Evripidis Lois
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Evripidis Lois has a total of 83 co-authors. Here are the top co-authors by number of shared publications:
- Fanourios Zannikos
National Technical University of Athens
29 shared publications - Dimitrios Karonis
Laboratory of Fuels and Lubricants Technology, School of Chemical Engineering, National Technical University of Athens, Iroon Polytechniou 9, 15780 Athens, Greece
22 shared publications S. Stournas
National Technical University of Athens
19 shared publications- Stamatios Kalligeros
Fuels and Lubricants Laboratory, Hellenic Naval Academy, Piraeus, 18539 Athens, Greece
18 shared publications G. Anastopoulos
Fuels and Lubricants Laboratory, School of Chemical Engineering, National Technical Univ. of Athens 1 , 9 Iroon Polytechniou, Athens157 80, Greece
14 shared publicationsA. Serdari
National Technical University of Athens, Department of Chemical Engineering, Laboratory of Fuels and Lubricants, Iroon polytechniou 9, Athens 157 80, Greece
7 shared publications
Latest Publications
- 1 January 2018
- Published by Elsevier in Materials Today: Proceedings
- Vol. 5 (14) , 27563-27571
Investigation of the Effectiveness of Monoethanolamides as Low Sulfur Marine Fuel Lubricity Additives
- 1 January 2018
- Published by Elsevier in Materials Today: Proceedings
- Vol. 5 (14) , 27563-27571
Investigation of the Effectiveness of Monoethanolamides as Low Sulfur Marine Fuel Lubricity Additives
- 1 November 2015
- Published by Elsevier in Industrial Crops and Products
- Vol. 75, 43-50
Renewable fuels and lubricants from Lunaria annua L.
- 1 November 2015
- Published by Elsevier in Industrial Crops and Products
- Vol. 75, 43-50
Renewable fuels and lubricants from Lunaria annua L.
- 1 September 2015
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Oxidation Stability Study of Biobased Lubricant Basestocks
One of the concerns for biolubricants is the improvement of their oxidation resistance. In this paper the oxidative behavior of seven different types of biobased lubricants basestocks is examined. The aim was to study their relative oxidation stability and also to investigate their response to various antioxidants. The renewable lubricants were treated with four antioxidant additives at a concentration of 0.5% wt. and a comparative assessments of the latters' effectiveness in suppressing the oxidation rate was carried out. Alterations in the acid value were examined as well as relative changes of the oxidized samples by FTIR spectroscopy. The oxidation stability was assessed by employing a Rapid Small Scale Oxidation Test (RSSOT) apparatus according to the accelerated oxidation stability standard method ASTM D7545/EN16091. RSSOT is a relatively new method and thus the behaviour of biobased lubricants and antioxidant agents in this accelerated method has not been thoroughly examined.
- 1 September 2015
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Oxidation Stability Study of Biobased Lubricant Basestocks
One of the concerns for biolubricants is the improvement of their oxidation resistance. In this paper the oxidative behavior of seven different types of biobased lubricants basestocks is examined. The aim was to study their relative oxidation stability and also to investigate their response to various antioxidants. The renewable lubricants were treated with four antioxidant additives at a concentration of 0.5% wt. and a comparative assessments of the latters' effectiveness in suppressing the oxidation rate was carried out. Alterations in the acid value were examined as well as relative changes of the oxidized samples by FTIR spectroscopy. The oxidation stability was assessed by employing a Rapid Small Scale Oxidation Test (RSSOT) apparatus according to the accelerated oxidation stability standard method ASTM D7545/EN16091. RSSOT is a relatively new method and thus the behaviour of biobased lubricants and antioxidant agents in this accelerated method has not been thoroughly examined.
