Minseok Seo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Minseok Seo has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Sang Woo Kim
Department of Electrical Engineering, Pohang University of Science and Technology, Pohang, South Korea
5 shared publications - Minho Choi
Digital Health Research Division, Korea Institute of Oriental Medicine, Daejeon, Daejeon, Republic of Korea
3 shared publications - Jaepil Ban
School of Electronic Engineering, Kumoh National Institute of Technology, Gumi, Republic of Korea
2 shared publications Donghyun Bae
Department of Materials Science and Engineering Yonsei University Seoul 03722 Korea
1 shared publicationGijoon Bae
Department of Materials Science and Engineering Yonsei University Seoul 03722 Korea
1 shared publication- Gyogwon Koo
Division of Intelligent Robot
1 shared publication
Latest Publications
- 20 March 2023
- Published by Elsevier in Expert Systems with Applications
- Vol. 223
Neural network MPC for heating section of annealing furnace
- 20 March 2023
- Published by Elsevier in Expert Systems with Applications
- Vol. 223
Neural network MPC for heating section of annealing furnace
- Open Access
- 5 October 2021
- Published by Wiley in Advanced Materials Technologies
- Vol. 6 (10) , 2170061
Colorimetric Detection of Mechanical Deformation in Metals using Thin‐Film Mechanochromic Sensor (Adv. Mater. Technol. 10/2021)
- 5 October 2021
- Published by Wiley in Advanced Materials Technologies
- Vol. 6 (10) , 2170061
Open AccessColorimetric Detection of Mechanical Deformation in Metals using Thin‐Film Mechanochromic Sensor (Adv. Mater. Technol. 10/2021)
- 1 January 2020
- Published by Elsevier in Automatica
- Vol. 111, 108600
Improved co-design of event-triggered dynamic output feedback controllers for linear systems
- 1 January 2020
- Published by Elsevier in Automatica
- Vol. 111, 108600
Improved co-design of event-triggered dynamic output feedback controllers for linear systems
- Open Access
Adaptive Noise Reduction Algorithm to Improve R Peak Detection in ECG Measured by Capacitive ECG Sensors
Electrocardiograms (ECGs) can be conveniently obtained using capacitive ECG sensors. However, motion noise in measured ECGs can degrade R peak detection. To reduce noise, properties of reference signal and ECG measured by the sensors are analyzed and a new method of active noise cancellation (ANC) is proposed in this study. In the proposed algorithm, the original ECG signal at QRS interval is regarded as impulsive noise because the adaptive filter updates its weight as if impulsive noise is added. As the proposed algorithm does not affect impulsive noise, the original signal is not reduced during ANC. Therefore, the proposed algorithm can conserve the power of the original signal within the QRS interval and reduce only the power of noise at other intervals. The proposed algorithm was verified through comparisons with recent research using data from both indoor and outdoor experiments. The proposed algorithm will benefit a noise reduction of noisy biomedical signal measured from sensors.
Open AccessAdaptive Noise Reduction Algorithm to Improve R Peak Detection in ECG Measured by Capacitive ECG Sensors
Electrocardiograms (ECGs) can be conveniently obtained using capacitive ECG sensors. However, motion noise in measured ECGs can degrade R peak detection. To reduce noise, properties of reference signal and ECG measured by the sensors are analyzed and a new method of active noise cancellation (ANC) is proposed in this study. In the proposed algorithm, the original ECG signal at QRS interval is regarded as impulsive noise because the adaptive filter updates its weight as if impulsive noise is added. As the proposed algorithm does not affect impulsive noise, the original signal is not reduced during ANC. Therefore, the proposed algorithm can conserve the power of the original signal within the QRS interval and reduce only the power of noise at other intervals. The proposed algorithm was verified through comparisons with recent research using data from both indoor and outdoor experiments. The proposed algorithm will benefit a noise reduction of noisy biomedical signal measured from sensors.
- Top Cited Papers
- 22 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 67 (3) , 634-645
Wearable Device-Based System to Monitor a Driver’s Stress, Fatigue, and Drowsiness
This paper proposes a wearable device-based system to monitor the abnormal conditions of a driver, including stress, fatigue, and drowsiness. The system measures the motional and physiological information of the driver using the developed wearable device on the wrist. Preprocessing is used to distinguish the valid signal parts of the measured signals, because various noises can occur in wearable sensors. Features are extracted from the signal parts, and an optimal feature set is determined by an analysis of variance and a sequential floating forward selection algorithm. To classify the driver's state, a support vector machine-based classification method is used to obtain high generalization performance considering interdriver variance. Experiments were conducted on an indoor driving simulator, with 28 subjects, to gather data for each state. The classification accuracy was 98.43% for fivefold cross validation on the data. In a subject-independent test, the accuracy was 68.31% for the four states and 84.46% for the three states consisting of normal, stressed, and fatigued or drowsy states. Using the proposed system, the abnormal conditions of the driver can be detected and distinguished. This advantage contributes to safer and more comfortable driving. Furthermore, the utilization of the wearable device makes the system easy to use.
- 22 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 67 (3) , 634-645
Top Cited PapersWearable Device-Based System to Monitor a Driver’s Stress, Fatigue, and Drowsiness
This paper proposes a wearable device-based system to monitor the abnormal conditions of a driver, including stress, fatigue, and drowsiness. The system measures the motional and physiological information of the driver using the developed wearable device on the wrist. Preprocessing is used to distinguish the valid signal parts of the measured signals, because various noises can occur in wearable sensors. Features are extracted from the signal parts, and an optimal feature set is determined by an analysis of variance and a sequential floating forward selection algorithm. To classify the driver's state, a support vector machine-based classification method is used to obtain high generalization performance considering interdriver variance. Experiments were conducted on an indoor driving simulator, with 28 subjects, to gather data for each state. The classification accuracy was 98.43% for fivefold cross validation on the data. In a subject-independent test, the accuracy was 68.31% for the four states and 84.46% for the three states consisting of normal, stressed, and fatigued or drowsy states. Using the proposed system, the abnormal conditions of the driver can be detected and distinguished. This advantage contributes to safer and more comfortable driving. Furthermore, the utilization of the wearable device makes the system easy to use.