SSSascha Schneiderwind

Sascha Schneiderwind

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sascha Schneiderwind has a total of 24 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Monitoring and Quantifying Soil Erosion and Sedimentation Rates in Centimeter Accuracy Using UAV-Photogrammetry, GNSS, and t-LiDAR in a Post-Fire Setting

    by Simoni Alexiou, Ioannis Papanikolaou, Sascha Schneiderwind, Valerie Kehrle, Klaus Reicherter

    Remote sensing techniques, namely Unmanned Aerial Vehicle (UAV) photogrammetry and t-LiDAR (terrestrial Light Detection and Ranging), two well-established techniques, were applied for seven years in a mountainous Mediterranean catchment in Greece (Ilioupoli test site, Athens), following a wildfire event in 2015. The goal was to monitor and quantify soil erosion and sedimentation rates with cm accuracy. As the frequency of wildfires in the Mediterranean has increased, this study aims to present a methodological approach for monitoring and quantifying soil erosion and sedimentation rates in post-fire conditions, through high spatial resolution field measurements acquired using a UAV survey and a t-LiDAR (or TLS—Terrestrial Laser Scanning), in combination with georadar profiles (Ground Penetration Radar—GPR) and GNSS. This test site revealed that 40 m3 of sediment was deposited following the first intense autumn rainfall events, a value that was decreased by 50% over the next six months (20 m3). The UAV–SfM technique revealed only 2 m3 of sediment deposition during the 2018–2019 analysis, highlighting the decrease in soil erosion rates three years after the wildfire event. In the following years (2017–2021), erosion and sedimentation decreased further, confirming the theoretical pattern, whereas sedimentation over the first year after the fire was very high and then sharply lessened as vegetation regenerated. The methodology proposed in this research can serve as a valuable guide for achieving high-precision sediment yield deposition measurements based on a detailed analysis of 3D modeling and a point cloud comparison, specifically leveraging the dense data collection facilitated by UAV–SfM and TLS technology. The resulting point clouds effectively replicate the fine details of the topsoil microtopography within the upland dam basin, as highlighted by the profile analysis. Overall, this research clearly demonstrates that after monitoring the upland area in post-fire conditions, the UAV–SfM method and LiDAR cm-scale data offer a realistic assessment of the retention dam’s life expectancy and management planning. These observations are especially crucial for assessing the impacts in the wildfire-affected areas, the implementation of mitigation strategies, and the construction and maintenance of retention dams.


  • Open Access

    The Seismic History of the Pisia Fault (Eastern Corinth Rift, Greece) From Fault Plane Weathering Features and Cosmogenic36Cl Dating

    by Silke Mechernich, Sascha Schneiderwind, Jack Mason, Ioannis D. Papanikolaou, Georgios Deligiannakis, Aggelos Pallikarakis, Steven A. Binnie, Tibor J. Dunai, Klaus Reicherter

    The deformation of the eastern Corinth rift (Greece) is distributed along several E‐W trending active normal faults. Here the 25‐km‐long Pisia fault experienced up to 150 cm of coseismic displacement during the 1981 Alkyonides earthquake sequence (M = 6.7, 6.4, 6.3). Using terrestrial laser scanning, coupled with analyses of color changes, lichen colonization, and karstic features, we identify differentially weathered horizontal stripes on the exposed Pisia fault plane. The stripe boundaries occur at scarp heights of 1.10, 2.05, 2.85, 3.60, 4.15, and 5.15 m, with two additional possible boundaries at 3.10 and 4.65 m (~±0.1 m, respectively). This indicates that six to eight paleoearthquakes have exhumed the fault plane in a series of distinct coseismic slip events. A vertical profile of cosmogenic36Cl measurements is used to constrain age models of the exhumation. The results imply that, in addition to the last earthquake of 1981 (EQ1), exhumation events occurred at ~2.0 kyr (EQ2), ~3.1 kyr (EQ3), ~4.5 kyr (EQ4/4a,b), ~6.0 kyr (EQ5), and ~7.3 kyr (EQ6/6a,b), with modeled age uncertainties of ~0.7 kyr. Bayesian modeling provides a middle and late Holocene slip rate of 0.5–0.6 mm/yr (last 7.3 ± 0.7 kyr), while the upper part of the 8.45‐m‐high fault plane was exhumed at a higher rate of 0.8–2.3 mm/yr (7.3 ± 0.7 kyr to 10.2 ± 1.9 kyr). This slip rate variability suggests an increased seismicity or larger slip events during the early Holocene.


