Aidin Razavi
Research Subjects
Aidin Razavi has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Jian Yang
Department of Electrical Engineering, Chalmers University of Technology, Gothenburg, Sweden
3 shared publications - Rob Maaskant
Chalmers University of Technology
3 shared publications Andres Alayon Glazunov
Signals and Systems Department, Chalmers University of Technology, Gothenburg, Sweden
2 shared publications- Andres Alayon Glazunov
Linköping University Norrköping Campus Sweden
2 shared publications Jian Yang
Department of Signals and Systems, Chalmers University of Technology, Gothenburg, Sweden
2 shared publications- Jonas Friden
Ericsson AB
2 shared publications
Latest Publications
- Open Access
- 14 November 2020
- Published by American Geophysical Union (AGU) in Radio Science
- Vol. 55 (11)
Semi‐Analytical Model of the Rician K‐Factor
The analysis of the performance of 5G wireless communication systems employing Massive MIMO at millimeter‐wave frequencies is of great practical relevance. Of special relevance are the signal fluctuations. In the present paper, we introduce a semi‐analytical model for a generic scattering environment by using randomly distributed resonant scatterers to investigate the impact of the size of the scattering environment, the scatterer density, and the number of scatterers on the signal variability in terms of the Rician K‐factor as a function of frequency. We further present an investigation of the impact of scattering on the frequency dependence of the signal fading statistics in the 500 MHz–100 GHz band. The simplified model is also verified against full‐wave simulation using the Method of Moments (MoM).
- 14 November 2020
- Published by American Geophysical Union (AGU) in Radio Science
- Vol. 55 (11)
Open AccessSemi‐Analytical Model of the Rician K‐Factor
The analysis of the performance of 5G wireless communication systems employing Massive MIMO at millimeter‐wave frequencies is of great practical relevance. Of special relevance are the signal fluctuations. In the present paper, we introduce a semi‐analytical model for a generic scattering environment by using randomly distributed resonant scatterers to investigate the impact of the size of the scattering environment, the scatterer density, and the number of scatterers on the signal variability in terms of the Rician K‐factor as a function of frequency. We further present an investigation of the impact of scattering on the frequency dependence of the signal fading statistics in the 500 MHz–100 GHz band. The simplified model is also verified against full‐wave simulation using the Method of Moments (MoM).
- 2 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 69 (11) , 13165-13179
Verification of the Random Line-of-Sight Measurement Setup at 1.5-3 GHz Including MIMO Throughput Measurements of a Complete Vehicle
The performance evaluation of wireless systems is crucial for the development of future systems with more connected devices. It is essential to have an easy and relevant method for ensuring the wireless communication performance of the devices. We have recently developed a new random line-of-sight (random-LOS) measurement system for evaluating the communication performance of wireless devices, e.g., transceivers and antennas installed on a vehicle. In the measurement system, a plane wave is generated in the test zone emulating the far-field wave transmitted from a radio base station. In this paper we present both numerical simulations and actual experimental results of the random-LOS over-the-air (OTA) measurement setup operating in the 1.5-3 GHz band. The measurement accuracy is determined by the field variations within the test zone, where a smaller variation gives better measurement accuracy. In this paper the achieved accuracy expressed in terms of standard deviation (STD) was evaluated to be approximately 1 dB of the power within a cylindrical test zone of height 0.4 m and diameter 2 m. The active multiple-input multiple-output (MIMO) performance of antenna systems installed on an actual vehicle was measured and evaluated using the presented setup. A comparison to a theoretical zero forcing (ZF) receiver is also presented.
