Zhuojun Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zhuojun Li has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Luiza Cintra Campos
Department of Civil, Environmental and Geomatic Engineering, University College London, London, UK
3 shared publications - Zhengxiao Guo
HKU‐CAS Joint Laboratory on New Materials & Department of Chemistry The University of Hong Kong Hong Kong SAR P. R. China
2 shared publications - Jong Kyu Kim
Department of Civil Engineering, Kyungnam University, Changwon, Republic of Korea
1 shared publication - Juntao Li
Department of Chemical Engineering, University College London, London, UK
1 shared publication - Suseeladevi Mayadevi
Chemical Engineering and Process Development Division, National Chemical Laboratory, Pune 411 008, Maharashtra, India
1 shared publication - Ulises Javier Jáuregui-Haza
Área de Ciencias Básicas y Ambientales, Instituto Tecnológico de Santo Domingo (INTEC), Ave. de los Próceres 49, Santo Domingo 10602, Dominican Republic
1 shared publication
Latest Publications
- Open Access
- 19 March 2020
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 6 (5) , 1432-1444
Investigation of metaldehyde removal by powdered activated carbon from different water samples
Applying PAC to the water sample collected after static flocculation (position 2) gave the best result regarding the removal of metaldehyde.
- 19 March 2020
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 6 (5) , 1432-1444
Open AccessInvestigation of metaldehyde removal by powdered activated carbon from different water samples
Applying PAC to the water sample collected after static flocculation (position 2) gave the best result regarding the removal of metaldehyde.
- Open Access
- 19 December 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 9 (1) , 11-22
The impact of humic acid on metaldehyde adsorption onto powdered activated carbon in aqueous solution
Metaldehyde has been detected in surface water and drinking water in the UK, exceeding the EU and UK standard of 0.1 μg L−1. The presence of natural organic matter (NOM) is considered to affect the removal efficiency of metaldehyde using traditional treatment methods such as adsorption by granular activated carbon. This paper selected humic acid (HA) to represent NOM and investigated the single and binary adsorption systems of metaldehyde and HA by powdered activated carbon (PAC). Metaldehyde was effectively removed by PAC in both systems. Since the percentage removal of metaldehyde was only 3% lower in the binary adsorption system, HA was therefore not considered as a significant compound competing with metaldehyde for adsorption sites on PAC. An adsorption equilibrium study and kinetic study for metaldehyde in a single system suggested that the Langmuir isotherm and the pseudo-second order kinetic model were more suitable in this case than the Freundlich isotherm and the pseudo-first order kinetic model. The two models revealed that the maximum adsorption capacity (qm) of metaldehyde by PAC was 28.3 mg g−1 and the adsorption rate (k2) was 0.16 g mg−1 min−1. The effect of pH of metaldehyde solution was also investigated in a single system. Higher percentage removal of metaldehyde was found under alkaline conditions. In contrast to metaldehyde, HA was not effectively and efficiently removed by PAC in both systems, even with higher PAC dosages and longer contact times. Hence, the microporous and mesoporous PAC was suitable for removing metaldehyde even in the binary system.
- 19 December 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 9 (1) , 11-22
Open AccessThe impact of humic acid on metaldehyde adsorption onto powdered activated carbon in aqueous solution
Metaldehyde has been detected in surface water and drinking water in the UK, exceeding the EU and UK standard of 0.1 μg L−1. The presence of natural organic matter (NOM) is considered to affect the removal efficiency of metaldehyde using traditional treatment methods such as adsorption by granular activated carbon. This paper selected humic acid (HA) to represent NOM and investigated the single and binary adsorption systems of metaldehyde and HA by powdered activated carbon (PAC). Metaldehyde was effectively removed by PAC in both systems. Since the percentage removal of metaldehyde was only 3% lower in the binary adsorption system, HA was therefore not considered as a significant compound competing with metaldehyde for adsorption sites on PAC. An adsorption equilibrium study and kinetic study for metaldehyde in a single system suggested that the Langmuir isotherm and the pseudo-second order kinetic model were more suitable in this case than the Freundlich isotherm and the pseudo-first order kinetic model. The two models revealed that the maximum adsorption capacity (qm) of metaldehyde by PAC was 28.3 mg g−1 and the adsorption rate (k2) was 0.16 g mg−1 min−1. The effect of pH of metaldehyde solution was also investigated in a single system. Higher percentage removal of metaldehyde was found under alkaline conditions. In contrast to metaldehyde, HA was not effectively and efficiently removed by PAC in both systems, even with higher PAC dosages and longer contact times. Hence, the microporous and mesoporous PAC was suitable for removing metaldehyde even in the binary system.
- Open Access
- 14 June 2017
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (21) , 17861-17873
Degradation of metaldehyde in water by nanoparticle catalysts and powdered activated carbon
Abstract Metaldehyde, an organic pesticide widely used in the UK, has been detected in drinking water in the UK with a low concentration (−1) which is still above the European and UK standard requirements. This paper investigates the efficiency of four materials: powdered activated carbon (PAC) and carbon-doped titanium dioxide nanocatalyst with different concentrations of carbon (C-1.5, C-40, and C-80) for metaldehyde removal from aqueous solutions by adsorption and oxidation via photocatalysis. PAC was found to be the most effective material which showed almost over 90% removal. Adsorption data were well fitted to the Langmuir isotherm model, giving a q m (maximum/saturation adsorption capacity) value of 32.258 mg g−1 and a K L (Langmuir constant) value of 2.013 L mg−1. In terms of kinetic study, adsorption of metaldehyde by PAC fitted well with a pseudo-second-order equation, giving the adsorption rate constant k 2 value of 0.023 g mg−1 min−1, implying rapid adsorption. The nanocatalysts were much less effective in oxidising metaldehyde than PAC with the same metaldehyde concentration and 0.2 g L−1 loading concentration of materials under UV light; the maximum removal achieved by carbon-doped titanium dioxide (C-1.5) nanocatalyst was around 15% for a 7.5 ppm metaldehyde solution. ᅟ
- 14 June 2017
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (21) , 17861-17873
Open AccessDegradation of metaldehyde in water by nanoparticle catalysts and powdered activated carbon
Abstract Metaldehyde, an organic pesticide widely used in the UK, has been detected in drinking water in the UK with a low concentration (−1) which is still above the European and UK standard requirements. This paper investigates the efficiency of four materials: powdered activated carbon (PAC) and carbon-doped titanium dioxide nanocatalyst with different concentrations of carbon (C-1.5, C-40, and C-80) for metaldehyde removal from aqueous solutions by adsorption and oxidation via photocatalysis. PAC was found to be the most effective material which showed almost over 90% removal. Adsorption data were well fitted to the Langmuir isotherm model, giving a q m (maximum/saturation adsorption capacity) value of 32.258 mg g−1 and a K L (Langmuir constant) value of 2.013 L mg−1. In terms of kinetic study, adsorption of metaldehyde by PAC fitted well with a pseudo-second-order equation, giving the adsorption rate constant k 2 value of 0.023 g mg−1 min−1, implying rapid adsorption. The nanocatalysts were much less effective in oxidising metaldehyde than PAC with the same metaldehyde concentration and 0.2 g L−1 loading concentration of materials under UV light; the maximum removal achieved by carbon-doped titanium dioxide (C-1.5) nanocatalyst was around 15% for a 7.5 ppm metaldehyde solution. ᅟ