  • Open Access

    GEOMETRY OF HOLOCENE TIDAL NOTCHES – SEA LEVEL MARKERS AT PERACHORA PENINSULA, GULF OF CORINTH, GREECE

    by S. Schneiderwind, M. Kázmér, S. Boulton, I. Papanikolaou, K. Reicherter

    Tidal notches are a generally accepted sea level indicator that, when different from mean sea level, witness tectonic activity at or near coastlines. However, how to infer related information is controversial since tectonic uplift from a single seismic event is not likely to exceed several decimetres. High resolution laser scanning offers the availability of close-up views on exposures and to detect evidence for multiple sea level indicators in between major emergence. Statistically representative profiles along exposure were analysed in order to prove for already described tidal notches and to highlight similar shapes in consistent geometries along coastal cliffs of Perachora Peninsula.


  • Hanging-wall colluvial cementation along active normal faults

    by Jack Mason, Sascha Schneiderwind, Aggelos Pallikarakis, Silke Mechernich, Ioannis Papanikolaou, Klaus Reicherter

    Many active normal faults throughout the Aegean juxtapose footwall limestone against hanging-wall colluvium. In places, this colluvium becomes cemented and forms large hanging-wall lobes or sheets of varying thickness attached to the bedrock fault. Investigations at the Lastros Fault in eastern Crete allow us to define criteria to distinguish between cemented colluvium and fault cataclasite (tectonic breccia), which is often present at bedrock faults. Macro- and microscopic descriptions of the cemented colluvium show that the colluvium was originally deposited through both rockfalls and debris flows. Stable isotope analyses of oxygen and carbon from 83 samples indicate that cementation then occurred through meteoric fluid flow in the fault zone from springs at localised positions along strike. Palaeotemperature calculations of the parent water from which the calcite cement precipitated are indicative of a climate between 7°C and 10°C colder than Crete’s present average annual temperature. This most likely represents the transition between a glacial and interglacial period in the late Pleistocene. Ground-penetrating radar also indicates that cemented colluvium is present in the hanging-wall subsurface below uncemented colluvium. Using these results, a model for the temporal development of the fault and formation of the cemented colluvium is proposed.


  • Numerical modeling of tidal notch sequences on rocky coasts of the Mediterranean Basin

    by S. Schneiderwind, S. J. Boulton, I. Papanikolaou, M. Kázmér, K. Reicherter

    Tidal notches have had the potential to form at sea level from ~6.5 kyr B.P. in the Mediterranean Basin and preserve a symmetrical shape comparable to a quadric polynomial. Continuous erosion, predominantly by biological agents, affects a limestone cliff face from low‐ to high‐tide level at <1 mm/yr. Statically determined, the roots of a quadric polynomial are defined by the tidal range representing the limits of effective erosion. However, gradual variations of eustatic sea level rise (slow) and coseismic uplift/subsidence (fast) in tectonically active regions contribute to vertical shifts in the erosional base at coastlines. As a consequence, the cliff morphology gets modified through time resulting in widening, deepening, and separation of notches and possible overprinting of older features. In order to investigate successive modifications of coastal cliff morphology, we developed a numerical model that considers the erosion rate, the erosion zone relative to sea level, the regional sea level curve, and tectonic motion. The results show how slow and rapid sea level changes bias the modern cliff face and highlight that the present‐day notch sequence from top descending to sea level is not inevitably of decreasing age. Furthermore, the initiation of notch formation is not necessarily linked to the date of a certain seismic event. Especially in extensional tectonic settings where coseismic uplift is low and coastal morphological marks are not as distinct, knowledge about coastal evolution is beneficial for paleoseismological research.


  • Fault structure and deformation rates at the Lastros-Sfaka Graben, Crete

    by J. Mason, S. Schneiderwind, A. Pallikarakis, T. Wiatr, S. Mechernich, I. Papanikolaou, K. Reicherter


  • Open Access

    3-D visualisation of palaeoseismic trench stratigraphy and trench logging using terrestrial remote sensing and GPR – a multiparametric interpretation

    by Sascha Schneiderwind, Jack Mason, Thomas Wiatr, Ioannis Papanikolaou, Klaus Reicherter

