Francisco Sanchez Sutil

This work presents the development and implementation of a three-phase meter for the analysis of electrical harmonics and supraharmonics, designed on reconfigurable Eclypse Z7 platforms equipped with ARM Cortex-A9 processors and an integrated FPGA (Field Programmable Gate Array) architecture. The proposed system enables continuous online acquisition, processing, and transmission of signals without requiring additional circuitry beyond the voltage and current transducers. Its design is based on the methodologies defined in IEC 61000-4-7 and the 2015 edition of IEC 61000-4-30, covering spectral analysis from low-frequency harmonics up to supraharmonics in the 150 kHz range. Experimental results obtained from calibration and verification tests show maximum errors below 0.2 V in voltage and 0.1 A in current, with uncertainties lower than 0.33 %. These results demonstrate that the proposed meter meets the accuracy and repeatability requirements established for Class A instruments by IEC 61000-4-7, IEC 61000-4-30 (2015). The proposed device offers advantages over available commercial analyzers by operating in a fully reconfigurable and continuous online manner without throughput backlog, while also allowing the future integration of new processing methodologies.

Power quality measurements are essential to monitor, analyse and control the operation of smart grids within power systems. This work aims to develop and calibrate a PQ network analyser. As the penetration of non-linear loads connected to power systems is increasing every day, it is essential to measure power quality. In this sense, a power quality (PQ) analyser is based on the high-speed sampling of electrical signals in single-phase and three-phase electrical installations, which are available in real time for analysis using wireless Wi-Fi (Wireless-Fidelity) networks. The PQAE (Power Quality Analyser Embedded) power quality analyser has met the calibration standards for Class A devices from IEC 61000-4-30, IEC 61000-4-7 and IEC 62586-2. In this paper, a complete guide to the tests included in this standard has been provided. The Fast Fourier Transform (FFT) obtains the harmonic components from the measured signals and the window functions used reduce spectral leakage. The window size depends on the fundamental frequency of, intensity of and changes in the signal. Harmonic measurements from the 2nd to 50th harmonics for each phase of the voltage and each phase and neutral of the current have been performed, using the Fast Fourier transform algorithm with various window functions and their comparisons. PQAE is developed on an open-source platform that allows you to adapt its programming to the measurement needs of the users.

The internet of things is undergoing rapid expansion, transforming diverse industries by facilitating device connectivity and supporting advanced applications. In the domain of energy production, internet of things holds substantial promise for streamlining processes and enhancing efficiency. This research introduces a comprehensive monitoring and energy management model tailored for the University of Cuenca’s microgrid system, employing internet of things and ThingSpeak as pivotal technologies. The proposed approach capitalizes on intelligent environments and employs ThingSpeak as a robust platform for presenting and analyzing data. Through the integration of internet of things devices and sensors, the photovoltaic system’s parameters, including solar radiation and temperature, are monitored in real time. The collected data undergo analysis using sophisticated models and are presented visually through ThingSpeak, facilitating effective energy management and decision making. The developed monitoring system underwent rigorous testing in a laboratory microgrid setup, where the photovoltaic system is interconnected with other generation and storage systems, as well as the electrical grid. This seamless integration enhances visibility and control over the microgrid’s energy production. The results attest to the successful implementation of the monitoring system, highlighting its efficacy in improving the supervision, automation, and analysis of daily energy production. By leveraging internet of things technologies and ThingSpeak, stakeholders gain access to real-time data, enabling them to analyze performance trends and optimize energy resources. This research underscores the practical application of internet of things in enhancing the monitoring and management of energy systems with tangible benefits for stakeholders involved.

The Internet of Things (IoT) is experiencing exponential growth, revolutionizing various industries with its ability to connect devices and enable advanced applications. In the realm of energy production, IoT offers significant potential for optimizing processes and improving efficiency. This study presents a comprehensive monitoring and energy management strategy for the University of Cuenca's microgrid photovoltaic (PV) system, utilizing IoT and ThingSpeak as key technologies. The proposed strategy leverages intelligent environments and utilizes ThingSpeak as a robust platform for data presentation and analysis. By integrating IoT devices and sensors, real-time monitoring of PV system parameters such as solar radiation and temperature is achieved. The collected data is then analyzed using advanced algorithms and visualized through ThingSpeak, enabling effective energy management and decision-making. The developed monitoring system was rigorously tested in a laboratory microgrid setting, where the PV system is interconnected with other generation and storage systems, as well as the electrical grid. Through the seamless integration of these components, the monitoring system provides enhanced visibility and control over the microgrid's energy production. The results demonstrate the successful implementation of the monitoring system, showcasing its ability to improve the supervision, automation, and analysis of daily energy production. By leveraging IoT technologies and ThingSpeak, stakeholders can access real-time data, analyze performance trends, and optimize energy resources.

Analytics is an essential procedure to acquire knowledge and support applications for determining electricity consumption in smart homes. Electricity variables measured by the smart meter (SM) produce a significant amount of data on consumers, making the data sets very sizable and the analytics complex. Data mining and emerging cloud computing technologies make collecting, processing, and analysing the so-called big data possible. The monitoring and visualization of information aid in personalizing applications that benefit both homeowners and researchers in analysing consumer profiles. This paper presents a smart meter for household (SMH) to obtain load profiles and a new platform that allows the innovative analysis of captured Internet of Things data from smart homes, photovoltaics, and electrical vehicles. We propose the use of cloud systems to enable data-based services and address the challenges of complexities and resource demands for online and offline data processing, storage, and classification analysis. The requirements and system design components are discussed.

Nowadays, the development, implementation and deployment of smart meters (SMs) is increasing in importance, and its expansion is exponential. The use of SMs in electrical engineering covers a multitude of applications ranging from real-time monitoring to the study of load profiles in homes. The use of wireless technologies has helped this development. Various problems arise in the implementation of SMs, such as coverage, locations without Internet access, etc. LoRa (long range) technology has great coverage and equipment with low power consumption that allows the installation of SMs in all types of locations, including those without Internet access. The objective of this research is to create an SM network under the LoRa specification that solves the problems presented by other wireless networks. For this purpose, a gateway for residential electricity metering networks using LoRa (GREMNL) and an electrical variable measuring device for households using LoRa (EVMDHL) have been created, which allow the development of SM networks with large coverage and low consumption.