Shixin Song
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Shixin Song has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Shulin Sun
Changchun University of Technology
10 shared publications - Xue Lv
School of Chemical Engineering, Changchun University of Technology, Changchun 130012, China
6 shared publications - Chuang Liu
Engineering Research Center of Synthetic Resin and Special Fiber, Ministry of Education, Changchun University of Technology, Changchun, China
2 shared publications Jing Hu
Engineering Research Center of Synthetic Resin and Special Fiber, Ministry of Education, Changchun University of Technology, Changchun 130012, China
2 shared publicationsJunhao Xie
Engineering Research Center of Synthetic Resin and Special Fiber, Ministry of Education, Changchun University of Technology, Changchun 130012, China
2 shared publications- Quanming Li
Jilin University
2 shared publications
Latest Publications
- 24 December 2021
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 36 (1) , 684-693
Methanol Environment Induced Smaller Crystallite Size to Enhance Energy Storage Properties of Poly(vinylidene fluoride)
- 24 December 2021
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 36 (1) , 684-693
Methanol Environment Induced Smaller Crystallite Size to Enhance Energy Storage Properties of Poly(vinylidene fluoride)
- 19 November 2021
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 139 (15) , 51945
The influence of organic montmorillonite on the breakdown strength and energy density of poly(vinylidene fluoride)‐based nanocomposites
Capacitor films with superior transmittance, flexibility, and high performance have attracted considerable attentions in the field of advanced energy storage devices. Nevertheless, the energy density is always increased at the expense of the dielectric constant or breakdown strength on one side. Therefore, based on the above stated issues, energy storage films with good optical transmission and breakdown resistance were prepared by combining a small amount of lamellar organic montmorillonite (OMMT) with poly(vinylidene fluoride) (PVDF) substrates by a simple but effective solution blending method. The addition of OMMT effectively converts the crystalline structure of the PVDF matrix, making it more favorable for dielectric energy storage films, and the polymer‐based nano energy storage films exhibit an optical transmission of approximately 90% at 800 nm. More importantly, the presence of OMMT, a unique lamellar structure, effectively hinders the growth of electrical trees within the polymer composite, thereby improving the overall breakdown strength of the composite. Ultimately, at 0.6 wt% filler content, the PVDF/OMMT nanocomposite exhibited a breakdown strength of 460 MV/m and a discharge energy density of 7.26 J/cm3 as well as an energy efficiency of 69%.
- 19 November 2021
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 139 (15) , 51945
The influence of organic montmorillonite on the breakdown strength and energy density of poly(vinylidene fluoride)‐based nanocomposites
Capacitor films with superior transmittance, flexibility, and high performance have attracted considerable attentions in the field of advanced energy storage devices. Nevertheless, the energy density is always increased at the expense of the dielectric constant or breakdown strength on one side. Therefore, based on the above stated issues, energy storage films with good optical transmission and breakdown resistance were prepared by combining a small amount of lamellar organic montmorillonite (OMMT) with poly(vinylidene fluoride) (PVDF) substrates by a simple but effective solution blending method. The addition of OMMT effectively converts the crystalline structure of the PVDF matrix, making it more favorable for dielectric energy storage films, and the polymer‐based nano energy storage films exhibit an optical transmission of approximately 90% at 800 nm. More importantly, the presence of OMMT, a unique lamellar structure, effectively hinders the growth of electrical trees within the polymer composite, thereby improving the overall breakdown strength of the composite. Ultimately, at 0.6 wt% filler content, the PVDF/OMMT nanocomposite exhibited a breakdown strength of 460 MV/m and a discharge energy density of 7.26 J/cm3 as well as an energy efficiency of 69%.
