Hüseyin Karaca
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Hüseyin Karaca has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
Cemil Koyunoglu
Energy Institute, Istanbul Technical University, Istanbul, Turkey
4 shared publicationsCemil Koyunoğlu
4 shared publications- Cemil Koyunoğlu
Energy Systems Engineering Department, Engineering Faculty, Yalova University, Yalova, Turkey
3 shared publications Figen Gündüz
2 shared publicationsM. Ali Coskun
Department of Chemical Engineering, İnönü University, Malatya, Turkey
2 shared publications- Mesut Karta
Department of Mining Engineering, İnönü University, Malatya, Turkey
2 shared publications
Latest Publications
- Open Access
- 7 September 2026
- Published by Elsevier in SSRN Electronic Journal
High-efficiency refrigerant additive solvent-based fire extinguishing system and computational fluid dynamics analysis
This study evaluates the thermal cooling efficiency of a high-efficiency refrigerant additive water-based fire extinguishing system through Computational Fluid Dynamics (CFD) analysis. The research focuses on the heat absorption capacity and gas-phase cooling performance of various suppressant formulations in high-temperature environments. Six distinct samples (K1 to K6), characterized by unique elemental compositions and thermodynamic properties, were analyzed to determine their effectiveness in thermal mitigation. Key material parameters, including molecular weight, specific heat, heat of vaporization, and enthalpy of formation, were analytically derived from elemental analysis and high heating value data to serve as precise inputs for numerical simulation models. The results indicate that the integration of refrigerant agents significantly enhances the heat extraction capacity of liquid droplets, resulting in a more effective reduction in ambient temperatures and radiant heat flux. The findings demonstrate that optimized additive concentrations provide superior thermal stability and cooling density compared to conventional water-based agents. This study underscores the importance of accurate thermodynamic modeling in predicting the cooling behavior of advanced firefighting additives.
- 7 September 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessHigh-efficiency refrigerant additive solvent-based fire extinguishing system and computational fluid dynamics analysis
This study evaluates the thermal cooling efficiency of a high-efficiency refrigerant additive water-based fire extinguishing system through Computational Fluid Dynamics (CFD) analysis. The research focuses on the heat absorption capacity and gas-phase cooling performance of various suppressant formulations in high-temperature environments. Six distinct samples (K1 to K6), characterized by unique elemental compositions and thermodynamic properties, were analyzed to determine their effectiveness in thermal mitigation. Key material parameters, including molecular weight, specific heat, heat of vaporization, and enthalpy of formation, were analytically derived from elemental analysis and high heating value data to serve as precise inputs for numerical simulation models. The results indicate that the integration of refrigerant agents significantly enhances the heat extraction capacity of liquid droplets, resulting in a more effective reduction in ambient temperatures and radiant heat flux. The findings demonstrate that optimized additive concentrations provide superior thermal stability and cooling density compared to conventional water-based agents. This study underscores the importance of accurate thermodynamic modeling in predicting the cooling behavior of advanced firefighting additives.
- 5 September 2025
- Published by Elsevier in Next Research
- Vol. 2 (4)
The effect of catalyst type on direct liquefaction of elbistan lignite: Preliminary evaluation
- 5 September 2025
- Published by Elsevier in Next Research
- Vol. 2 (4)
The effect of catalyst type on direct liquefaction of elbistan lignite: Preliminary evaluation
- Open Access
- 9 February 2023
- Published by Taylor & Francis in International Journal of Sustainable Energy
- Vol. 42 (1) , 1-24
Microbial desulphurisation of coal: a review
During the production and processing of coal, burning it for energy production may cause a series of environmental pollution due to the amount of sulphur in it. When the consumed sulphur in coal is in the form of sulphur dioxide at the end of combustion, it reacts with water at high altitudes. Moreover, it goes down to the earth in the form of sulphuric acid, as well as damaging plants. The corrosive harmful impact on industrial plants is the removal of the sulphur in the coal when it is environmental. Microorganisms that use sulphur as food to eliminate the anxiety of clean production brought about by the chemical method. This review determined the study contains information about which microorganism is effective in removing sulphur in coal and also the types of organisms that should be according to the organic sulphur type in coal.
- 9 February 2023
- Published by Taylor & Francis in International Journal of Sustainable Energy
- Vol. 42 (1) , 1-24
Open AccessMicrobial desulphurisation of coal: a review
During the production and processing of coal, burning it for energy production may cause a series of environmental pollution due to the amount of sulphur in it. When the consumed sulphur in coal is in the form of sulphur dioxide at the end of combustion, it reacts with water at high altitudes. Moreover, it goes down to the earth in the form of sulphuric acid, as well as damaging plants. The corrosive harmful impact on industrial plants is the removal of the sulphur in the coal when it is environmental. Microorganisms that use sulphur as food to eliminate the anxiety of clean production brought about by the chemical method. This review determined the study contains information about which microorganism is effective in removing sulphur in coal and also the types of organisms that should be according to the organic sulphur type in coal.
