Elena V. Timofeeva

Both Co-free and lithium- and manganese-rich layered oxide Li(Li_0.2Mn_xNi_yFe_z)O₂ (MNF) cathodes have recently attracted attention in lithium-ion battery (LIB) research due to their high capacities of over 250 mAhg⁻¹, as well as being more eco-friendly and inexpensive than commercial NMC and LiCoO₂. However, they still suffer from lower experimental capacity as well as capacity decay, voltage fade, poor rate capability, and thermal instability. In this paper, fluorine (F)-doped Li_1.2(Mn_0.5Ni_0.2Fe_0.1)O_2(1−x)F_2x (MNF502010, x = 0, 0.025, 0.05, 0.075, 0.1) cathode materials have been synthesized in the nanoscale via sol–gel and subsequent solid-phase calcination to address some of these problems. The resulting 5% F-doped MNF502010 cathode demonstrates the advantage of fluorine doping, which makes a significant contribution to the formation of a well-ordered layer structure with a minimal LiM₂O₄ spinel phase as an impurity. This composition achieves an initial discharge capacity of 252 mAhg⁻¹ (1C = 250 mAhg⁻¹) and a 156 mAhg⁻¹ discharge capacity at 0.3 C on the 100th discharge, with an average voltage fade of 0.24 V. The optimization of fluorine composition results in an enhancement in the activation of the Li₂MnO₃-type monoclinic phase, as well as an increase in the electronic conductivity compared to the fluorine-free cathode. To understand the structural origin of this improved performance, X-ray absorption spectroscopy (XAS) measurements were carried out on pristine and cycled MNF electrodes.

Despite the challenges in achieving its full theoretical capacity of reversible extraction of two Li ions, the Li₂FeSiO₄ (LFS) cathode shows a remarkable cycling stability once its low electronic conductivity is addressed. By studying the local structure around the iron during electrochemical cycling using in situ x-ray absorption spectroscopy (XAS), it is possible to gain insight into the factors which determine the electrochemical properties of this material. In order to practically perform in situ XAS studies, the charge/discharge of LFS was maximized using two approaches: (a) reducing the particle size of LFS samples from micro-scale to nano-scale in order to reduce the diffusion path for intercalating ions; and (b) applying a conductive coating to each nanoparticle to facilitate electron transfer. A family of LFS materials was synthesized and characterized using x-ray diffraction, and scanning electron microscopy with energy dispersive analysis for structural and morphological analysis, as well as cyclic voltammetry and cycling tests for electrochemical performance diagnosis. This material was then characterized by in situ XAS. The results provide insight into the stable electrochemical performance of LFS and suggest new synthetic routes to reaching the theoretical capacity.

Li-rich Mn-Ni-Fe (MNF) oxide cathodes are emerging as a low-cost alternative to commercial Ni-Mn-Co (NMC) oxides with the cost of raw iron being three orders of magnitude lower than cobalt. MNF cathodes have demonstrated potential for high capacity and high discharge voltage cathodes, however, the capacity decay and instability of discharge voltage upon cycling still need to be resolved for their successful commercialization. Both phenomena are related to the changes in structure and in this study, we utilize SXRD and XAFS to investigate the structural changes correlated to electrochemical performance of Li_1.2Mn_0.5Ni_0.2Fe_0.1O₂ cathode. This material, prepared by sol gel synthesis, showed initial discharge capacity of 226 mAhg⁻¹ and 93% capacity retention after 100 cycles. Fitting of the XAFS results provided information on the changes in local environment of each transition metal atom. Such detailed information on atomic environment is reported for the first time and compared to prior studies of NMC cathodes. In the discharged state Mn atoms show a shift to lower oxidation state and an irreversible loss of oxygen near neighbors after cycling, while Ni and Fe show only minor changes in their environment. An observed 5.87% lattice expansion after cycling is suggested to contribute to voltage fade.

A novel Sn₄P₃/graphite composite anode material with superior capacity and cycling performance (651 mA h g⁻¹ after 100 cycles) is investigated by in situ X‐ray absorption spectroscopy. Extended X‐ray absorption fine structure modeling and detailed analysis of local environment changes are correlated to the cell capacity and reveal the mechanism of lithiation/delithiation process. Results show that in the first two lithiation/delithiation cycles crystalline Sn₄P₃ is fully converted to an amorphous SnP_x phase, which in further cycles participates in reversible conversion and alloying reactions. The superior reversibility of this material is attributed to the highly dispersed SnP_x in the graphite matrix, which provides enhanced electrical conductivity and prevents aggregation of Sn clusters during the lithiation/delithiation process. The gradual capacity fading in long‐term cycling is attributed to the observed increase in the size and the amount of metallic Sn clusters in the delithiated state, correlated to the reduced recovery of the SnP_x phase. This paper reveals the mechanism responsible for the highly reversible tin phosphides and provides insights for improving the capacity and cycle life of conversion and alloying materials.