CLChenyu Li

Chenyu Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Chenyu Li has a total of 41 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Shear-Wave Velocity Models of the Subsurface Critical Zone at Mpala, Kenya, from Ambient Noise

    by Emerald A. Olango, Chenyu Li, Hasbi Ash Shiddiqi, Laura Parisi, P. Martin Mai

    In this study, we develop 1D shallow subsurface velocity profiles from one year of ambient-noise measurements collected at the Mpala Research Centre (Mpala), a wildlife preservation area in Laikipia County, Kenya. Mpala is located in a rangeland shared by wildlife, livestock, and people, and experienced extreme drought in 2023, during which water access depended largely on shallow wells influenced by subsurface hydrogeology. In addition, growing interest in seismic wildlife monitoring relies on interpreting ground-coupled animal vibrations, for which amplitudes and dominant frequencies are affected by local site effects. Both issues highlight the need for information on shallow subsurface structure. Mapping of site-specific shear-wave velocities (VS) provides a common framework to relate stratigraphy to shallow groundwater availability and to correct for spatial variability in amplification that biases wildlife signal detectability. Motivated by these needs, we develop the first locally constrained VS models in Mpala based on 12 months of seismic data recorded by a 15-station broadband seismic array using ambient-noise horizontal-to-vertical spectral ratio (HVSR) and passive seismic interferometry. The HVSR and Rayleigh-wave dispersion measurements from the two methods are jointly inverted. The dispersion curves’ frequency band (≈2–9 Hz) provides depth sensitivity of ∼70 to 430 m, whereas HVSR constrains near-surface impedance contrasts. Across our seismic network, we detect three consistent velocity contrasts in the upper 100 m, first at ∼1 to 4 m (VS∼280 to 500 m/s), second at ∼5 to 20 m (VS∼345 to 900 m/s), and finally at ∼15 to 50 m (VS∼1160 to 2600 m/s). The resulting VS models support well-siting and inform how to account for local site-amplification effects for monitoring and modeling ground-coupled wildlife sensing. For future work, we recommend multiscale seismic array configurations with both locally denser and targeted wider station spacing to reliably estimate shallow depths and the geological structure.


  • Open Access

    Passive subsurface imaging around the KAUST shallow well site using a multi-scale seismic acquisition system

    by Chenyu Li, Marine Deheuvels, Ning Wang, Matteo Ravasi, Kit Chambers, Thomas Finkbeiner, P. Martin Mai

    Passive seismic monitoring is an effective tool to assess seismic activity and analyze subsurface structures in and around well sites because it does not require an active source and, thus, is cheap, non-intrusive, and environmentally friendly. The on-campus shallow monitoring well at King Abdullah University of Science and Technology (KAUST) was drilled from February to April 2024, reaching a target depth of ~392 meters, and subsequently cased and cemented along its entire length to total depth. The main challenge for seismic monitoring at the site is the unconsolidated topmost layer of sand and construction debris that strongly weakens the seismic wave energy. At this site, we deployed various types of seismic sensors targeting different spatial and frequency-resolution scales to monitor seismic energy during drilling and from other random surface sources (e.g., vehicular traffic). The seismic monitoring system includes four three-component broadband stations deployed over a period of 5 to 18 months before drilling and a dense array of autonomous STRYDE nodes (measuring the vertical component of the particle acceleration field), which acquired data for about one month during drilling. The array was composed of 89 nodes with a spacing of 2 m and a total offset of 176 m. Seismic interferometry was applied on a portion of the data acquired while drilling operations were stopped (about 7 days) to synthesize surface waves and extract their dispersive behavior (i.e., dispersion curves) between 5 and 15 Hz. The resulting dispersion curves were then used to estimate a 2D near-surface shear wave velocity model down to 20 m depth. The horizontal-to-vertical spectral ratio (HVSR) was instead used on the recordings from the broadband seismic stations to estimate the site response transfer functions from which we extracted four 1D shallow shear wave velocity profiles. We first computed the HVSR for 14 days each month, then stacked the HVSR for 5 months to obtain the final HVSR of each station. The HVSR curves show two main peak frequencies ~2 Hz and 6 Hz. 1D shear wave velocity profiles down to 150 were finally obtained by joint inversion of the HVSR and dispersion curves. The velocity profiles from the broadband seismic stations and the closest profile from the nodes are consistent in the depth range where they overlap. Moreover, the shear wave profiles agree with the lithology interpreted from drilling cuttings. Our project demonstrates that a multi-scale seismic monitoring system can effectively reveal the subsurface structure of a specific site.


