Uriel Nogal Luis
Uriel Nogal Luis has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- José Bruno Rojas Trigos
Instituto Politécnico Nacional, Centro de Investigación en Ciencia Aplicada y Tecnología Avanzada 2 , Legaria No. 694, C. P. 11500 Ciudad de México
4 shared publications - Alejandro Rojas Marroquin
SECIHTI-Instituto Politécnico Nacional, Centro de Investigación en Ciencia Aplicada y Tecnología Avanzada 1 , Legaria No. 694, C. P. 11500 Ciudad de México
3 shared publications - Antonio Calderon
Instituto Politécnico Nacional, Centro de Investigación en Ciencia Aplicada y Tecnología Avanzada 2 , Legaria No. 694, C. P. 11500 Ciudad de México
3 shared publications - Ernesto Marin
Instituto Politécnico Nacional, Centro de Investigación en Ciencia Aplicada y Tecnología Avanzada (CICATA) Unidad Legaria, Ciudad de México, Mexico
3 shared publications - Joel Hernández-Wong
SECIHTI-Instituto Politécnico Nacional, Centro de Investigación en Ciencia Aplicada y Tecnología Avanzada 1 , Legaria No. 694, C. P. 11500 Ciudad de México
3 shared publications - Lizbeth Luviano Elizalde
SECIHTI-Instituto Politécnico Nacional, Centro de Investigación en Ciencia Aplicada y Tecnología Avanzada 1 , Legaria No. 694, C. P. 11500 Ciudad de México
2 shared publications
Latest Publications
- 1 September 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (9)
Phase-resolved phasor method for the spectral separation of photoacoustic signal
This work presents a straightforward methodology for the spectral separation of two optical absorption contributions within a photoacoustic spectroscopy spectrum and directly determining the phase separation of their independent responses. By representing the photoacoustic signal as the sum of phasors from two independent absorption centers, we derived analytical expressions that enable the direct isolation of each center's spectrum. As an improvement over the well-known phase-resolved method, this approach does not require calculating scalar projections of the photoacoustic signal across multiple phase directions, nor does it require visual selection of specific projections based on their varying shapes. Furthermore, our methodology allows validation by comparing the measured spectrum to the one from the phasor sum of the isolated absorption centers’ responses. We tested this methodology on experimental data from aquatic lirium leaves and Golden Delicious apple peels using a standard photoacoustic spectroscopy setup. In each case, the methodology clearly identified the two distinct contributions corresponding to the known composition, with their sum closely matching the measured signal. The obtained phase separation in the responses of the absorption centers was attributed to a 7.1 ms time lag caused by the photosynthetic process in aquatic lirium leaves and to a 32.7 μm spatial separation between the two absorption centers in apple peels.
- 1 September 2026
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 140 (9)
Phase-resolved phasor method for the spectral separation of photoacoustic signal
This work presents a straightforward methodology for the spectral separation of two optical absorption contributions within a photoacoustic spectroscopy spectrum and directly determining the phase separation of their independent responses. By representing the photoacoustic signal as the sum of phasors from two independent absorption centers, we derived analytical expressions that enable the direct isolation of each center's spectrum. As an improvement over the well-known phase-resolved method, this approach does not require calculating scalar projections of the photoacoustic signal across multiple phase directions, nor does it require visual selection of specific projections based on their varying shapes. Furthermore, our methodology allows validation by comparing the measured spectrum to the one from the phasor sum of the isolated absorption centers’ responses. We tested this methodology on experimental data from aquatic lirium leaves and Golden Delicious apple peels using a standard photoacoustic spectroscopy setup. In each case, the methodology clearly identified the two distinct contributions corresponding to the known composition, with their sum closely matching the measured signal. The obtained phase separation in the responses of the absorption centers was attributed to a 7.1 ms time lag caused by the photosynthetic process in aquatic lirium leaves and to a 32.7 μm spatial separation between the two absorption centers in apple peels.