- 1 June 2015
- Published by American Society of Civil Engineers (ASCE) in Journal of Energy Engineering
- Vol. 141 (2)
Impact of Biodiesel Addition on Distillation Characteristics and Cetane Index of Diesel Fuels
- 1 June 2015
- Published by American Society of Civil Engineers (ASCE) in Journal of Energy Engineering
- Vol. 141 (2)
Impact of Biodiesel Addition on Distillation Characteristics and Cetane Index of Diesel Fuels
- 13 October 2014
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Assessment of the Oxidation Stability of Biodiesel Fuel using the Rancimat and the RSSOT methods
For many years Rancimat was the only standardized method for measuring the oxidation stability of FAME and FAME/diesel blends. However this method is not applicable to pure conventional petroleum products and so the effect of FAME on diesel fuel stability could not be evaluated directly. Recently a Rapid Small Scale Oxidation Test (RSSOT) that covers the determination of the stability of biofuels and petroleum products was developed and standardized. In this study the oxidation stability of seven different types of FAMEs was assessed, either neat or blended with three types of ULSD fuel, by employing both the Rancimat and the RSSOT accelerated oxidation methods. The determinations from either test were analyzed and a comparative assessment of these two method was carried out.
- 13 October 2014
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Assessment of the Oxidation Stability of Biodiesel Fuel using the Rancimat and the RSSOT methods
For many years Rancimat was the only standardized method for measuring the oxidation stability of FAME and FAME/diesel blends. However this method is not applicable to pure conventional petroleum products and so the effect of FAME on diesel fuel stability could not be evaluated directly. Recently a Rapid Small Scale Oxidation Test (RSSOT) that covers the determination of the stability of biofuels and petroleum products was developed and standardized. In this study the oxidation stability of seven different types of FAMEs was assessed, either neat or blended with three types of ULSD fuel, by employing both the Rancimat and the RSSOT accelerated oxidation methods. The determinations from either test were analyzed and a comparative assessment of these two method was carried out.
- 13 October 2014
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Monoglyceride Content in Marine Diesel Fuel-A Guide
Problems with the low-temperature operability performance of biodiesel in blends with petroleum diesel are infrequent, but continue to limit the use of biodiesel during winter months. A troubling aspect of this problem is that in some cases precipitates above the blend Cloud Point (CP) have been detected and have led to plugging of fuel filters and subsequent engine stalling, as well as plugging of fuel dispenser filters. Many researchers found that the saturated monoglyceride content was a main component of the material that was found on plugged fuel filters, as well as traces of Saturated DiGlycerides (SDG), were also present on the plugged fuel filters.This is the reason which forced the organization of standardization to suggest a procedure in order to predict the content of the Saturated MonoGlycerides (SMG) even with uncertainty which can vary from −50% to +50%. The model which was used will be the same as that which was introduced in the Annex C of EN 14214+A1:2013. The model is based on the assumption that saturated fatty esters, saturated fatty acids and saturated monoglycerides are present in the same concentration levels in the FAME. The present work will give a guide with the prediction of the saturate monoglyceride in the distilled marine diesel fuel according to ISO 8217 depending on the operating climate requirements. The target is to provide a guide to understand the difference between the various climate conditions with respect to marine diesels potential cold flow performance.
- 13 October 2014
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Monoglyceride Content in Marine Diesel Fuel-A Guide
Problems with the low-temperature operability performance of biodiesel in blends with petroleum diesel are infrequent, but continue to limit the use of biodiesel during winter months. A troubling aspect of this problem is that in some cases precipitates above the blend Cloud Point (CP) have been detected and have led to plugging of fuel filters and subsequent engine stalling, as well as plugging of fuel dispenser filters. Many researchers found that the saturated monoglyceride content was a main component of the material that was found on plugged fuel filters, as well as traces of Saturated DiGlycerides (SDG), were also present on the plugged fuel filters.This is the reason which forced the organization of standardization to suggest a procedure in order to predict the content of the Saturated MonoGlycerides (SMG) even with uncertainty which can vary from −50% to +50%. The model which was used will be the same as that which was introduced in the Annex C of EN 14214+A1:2013. The model is based on the assumption that saturated fatty esters, saturated fatty acids and saturated monoglycerides are present in the same concentration levels in the FAME. The present work will give a guide with the prediction of the saturate monoglyceride in the distilled marine diesel fuel according to ISO 8217 depending on the operating climate requirements. The target is to provide a guide to understand the difference between the various climate conditions with respect to marine diesels potential cold flow performance.