  • Open Access

    Creep and seismic rupture of a serpentinite-rich Sumatran fault segment

    by Shengji Wei, Zheng-Yang Choong, Chenyu Li, Yukuan Chen, Muksin Umar, Karen Lythgoe, Arifullah Arifullah, Andrean Simanjuntak

    Earthquake is produced by shear dislocation of rocks across the fault, the frictional status and the area of locked/creeping patches on the fault thus govern the size and occurrence of damaging earthquakes. To better understand these fundamental earthquake physics issues, we deployed over 130 short period seismic nodal stations along the plate boundary type Sumatran fault in Aceh region to cover a segment that was reported to be creeping at various depths. We maintained the nodal array deployment from Jan 2020 to July 2021 by recharging the nodes every 35 days. A machine learning based earthquake detection algorithm was applied to the acquired dataset, which results in a high-resolution seismic catalog that has more than 8000 micro-seismic events. These events clearly delineate the subvertical creeping segment of the Sumatran fault and its Seulimeum branch to the northwest. The seismicity on the creeping segment is almost uniformly distributed from 3 to 12 km in depth, confirming the creeping nature of the fault segment as revealed by geodetic observations, but providing a much more accurate depth constraint. In contrast, the Seulimeum fault branch shows a much deeper seismicity at the depth range of 18 to 25 km, indicating the entire upper crust is fully locked. Sharp stepovers are observed along both strike (~10km) and strike-normal (~4km) directions between the seismicity on these fault segments. The creeping segment of the Sumatran fault, as defined by similar earthquake families, agrees well with the lenses of serpentinite, which has much smaller frictional coefficient that facilitates fault creep. Similar earthquake families show ~ km scale lineation along strike of the fault, where repeating earthquake pairs are identified. However, two shallow Mw6 earthquakes occurred on the creeping segment in the last 25 years. In particular, finite fault inversion of the 2013 Mw6.1 earthquake shows the rupture from 12 km to the surface. These observations suggest a partially creeping/locking or conditionally stable frictional status on the serpentinite-rich segment of the Sumatran fault, that should be considered in both single event and earthquake cycle simulations, as well as seismic hazard assessment.

  • Temporal changes of seismicity in Salton Sea Geothermal Field due to distant earthquakes and geothermal productions

    by Chenyu Li, Zhigang Peng, Dongdong Yao, Xiaofeng Meng, Qiushi Zhai

    The Salton Sea Geothermal Field (SSGF) is one of the most seismically active and geothermally productive fields in California. Here we present a detailed analysis of short-term seismicity change in SSGF from 2008 to 2013 during and right following large distant earthquakes, as well as long-term seismicity change due to geothermal productions. We first apply a GPU-based waveform matched-filter technique (WMFT) to the continuous data recorded by the Calenergy Borehole (EN) Network and detect more than 70 000 new micro-earthquakes than listed in the standard Southern California Seismic Network catalogue. We then analyse the seismicity rate changes in the SSGF associated with transient stress fluctuations triggered by regional and large teleseismic earthquakes from 1999 to 2019. We find triggered seismicity in the SSGF following seven regional M > 5.5 earthquakes. In comparison, most teleseismic earthquakes with M > 8.0 did not trigger significant seismicity rate change in the SSGF, likely indicating a frequency dependence in remote dynamic triggering. We further characterize the correlation between the long-term seismicity rate and geothermal production rates, and the temporal and spatial distribution of Guttenberg–Richter b-values inside and outside the SSGF with the newly detected catalogue. The long-term seismicity shows that events with M > 1.5 are likely correlated with net production rates, while smaller events do not show any correlation. The b-values inside the SSGF are higher than those outside the SSGF, and the locations of dynamically triggered events are close to locations with high b-values.


  • Remote Triggering of Icequakes at Mt. Erebus, Antarctica by Large Teleseismic Earthquakes

    by Chenyu Li, Zhigang Peng, Julien A. Chaput, Jacob I. Walter, Richard C. Aster

    Recent studies have shown that the Antarctic cryosphere is sensitive to external disturbances such as tidal stresses or dynamic stresses from remote large earthquakes. In this study, we systematically examine evidence of remotely triggered microseismicity around Mount (Mt.) Erebus, an active high elevation stratovolcano located on Ross Island, Antarctica. We detect microearthquakes recorded by multiple stations from the Mt. Erebus Volcano Observatory Seismic Network one day before and after 43 large teleseismic earthquakes, and find that seven large earthquakes (including the 2010 Mw 8.8 Maule, Chile, and 2012 Mw 8.6 Indian Ocean events) triggered local seismicity on the volcano, with most triggered events occurring during the passage of the shorter‐period Rayleigh waves. In addition, their waveforms and locations for the triggered events are different when comparing with seismic events arising from the persistent small‐scale eruptions, but similar to other detected events before and after the mainshocks. Based on the waveform characteristics and their locations, we infer that these triggered events are likely shallow icequakes triggered by dilatational stress perturbations from teleseismic surface waves. We show that teleseismic earthquakes with higher peak dynamic stress changes are more capable of triggering icequakes at Mt. Erebus. We also find that the icequakes in this study are more likely to be triggered during the austral summer months. Our study motivates the continued monitoring of Mount Erebus with dense seismic instrumentation to better understand interactions between dynamic seismic triggering, crospheric processes, and volcanic activity.


