Rafael Rodríguez-Mosqueda
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Rafael Rodríguez-Mosqueda has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Eduard Augustinus Bramer
Department of Thermal Engineering, Faculty of Engineering Technology, University of Twente, Drienerlolaan 5, 7500 AE Enschede, The Netherlands
1 shared publicationGerrit Brem
Department of Thermal Engineering, Faculty of Engineering Technology, University of Twente, Drienerlolaan 5, 7500 AE Enschede, The Netherlands
1 shared publicationHeriberto Pfeiffer
Instituto de Investigaciones en Materiales, Universidad Nacional Autónoma de México, Circuito exterior s/n, Cd. Universitaria, Del. Coyoacán, México DF, CP 04510 Mexico
1 shared publication- Heriberto Pfeiffer
Instituto de Investigaciones en Materiales, Universidad Nacional Autónoma de México, Circuito Exterior s/n, Cd. Universitaria, Del Coyoacán, Ciudad de Mexico CP 04510, Mexico
1 shared publication Timo Roestenberg
Department of Thermal Engineering, Faculty of Engineering Technology, University of Twente, Drienerlolaan 5, 7500 AE Enschede, The Netherlands
1 shared publication
Latest Publications
- Open Access
- 28 February 2018
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 57 (10) , 3628-3638
Parametrical Study on CO2 Capture from Ambient Air Using Hydrated K2CO3 Supported on an Activated Carbon Honeycomb
Potassium carbonate is a highly hygroscopic salt and this aspect becomes important for CO2 capture from ambient air. Moreover, CO2 capture from ambient air requires adsorbents with a very low pressure drop. In the present work an activated carbon honeycomb monolith was coated with K2CO3 and it was treated with moist N2 to hydrate it. Its CO2 capture capacity was studied as function of the temperature, the water content of the air and the air flow rate, following a factorial design of experiments. It was found that the water vapor content in the air had the largest influence on the CO2 adsorption capacity. Moreover, the deliquescent character of K2CO3 led to the formation of an aqueous solution in the pores of the carrier, which regulated the temperature of the CO2 adsorption. The transition between the anhydrous and the hydrated forms of potassium carbonate was studied by means of FT-IR spectroscopy. It can be concluded that hydrated potassium carbonate is a promising and cheap alternative for CO2 capture from ambient air for the production of CO2-enriched air or for the synthesis of solar fuels, such as methanol.
- 28 February 2018
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 57 (10) , 3628-3638
Open AccessParametrical Study on CO2 Capture from Ambient Air Using Hydrated K2CO3 Supported on an Activated Carbon Honeycomb
Potassium carbonate is a highly hygroscopic salt and this aspect becomes important for CO2 capture from ambient air. Moreover, CO2 capture from ambient air requires adsorbents with a very low pressure drop. In the present work an activated carbon honeycomb monolith was coated with K2CO3 and it was treated with moist N2 to hydrate it. Its CO2 capture capacity was studied as function of the temperature, the water content of the air and the air flow rate, following a factorial design of experiments. It was found that the water vapor content in the air had the largest influence on the CO2 adsorption capacity. Moreover, the deliquescent character of K2CO3 led to the formation of an aqueous solution in the pores of the carrier, which regulated the temperature of the CO2 adsorption. The transition between the anhydrous and the hydrated forms of potassium carbonate was studied by means of FT-IR spectroscopy. It can be concluded that hydrated potassium carbonate is a promising and cheap alternative for CO2 capture from ambient air for the production of CO2-enriched air or for the synthesis of solar fuels, such as methanol.
- 10 June 2013
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 117 (26) , 13452-13461
High CO2Capture in Sodium Metasilicate (Na2SiO3) at Low Temperatures (30–60 °C) through the CO2–H2O Chemisorption Process
- 10 June 2013
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 117 (26) , 13452-13461
High CO2Capture in Sodium Metasilicate (Na2SiO3) at Low Temperatures (30–60 °C) through the CO2–H2O Chemisorption Process
- 17 March 2010
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 114 (13) , 4535-4541
Thermokinetic Analysis of the CO2 Chemisorption on Li4SiO4 by Using Different Gas Flow Rates and Particle Sizes
Lithium orthosilicate (Li4SiO4) was synthesized by solid-state reaction and then its CO2 chemisorption capacity was evaluated as a function of the CO2 flow rate and particle size. Initially, a Li4SiO4 sample, with a total surface area of 0.4 m2/g, was used to analyze the CO2 chemisorption, varying the CO2 flow between 30 and 200 mL/min. Results showed that CO2 flows modify the kinetic regime from which CO2 capture is controlled. In the first moments and at low CO2 flows, the CO2 capture is controlled by the CO2 diffusion through the gas-film system, whereas at high CO2 flows it is controlled by the CO2 chemisorption reaction rate. Later, at larger times, once the carbonate−oxide external shell has been produced the whole process depends on the CO2 chemisorption kinetically controlled by the lithium diffusion process, independently of the CO2 flow. Additionally, thermokinetic analyses suggest that temperature induces a CO2 particle surface saturation, due to an increment of CO2 diffusion through the gas-film interface. To elucidate this hypothesis, the Li4SiO4 sample was pulverized to increase the surface area (1.5 m2/g). Results showed that increasing the surface particle area, the saturation was not reached. Finally, the enthalpy activation (ΔH‡) values were estimated for the two CO2 chemisorption processes, the CO2 direct chemisorption produced at the Li4SiO4 surface, and the CO2 chemisorption kinetically controlled by the lithium diffusion, once the carbonate−oxide shell has been produced.
- 17 March 2010
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 114 (13) , 4535-4541
Thermokinetic Analysis of the CO2 Chemisorption on Li4SiO4 by Using Different Gas Flow Rates and Particle Sizes
Lithium orthosilicate (Li4SiO4) was synthesized by solid-state reaction and then its CO2 chemisorption capacity was evaluated as a function of the CO2 flow rate and particle size. Initially, a Li4SiO4 sample, with a total surface area of 0.4 m2/g, was used to analyze the CO2 chemisorption, varying the CO2 flow between 30 and 200 mL/min. Results showed that CO2 flows modify the kinetic regime from which CO2 capture is controlled. In the first moments and at low CO2 flows, the CO2 capture is controlled by the CO2 diffusion through the gas-film system, whereas at high CO2 flows it is controlled by the CO2 chemisorption reaction rate. Later, at larger times, once the carbonate−oxide external shell has been produced the whole process depends on the CO2 chemisorption kinetically controlled by the lithium diffusion process, independently of the CO2 flow. Additionally, thermokinetic analyses suggest that temperature induces a CO2 particle surface saturation, due to an increment of CO2 diffusion through the gas-film interface. To elucidate this hypothesis, the Li4SiO4 sample was pulverized to increase the surface area (1.5 m2/g). Results showed that increasing the surface particle area, the saturation was not reached. Finally, the enthalpy activation (ΔH‡) values were estimated for the two CO2 chemisorption processes, the CO2 direct chemisorption produced at the Li4SiO4 surface, and the CO2 chemisorption kinetically controlled by the lithium diffusion, once the carbonate−oxide shell has been produced.