- 22 December 2022
- Published by Elsevier in Process Safety and Environmental Protection
- Vol. 170, 1208-1216
Direct liquefaction of low rank lignite with peach seed kernel and waste polypropylene for alternative fuel production
- 22 December 2022
- Published by Elsevier in Process Safety and Environmental Protection
- Vol. 170, 1208-1216
Direct liquefaction of low rank lignite with peach seed kernel and waste polypropylene for alternative fuel production
- 23 March 2022
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 41 (4)
Characterization of products obtained of waste polyethylene terephthalate by pyrolysis
In this study, waste polyethylene terephthalate (wPET) was converted to liquid fuel by the pyrolysis method. It was also investigated both effects of microwave pre‐treatment and catalyst (sodium borohydride) on total conversion and oil + gas yield. The reaction temperature of 375–425°C and the reaction time of 30 min are sufficient for the pyrolysis of waste plastic samples in a batch reactor. In the pyrolysis of wPETs, the highest oil + gas yield of 45% was obtained under the conditions of reaction temperature of 425°C and reaction time of 30 min. The highest total conversion was 62% of microwave pre‐treated wPETs under catalytic conditions. It can be argued that microwave pre‐treatment and NaBH4 influence the oil + gas yield in pyrolysis experiments. According to the gas chromatography–mass spectrometry (GC–MS) analysis results of the oil products, they consist of aromatic, mono and multi‐ring aromatic compounds and polyaromatic compounds. Higher heating values of the solid products obtained in pyrolysis are approximately 4000–6000 cal/g. According to X‐ray diffraction analysis (XRD) of the solid products, they consist largely of crystalline terephthalic acid (C8H6O4).
- 23 March 2022
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 41 (4)
Characterization of products obtained of waste polyethylene terephthalate by pyrolysis
In this study, waste polyethylene terephthalate (wPET) was converted to liquid fuel by the pyrolysis method. It was also investigated both effects of microwave pre‐treatment and catalyst (sodium borohydride) on total conversion and oil + gas yield. The reaction temperature of 375–425°C and the reaction time of 30 min are sufficient for the pyrolysis of waste plastic samples in a batch reactor. In the pyrolysis of wPETs, the highest oil + gas yield of 45% was obtained under the conditions of reaction temperature of 425°C and reaction time of 30 min. The highest total conversion was 62% of microwave pre‐treated wPETs under catalytic conditions. It can be argued that microwave pre‐treatment and NaBH4 influence the oil + gas yield in pyrolysis experiments. According to the gas chromatography–mass spectrometry (GC–MS) analysis results of the oil products, they consist of aromatic, mono and multi‐ring aromatic compounds and polyaromatic compounds. Higher heating values of the solid products obtained in pyrolysis are approximately 4000–6000 cal/g. According to X‐ray diffraction analysis (XRD) of the solid products, they consist largely of crystalline terephthalic acid (C8H6O4).
- 1 December 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (60) , 32095-32100
A new catalyst (colemanite) for coal-to-liquid technology; a case study for the liquefaction of Elbistan Lignite: the effect of colemanite and Fe2O3 catalyst blending
- 1 December 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (60) , 32095-32100
A new catalyst (colemanite) for coal-to-liquid technology; a case study for the liquefaction of Elbistan Lignite: the effect of colemanite and Fe2O3 catalyst blending
Co-processing behavior of Gölbaşı lignite and poplar sawdust by factorial experimental design method
- Open Access
- 24 June 2019
- Published by Springer Nature in Scientific Reports
- Vol. 9 (1) , 1-9
Proving hydrogen addition mechanism from manure to coal surface obtained by GC-MS and 1H-NMR analysis
In this study, to explain the possibility of hydrogen transfer paths from manure to coal, Elbistan lignite (EL) combined with manure liquefaction of oil + gas products were analysed with Gas Chromatography-Mass Spectroscopy (GC-MS) and Nuclear Magnetic Resonance Spectroscopy (1H-NMR) technique. In the same way, it is observed that oils which as they fragment to an alkane-alkene mixture, serve as a hydrogen “sponge” and put a serious hydrogen need on the parts of the free radicals and molecules that are currently hydrogen poor. Concerning Elbistan lignite and manure do not have any aromatic hydrogen. Moreover, when the aromatic compounds were hydrogenated, their aromatic hydrogen was transformed to naphthenic hydrogen. Hydrogen transfer was due to isomerization of heptane from 3-methylhexane obtained in test oil where only manure was present as hydrogen donor in the liquefaction environment despite hydrogenation of isomerization from naphthalene to azulene.
- 24 June 2019
- Published by Springer Nature in Scientific Reports
- Vol. 9 (1) , 1-9
Open AccessProving hydrogen addition mechanism from manure to coal surface obtained by GC-MS and 1H-NMR analysis
In this study, to explain the possibility of hydrogen transfer paths from manure to coal, Elbistan lignite (EL) combined with manure liquefaction of oil + gas products were analysed with Gas Chromatography-Mass Spectroscopy (GC-MS) and Nuclear Magnetic Resonance Spectroscopy (1H-NMR) technique. In the same way, it is observed that oils which as they fragment to an alkane-alkene mixture, serve as a hydrogen “sponge” and put a serious hydrogen need on the parts of the free radicals and molecules that are currently hydrogen poor. Concerning Elbistan lignite and manure do not have any aromatic hydrogen. Moreover, when the aromatic compounds were hydrogenated, their aromatic hydrogen was transformed to naphthenic hydrogen. Hydrogen transfer was due to isomerization of heptane from 3-methylhexane obtained in test oil where only manure was present as hydrogen donor in the liquefaction environment despite hydrogenation of isomerization from naphthalene to azulene.