    Two normal faults on the island of Crete and mainland Greece were studied to test an innovative workflow with the goal of obtaining a more objective palaeoseismic trench log, and a 3-D view of the sedimentary architecture within the trench walls. Sedimentary feature geometries in palaeoseismic trenches are related to palaeoearthquake magnitudes which are used in seismic hazard assessments. If the geometry of these sedimentary features can be more representatively measured, seismic hazard assessments can be improved. In this study more representative measurements of sedimentary features are achieved by combining classical palaeoseismic trenching techniques with multispectral approaches. A conventional trench log was firstly compared to results of ISO (iterative self-organising) cluster analysis of a true colour photomosaic representing the spectrum of visible light. Photomosaic acquisition disadvantages (e.g. illumination) were addressed by complementing the data set with active near-infrared backscatter signal image from t-LiDAR measurements. The multispectral analysis shows that distinct layers can be identified and it compares well with the conventional trench log. According to this, a distinction of adjacent stratigraphic units was enabled by their particular multispectral composition signature. Based on the trench log, a 3-D interpretation of attached 2-D ground-penetrating radar (GPR) profiles collected on the vertical trench wall was then possible. This is highly beneficial for measuring representative layer thicknesses, displacements, and geometries at depth within the trench wall. Thus, misinterpretation due to cutting effects is minimised. This manuscript combines multiparametric approaches and shows (i) how a 3-D visualisation of palaeoseismic trench stratigraphy and logging can be accomplished by combining t-LiDAR and GPR techniques, and (ii) how a multispectral digital analysis can offer additional advantages to interpret palaeoseismic and stratigraphic data. The multispectral data sets are stored allowing unbiased input for future (re)investigations.


  • Open Access

    New constraints on extensional tectonics and seismic hazard in northern Attica, Greece: the case of the Milesi Fault

    by Christoph Grützner, Sascha Schneiderwind, Ioannis Papanikolaou, Georgios Deligiannakis, Aggelos Pallikarakis, Klaus Reicherter

    Northern Attica in Greece is characterized by a set of north dipping, subparallel normal faults. These faults were considered to have low tectonic activity, based on historical earthquake reports, instrumental seismicity and slip rate estimates. This study presents new data for one of these faults, the Milesi Fault. We run GIS based geomorphological analyses on fault offset distribution, field mapping of postglacial fault scarps and ground penetrating radar profiling to image hangingwall deformation. The first palaeoseismological trenching in this part of Greece allowed obtaining direct data on slip rates and palaeoearthquakes. The trenching revealed downthrown and buried palaeosols, which were dated by radiocarbon. The results of our investigations show that the slip rates are higher than previously thought and that at least four palaeoearthquakes with magnitudes of around M6.2 occurred during the last 4000–6000 yr. We calculate an average recurrence interval of 1000–1500 yr and a maximum throw rate of ∼0.4–0.45 mm a−1. Based on the new geological earthquake data we developed a seismic hazard scenario, which also incorporates geological site effects. Intensities up to IX must be expected for Northern Attica and the southeastern part of Evia. Earthquake environmental effects like liquefaction and mass movements are also likely to occur. This scenario is in contrast to the official Greek seismic hazard zonation that is based on historical records and assigns different hazard zones for municipalities that will experience the same intensity by earthquakes on the Milesi Fault. We show that the seismic hazard is likely underestimated in our study area and emphasize the need to incorporate geological information in such assessments.


  • Open Access

    3-D visualisation of palaeoseismic trench stratigraphy and trench logging using terrestrial remote sensing and GPR – combining techniques towards an objective multiparametric interpretation

    by Sascha Schneiderwind, Jack Mason, Thomas Wiatr, Ioannis Papanikolaou, Klaus Reicherter

    Two normal faults on the Island of Crete and mainland Greece were studied to create and test an innovative workflow to make palaeoseismic trench logging more objective, and visualise the sedimentary architecture within the trench wall in 3-D. This is achieved by combining classical palaeoseismic trenching techniques with multispectral approaches. A conventional trench log was firstly compared to results of iso cluster analysis of a true colour photomosaic representing the spectrum of visible light. Passive data collection disadvantages (e.g. illumination) were addressed by complementing the dataset with active near-infrared backscatter signal image from t-LiDAR measurements. The multispectral analysis shows that distinct layers can be identified and it compares well with the conventional trench log. According to this, a distinction of adjacent stratigraphic units was enabled by their particular multispectral composition signature. Based on the trench log, a 3-D-interpretation of GPR data collected on the vertical trench wall was then possible. This is highly beneficial for measuring representative layer thicknesses, displacements and geometries at depth within the trench wall. Thus, misinterpretation due to cutting effects is minimised. Sedimentary feature geometries related to earthquake magnitude can be used to improve the accuracy of seismic hazard assessments. Therefore, this manuscript combines multiparametric approaches and shows: (i) how a 3-D visualisation of palaeoseismic trench stratigraphy and logging can be accomplished by combining t-LiDAR and GRP techniques, and (ii) how a multispectral digital analysis can offer additional advantages and a higher objectivity in the interpretation of palaeoseismic and stratigraphic information. The multispectral datasets are stored allowing unbiased input for future (re-)investigations.