QLQi Liu

Qi Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Qi Liu has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Monitoring and correction of the stress in an anchor bolt based on Pulse Pre‐Pumped Brillouin Optical Time Domain Analysis

    by Qi Liu, Jing Chai, Shaojie Chen, Dingding Zhang, Qiang Yuan, Shuai Wang

    Bolt is an important connection in underground construction and monitoring its stress characteristics is essential to evaluate the effectiveness of bolt. The strain information collected along a rock bolt reveals the long‐term movement characteristics of rock mass, which greatly helps toward disaster prevention and risk warning. Grooving on the surface of a bolt and embedding an optical fiber is one of the main methods for monitoring the anchorage performance and stress distribution around the bolt in underground engineering. In this study, Pulse Pre‐Pumped Brillouin Optical Time Domain Analysis (PPP‐BOTDA) technology is used to evaluate the stress, axial force, and shear stress distribution of the bolt under tensile load for different types (grooved and nongrooved) of bolts embedded in concrete with resin as anchoring agent. The results show that the PPP‐BOTDA sensor can be used to monitor the stress state of the bolt embedded in concrete with resin as anchoring agent when the bolt is subjected to a tensile force. However, the apparent stress value measured in this way is not the actual stress value of the bolt, but is an increased value caused due to the groove. The closer to the exposed end of the bolt, the greater is the deviation between the apparent stress value and the actual stress value of the bolt. Based on the monitoring results from this experimental study, a stress reduction calculation method is proposed, which can change the measured value into the actual stress of the bolt.


  • Open Access

    Assessing the Difference in Measuring Bolt Stress: A Comparison of Two Optical Fiber Sensing Techniques

    by Jing Chai, Qi Liu, Jinxuan Liu, Guihua Zhang, Dingding Zhang, Fengqi Qiu

    Monitoring the load level of the rock bolts is of great importance for assessing risk. Based on the mechanical transmission mechanism of grouting bolts, the bolt pull-out test was carried out in lab. The performance of the bolt under pull-out loading was measured using the pulse-pre-pump Brillouin optical time domain analysis (PPP-BOTDA) and fiber Bragg grating (FBG) sensing technologies. The distribution characteristic of axial stress along the bolt was analysed in combination with the measurements obtained by the two sensing technologies. The relative standard deviation for repeatability errors in the determination and the setting time of resin grout was investigated. The results show that the distribution of axial stress is nonuniform along the anchorage section. The maximum value of axial stress on the bolt is closed to the pull-out side. The relative standard deviation for repeatability errors obtained by PPP-BOTDA is less than that obtained by FBG. The comparison of the measurements obtained by the two methods indicates that when the drawing force is greater than 20 kN and the axial stress is more than 10 kN, the two methods have better consistency. In the field application, it is necessary to estimate the deformation of matrix, leaving at least 500 minutes for resin bond to work.