Angel de Jesús Montes‐Luna
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Angel de Jesús Montes‐Luna has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
Griselda Castruita de León
CONACYT ‐ Centro de Investigación en Química Aplicada (CIQA) Saltillo Coahuila Mexico
2 shared publicationsNidia C. Fuentes López
Centro de Investigación en Química Aplicada (CIQA) Saltillo Coahuila Mexico
2 shared publicationsOdilia Pérez Camacho
Centro de Investigación en Química Aplicada (CIQA) Saltillo Coahuila Mexico
2 shared publicationsYibran A. Perera Mercado
ABSG Consulting Inc. (ABS Group), City Plaza Drive, Spring Houston Texas USA
2 shared publicationsBeatriz Liliana España‐Sánchez
Centro de Investigación y Desarrollo Tecnológico en Electroquímica CIDETEQ S. C., Parque Tecnológico Querétaro Querétaro Mexico
1 shared publicationClaudia Y. Yeverino Miranda
Centro de Investigación en Química Aplicada (CIQA) Saltillo Coahuila Mexico
1 shared publication
Latest Publications
- 28 November 2022
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 140 (6)
Effect of poly(ether block amide)‐graphene/ZnO membranes in mixed gas separation performance
In this work, graphene/zinc oxide nanoparticles (G/ZnO NPs) were synthesized by a metathesis‐assisted molten salt route. The methodology followed has outstanding features such as innovative, environmentally friendly, high‐yield, efficient, and straightforward. In addition, poly(ether‐block‐amide) (PEBA)‐based mixed matrix membranes (MMMs) filled with different amounts of G/ZnO NPs (up to 2%) were successfully prepared. Thermogravimetric analysis and X‐ray diffraction were performed to determine the thermal and structural properties of the pristine and MMMs. Scanning electron microscopy and electron dispersive spectroscopy were used for morphological studies and for identifying the as‐prepared G/ZnO NPs. Incorporating G/ZnO NPs (PEBA‐G/ZnO 2% 476 Barrer) provided benefits to the permeability properties and showed an increase of 37% concerning the polymeric membrane (318.06 Barrer). The gas separation performance improved by increasing the amount of G/ZnO NPs. A synergistic effect between PEBA properties and G/ZnO NPs led to enhanced CO2 selectivity for ternary mixed gas separation (CO2/CH4/N2). Selectivity of the MMMs showed an increase of 34% higher than to pristine (PEBA) membrane favoring the permeation of CO2. G/ZnO NPs can be potentially helpful in membranes applied in the CO2 mixed gas separation.
- 28 November 2022
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 140 (6)
Effect of poly(ether block amide)‐graphene/ZnO membranes in mixed gas separation performance
In this work, graphene/zinc oxide nanoparticles (G/ZnO NPs) were synthesized by a metathesis‐assisted molten salt route. The methodology followed has outstanding features such as innovative, environmentally friendly, high‐yield, efficient, and straightforward. In addition, poly(ether‐block‐amide) (PEBA)‐based mixed matrix membranes (MMMs) filled with different amounts of G/ZnO NPs (up to 2%) were successfully prepared. Thermogravimetric analysis and X‐ray diffraction were performed to determine the thermal and structural properties of the pristine and MMMs. Scanning electron microscopy and electron dispersive spectroscopy were used for morphological studies and for identifying the as‐prepared G/ZnO NPs. Incorporating G/ZnO NPs (PEBA‐G/ZnO 2% 476 Barrer) provided benefits to the permeability properties and showed an increase of 37% concerning the polymeric membrane (318.06 Barrer). The gas separation performance improved by increasing the amount of G/ZnO NPs. A synergistic effect between PEBA properties and G/ZnO NPs led to enhanced CO2 selectivity for ternary mixed gas separation (CO2/CH4/N2). Selectivity of the MMMs showed an increase of 34% higher than to pristine (PEBA) membrane favoring the permeation of CO2. G/ZnO NPs can be potentially helpful in membranes applied in the CO2 mixed gas separation.
- 6 October 2022
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 139 (47)
PPSU dual layer hollow fiber mixed matrix membranes with functionalized MWCNT for enhanced antifouling, salt and dye rejection in water treatment
Loose nanofiltration dual layer hollow fiber membranes (DLHFM) were prepared from polyphenylsulfone (PPSU) with a thin contact mixed matrix membrane (MMM) outer layer containing functionalized multiwalled carbon nanotubes (MWCNT). Two types of MWCNT were used; oxidized MWCNT (OMWCNT) and polyethyleneimine (PEI) functionalized MWCNT (PEI‐MWCNT). Z potential measurements indicate that OMWCNT and PEI‐MWCNT were negatively charged, being OMWCNT most negative. Na2SO4, MgSO4, and methylene blue (MB) rejection was enhanced due to OMWCNT and PEI‐MWCNT incorporation in DLHFM outer layer. Enhanced hydrophilicity and negatively charge mixed matrix DLHFM layer was the key factor for a better mixed matrix DLHFM performance. The best salt and MB rejection was found in those membranes prepared with (OMWCNT) followed by (PEI‐MWCNT) compared with neat PPSU membranes. An increase of 113% and 100% in Na2SO4 and MB rejection respectively was attained in DLHFM with 0.04 wt%, OMWCNT (relative to dope's weight) in comparison with the neat PPSU membrane. Antifouling test for bovine serum albumin (BSA) and MB showed better performance also for the mixed matrix DLHFM containing OMWCNT's. In antifouling tests, a 4.4% and 25% flux recovery increase for MB and BSA respectively was obtained in DLHFM with 0.04 wt% OMWCNT compared with the neat PPSU DLHFM.
