Kasturi Vasudevan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kasturi Vasudevan has a total of 78 co-authors. Here are the top co-authors by number of shared publications:
- Prem Singh
IIIT Bangalore
7 shared publications - Bhaskar Ramamurthi
Department of Electrical Engineering, Indian Institute of Technology Madras, Chennai, India
5 shared publications - Rohit Budhiraja
Indian Institute of Technology Kanpur
5 shared publications - Krishnamurthy Giridhar
Indian Institute of Technology Madras
4 shared publications - Ekant Sharma
ECE Department, IIT Roorkee, Roorkee, India
3 shared publications - Lajos Hanzo
University of Southampton
3 shared publications
Latest Publications
- Open Access
- 20 December 2023
- Published by IntechOpen
New Results on Single User Massive MIMO
Achieving high bit rates is the main goal of wireless technologies like 5G and beyond. This translates to obtaining high spectral efficiencies using large number of antennas at the transmitter and receiver (single user massive multiple input multiple output or SU-MMIMO). It is possible to have a large number of antennas in the mobile handset at mm-wave frequencies in the range 30–300 GHz due to the small antenna size. In this work, we investigate the bit-error-rate (BER) performance of SU-MMIMO in two scenarios (a) using serially concatenated turbo code (SCTC) in uncorrelated channel and (b) parallel concatenated turbo code (PCTC) in correlated channel. Computer simulation results indicate that the BER is quite insensitive to re-transmissions and wide variations in the number of transmit and receive antennas. Moreover, we have obtained a BER of 10−5 at an average signal-to-interference plus noise ratio (SINR) per bit of just 1.25 dB with 512 transmit and receive antennas (512 × 512 SU-MMIMO system) with a spectral efficiency of 256 bits/transmission or 256 bits/sec/Hz in an uncorrelated channel. Similar BER results have been obtained for SU-MMIMO using PCTC in correlated channel. A semi-analytic approach to estimating the BER of a turbo code has been derived.
- 20 December 2023
- Published by IntechOpen
Open AccessNew Results on Single User Massive MIMO
Achieving high bit rates is the main goal of wireless technologies like 5G and beyond. This translates to obtaining high spectral efficiencies using large number of antennas at the transmitter and receiver (single user massive multiple input multiple output or SU-MMIMO). It is possible to have a large number of antennas in the mobile handset at mm-wave frequencies in the range 30–300 GHz due to the small antenna size. In this work, we investigate the bit-error-rate (BER) performance of SU-MMIMO in two scenarios (a) using serially concatenated turbo code (SCTC) in uncorrelated channel and (b) parallel concatenated turbo code (PCTC) in correlated channel. Computer simulation results indicate that the BER is quite insensitive to re-transmissions and wide variations in the number of transmit and receive antennas. Moreover, we have obtained a BER of 10−5 at an average signal-to-interference plus noise ratio (SINR) per bit of just 1.25 dB with 512 transmit and receive antennas (512 × 512 SU-MMIMO system) with a spectral efficiency of 256 bits/transmission or 256 bits/sec/Hz in an uncorrelated channel. Similar BER results have been obtained for SU-MMIMO using PCTC in correlated channel. A semi-analytic approach to estimating the BER of a turbo code has been derived.
- Open Access
- 25 April 2023
- Published by Bilingual Publishing Group in Semiconductor Science and Information Devices
- Vol. 5 (1) , 1-2
Minus Infinity Plus Infinity
- 25 April 2023
- Published by Bilingual Publishing Group in Semiconductor Science and Information Devices
- Vol. 5 (1) , 1-2
Open AccessMinus Infinity Plus Infinity
- Open Access
- 9 October 2021
- Published by Bilingual Publishing Group in Semiconductor Science and Information Devices
- Vol. 3 (2) , 27-28
Confluence of Encryption, Absorption and Sensation – Well Almost Nearly
In this issue, manuscripts have been published on a wide variety of topics, which demonstrates the large scope of Semiconductor Science & Information Devices.
- 9 October 2021
- Published by Bilingual Publishing Group in Semiconductor Science and Information Devices
- Vol. 3 (2) , 27-28
Open AccessConfluence of Encryption, Absorption and Sensation – Well Almost Nearly
In this issue, manuscripts have been published on a wide variety of topics, which demonstrates the large scope of Semiconductor Science & Information Devices.
- Open Access
- 26 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 112290-112311
5G New Radio Key Performance Indicators Evaluation for IMT-2020 Radio Interface Technology
The International Telecommunication Union (ITU) has recently announced the detailed 5G specifications for International Mobile Telecommunications (IMT-2020). A number of candidate Radio Interface Technologies (RITs) were being evaluated by the independent evaluation groups of the ITU. Meanwhile, the roll out of fifth generation (5G) is now going on, and 5G services are offered by more than 160 mobile network operators (MNO). This paper presents the evaluation of the proponent technologies, including the ones specified as $3^{\text {rd}}$ generation partnership project (3GPP) 5G new radio (NR). The entire 3GPP specifications were examined and evaluated through simulation using Matlab and a custom simulator based on the Go-language. The simulator facilitated the comprehensive evaluation of the 5G NR performance by using the IMT-2020 evaluation framework. Some of the submitted technologies displayed certain discrepancies which were reported to ITU as well as discussed with proponents to improvise the shortcomings. The detailed results and observations are presented in this paper.