  • Open Access

    Triggered Seismicity and Temporal Change of Seismic Velocity in Salton Sea Geothermal Field

    by Chenyu Li

    The Salton Sea Geothermal Field (SSGF) is one of the most seismically active and geothermally productive fields in Southern California. Previous studies showed that local seismicity and seismic velocity in SSGF was disturbed by the 2010 M7.2 El Mayor-Cucapah earthquake. Here we present a systematic investigation of triggered seismicity and the spatial-temporal change of seismic velocity in SSGF following some regional and remote earthquakes. The continuous waveform from 2007 to 2014 in the Calenergy Borehole Network (EN) is used for this study. We apply a GPU-based waveform matched-filter technique (WMFT) to 60 days before and after the selected earthquakes, and find possible triggered seismicity following several regional earthquakes, such as the 2009 Mw6.9 Baja California and 2010 Mw5.7 Ocotillo Earthquakes. We also utilize an ambient noise cross-correlation method to quantify the temporal and spatial velocity changes in SSGF. Our result shows clear velocity reduction following the 2010 M7.2 El-Mayor earthquake, and the co-seismic reductions are larger for ray paths outside the geothermal regions. We also find some possible triggered events in SSGF following the 2019 M7.1 Ridgecrest earthquake. Our next step is to conduct a detailed investigation on the possible correlation between triggered seismicity and seismic velocity changes associated with the occurrence of the 2010 M7.2 earthquake, and other regional earthquakes.

  • Open Access

    Transfer Learning for Seismic Phase Picking on Different Geographic Regions

    by Chenyu Li, Lijun Zhu, Dongdong Yao, Xiaofeng Meng, Zhigang Peng, James McClellan, Jake Walter

    Machine learning algorithms have become a powerful tool in different areas of seismology, such as phase picking/earthquake detection, earthquake early warning and focal mechanism determination. Previously convolutional neural networks (CNN) have been applied to continuous seismic waveform recordings to perform efficient phase picking and event detection with good accuracy [Zhu et al., 2018]. However, the off-line training of current CNN requires at least a few thousands of accurately picked seismic phases, which makes it difficult to be applied to regions without sufficient picked phases. In this work, we will validate the transfer learning among different geographic regions. Our tests show that the phase picker trained on manually-labeled data acquired from Sichuan, China following the 2008 M7.9 Wenchuan earthquake [Zhu et al., 2018] works equally well on the continuous waveform acquired from Oklahoma, US [Zhu et al., 2018]. Specifically, using the CNN trained on the Wenchuan dataset, together with 895 local/regional catalog events recorded in central Oklahoma, we refine part of the networks to pick the arrival times of the local seismicity in Oklahoma. The refined CNN results are compatible with the matched filter results using the same catalog events as templates. Our next step is to extend our test to waveforms from different tectonic regions to demonstrate the generality of CNN-based phase picker. We plan to further use a New Zealand seismic dataset that includes more than 20 GeoNet stations in the North Island, where the matched-filter detected results are available to be compared with (Yao et al., 2018). Alternatively dataset include a subset of events in the waveform relocated catalog in Southern California. Updated results will be presented at the meeting.

  • Long‐Period Long‐Duration Events Detected by the IRIS Community Wavefield Demonstration Experiment in Oklahoma: Tremor or Train Signals?

    by Chenyu Li, Zefeng Li, Zhigang Peng, Chengyuan Zhang, Nori Nakata, Tim Sickbert

    In this study, we apply a recently developed local similarity method to detect long‐period long‐duration (LPLD) seismic events using 1‐month continuous waveforms recorded by a nodal array from the Incorporated Research Institutions for Seismology (IRIS) community wavefield experiment in Oklahoma. The local similarity method detects seismic events by correlating waveforms at each station with its neighboring stations. Using this method, we visually identify 21 potential tremor‐like LPLD events lasting more than 300 s during the 1‐month period. However, with beamforming analysis, we find that the source locations and waveform characteristics of these events are consistent with train‐generated seismic signals from the nearby Union Pacific railway. Additional evidence includes amplitude decay away from the railway track, and similarities in frequency–time contents with other confirmed train‐generated seismic signals. This case study highlights the need of dense‐array observations to distinguish between natural and anthropogenic LPLD seismic signals.