- 2 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 69 (11) , 13165-13179
Verification of the Random Line-of-Sight Measurement Setup at 1.5-3 GHz Including MIMO Throughput Measurements of a Complete Vehicle
The performance evaluation of wireless systems is crucial for the development of future systems with more connected devices. It is essential to have an easy and relevant method for ensuring the wireless communication performance of the devices. We have recently developed a new random line-of-sight (random-LOS) measurement system for evaluating the communication performance of wireless devices, e.g., transceivers and antennas installed on a vehicle. In the measurement system, a plane wave is generated in the test zone emulating the far-field wave transmitted from a radio base station. In this paper we present both numerical simulations and actual experimental results of the random-LOS over-the-air (OTA) measurement setup operating in the 1.5-3 GHz band. The measurement accuracy is determined by the field variations within the test zone, where a smaller variation gives better measurement accuracy. In this paper the achieved accuracy expressed in terms of standard deviation (STD) was evaluated to be approximately 1 dB of the power within a cylindrical test zone of height 0.4 m and diameter 2 m. The active multiple-input multiple-output (MIMO) performance of antenna systems installed on an actual vehicle was measured and evaluated using the presented setup. A comparison to a theoretical zero forcing (ZF) receiver is also presented.
- Open Access
- 24 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 57826-57839
Angular Sampling, Test Signal, and Near-Field Aspects for Over-The-Air Total Radiated Power Assessment in Anechoic Chambers
5th-generation mobile network systems operating in millimeter-wave bands will employ base stations with integrated active antenna systems. Such systems are capable of beam-tracking using narrow beams obtained from antenna arrays. Regulatory limits for unwanted radio frequency and Over-The-Air methods for TRP of unwanted emissions are needed. The method investigated here uses power density measurements on a spherical surface in an anechoic chamber. Two major challenges with such a method are: need for a large number of angular points and search for a worst case antenna configuration per frequency for electrically large devices at high frequencies. These challenges are addressed by investigating sparse sampling and use of beam sweeping. Finally, it is investigated how and in which spatial regions near-field tangential electric field measurements can be used to assess TRP.
- 24 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 6, 57826-57839
Open AccessAngular Sampling, Test Signal, and Near-Field Aspects for Over-The-Air Total Radiated Power Assessment in Anechoic Chambers
5th-generation mobile network systems operating in millimeter-wave bands will employ base stations with integrated active antenna systems. Such systems are capable of beam-tracking using narrow beams obtained from antenna arrays. Regulatory limits for unwanted radio frequency and Over-The-Air methods for TRP of unwanted emissions are needed. The method investigated here uses power density measurements on a spherical surface in an anechoic chamber. Two major challenges with such a method are: need for a large number of angular points and search for a worst case antenna configuration per frequency for electrically large devices at high frequencies. These challenges are addressed by investigating sparse sampling and use of beam sweeping. Finally, it is investigated how and in which spatial regions near-field tangential electric field measurements can be used to assess TRP.
- Open Access
- 3 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 5, 25635-25645
Probability of Detection Functions of Polarization-MIMO Systems in Random-LOS
We derive the probability of detection functions of 1- and 2-bitstreams for polarization multiple-input multiple-output antenna systems in random line-of-sight propagation conditions. The derivations are produced assuming that the angle-of-arrival of the field impinging at the receive antenna is fixed. Hence, randomness is only due to the direction of polarization of the incident field relative to the polarization of the far-field of the receiver antenna. Also, a general analytical orthogonalization transformation matrix has been derived for far-field functions of arbitrary dual-polarized antennas and used in the probability of detection derivations. Analytical results are obtained for the maximum ratio combining receiver diversity and the zero-forcing multiplexing receiver algorithms. These results provide a practical prediction tool of the impact of antennas on system performance due to polarization deficiencies of analytical, measured or simulated radiation field patterns of dual polarized antennas. This is illustrated by the provided numerical examples.
- 3 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 5, 25635-25645
Open AccessProbability of Detection Functions of Polarization-MIMO Systems in Random-LOS
We derive the probability of detection functions of 1- and 2-bitstreams for polarization multiple-input multiple-output antenna systems in random line-of-sight propagation conditions. The derivations are produced assuming that the angle-of-arrival of the field impinging at the receive antenna is fixed. Hence, randomness is only due to the direction of polarization of the incident field relative to the polarization of the far-field of the receiver antenna. Also, a general analytical orthogonalization transformation matrix has been derived for far-field functions of arbitrary dual-polarized antennas and used in the probability of detection derivations. Analytical results are obtained for the maximum ratio combining receiver diversity and the zero-forcing multiplexing receiver algorithms. These results provide a practical prediction tool of the impact of antennas on system performance due to polarization deficiencies of analytical, measured or simulated radiation field patterns of dual polarized antennas. This is illustrated by the provided numerical examples.