- 1 September 2014
- Published by American Society of Civil Engineers (ASCE) in Journal of Energy Engineering
- Vol. 140 (3)
Vapor Pressure and Octane Numbers of Ternary Gasoline–Ethanol–ETBE Blends
- 1 September 2014
- Published by American Society of Civil Engineers (ASCE) in Journal of Energy Engineering
- Vol. 140 (3)
Vapor Pressure and Octane Numbers of Ternary Gasoline–Ethanol–ETBE Blends
- 1 June 2014
- Published by Elsevier in Fuel Processing Technology
- Vol. 122, 107-119
Lubricity assessment of gasoline fuels
- 1 June 2014
- Published by Elsevier in Fuel Processing Technology
- Vol. 122, 107-119
Lubricity assessment of gasoline fuels
- 14 October 2013
- Published by SAE International in SAE International Journal of Fuels and Lubricants
- Vol. 06 (3) , 863-869
Investigating “De Minimis” Level of Fatty Acid Methyl Esters (FAME) in Distillate Marine Gas Oil
According to the existing maritime regulation, the marine diesel equipment will be necessary to operate with low sulfur marine fuels. Low Sulfur Middle Gas Oils (MGOs) often have a viscosity that is lower than that of Heavy Fuel Oil (HFO). The problems in diesel engines are mainly related to high pressure fuel pumps that depend on the fuel oil for their lubrication. A solution to that problem probably will be the addition of Fatty Acid Methyl Esters (FAME) as an additive to the fuel. On the other hand, for the purposes of International Standard ISO 8217:2012 in the case of distillate fuels it is recommended that “de minimis” level of FAME is recommended. “De minimis” level is determined approximately as the 0.1% volume of the fuel.In this study, Distillate Marine Diesel Oil with good lubricity performance was used blended with FAME fuel, according to national and European Standard (ELOT EN 14214), was used as an additive. The FAME was stored for three months period in a plastic container. Then mixture with concentrations of 0.5%, 1.0%, 2.0%, 3.0%, 4.0% and 5.0% by volume were used.The obtained results shown that all the mixtures are within the specification limits but the tribological measurements, which were carried out with an applied load of 600 g using the High Frequency Reciprocating Rig (HFRR) with test duration for each test 150 min., revealed an increased wear. This happened because after the storage period the water content of the FAME increased significant.
- 14 October 2013
- Published by SAE International in SAE International Journal of Fuels and Lubricants
- Vol. 06 (3) , 863-869
Investigating “De Minimis” Level of Fatty Acid Methyl Esters (FAME) in Distillate Marine Gas Oil
According to the existing maritime regulation, the marine diesel equipment will be necessary to operate with low sulfur marine fuels. Low Sulfur Middle Gas Oils (MGOs) often have a viscosity that is lower than that of Heavy Fuel Oil (HFO). The problems in diesel engines are mainly related to high pressure fuel pumps that depend on the fuel oil for their lubrication. A solution to that problem probably will be the addition of Fatty Acid Methyl Esters (FAME) as an additive to the fuel. On the other hand, for the purposes of International Standard ISO 8217:2012 in the case of distillate fuels it is recommended that “de minimis” level of FAME is recommended. “De minimis” level is determined approximately as the 0.1% volume of the fuel.In this study, Distillate Marine Diesel Oil with good lubricity performance was used blended with FAME fuel, according to national and European Standard (ELOT EN 14214), was used as an additive. The FAME was stored for three months period in a plastic container. Then mixture with concentrations of 0.5%, 1.0%, 2.0%, 3.0%, 4.0% and 5.0% by volume were used.The obtained results shown that all the mixtures are within the specification limits but the tribological measurements, which were carried out with an applied load of 600 g using the High Frequency Reciprocating Rig (HFRR) with test duration for each test 150 min., revealed an increased wear. This happened because after the storage period the water content of the FAME increased significant.