JLJin Gyu Lim

Jin Gyu Lim

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jin Gyu Lim has a total of 56 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Two-Tier Low-Complexity Linearization Architecture for Fully Digital mMIMO Transmitters

    by Jin Gyu Lim, Ahmed Ben Ayed, Slim Boumaiza

    This letter presents a two-tier, low-complexity linearization framework for fully digital multiple-input multiple-output (MIMO) transmitters that jointly minimizes total radiated power–adjacent channel power ratio (TRP-ACPR) and user error vector magnitude (EVM). The proposed architecture consists of: 1) a single-input single-output (SISO) digital predistorter (DPD), trained using a feedback signal processed through an in-band notch filter to isolate and suppress out-of-band distortion in each channel and 2) a low-order linear MIMO pre-equalizer placed before the precoder to compensate for in-band distortion at the user receivers. The two stages are jointly trained, enabling simultaneous minimization of TRP-ACPR and EVM without increasing precoder complexity or relying on multiinput or high-order nonlinear DPD models. Experimental results from a 16-channel fully digital transmitter operating at 3.5 GHz in a two-user line-of-sight (LoS) scenario show that the pre-equalizer reduces user EVM to 0.7%, while a 13-coefficient per-antenna SISO-DPD improves TRP-ACPR from −33 to −43dB and improves ACPR at users 1 and 2 from −36.5 to −49.6 dB and from −37 to −51.2 dB, respectively.

  • Active Calibration Approach Addressing Antenna Mutual Coupling and Power Amplifier Output Mismatch in Fully Digital MIMO Transmitters

    by Hoda Barkhordar-Pour, Jin Gyu Lim, Ahmed Ben Ayed, Patrick Mitran, Slim Boumaiza

    This article introduces an active calibration scheme tailored for fully digital multiple-input multiple-output (MIMO) transmitters, a key step toward ensuring channel reciprocity. The theoretical analysis starts by examining the influence of antenna mutual coupling and power amplifier (PA) output impedances on the MIMO transmitter and channel reciprocity. This analysis highlights the significant impact of the inherently poor output matching, exhibited in high-efficiency PAs, exacerbating the effects of antenna mutual coupling on channel reciprocity. Consequently, an active calibration scheme is formulated to concurrently characterize and compensate for the nonflat responses of all radio frequency (RF) chains in the fully digital MIMO transmitter. To validate the proposed scheme, a proof-of-concept experiment is conducted using a custom-built 16-chain fully digital MIMO system, driven with 200-MHz orthogonal frequency-division multiplexing (OFDM) signals at 3.5-GHz center frequency. Measurement results demonstrate the efficacy of the calibration scheme in mitigating the impact of antenna coupling and PA output mismatch on channel reciprocity. The root normalized mean square error (RNMSE) after calibration is reduced from ${22\%}$ to ${1\%}$ .


  • Real-Time FPGA-Based Implementation of Digital Predistorters for Fully Digital MIMO Transmitters

    by Hoda Barkhordar-Pour, Jin Gyu Lim, Mohammed Almoneer, Patrick Mitran, Slim Boumaiza

    This paper presents the hardware implementation of a real-time digital predistorter (DPD) for fully digital multiple-input multiple-output (MIMO) transmitters. The predistorter is comprised of a dual-input single-output (DISO) DPD module for each chain and a shared crosstalk and mismatch (CTMM) module that estimates the reflected wave back into each PA. The proposed real-time DPD is a DISO piece-wise linear (PWL) model implemented on a field-programmable gate array (FPGA) and achieves a linearization bandwidth up to 1.2 GHz at a clock rate of 300 MHz. The real-time DPD engine is demonstrated on a four-chain MIMO testbed and validated against a PC-based DPD engine. The FPGA-based DISO DPD performs within 1 dB ACPR of the PC-based implementation and achieves a similar root-normalized-mean-square error (RNMSE) of 1.59%.