- Open Access
- 1 January 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 4, 10067-10075
Characterizing Polarization-MIMO Antennas in Random-LOS Propagation Channels
In the 5G system, we foresee the use of LOS-dominated mm-wave radio links to moving users being subject to slow fading resulting from the users' random locations and orientations. We refer to this as a random-LOS channel. MIMO processing algorithms will be used in 5G to improve performance in slow fading, similar to how they are used in Rayleigh fading. To this end, we study the probability of detection in the random-LOS channel when there are dual-polarized antennas on both sides of the link. We introduce two polarization deficiencies: the polarization non-orthogonality and the amplitude imbalance between the ports of a two-port antenna. The MIMO efficiency is evaluated as a function of these deficiencies. In the analysis, we consider the MRC algorithm for one bitstream, and the ZF and SVD algorithms for two bitstreams. We also present two analytical formulas for the MIMO efficiency that can be used to determine performance. We use the formulas on two ideally orthogonal dipoles, and show by means of coverage plots how much the 1- and 2-bitstream performances degrade due to the polarization deficiencies in off-boresight directions.
- 1 January 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 4, 10067-10075
Open AccessCharacterizing Polarization-MIMO Antennas in Random-LOS Propagation Channels
In the 5G system, we foresee the use of LOS-dominated mm-wave radio links to moving users being subject to slow fading resulting from the users' random locations and orientations. We refer to this as a random-LOS channel. MIMO processing algorithms will be used in 5G to improve performance in slow fading, similar to how they are used in Rayleigh fading. To this end, we study the probability of detection in the random-LOS channel when there are dual-polarized antennas on both sides of the link. We introduce two polarization deficiencies: the polarization non-orthogonality and the amplitude imbalance between the ports of a two-port antenna. The MIMO efficiency is evaluated as a function of these deficiencies. In the analysis, we consider the MRC algorithm for one bitstream, and the ZF and SVD algorithms for two bitstreams. We also present two analytical formulas for the MIMO efficiency that can be used to determine performance. We use the formulas on two ideally orthogonal dipoles, and show by means of coverage plots how much the 1- and 2-bitstream performances degrade due to the polarization deficiencies in off-boresight directions.
- 17 September 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 14 (15361225) , 175-178
Maximum Aperture Power Transmission in Lossy Homogeneous Matters
We apply array signal processing techniques to the transmitting aperture field modes in order to determine the optimal field distribution that maximizes the power transmission through lossy media between a transmitting and an ideally receiving antenna aperture. The optimal aperture distribution is then used as a reference field for developing curves applicable to the design of many near-field systems, such as for the detection of foreign objects in lossy matters (e.g., food contamination detectors), wireless charging of batteries of human body implanted devices, and for in-body communication systems.
- 17 September 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 14 (15361225) , 175-178
Maximum Aperture Power Transmission in Lossy Homogeneous Matters
We apply array signal processing techniques to the transmitting aperture field modes in order to determine the optimal field distribution that maximizes the power transmission through lossy media between a transmitting and an ideally receiving antenna aperture. The optimal aperture distribution is then used as a reference field for developing curves applicable to the design of many near-field systems, such as for the detection of foreign objects in lossy matters (e.g., food contamination detectors), wireless charging of batteries of human body implanted devices, and for in-body communication systems.
- 22 July 2014
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 56 (10) , 2301-2304
Optimal size of uniform aperture for near-field penetration through lossy medium
- 22 July 2014
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 56 (10) , 2301-2304
Optimal size of uniform aperture for near-field penetration through lossy medium