- 6 October 2022
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 139 (47)
PPSU dual layer hollow fiber mixed matrix membranes with functionalized MWCNT for enhanced antifouling, salt and dye rejection in water treatment
Loose nanofiltration dual layer hollow fiber membranes (DLHFM) were prepared from polyphenylsulfone (PPSU) with a thin contact mixed matrix membrane (MMM) outer layer containing functionalized multiwalled carbon nanotubes (MWCNT). Two types of MWCNT were used; oxidized MWCNT (OMWCNT) and polyethyleneimine (PEI) functionalized MWCNT (PEI‐MWCNT). Z potential measurements indicate that OMWCNT and PEI‐MWCNT were negatively charged, being OMWCNT most negative. Na2SO4, MgSO4, and methylene blue (MB) rejection was enhanced due to OMWCNT and PEI‐MWCNT incorporation in DLHFM outer layer. Enhanced hydrophilicity and negatively charge mixed matrix DLHFM layer was the key factor for a better mixed matrix DLHFM performance. The best salt and MB rejection was found in those membranes prepared with (OMWCNT) followed by (PEI‐MWCNT) compared with neat PPSU membranes. An increase of 113% and 100% in Na2SO4 and MB rejection respectively was attained in DLHFM with 0.04 wt%, OMWCNT (relative to dope's weight) in comparison with the neat PPSU membrane. Antifouling test for bovine serum albumin (BSA) and MB showed better performance also for the mixed matrix DLHFM containing OMWCNT's. In antifouling tests, a 4.4% and 25% flux recovery increase for MB and BSA respectively was obtained in DLHFM with 0.04 wt% OMWCNT compared with the neat PPSU DLHFM.
- 3 November 2020
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 138 (14)
PBI/Clinoptilolite mixed‐matrix membranes for binary (N2/CH4) and ternary (CO2/N2/CH4) mixed gas separation
In this work, polybenzimidazole (PBI)‐based mixed matrix membranes (MMMs) with natural zeolite were prepared and their transport properties for binary (N2/CH4) and ternary (CO2/N2/CH4) mixed‐gas separation were studied. The MMMs, were prepared with PBI as polymeric matrix and Mexican natural zeolite clinoptilolite enriched with cations of Ca2+ as filler. The thermal properties analysis of the PBI and MMMs studied by differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) indicates that the MMMs membranes have Tg higher than 350°C and decomposition temperatures above 600°C compared with the pristine membranes. PBI membrane and MMMs were analyzed by X‐Ray Diffraction (XRD) and the diffraction patterns showed the zeolite signals combine with the amorphous dome from the polymeric matrix. In addition, the perm‐selectivity properties of the polymeric membranes and MMMs were tested with binary (N2/CH4; 10/90 mol%) and ternary (CO2/N2/CH4; 5/10/85 mol%) gas mixtures at different pressure rates (50, 150 and 300 psi). The perm‐selectivity properties of the MMMs membranes show an improvement in their values about 30% higher compared to the PBI polymeric membranes, favoring the permeation of CO2 and N2.
- 3 November 2020
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 138 (14)
PBI/Clinoptilolite mixed‐matrix membranes for binary (N2/CH4) and ternary (CO2/N2/CH4) mixed gas separation
In this work, polybenzimidazole (PBI)‐based mixed matrix membranes (MMMs) with natural zeolite were prepared and their transport properties for binary (N2/CH4) and ternary (CO2/N2/CH4) mixed‐gas separation were studied. The MMMs, were prepared with PBI as polymeric matrix and Mexican natural zeolite clinoptilolite enriched with cations of Ca2+ as filler. The thermal properties analysis of the PBI and MMMs studied by differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) indicates that the MMMs membranes have Tg higher than 350°C and decomposition temperatures above 600°C compared with the pristine membranes. PBI membrane and MMMs were analyzed by X‐Ray Diffraction (XRD) and the diffraction patterns showed the zeolite signals combine with the amorphous dome from the polymeric matrix. In addition, the perm‐selectivity properties of the polymeric membranes and MMMs were tested with binary (N2/CH4; 10/90 mol%) and ternary (CO2/N2/CH4; 5/10/85 mol%) gas mixtures at different pressure rates (50, 150 and 300 psi). The perm‐selectivity properties of the MMMs membranes show an improvement in their values about 30% higher compared to the PBI polymeric membranes, favoring the permeation of CO2 and N2.