 June 2024
- Published by Springer Nature
- p. 277-283
Bioconversion of Glycerol for Bioethanol Production Using Soil Consortium
- 16 June 2024
- Published by Springer Nature
- p. 277-283
Bioconversion of Glycerol for Bioethanol Production Using Soil Consortium
- Open Access
- 19 October 2023
- Published by Centre de Developpement des Energie Renouvelables in Journal of Renewable Energies
- Vol. 17 (2)
Experimental regeneration process of used motor oils
The present work, on an experimental basis, consists of an analysis and treatment of used motor oil (used oil collected by NAFTAL stored at the port of Algiers). For this, we carried out tests in the laboratory in order to develop an adequate re-refining process. First we made a comparative analysis between the sample taken from a storage tank and a new engine oil produced in the Arzew refinery. The results of these analysis allowed us to identify the different stages of the process of regeneration (Pre-treatment, metal removal by a chemical agent, a finishing treatment by passage through the bentonite and filtration). This process has enabled us to eliminate most of the impurities and the optimization of different parameters, the engine oil obtained at the end of the process is a basic oil ready to be used again.
- 19 October 2023
- Published by Centre de Developpement des Energie Renouvelables in Journal of Renewable Energies
- Vol. 17 (2)
Open AccessExperimental regeneration process of used motor oils
The present work, on an experimental basis, consists of an analysis and treatment of used motor oil (used oil collected by NAFTAL stored at the port of Algiers). For this, we carried out tests in the laboratory in order to develop an adequate re-refining process. First we made a comparative analysis between the sample taken from a storage tank and a new engine oil produced in the Arzew refinery. The results of these analysis allowed us to identify the different stages of the process of regeneration (Pre-treatment, metal removal by a chemical agent, a finishing treatment by passage through the bentonite and filtration). This process has enabled us to eliminate most of the impurities and the optimization of different parameters, the engine oil obtained at the end of the process is a basic oil ready to be used again.
- Open Access
- 8 July 2022
- Published by EDP Sciences in Science and Technology for Energy Transition
- Vol. 77, 14
Experimental optimization of Waste Cooking Oil ethanolysis for biodiesel production using Response Surface Methodology (RSM)
Biodiesel production from Waste Cooking Oil (WCO) is the most suitable diesel fuel substitute, due to its cleaner emissions, engine lubricity, nontoxic properties, and renewable sources. This study mainly focused on improving biodiesel experimental production using ethanol and investigating the influence of main operating parameters (ethanol–oil molar ratio, catalyst concentration and stirring speed) on biodiesel yield using Response Surface Methodology (RSM). The problem with using ethanol at the expense of the toxicity of methanol as an alcohol is mainly the separation of glycerol from biodiesel at the end of the transesterification reaction. However, the addition of 5% (v/v) glycerol and 1% (v/v) water at the end of the reaction has been found to aid this separation and improve oil conversion. The optimization of the produced biodiesel is carried out through three factors: Face-Centered-Composite Design (FCCD), building a mathematical model, and statistical analysis, shows that the experimental results agree with the predicted values; they are close to unity with the R2 value (0.9924), indicating the correctness of the model. The optimal conditions of catalyst concentration (1.62 wt%), stirring speed (200 rpm) and molar ratio of ethanol to oil (12.9:1) were obtained, resulting in a biodiesel efficiency of 89.75%. The model was also experimentally validated, achieving about 90% biodiesel yield. The fuel properties of the ethyl ester were investigated and compared successfully with the EN and ASTM standards and with baseline local diesel (NA 8110).