- 26 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 9, 112290-112311
Open Access5G New Radio Key Performance Indicators Evaluation for IMT-2020 Radio Interface Technology
The International Telecommunication Union (ITU) has recently announced the detailed 5G specifications for International Mobile Telecommunications (IMT-2020). A number of candidate Radio Interface Technologies (RITs) were being evaluated by the independent evaluation groups of the ITU. Meanwhile, the roll out of fifth generation (5G) is now going on, and 5G services are offered by more than 160 mobile network operators (MNO). This paper presents the evaluation of the proponent technologies, including the ones specified as $3^{\text {rd}}$ generation partnership project (3GPP) 5G new radio (NR). The entire 3GPP specifications were examined and evaluated through simulation using Matlab and a custom simulator based on the Go-language. The simulator facilitated the comprehensive evaluation of the 5G NR performance by using the IMT-2020 evaluation framework. Some of the submitted technologies displayed certain discrepancies which were reported to ITU as well as discussed with proponents to improvise the shortcomings. The detailed results and observations are presented in this paper.
- Open Access
- 1 January 2021
- Published by Wiley in Wireless Communications and Mobile Computing
- Vol. 2021 (1)
Design and Experimental Analysis of Multiband Compound Reconfigurable 5G Antenna for Sub‐6 GHz Wireless Applications
In this paper, a printed low‐profile antenna with frequency and pattern reconfigurable functionality is designed in three modes. Each mode operates at different frequency bands and has several options available for pattern reconfiguration in these bands. The proposed antenna consists of eight pin‐diode switches (S1 to S8). The switches S1 and S2, installed in the radiating patch, are used for frequency reconfigurability to control the operating bands of the antenna. The rest of the six switches (S3, S4, S5, S6, S7, and S8), loaded in the stubs on the rear side of the antenna, are used for pattern reconfiguration to control the main lobe beam steering. When all switches are off, the proposed antenna operates in a wideband mode, covering the 3.82‐9.32 GHz frequency range. When S1 is on, the antenna resonates in the 3.5 GHz (3.09‐4.17 GHz) band. When both S1 and S2 are on, the resonant band of the antenna is shifted to 2.5 GHz band (2.40‐2.81 GHz). A very good impedance matching with a return loss of less than ‐10 dB is attained in these bands. The beam steering is done at each operating frequency by controlling the on and off states of the six pin‐diode switches (S3, S4, S5, S6, S7, and S8). Depending on the state of the switches, the antenna can direct the beam in seven distinct directions at 4.2 GHz, 4.5 GHz, and 5 GHz. The main beam of the radiation pattern is steered in five different directions at 5.5 GHz, 3.5 GHz, and 2.6 GHz operating bands for the given state of the mentioned switches. The proposed antenna supports several sub‐6 GHz 5G bands (2.6 GHz, 3.5 GHz, 4.2 GHz, 4.5 GHz, and 5 GHz) and can be used in handheld 5G devices.
- 1 January 2021
- Published by Wiley in Wireless Communications and Mobile Computing
- Vol. 2021 (1)
Open AccessDesign and Experimental Analysis of Multiband Compound Reconfigurable 5G Antenna for Sub‐6 GHz Wireless Applications
In this paper, a printed low‐profile antenna with frequency and pattern reconfigurable functionality is designed in three modes. Each mode operates at different frequency bands and has several options available for pattern reconfiguration in these bands. The proposed antenna consists of eight pin‐diode switches (S1 to S8). The switches S1 and S2, installed in the radiating patch, are used for frequency reconfigurability to control the operating bands of the antenna. The rest of the six switches (S3, S4, S5, S6, S7, and S8), loaded in the stubs on the rear side of the antenna, are used for pattern reconfiguration to control the main lobe beam steering. When all switches are off, the proposed antenna operates in a wideband mode, covering the 3.82‐9.32 GHz frequency range. When S1 is on, the antenna resonates in the 3.5 GHz (3.09‐4.17 GHz) band. When both S1 and S2 are on, the resonant band of the antenna is shifted to 2.5 GHz band (2.40‐2.81 GHz). A very good impedance matching with a return loss of less than ‐10 dB is attained in these bands. The beam steering is done at each operating frequency by controlling the on and off states of the six pin‐diode switches (S3, S4, S5, S6, S7, and S8). Depending on the state of the switches, the antenna can direct the beam in seven distinct directions at 4.2 GHz, 4.5 GHz, and 5 GHz. The main beam of the radiation pattern is steered in five different directions at 5.5 GHz, 3.5 GHz, and 2.6 GHz operating bands for the given state of the mentioned switches. The proposed antenna supports several sub‐6 GHz 5G bands (2.6 GHz, 3.5 GHz, 4.2 GHz, 4.5 GHz, and 5 GHz) and can be used in handheld 5G devices.
- 1 December 2020
- Published by Springer Nature in International Journal of Wireless Information Networks
- Vol. 27 (4) , 551-557
Efficient Hybrid Linear Massive MIMO Detector Using Gauss-Seidel And Successive Over-Relaxation
- 1 December 2020
- Published by Springer Nature in International Journal of Wireless Information Networks
- Vol. 27 (4) , 551-557
Efficient Hybrid Linear Massive MIMO Detector Using Gauss-Seidel And Successive Over-Relaxation
- 15 August 2020
- Published by Springer Nature
- p. 243-294
Frequency Modulation
- 15 August 2020
- Published by Springer Nature
- p. 1-76
Signals and Systems
- 15 August 2020
- Published by Springer Nature
- p. 77-151
Random Variables and Random Processes
- 15 August 2020
- Published by Springer Nature
- p. 357-367
Signaling Through AWGN Channel