- Open Access
- 26 February 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 137 (8)
Analytical models for the thermal properties of n-type porous silicon layers: Dependence of porosity
Several reports in the literature concern the thermal properties of porous silicon samples considering the porous layer plus the silicon substrate, but not so of the porous layer in particular. This work uses the frequency domain photoacoustic technique in a heat transmission configuration together with an analysis based on a composite two-layer model of thermal resistances on n-type porous silicon and the porosity concept to develop a non-separative (and hence non-destructive) methodology for determining the thermal properties of the porous layer of n-type porous silicon and provide analytical models to obtain such properties as a function of its porosity. The porous silicon samples were elaborated by anodization, with anodization times from 10 to 100 min on (100)-oriented n-type crystalline silicon wafers and using a 48% hydrofluoric acid water solution. These wafers were non-degenerated, phosphorous doped, 500 μm roughly thick, and had 1.72 Ω cm electrical resistivity. In each sample, gravimetry determined porosity ranging from 0.279 to 0.702, and the porous layer's thickness was determined by electron microscopy. An analytical expression was obtained for the effective thermal diffusivity of the n-type porous silicon as a whole. After fitting it to the data obtained by the photoacoustic measurements, a value around 0.076 cm2/s, independent of porosity, was obtained for the thermal diffusivity of the porous layer. In addition, analytical expressions were obtained for the porous layer's thermal conductivity, volumetric heat capacity, and thermal effusivity, all showed a decreasing linear dependence on the porosity.
- 26 February 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 137 (8)
Open AccessAnalytical models for the thermal properties of n-type porous silicon layers: Dependence of porosity
Several reports in the literature concern the thermal properties of porous silicon samples considering the porous layer plus the silicon substrate, but not so of the porous layer in particular. This work uses the frequency domain photoacoustic technique in a heat transmission configuration together with an analysis based on a composite two-layer model of thermal resistances on n-type porous silicon and the porosity concept to develop a non-separative (and hence non-destructive) methodology for determining the thermal properties of the porous layer of n-type porous silicon and provide analytical models to obtain such properties as a function of its porosity. The porous silicon samples were elaborated by anodization, with anodization times from 10 to 100 min on (100)-oriented n-type crystalline silicon wafers and using a 48% hydrofluoric acid water solution. These wafers were non-degenerated, phosphorous doped, 500 μm roughly thick, and had 1.72 Ω cm electrical resistivity. In each sample, gravimetry determined porosity ranging from 0.279 to 0.702, and the porous layer's thickness was determined by electron microscopy. An analytical expression was obtained for the effective thermal diffusivity of the n-type porous silicon as a whole. After fitting it to the data obtained by the photoacoustic measurements, a value around 0.076 cm2/s, independent of porosity, was obtained for the thermal diffusivity of the porous layer. In addition, analytical expressions were obtained for the porous layer's thermal conductivity, volumetric heat capacity, and thermal effusivity, all showed a decreasing linear dependence on the porosity.