- 8 July 2022
- Published by EDP Sciences in Science and Technology for Energy Transition
- Vol. 77, 14
Open AccessExperimental optimization of Waste Cooking Oil ethanolysis for biodiesel production using Response Surface Methodology (RSM)
Biodiesel production from Waste Cooking Oil (WCO) is the most suitable diesel fuel substitute, due to its cleaner emissions, engine lubricity, nontoxic properties, and renewable sources. This study mainly focused on improving biodiesel experimental production using ethanol and investigating the influence of main operating parameters (ethanol–oil molar ratio, catalyst concentration and stirring speed) on biodiesel yield using Response Surface Methodology (RSM). The problem with using ethanol at the expense of the toxicity of methanol as an alcohol is mainly the separation of glycerol from biodiesel at the end of the transesterification reaction. However, the addition of 5% (v/v) glycerol and 1% (v/v) water at the end of the reaction has been found to aid this separation and improve oil conversion. The optimization of the produced biodiesel is carried out through three factors: Face-Centered-Composite Design (FCCD), building a mathematical model, and statistical analysis, shows that the experimental results agree with the predicted values; they are close to unity with the R2 value (0.9924), indicating the correctness of the model. The optimal conditions of catalyst concentration (1.62 wt%), stirring speed (200 rpm) and molar ratio of ethanol to oil (12.9:1) were obtained, resulting in a biodiesel efficiency of 89.75%. The model was also experimentally validated, achieving about 90% biodiesel yield. The fuel properties of the ethyl ester were investigated and compared successfully with the EN and ASTM standards and with baseline local diesel (NA 8110).
- 20 August 2020
- Published by Springer Nature
- p. 177-184
Response Surface Methodology Based Optimization of Transesterification of Waste Cooking Oil
- 20 August 2020
- Published by Springer Nature
- p. 177-184
Response Surface Methodology Based Optimization of Transesterification of Waste Cooking Oil
- Open Access
- 10 February 2020
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 307, 01019
Heat transfer and fluid flow of Biodiesel at a backward-Facing step
You should Three-dimensional simulation of a biodiesel fluid flow within a rectangular duct over a backward-facing step is investigated in the present paper. The fluid, which obeys to the Newtonian rheological behavior, is obtained by transformation of Algerian waste cooking oil into a biodiesel. Flow through a rectangular channel subjected to a constant wall temperature or constant heat flux as boundary conditions. The partial differential equations governing fluid flow and heat transfer are solved by the Fluent CFD computational code based on the Finite Volume Method. The numerical experiments are carried out to examine the effect of the Reynolds number by fluid inlet velocity variation for the two boundary conditions. The results are analyzed through the distribution of the temperature and the velocity contours. The variation of the Reynolds number and boundary conditions affects greatly the heat transfer and the fluid flow, in particular near the step region.
- 10 February 2020
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 307, 01019
Open AccessHeat transfer and fluid flow of Biodiesel at a backward-Facing step
You should Three-dimensional simulation of a biodiesel fluid flow within a rectangular duct over a backward-facing step is investigated in the present paper. The fluid, which obeys to the Newtonian rheological behavior, is obtained by transformation of Algerian waste cooking oil into a biodiesel. Flow through a rectangular channel subjected to a constant wall temperature or constant heat flux as boundary conditions. The partial differential equations governing fluid flow and heat transfer are solved by the Fluent CFD computational code based on the Finite Volume Method. The numerical experiments are carried out to examine the effect of the Reynolds number by fluid inlet velocity variation for the two boundary conditions. The results are analyzed through the distribution of the temperature and the velocity contours. The variation of the Reynolds number and boundary conditions affects greatly the heat transfer and the fluid flow, in particular near the step region.
- 23 August 2018
- Published by Springer Nature
- p. 333-339
Experimental Investigation on Citrullus colocynthis Oil as Alternative Fuel
- 23 August 2018
- Published by Springer Nature
- p. 333-339
Experimental Investigation on Citrullus colocynthis Oil as Alternative Fuel
- 23 August 2018
- Published by Springer Nature
- p. 383-389
Regeneration of Waste Frying Oil for Biodiesel Production
- 23 August 2018
- Published by Springer Nature
- p. 383-389
Regeneration of Waste Frying Oil for Biodiesel Production