  • On the Viability of Using a Subset of Transmitter- Observation Receivers for Training a Common DPD in Fully Digital MIMO Transmitters

    by Jin Gyu Lim, Hoda Barkhordar-Pour, Ahmed Ben Ayed, Patrick Mitran, Slim Boumaiza

    This letter lays the foundation for reducing the required number of transmitter-observation receivers (TORs) for training digital predistortion (DPD) in fully digital massive multiple-input, multiple-output (MIMO) transmitters. Specifically, it investigates the viability of applying the same, common set of DPD coefficients to linearize all RF chains in fully digital massive MIMO transmitters. First, it is shown that if all RF chains are operated at the same output power, the common set of DPD coefficients can be found by simply averaging the coefficients obtained by training each RF chain on its own. This suggests that only a few chains may be needed for training provided the chains are a representative sample. Experimental results are then conducted where one and three chains are used for training. It is found that when training for one chain, significant variations in normalized mean square error (NMSE) and adjacent channel power ratio (ACPR) of up to 9 dB across the chains are realized. For training with three chains, the common set of DPD coefficients can reduce the variation to 1–2 dB. Finally, after over-the-air (OTA) combining, excellent linearization performance is found for three chains.


  • Massive MIMO Precoding Methods That Minimize the Variation in Average Power and Active Impedance With Channel Conditions

    by Mohammed Almoneer, Jin Gyu Lim, Hang Yu, Patrick Mitran, Slim Boumaiza

    This article investigates the impact of precoding on the performance of massive multiple-input multiple-output (mMIMO) transmitters exhibiting nonnegligible antenna crosstalk. For this, a new metric, called the average active impedance, is introduced to quantify the extent of load modulation as a function of the antenna S-parameters and the employed precoding. The new metric is then used to investigate the load modulation under conventional precoding schemes. It is shown that these precoders yield large disparities in average-power levels across the radio frequency (RF) chains, which results in substantial performance variations with channel conditions. Based on this investigation, we propose three new precoding schemes that yield equal average-power (EP) levels across all RF chains, independent of the channel conditions. Numerical simulations and experiments conducted on an mMIMO transmitter prototype confirmed that the proposed schemes improve the transmitter’s resilience to the variation in channel conditions.


  • Open Access

    Space QUEST mission proposal: experimentally testing decoherence due to gravity

    by Siddarth Koduru Joshi, Jacques Pienaar, Timothy C Ralph, Luigi Cacciapuoti, Will McCutcheon, John Rarity, Dirk Giggenbach, Jin Gyu Lim, Vadim Makarov, Ivette Fuentes, et al.


  • Open Access

    Laser annealing heals radiation damage in avalanche photodiodes

    by Jin Gyu Lim, Elena Anisimova, Brendon L Higgins, Jean-Philippe Bourgoin, Thomas Jennewein, Vadim Makarov

    Avalanche photodiodes (APDs) are a practical option for space-based quantum communications requiring single-photon detection. However, radiation damage to APDs significantly increases their dark count rates and thus reduces their useful lifetimes in orbit. We show that high-power laser annealing of irradiated APDs of three different models (Excelitas C30902SH, Excelitas SLiK, and Laser Components SAP500S2) heals the radiation damage and several APDs are restored to typical pre-radiation dark count rates. Of nine samples we test, six APDs were thermally annealed in a previous experiment as another solution to mitigate the radiation damage. Laser annealing reduces the dark count rates further in all samples with the maximum dark count rate reduction factor varying between 5.3 and 758 when operating at − 80 ∘ C ${-}80^{\circ}\mathrm{C}$ . This indicates that laser annealing is a more effective method than thermal annealing. The illumination power to reach these reduction factors ranges from 0.8 to 1.6 W. Other photon detection characteristics, such as photon detection efficiency, timing jitter, and afterpulsing probability, fluctuate but the overall performance of quantum communications should be largely unaffected by these variations. These results herald a promising method to extend the lifetime of a quantum satellite equipped with APDs.