- 17 January 2021
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 138 (21)
Effect of shell phase composition on the dielectric property and energy density of core‐shell structured BaTiO3 particles modified poly(vinylidene fluoride) nanocomposites
Dielectric nanocomposites have attracted much attention due to their wide applications in electronics and electrical industry. Recently, incorporating core‐shell nanoparticles into polymer matrix to improve the dielectric properties of nanocomposites has been widely reported. Tailoring the interfacial region between the polymer and the nanoparticles plays a crucial role in achieving the desired dielectric and energy storage properties of nanocomposites. However, the effect of shell structure in the interface region on the dielectric and energy storage properties is rarely studied. Based on this, core‐shell BaTiO3 nanoparticles with two different shell polymers, a “hard‐soft” copolymer of methyl methacrylate and butyl acrylate (P[MMA‐BA]) and a “hard” homopolymer of methyl methacrylate (PMMA), were prepared in this paper. The effect of core‐shell BaTiO3 nanoparticles with different shell structures on the dielectric and energy storage properties of poly(vinylidene fluoride) (PVDF) was investigated in depth. Due to the formation of a tight interfacial region between P(MMA‐BA)@BT and PVDF matrix, P(MMA‐BA)@BT/PVDF nanocomposites not only have low dielectric loss but also higher energy efficiency than PMMA@BT/PVDF nanocomposites. This study suggests a potential strategy that fabricating a “hard‐soft” copolymer shell on BaTiO3 surface can obtain desirable energy storage efficiency than the single “hard” shell structure in dielectric nanocomposites.
- 17 January 2021
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 138 (21)
Effect of shell phase composition on the dielectric property and energy density of core‐shell structured BaTiO3 particles modified poly(vinylidene fluoride) nanocomposites
Dielectric nanocomposites have attracted much attention due to their wide applications in electronics and electrical industry. Recently, incorporating core‐shell nanoparticles into polymer matrix to improve the dielectric properties of nanocomposites has been widely reported. Tailoring the interfacial region between the polymer and the nanoparticles plays a crucial role in achieving the desired dielectric and energy storage properties of nanocomposites. However, the effect of shell structure in the interface region on the dielectric and energy storage properties is rarely studied. Based on this, core‐shell BaTiO3 nanoparticles with two different shell polymers, a “hard‐soft” copolymer of methyl methacrylate and butyl acrylate (P[MMA‐BA]) and a “hard” homopolymer of methyl methacrylate (PMMA), were prepared in this paper. The effect of core‐shell BaTiO3 nanoparticles with different shell structures on the dielectric and energy storage properties of poly(vinylidene fluoride) (PVDF) was investigated in depth. Due to the formation of a tight interfacial region between P(MMA‐BA)@BT and PVDF matrix, P(MMA‐BA)@BT/PVDF nanocomposites not only have low dielectric loss but also higher energy efficiency than PMMA@BT/PVDF nanocomposites. This study suggests a potential strategy that fabricating a “hard‐soft” copolymer shell on BaTiO3 surface can obtain desirable energy storage efficiency than the single “hard” shell structure in dielectric nanocomposites.
- 8 May 2020
- Published by Springer Nature in Journal of Polymer Research
- Vol. 27 (6) , 1-9
The thiol group modified multi-wall carbon nanotubes to enhance the dielectric properties of polystyrene
- 8 May 2020
- Published by Springer Nature in Journal of Polymer Research
- Vol. 27 (6) , 1-9
The thiol group modified multi-wall carbon nanotubes to enhance the dielectric properties of polystyrene
- 5 November 2019
- Published by Springer Nature in Journal of Materials Science
- Vol. 55 (8) , 3212-3227
Fluoro-polymer-coated carbon nanotubes for improved interfacial interactions and dielectric properties in MWCNTs/PVDF composites
- 5 November 2019
- Published by Springer Nature in Journal of Materials Science
- Vol. 55 (8) , 3212-3227
Fluoro-polymer-coated carbon nanotubes for improved interfacial interactions and dielectric properties in MWCNTs/PVDF composites
- 21 November 2018
- Published by Springer Nature in Journal of Materials Science
- Vol. 54 (5) , 3832-3846
Improving the electroactive phase, thermal and dielectric properties of PVDF/graphene oxide composites by using methyl methacrylate-co-glycidyl methacrylate copolymers as compatibilizer
- 21 November 2018
- Published by Springer Nature in Journal of Materials Science
- Vol. 54 (5) , 3832-3846
Improving the electroactive phase, thermal and dielectric properties of PVDF/graphene oxide composites by using methyl methacrylate-co-glycidyl methacrylate copolymers as compatibilizer
- 28 June 2018
- Published by Springer Nature in Journal of Polymer Research
- Vol. 25 (7) , 157
Enhanced electroactive phase, toughness and dielectric properties of poly(vinylidene fluoride) with addition of MMA-BA-IL copolymer
- 28 June 2018
- Published by Springer Nature in Journal of Polymer Research
- Vol. 25 (7) , 157
Enhanced electroactive phase, toughness and dielectric properties of poly(vinylidene fluoride) with addition of MMA-BA-IL copolymer