Vasily Pashkov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Vasily Pashkov has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Ruslan L. Smeliansky
Department of Computing Systems and Automation, Faculty of Computational Mathematics and Cybernetics, Lomonosov Moscow State University, 119991 Moscow, Russia
2 shared publications A. Shalimov
Lomonosov Moscow State University, Applied Research Center for Computer Networks, Russia
1 shared publicationAlexander Shalimov
Moscow State University
1 shared publication- Alexey Bergovin
Department of Computational Mathematics and Cybernetics, Moscow State University, Moscow, Russia
1 shared publication Daria Zimarina
Moscow State University
1 shared publicationDmitry Zuikov
Applied Research Center for Computer Networks
1 shared publication
Latest Publications
- 17 June 2024
- Published by Springer Nature
- p. 33-45
Selecting the Performance Metrics to Control the CPU Oversubscription Ratio in a Cloud Server
- 17 June 2024
- Published by Springer Nature
- p. 33-45
Selecting the Performance Metrics to Control the CPU Oversubscription Ratio in a Cloud Server
- Open Access
- 15 March 2019
- Published by P.G. Demidov Yaroslavl State University in Modeling and Analysis of Information Systems
- Vol. 26 (1) , 101-121-121
Fault-Tolerance Distributed Control Plane for Software Defined Networks
The architecture of the high availability distributed control plane for SDN/OpenFlow networks are considered. High availability is achieved by redundancy of controller instances, active switch-controller communications, computing resources and tools for a controller instance failure and overloading detection and recovery. The proactive backup controller allocation algorithm which allows to minimize the time to repair in the case of a single controller instance failure is discussed. The algorithm for controller load-balancing allows dynamically reconfigure the control plane with a minimum number of switch control transfer operations to avoid controller instance overloading. The initial experimental results of the proposed algorithms for the HA distributed SDN control plane are described.
- 15 March 2019
- Published by P.G. Demidov Yaroslavl State University in Modeling and Analysis of Information Systems
- Vol. 26 (1) , 101-121-121
Open AccessFault-Tolerance Distributed Control Plane for Software Defined Networks
The architecture of the high availability distributed control plane for SDN/OpenFlow networks are considered. High availability is achieved by redundancy of controller instances, active switch-controller communications, computing resources and tools for a controller instance failure and overloading detection and recovery. The proactive backup controller allocation algorithm which allows to minimize the time to repair in the case of a single controller instance failure is discussed. The algorithm for controller load-balancing allows dynamically reconfigure the control plane with a minimum number of switch control transfer operations to avoid controller instance overloading. The initial experimental results of the proposed algorithms for the HA distributed SDN control plane are described.
- Open Access
- 30 June 2018
- Published by Internet Media League in Международный научный журнал "Современные информационные технологии и ИТ-образование"
- Vol. 14 (2) , 355-367
Метод выбора конфигурации распределенной платформы управления высокой готовности для транспортных программно-конфигурируемых сетей
В работе рассматривается задача выбора конфигурации распределенной платформы управления (РПУ) с высокой степенью готовности для транспортных программно-конфигурируемых (ПКС) сетей. Для обеспечения устойчивости РПУ к единичным отказам контроллеров в рамках данной проблемы затрагиваются следующие аспекты: выбор размещения контроллеров РПУ в узлах транспортной ПКС сети, выбор основных и резервных контроллеров для каждого коммутатора сети с использованием наименьшего количества активных контроллеров распределенной платформы управления. В качестве критерия оптимизации размещения контроллеров рассматривается минимизация задержек на передачу управляющих сообщений между контроллером и коммутатором. В случае единичного отказа контроллера РПУ управление коммутаторами распределяется между исправными контроллерами таким образом, чтобы количество коммутаторов, управляемое одним контроллером, не превышало заданного максимального числа. Предлагается комплексный метод решения данной задачи, включающий в себя алгоритмы на графах, алгоритмы кластеризации и алгоритм решения задачи булевого линейного программирования, позволяющий выбрать размещение контроллеров РПУ в сети и конфигурацию основного и резервного контроллера для каждого коммутатора сети. Предложенный метод реализован в виде программного средства. Проведено экспериментальное исследование разработанного метода на топологиях реальных транспортных сетей. The method of choosing a configuration of a high availability distributed control platform (HA DCP) for transport software-defined networks is considered. To provide fault tolerance to single controller failures the following aspects are affected in this problem: the choice of the controller instance location in the nodes of the transport SDN, the choosing of the primary and backup controllers for each switch, determining the optimal number of active controllers for distributed control platform. The minimization of delays in the transmission of control messages between the controller and the switch is a criterion for optimizing the controller placement. In the case of a single controller failure, the management of the switches is distributed among the active backup controllers. A complex method for solving this problem is proposed, including algorithms on graphs, clustering algorithms, and an algorithm for solving the Boolean linear programming problem, which allows selecting the location of the controllers in the network and the configuration of the primary and backup controller for each switch. The proposed method is implemented as a software tool. An experimental investigation of the developed method on the topologies of real transport networks is carried out.