- 3 January 2024
- Published by Taylor & Francis in International Journal of Radiation Biology
- Vol. 100 (3) , 445-452
Stomata damage, photosynthesis, and transpiration evaluation of aquatic lirium after ultrasound irradiation
Evaluate the structural damage and the changes in the photosynthesis and transpiration rates of aquatic lirium leaves caused by ultrasound (US) irradiation in search of environmentally friendly methodologies for the control of this weed. Aquatic lirium plants were extracted from Xochimilco water canals in Mexico City. A part of the group of plants was selected for irradiation, and the rest formed the control group. The irradiation plants group was exposed to US irradiation of 17 kHz frequency and 30 W × 4 output power for 2 h, at noon and 25 °C room temperature. The structural analysis was done with a MOTICAM 1 digital camera, 800 × 600 pixels, incorporated into the MOTIC PSM-1000 optical microscope and edited with Motic Images Plus 2.0 ML software. The total stomata density and the damaged stomata density were determined by dividing the numbers of total and damaged stomata by the visual field area (67,917 mm2), respectively. The leaves' photosynthesis and transpiration rates were measured using an LI-6400XT Portable Photosynthesis System. Significant damage was observed in the stomata and epidermal cells, finding that the average ratio between the damaged and total stomata densities as a function of time (days) showed an exponential increase described by a Box-Lucas equation with a saturation value near unity and a maximum rate of change of the density of damaged stomata on zero-day (immediately after irradiation), decreasing as the days go by. The transpiration rate showed a sudden increase during the first hour after irradiation, reaching a maximum of 36% of its value before irradiation. It then quickly fell during the next 6 days and more slowly until the 21st day, decreasing 79.9% of its value before irradiation. The photosynthetic rate showed similar behavior with a 37.7% maximum increment and a 73.6% minimum decrease of its value before irradiation. The results of structural stomata damage on the ultrasound-irradiated aquatic lirium leaves are consistent with an excessive ultrasound stimulation on stomata's mechanical operation by guard cells that produce the measured significant increase of the photosynthetic and transpiration rates during the first hour after irradiation. The initial high evaporation could alter the water potential gradient, with a possible generation of tensions in the xylem that could cause embolism in their conduits. The loss of xylem conductivity or hydraulic failure would be consistent with the observed significant fall in the photosynthesis and transpiration rates of the aquatic lirium leaves after its sudden rise in the first hour after irradiation.
- 3 January 2024
- Published by Taylor & Francis in International Journal of Radiation Biology
- Vol. 100 (3) , 445-452
Stomata damage, photosynthesis, and transpiration evaluation of aquatic lirium after ultrasound irradiation
Evaluate the structural damage and the changes in the photosynthesis and transpiration rates of aquatic lirium leaves caused by ultrasound (US) irradiation in search of environmentally friendly methodologies for the control of this weed. Aquatic lirium plants were extracted from Xochimilco water canals in Mexico City. A part of the group of plants was selected for irradiation, and the rest formed the control group. The irradiation plants group was exposed to US irradiation of 17 kHz frequency and 30 W × 4 output power for 2 h, at noon and 25 °C room temperature. The structural analysis was done with a MOTICAM 1 digital camera, 800 × 600 pixels, incorporated into the MOTIC PSM-1000 optical microscope and edited with Motic Images Plus 2.0 ML software. The total stomata density and the damaged stomata density were determined by dividing the numbers of total and damaged stomata by the visual field area (67,917 mm2), respectively. The leaves' photosynthesis and transpiration rates were measured using an LI-6400XT Portable Photosynthesis System. Significant damage was observed in the stomata and epidermal cells, finding that the average ratio between the damaged and total stomata densities as a function of time (days) showed an exponential increase described by a Box-Lucas equation with a saturation value near unity and a maximum rate of change of the density of damaged stomata on zero-day (immediately after irradiation), decreasing as the days go by. The transpiration rate showed a sudden increase during the first hour after irradiation, reaching a maximum of 36% of its value before irradiation. It then quickly fell during the next 6 days and more slowly until the 21st day, decreasing 79.9% of its value before irradiation. The photosynthetic rate showed similar behavior with a 37.7% maximum increment and a 73.6% minimum decrease of its value before irradiation. The results of structural stomata damage on the ultrasound-irradiated aquatic lirium leaves are consistent with an excessive ultrasound stimulation on stomata's mechanical operation by guard cells that produce the measured significant increase of the photosynthetic and transpiration rates during the first hour after irradiation. The initial high evaporation could alter the water potential gradient, with a possible generation of tensions in the xylem that could cause embolism in their conduits. The loss of xylem conductivity or hydraulic failure would be consistent with the observed significant fall in the photosynthesis and transpiration rates of the aquatic lirium leaves after its sudden rise in the first hour after irradiation.
- 7 May 2018
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 39 (6) , 77
Optical Characterization of Tb3+:BaHfO3 Thin Films by Means of Photoacoustic Spectroscopy
- 7 May 2018
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 39 (6) , 77
Optical Characterization of Tb3+:BaHfO3 Thin Films by Means of Photoacoustic Spectroscopy