Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Carlos Pinho has a total of 89 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Thermodynamic Simulations of a Single-Stage Absorption Heat Transformer Utilizing Low-Temperature Waste Heat (60 °C)

    by Marta Santos, Carlos Pinho, João B. L. M. Campos

    This study focuses on the theoretical performance of a single-stage absorption heat transformer (SSAHT) using the working pair H2O/LiBr for low-temperature waste heat recovery. A thermodynamic model was implemented in Engineering Equation Software (EES) considering a waste heat temperature of 60 °C in a small-scale SSAHT. A sensitivity analysis was performed where important system parameters were varied, including the inlet temperatures, mass flow rates, and solution heat exchanger effectiveness. Their impact on different AHT performance parameters (COP, ECOP, GTL, and FR) was evaluated, and these results provided practical guidelines that were utilized to optimize the SSAHT operating conditions.


  • Open Access

    The Experimental Analysis of Biochar Combustion in a Traveling Grate Furnace

    by Tânia Ferreira, João Monney Paiva, Carlos Pinho

    The current energy policy targets reducing energy dependence and minimizing pollutant emissions. Therefore, with the growing interest in using biomass as an alternative energy source, conducting scientific studies on its behavior and optimizing the respective conversion systems has become imperative. The present study focuses on investigating the combustion of biochar pellets in a laboratory-scale traveling grate furnace at three different bed temperatures: 700, 750, and 800 °C. The biochars were obtained via the carbonization process of Pinus pinaster, Acacia dealbata, and Cytisus scoparius pellets. The biochar combustion was studied using a moving-bed carbon particle burning model, supported by kinetic information which was obtained via the combustion of the same biochars in a bubbling fluidized bed. The diffusive parameter which was representative of this traveling grate combustion technology was determined, particularly the bed bypass factor. The combustion tests were carried out with the incomplete combustion of the char pellets. In general, the increase in biochar size led to a decrease in the bypass factor. However, the furnace temperature did not influence this parameter.


  • Thermodynamic Equilibrium Modelling of Glycerol Gasification

    by Ana Almeida, Elisa Ramalho, Albina Ribeiro, Carlos Pinho, Rosa Pilão

  • A Preliminary Study on the Ignition of Some Ligneous Biomass Pellets Inside a Traveling Grate Furnace

    by Tânia Ferreira, Edmundo Marques, João Monney Paiva, Carlos Pinho

  • Open Access

    A Study on the Spontaneous Ignition of Some Ligneous Pellets

    by Tânia Ferreira, Edmundo Marques, João Monney Paiva, Carlos Pinho

    A preliminary non-exhaustive study was conducted on the ignition of some ligneous biomass pellets inside a laboratory scale traveling bed furnace. The experiments consisted in the measurement of the ignition time of volatiles released by six different types of pellets, obtained from wood species found in the Portuguese forest, namely Pinus pinaster, Acacia dealbata, Cytisus scoparius, Cistus ladanifer, Paulownia cotevisa and Eucalyptus globulus. The experiments were carried out at corrected furnace temperatures of 359, 381, 403, 424 and 443 °C, using two different pellet sizes and with batches of 6 and 8 g of pellets. The ignition time was determined measuring the time elapsed between placing the batch of pellets on the traveling grate and the volatiles’ ignition moment. Its dependency was linear, and an increase in ignition time with the furnace temperature was verified. Pinus pinaster was the species that presented a higher ignition time and Cytisus scoparius the shortest. For the same pellets size, an increase in the mass of batches led to shorter ignition times.


  • Open Access

    Combustion Characteristics of Premixed Hydrogen/Air in an Undulate Microchannel

    by Pedro R. Resende, Leandro C. Morais, Carlos Pinho, Alexandre M. Afonso

    This work reports a numerical investigation of microcombustion in an undulate microchannel, using premixed hydrogen and air to understand the effect of the burner design on the flame in order to obtain stability of the flame. The simulations were performed for a fixed equivalence ratio and a hyperbolic temperature profile imposed at the microchannel walls in order to mimic the heat external losses occurred in experimental setups. Due to the complexity of the flow dynamics combined with the combustion behavior, the present study focuses on understanding the effect of the fuel inlet rate on the flame characteristics, keeping other parameters constant. The results presented stable flame structure regardless of the inlet velocity for this type of design, meaning that a significant reduction in the heat flux losses through the walls occurred, allowing the design of new simpler systems. The increase in inlet velocity increased the flame extension, with the flame being stretched along the microchannel. For higher velocities, flame separation was observed, with two detected different combustion zones, and the temperature profiles along the burner centerline presented a non-monotonic decrease due to the dynamics of the vortices observed in the convex regions of the undulated geometry walls. The geometry effects on the flame structure, flow field, thermal evolution and species distribution for different inlet velocities are reported and discussed.


  • Open Access

    Determination of biomass combustion rate in a domestic fixed bed boiler

    by Mariana Vale da Silva, Porto Inegi—Instituto de Ciência e Inovação Em Engenharia Mecânica e Engenharia Industrial, Victor Ferreira, Carlos Pinho

    This manuscript presents an experimental study on the combustion rate of biomass briquettes or logs in a domestic boiler, by monitoring the time decay of its mass and the temperature of the flame inside the boiler. Assuming close to steady state conditions, two combustion models were studied: the constant particle density-burning model and the constant particle diameter-burning model. For each model, the evolution of the global combustion resistance with the decay of the particle diameter was analyzed, and it was possible to conclude that the burning occurred approximately with constant particle size and that the heterogeneous C to CO reaction takes place at the surface of the inner carbonaceous core. The high values obtained for the Sherwood number revealed that there were significant convective effects inside the furnace and compare well with a previously developed Sherwood number correlation for a packed bed of active particles.


  • Open Access

    Co-Gasification of Crude Glycerol/Animal Fat Mixtures

    by Ana Almeida, Rosa Pilão, Albina Ribeiro, Elisa Ramalho, Carlos Pinho

    The aim of this work was to assess the technical viability of glycerol/fat co-gasification. The gasification performance was studied in a downflow fixed bed reactor using activated alumina particles as bed material and steam as oxidizing agent. The effect of gasification temperature, from 800 to 950 °C was studied with a feed mixture with 10% (w/w) of animal fat. The influence of fat incorporation on the feedstock in the overall gasification process was also performed, using 3% (w/w) and 5% (w/w) of fat in feed mixtures. Samples of dry gas from the gasifier were collected and analyzed by gas chromatography in order to determine the CO, CO2, CH4, and H2 content. The best results were obtained using the highest tested temperature, 950 °C, and using 3% (w/w) of animal fat in the feed mixture. The overall results revealed that the co-gasification of glycerol/animal fat mixtures seems to be a feasible technical option.