- 30 June 2018
- Published by Internet Media League in Международный научный журнал "Современные информационные технологии и ИТ-образование"
- Vol. 14 (2) , 355-367
Open AccessМетод выбора конфигурации распределенной платформы управления высокой готовности для транспортных программно-конфигурируемых сетей
В работе рассматривается задача выбора конфигурации распределенной платформы управления (РПУ) с высокой степенью готовности для транспортных программно-конфигурируемых (ПКС) сетей. Для обеспечения устойчивости РПУ к единичным отказам контроллеров в рамках данной проблемы затрагиваются следующие аспекты: выбор размещения контроллеров РПУ в узлах транспортной ПКС сети, выбор основных и резервных контроллеров для каждого коммутатора сети с использованием наименьшего количества активных контроллеров распределенной платформы управления. В качестве критерия оптимизации размещения контроллеров рассматривается минимизация задержек на передачу управляющих сообщений между контроллером и коммутатором. В случае единичного отказа контроллера РПУ управление коммутаторами распределяется между исправными контроллерами таким образом, чтобы количество коммутаторов, управляемое одним контроллером, не превышало заданного максимального числа. Предлагается комплексный метод решения данной задачи, включающий в себя алгоритмы на графах, алгоритмы кластеризации и алгоритм решения задачи булевого линейного программирования, позволяющий выбрать размещение контроллеров РПУ в сети и конфигурацию основного и резервного контроллера для каждого коммутатора сети. Предложенный метод реализован в виде программного средства. Проведено экспериментальное исследование разработанного метода на топологиях реальных транспортных сетей. The method of choosing a configuration of a high availability distributed control platform (HA DCP) for transport software-defined networks is considered. To provide fault tolerance to single controller failures the following aspects are affected in this problem: the choice of the controller instance location in the nodes of the transport SDN, the choosing of the primary and backup controllers for each switch, determining the optimal number of active controllers for distributed control platform. The minimization of delays in the transmission of control messages between the controller and the switch is a criterion for optimizing the controller placement. In the case of a single controller failure, the management of the switches is distributed among the active backup controllers. A complex method for solving this problem is proposed, including algorithms on graphs, clustering algorithms, and an algorithm for solving the Boolean linear programming problem, which allows selecting the location of the controllers in the network and the configuration of the primary and backup controller for each switch. The proposed method is implemented as a software tool. An experimental investigation of the developed method on the topologies of real transport networks is carried out.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Controller failover for SDN enterprise networks
In SDN network based on OpenFlow a controller performs logically centralized control of enterprise network infrastructure, network policies, and data flows. At the same time the controller is a single point of failure which can cause a very serious problem (e.g. network outage) for network reliability and production use cases. To address this problem, we consider different active/standby strategies to provide a controller failover in case of controller failure. We propose a high-available controller (HAC) architecture, which allows to deploy a high-availability control plane for enterprise networks. We develop a HAC prototype to demonstrate the efficiency of our solution and also describe initial experimental results.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Controller failover for SDN enterprise networks
In SDN network based on OpenFlow a controller performs logically centralized control of enterprise network infrastructure, network policies, and data flows. At the same time the controller is a single point of failure which can cause a very serious problem (e.g. network outage) for network reliability and production use cases. To address this problem, we consider different active/standby strategies to provide a controller failover in case of controller failure. We propose a high-available controller (HAC) architecture, which allows to deploy a high-availability control plane for enterprise networks. We develop a HAC prototype to demonstrate the efficiency of our solution and also describe initial experimental results.
- Open Access
- 24 October 2013
- Published by Association for Computing Machinery (ACM)
- p. 1-6
Advanced study of SDN/OpenFlow controllers
- 24 October 2013
- Published by Association for Computing Machinery (ACM)
- p. 1-6
Open AccessAdvanced study of SDN/OpenFlow controllers